Accent LC (2000-05) :: Rear Brake Drum Cylinder Removal?
I must replace my driver's side rear brake drum cylinder but I am unable to fit any socket or wrench on the backing plate bolts holding on the brake cylinder. They are rusted and never been touched I think; how does one remove the bolts holding on the brake cylinder without stripping them? There is basically no room for leverage and the walls of a socket are too thick.
View 3 RepliesToyota - Tundra :: 2002 - Rear Drum Brake Adjustment
Don't seem to have an adjustment hole on my 2002 Tundra SR5, 2W drive. These are self adjusting brakes and, if they are, how to I go about adjusting them....simply backing up and engaging the brakes?
View 4 RepliesPontiac - Bonneville :: Removing Hub From Front Brake Drum
i have a 1966 pontiac catalina and i am replacing most of the brake components including the drums, which a car of this vintage has at the front also. the new drums don't include hubs, so i will have to swap the old hubs to the new drums. do i have to go to the machine shop to have them press these apart?
View 16 RepliesPontiac - Sunfire :: Rear End Noise While Driving Slowly?
I own a pontiac sunfire '00, and it makes a crackling noise in the rear end whenever I drive slowly, what could it be?
View 3 RepliesPontiac - Sunfire :: 2002 - Check Engine Light Turned On Again?
Check engine light issue. For the past 3 months, my check engine light has been turning on. The first time it happened, the garage replaced the EVAP Purge Solenoid (which includes the vapor can purge solenoid and the EVAP canister purge solenoid). Of course, a few months later, the check engine light turned on again. The second time, the garage replaced the gas cap. Then the check engine light turned on again the next day.
So, the third time, the garage performed maintenance/repair on the vapor can purge solenoid and the EVAP canister purge solenoid. Of course, three days after driving my car, the check engine light turned back on. I've contacted the garage for the fourth time now. I explained that their diagnostics have obviously been exhausted, and they aren't really sure what the problem is. I'm going back in a few days to speak to the lead mechanic hoping to be compensated for their guess-work or at the least to be given an honest "I don't know" answer.
Brakes - Pontiac - Sunfire :: 1997 - Squealing Noise Coming From Brake Pedal
After replacing my brake pads and shoes I am hearing a squealing noise coming from the area near my brake pedal. This noise sometimes becomes high pitched if I depress the brake too hard. I am also losing a little bit of brake fluid if I depress the pedal hard several times. The brakes themselves function fine and have no problem stopping. When I bled the brakes today some of the fluid was black. I figured it might be air in the system but after bleeding them it is still happening. I also replaced the bleeder screws.
1997 Pontiac Sunfire 2.4L uses DOT 3 brake fluid.
Pontiac - Sunfire :: Brake Fluid Leaks Out Where Reservoir Attaches To Master Cylinder
I'm getting ready to work on a 2000 Pontiac Sunfire for a co-worker. They told me that brake fluid leaks out where the fluid reservoir attaches to the master cylinder. Could that be a bad master cylinder or something with the brake booster? It looks like there is a lot of sludge in the reservoir.
View 8 RepliesPontiac - Sunfire :: 2001 - Service And Theft Lights Come On When Rear Defrost Button Pushed
I have a 2001 sunfire. recently when you push the rear defrost button the service and theft lights come on. was told to replace heating/ac unit. did it today but lights came back on.
View 3 RepliesCamry :: 2005 - Rear Brake Drum Won't Come Off
I had a tire blow out, two nuts snapped off, custom rims came with car when I brought it, 12mm internal hex. I suspect they were over torqued.
I loosened self adjuster star all the way, and the drum still wont come off, I have tried heat with propane torch where hub meets drum.
And no parking brake isn't on. 2005 Camry right rear drum.
Elantra XD (2001-06) :: Rear Drum Brake Replacement
This is my first time working on drum breaks, all the repair manuals and videos don't make it look too bad. I did have a question about the parts required to replace the rear breaks.
Assuming these breaks are very worn. What parts would need to be replaced in a typical break job.
The pics below are what I'm planning on buying:
Shoes
Rotors
Drum
Hardware Kit
Is there anything that I'm missing?
Accord :: Knocking And Vibration From Rear Passenger Drum Brake
I recently attempted to replace the rear brake shoes on my 01 Accord. Everything seemed to go reasonably well, but now when the brakes heat up I get a loud knocking and vibration while driving that goes away while braking. I popped the drum off last night and backed off the adjustment as the drum was hanging on one spot during rotation. This seemed to make it worse (though some minimal did stop suddenly in front of me, so I had to emergency brake and heat everything up). It has the original drums.
As a second, related question, there was no problem on my little test drive last night so I drove to work this morning. About 3/4 of the way there was when this started, and kept getting progressively worse. Understanding that you don't know exactly what the problem is, do you think it's reasonably ok to drive home (about 10 miles and I can stay off the highway)?
Knocking and vibration from rear passenger drum brake after replacing brake shoes, only while driving.
Car: 2001 Accord LX 4 cylinder
Took the drum off, backed down the tension on the adjustment screws. Drives and feels fine until the brakes heat up.
Ford - Escape :: 2011 - Odd Noises From Right Rear Drum Brake
Well, I have a 2011 Ford Escape. Recently, the car has been making two noises coming from the right rear drum brake.
I can only hear it going 5 mph or lower, possibly from road noise.
First noise: It sounds like someone is rubbing wet rubber on a wood floor (weird analogy). Not a grinding sound like a bad pad, but more of a hard rubbing sound.
Second noise: Whenever the car is at 5 MPH or lower and starts to decelerate, there is a high-pitched very small whistle coming from the same area. The pitch decreases as the speed does.
Got the brakes checked, no issues.
Accent MC (2006-11) :: Rear Drum To Disc Brake Conversion
I bought my accent in 2006 and it came with rear drum brakes and I want to know if it is possible to switch to rear disc brakes. I know that newer accents have all disc brakes so maybe it wont be that hard, but what do I need? I dont have abs. I asked the dealer like a year ago and they told me they wont do it. I have seen this conversion before in other cars that did not have rear disc brakes in newer versions either.
View 91 RepliesCamry :: Unable To Find A Diagram For The Rear Brake Drum Of 2005?
Worthless Chilton's manual went in trash. I don't have a working PC and Im unable to find a diagram for the rear brake drum of my 2005 camry.
View 3 RepliesPrius (2004-09) :: 2008 - Rear Drum Brake Shoe Thickness?
Getting ready to perform the clean and adjust rear brakes maintenance. I took a digital caliper and measured my rear drum brake thickness. The thinnest measurement I got was 3.19 mm.
I looked up the specifications and rear shoes brand-new are 4 mm. Minimum thickness allowed is 1mm.
I have 95K on my 2008. Since my brake shoes are showing close to brand-new measurements does this mean my rear drums are out of adjustment or is this normal?
XT1080 ?
Ford - Focus :: 2006 - Size Of Rear Drum Brake Bleeder Valve?
I replaced a brake cylinder on my 2006 Focus rear drum brake. Now, I need to bleed the brake fluid, but I can't find a wrench to fit the nut.10mm is too small and 11mm is too big. What's going on? Could it be the rusted nut has grown in size enough to make the 10mm wrench too small? Or, is the nut standard?I know the drum bleeder nut I know the front disc brake bleeder brake is 10mm. So, I am thinking the rear should be metric, but since it's drum, I am not so sure. What the size is?
View 13 RepliesFord F-150 - 1997-2003 :: 2002 - Rear Axle Drum To Disc Brakes
I got a 2002 f150, right now it has a 9.75 with disc brakes. But it exploded. I can only find a 9.75 with drums in the wrecking yard. Can I just swap my disc brakes on to the axle with drums?
View 1 RepliesFord Brakes/Suspension :: 1997 F250 - Passenger Side Rear Drum Brake Was Full Of Oil
Recently purchased my first Ford truck, a 97 F250 w/7.3L diesel. I discovered the passenger rear drum brake was full of oil. Cleaned it up and put it back together to do some research.
I see how the hub comes off and there are two bearings in it an an oil seal. The bearings are lubed in wheel bearing grease. Does differential oil circulate through the bearings too?
It doesn't look like a difficult job. Do the seals go bad often or could this be due to a clogged differential vent? Truck has only 100k miles. Any gotchas I should be aware of?
Pontiac - Sunfire :: Car Stalling While Driving
So my car keeps just dying while i'm driving..my car was running just fine until i got gas one morning and then started to sputter while i was driving and didn't want to accelerate very well...read a multiple misfire code when my check engine light was on..changed the coil packs and now isn't reading anything but now it takes a lot of cranks to get the car to start and while i am going down the road it will just die...normal engine dying lights will come on the dash when it dies..have changed the fuel filter..checked the catalytic convertor...checked plugs and wires..once in a while i do get a funny gas smell on the outside of my car but it's not leaking anywhere..checked the battery and still does it with a new battery..changed the fuel pump about 3 years ago..
View 7 Replies