Pontiac - Grandam :: 1999 - Security Light Came On?
I have a 1999 Pontiac Grand Am coupe. Over 195,000 miles. Not worried about someone stealing it This past month we have the SECURITY light come on and blink.It's do that 3 times. Two times I remained in the car, with the windows down, while my wife was in a store, with her keys. I have my own, but just sat there reading, no A/C or radio on, According to the manual, it is an anti-theft "feature". When it does the computer shuts off the fuel and the car won't start. It turns over. We have to wait until the light goes off, then it starts. Dealership says they can't disable this "feature". They said it could be ignition switch or computer $$$. What can I do?
View 1 RepliesPontiac - Grandam :: Security Light Come On / No Alarm Fob
When mother purchased car she wasn't given an alarm fob. She just locks the doors. One day the "Security" light comes on and the car acts like there is a kill switch on it. Can't seem to locate the problem. She purchased it used in another state.
View 7 RepliesPontiac - Firebird :: 1993 - Security Light And No Start
I have a 93 firebird. it has a new engine ,starter and battery. fuse under hood is good. turn switch lights work as usual .
View 11 Replies2002 Pontiac Aztek - Can Reprogram Transponder Keys?
I have a 2002 Pontiac Aztek. I am having to do the relearn process. I was wanting to know if you can reprogram the passkey 3 key not the key fob but the actual key. It was already programmed before but I want to know if I can REprogram it.
View 1 RepliesPontiac - Aztek :: Hesitate Then Jerk Forward And Go When Hit Gas To Speed Up
I have a 2002 Pontiac Aztek with about 170,000 miles on it. About 3 weeks ago, it began having problems when I would hit the gas to speed up. It would hesitate, and then jerk forward and go. Then about 2 weeks ago, I was driving on the highway and the engine just suddenly stopped - as if I had turned off the key.
There was no warning, no sound, nothing. I kept hitting the gas the whole time and it started up again after a minute. I replaced the fuel filter and it ran well for a week. Then it happened again, but this time the engine completely turned off and I had to turn the key to restart the engine. The engine started with no problem.
I tried to drive to the mechanic, but the engine stopped & started again on the way, so I ended up having it towed. It is not driving roughly or idling roughly, it doesn't make any strange sounds and no warning lights come on. When the engine stops, all electrical components are still working (lights, radio, etc.). My mechanic appears to be stumped. What could be causing this?
Pontiac - Aztek :: 1994 - Loud Engine Noise When Driving
I have a '94 Aztek that sounds like a small plane engine when driving. What is causing the noise?
View 10 RepliesPontiac - Aztek :: Shimmy When Turning Right At Highway Speeds And When Accelerating
My '01 Aztek has a very odd shimmy. It only happens when turning right, at highway speeds, and when accelerating. Not when turning left, and not while just 'coasting'. Only when accelerating.
The mechanic replaced a tie rod end, and that seemed to fix things for a few hundred miles. But now it's back and is happening at lower speeds.
Pontiac - Aztek :: Clicking / Slipping Brake - Pedal Depresses In A Jerky Manner
2003 Pontiac Aztek ... I'm a slow stopper. I like a rolling stop. Lately when I do that my breaks will make a clicking sound (around 6 clicks) only heard inside the car. I'd i let it click, then it's fine, if I press the brake down all the way before the clicks it depresses in a jerky manner. This problem has existed for awhile now. I now an the proud owner of new abs module, wiring harness, multiple wheel housing assys, new brakes, rotors... That may be it with the break system. We just checked and bled the break line for air. I'm tired of paying several mechanics and no results.
View 10 RepliesTouareg :: Blinking 2WD Indicator On 4WD Knob And In Info Center
On my 4WD selector, the small icon that shows the 4 wheels with 2 of them angled (the right most choice if turning the knob) is showing up in my info center on my 2004 Touareg. As well, all the lights on that 4WD selector know are blinking. I can't find anything about this in the manual.
View 1 RepliesPontiac Grand AM :: 2001 - Security Flashing On Dashboard
I have a 2001 Poniac Grand Am Gt v6 2 door and yesterday I was about to start my car it did made that noise when its going start but it didn't so I notice the SECURITY flashing! i made some research it has to do with the pass lock?
View 1 RepliesImpala - Chevrolet :: 2003 - Power To Heater Blower / Cruise Control And Info Center Stopped Working
I am trying to troubleshoot why my heater blower, cruise control and info center above my rear-view mirror has stopped working. I am trying to confirm power to an orange wire next to the driver-side fuse box. I have confirmed no power at the fuses. I am hoping the problem is the wire box below the fuse box and not the ignition switch. I have a wiring diagram and the power feed to these three fuses is via an Orange wire. There are two Orange wires in the box, I am trying to determine which one feeds the fuses for these three devices. I have a picture of the fuse box.
View 2 RepliesFord Brakes/Suspension :: 2010 F350 - Tire Pressure Monitor Fault Showing On Dash Info Center
I have a 2010 F350 that has been throwing the "tire pressure monitor fault” on the dashes info center. Here is where it started. I purchased new wheels, tires and sensors a few weeks ago. I put them on and they were fine on the way home because I assume that the stock ones where still being read (they were in the bed of the truck). Put the old ones in the garage and then while driving to work the next morning I got the message. I tried to reset or “learn” the new sensors that night with no luck. There are two ways to get my truck into learn mode. One uses the hazard flashers then releasing some of the tire pressure until the truck horn beeps. The other method is a series of break pumps and turning the ignition from on to off then using the TPMS tool that apparently comes with the truck.
The truck went into learn mode every time with either method but it would never recognize the new sensors. After attempting everything on the sensors I checked to see if for some reason the trucks actual monitor was in a “fault” mode. Last night I tried relearning the old stock sensors with great luck. They all were recognized… for about 10 minutes. After getting them to work I left the shop I work at and on the way home the "tire pressure monitor fault” came back again. So just in case something had been in sleep mode when I did it I pulled over and reset them once more. Again with great luck… until this morning on the way to work again it went back to fault mode even with the stock wheels still in the bed.
Pontiac - Sunfire :: Driver Side Headlight Not Working
On Tuesday I discovered that my drivers side headlight wasn't working, so I bought a light-bulb and went to replace the light. It turns none of the wires are still attached to the light holder and so the light is obviously not attached to the car. Is it likely that they all broke off at once or that someone cut them? (I have some nasty neighbors). Is it going to be really expensive to get this fixed? Can I buy the part that attaches to the light-bulb that has the wires attached and attach the wires to the car myself? If so, what is the part called so that I can order it?
View 6 RepliesPhaeton :: Sound In Center Console On Driver Side Like A Loud CPU Fan
I have been getting a sound like a loud cpu fan on the driver's side of the console wall, just below the ignition port. Any other NAR cars have this problem? It will go away after awhile but will turn back on again.
View 9 RepliesPontiac - Grandam :: 2003 - Flashers Fast On Driver Side
2003 Grandam turn signal flashes fast on drivers' side...
View 9 RepliesPontiac - Vibe :: Driver Side Front End Braking Noise
What's that noise coming from the front end driver side. About 2 months ago Firestone replaced my 06 Vibe 5 speed manual base brakes, rotors, calipers, brake line & fluid replaced. The car is still making a noise when braking at low speeds. It generally happens after the cars been driven awhile or when warm. It sounds like metal on metal scraping. I can also feel vibration in the steering wheel when braking, is it possible that the hub bearing is going. I had the bearing replaced on the passengers side 2 years ago. Doesn't quite sound like the first bearing replacement. I took it back to shop and they replaced the brakes again when they replaced and flushed the lines. The problem is by the time they get to the car it's cooled down and they don't hear the sound. Should I have the hub wheel bearing replaced or is it something else.
View 3 RepliesPontiac - Vibe :: 2005 - Power Windows Other Than Driver Side Won't Go Down
My driver seat power window works, however, the other three windows won't go down. When I press those three buttons - I hear nothing. Are the other three windows on a separate circuit? Would this be a fuse, or possibly the master switch assembly?
View 9 RepliesPontiac - Grandam :: Clicking Noise In Front Driver Side
I'm getting this clicking noise in the front drivers side of my car... it sounds like its related to the wheel because it's clicking in a rotation pattern, i.e. it slows down as I slow down, etc. The clicking noise dulls/goes away whenever I brake. Not sure if that means it's related to the brakes...or if it's something else.
View 2 RepliesPhaeton :: 2004 - Rear Window Cracked From Bottom Center On Driver Side
Cracked rear window from bottom center (on the driver's side just past the Dole light). Dealer says that they would have to sub out the install. That worries me a little, given antennae & other items hooked up on/near rear window.
View 4 Replies