Mazda - Miatamx-5 :: 2000 - Intermittent Scraping Noise
I drive a fixer-upper 2000 Miata SE. When I turn in reverse, like to get out of a parking spot, I get this awful, intermittent scraping noise. Imagine a sci-fi movie where some ancient rusted megabot stands up for the first time in 1,000 years - that's basically the noise. I'm thinking the most likely culprits are the LSD and the steering column. But it only happens in reverse, which doesn't fit with the steering column theory (I think), and it sounds like it's coming from the front, which doesn't fit with the LSD.
View 5 RepliesMazda - Miatamx-5 :: Wipers Only Work On Slowest Settings
Wipers Only Work on Slowest Setting or if I operate them manually. Is this a problem with the motor? If it was a fuse problem, they probably wouldn't work at all, right? I've read that the problem could also be battery-related. This problem seemed to start after the battery died and was jumped.
View 4 RepliesMazda - Miatamx-5 :: Air Conditioner Keeps Blowing The High Pressure Hose
My car is a 2006 Mazda Miata, stock except for being lowered and having a different muffler. Nothing really noteworthy about it. I did run over a big chunk of something a few years ago that cracked the plastic undertray under the nose of the car and dented the bottom row of the condenser, but the problem I'm having is more recent.
About a year ago the AC stopped working. I took it to one shop that found there was no refrigerant in the system. They refilled it, and a few hours later it stopped working again. I took it to another shop that detected a leak in one of the schrader valves (the low pressure I think). He replaced that, filled it, and it worked again for another few months.
Recently it stopped working again. I took it to the same guy that replaced the schrader valve and he found that the high pressure hose had failed. He replaced it and refilled the system. It worked for a few hours. Then when I was sitting at a drive thru, a massive cloud of refrigerant erupted from under the hood and the AC stopped working. Took it back to the guy and he found the high pressure hose had blown off. He put it back on, refilled it, and the same thing happened again. Sitting in traffic, the high pressure hose blew and all the refrigerant poured out.
I took it back to him again and he put the hose back on and refilled it again. We let the car idle for about 30 minutes with the AC on and it worked fine. During this he had the high pressure gauge hooked up and it read between 150 and 175 with the car idling (about 70 degrees F ambient temp). He didn't have the low side gauge hooked up. We did see that the fan is working and kicked up to the higher speed. He did say he checked the dryer and that it looked like the bag that held the desiccant was intact, but he didn't mention replacing the dryer in any of these visits.
Mazda - Miatamx-5 :: Coolant Sprayed On The Hood / Reservoir Empty
I noticed recently that I have a coolant leak in a used car that I got a few months ago. I've been driving this thing pretty regularly at this point, but I haven't noticed any overheating. The engine temp stays shy of the midpoint line on the meter, both at speed and in idle.
The coolant reservoir was empty a little over a month ago, so I filled it up. A few days ago, I took a look at it, and it was empty again. I refit a hose that was a little loose and decided I'd just wait and see what happened after driving it some. Over the past few days, I've noticed slight decreases in the coolant level each day.
Today was no different, except that after I drove for about 15 minutes on probably the hottest day of the year so far (about 95 degrees, don't know if that matters at all), I noticed there was coolant sprayed on the hood. I opened the hood and there was quite a bit of coolant pooled on the far left of the radiator top, right between the coolant reservoir and the radiator pressure cap. What's going on here?
Mazda - Miatamx-5 :: 2008 - Bumping Feel For The First Couple Of Minutes Of Driving Then Smooths Out
I have a 2008 Miata that is new to me (<40K miles). When I first drive it in the morning it has a very noticeable bumping feel for the first couple of minutes then smooths out and is not noticeable for the rest of the day, even if I park it for a couple of hours. I believe the bumping is coming from the rear driver's side. I just replaced the tires (thinking they were flat spotted), but the problem persists.
View 3 RepliesMazda - Mazda3 :: Skipping Gears While Shifting
Is it ok/better/worse to skip gears while accelerating in a manual car? Example would be starting from a stop in 1st and going strait from 1st to 3rd gear. , I have a mazda 3 and i usually run 1st up to 3500 rpm or so and when i hit 3rd its around 1400 when I let the clutch out.
View 13 RepliesMazda :: Manual Transmission - Can Change Gears But Car Only Revs
So my brother "learned" how to drive manual and asked if he could take my car for a spin. As we were driving he went from fifth gear (which he had prematurely switched to) to first. This occurred at about 35 or 40 mph. The car kind of jerked and a mechanical clicking could be heard. The clutch feels fine, and I can switch to all gears it seems, but when I let out the clutch, the gears won't engage, and the car can only be revved. This comes with a clanking noise.
View 10 RepliesMazda :: 2001 - Engine Humming Sound While Shifting Gears
I hear a weird humming sound when I press the gas pedal.it goes away when I press hard. Also it sounds while shifting gears...
View 3 RepliesMazda - B2300 :: Clutch Replaced - Clunky While Switching The Lower Gears
I had my clutch replaced about a year ago in my 2003 mazda b2300 truck. Recently, it's been showing some of the same symptoms that popped up about a year ago. Such as, it's having a hard time going into first gear, and it seems to be generally clunky while switching the lower gears. The first clutch was replaced at 130k so I was alright with that. However, I find it hard to believe that I burned out this new one in a year. I do live in Boston, so traffic is pretty bad, but I try to not ride the clutch in traffic.
View 12 Replies5 Series :: 91 525i Will Only Engage 1st And Reverse Gears?
my 91 525i wont engage 1st gear..fluids fine..nothing smoking...fluid levels great. color correct in fluid appearance..reverse works..no funny noises from rear end..car just will not shift above 1st. i have replaced transmission filter and fluid.
View 1 RepliesMazda :: 2015 CX - Squealing Noise When In Reverse
Squealing noise when in reverse, mainly noise coming from front passenger. What it is?
View 7 RepliesNissan - Sentra :: Changing Gears From Reverse To Drive
My wife always chastises me for not coming to a complete stop from backing up before I shift the car into drive. I do not shift when the car is still moving more than 1-2 MPH, in fact it is barely moving when I change gears. My wife insists that I come to a complete stop and wait 1-2 seconds before shifting from reverse to drive. She is convinced that I am doing damage to the transmission the way I shift. I insist that no damage is being done and point out that with over 100,000 miles there have been no transmission problems with the car. Am I damaging the transmission by shifting before I come to a complete stop in reverse?
View 9 RepliesAccent LC (2000-05) :: 2004 - Lost Reverse And All Gears Aside From First
I have the opportunity of getting i believe a 2004 accent gt for next to nothing. It recently lost reverse and all gears aside from first. The codes it is triggering are p0734 p0732 and p0733. Prior to throwing the codes it moved back but wouldn't budge forward. With codes no reverse or any gear higher than first. Car has 160k miles I am pretty mechanical. Should I run from this "cheap" "gas saver" or pick it up? With all 3 codes could it be just that sensor?
View 6 RepliesFord Transmission :: 2004 Explorer Reverse In All Gears
I have a 04 Explorer 4.0 4x4 with 130,000 mi. It all started about 3 months ago. The truck would neutral out while driving. After changing tranny fluid and filter, along with rear speed sensor the problem returned after driving 3-4 miles. After digging deeper I found the transfer case was bone dry and fried inside. Replaced the TC and check fluid level again. Back out of garage and drove the vehicle approx. 2 miles. Stopped to grab a coffee and left truck running. Returned to find I had no reverse or drive. This is after driving it to where I was. Towed truck back home.
I noticed the vehicle would start in gear. Replaced neutral safety switch ( grooves properly aligned ). Started truck, reverse lights come on when in reverse.. The problem now is when I put vehicle into R,N,D,3,2,1, the truck does one thing... REVERSE. All gears put truck into reverse, no forward movement at all. I attempted to replace safety switch a couple of weeks ago but was unable to remove the nut holding the lever on. 2 days I spent on that nut. Now I'm wondering if I did something inside the tranny when I was wrenching on that nut for 2 days?
Ford Transmission :: 4r70w - No Forward Gears Only Reverse
I have a 98 expedition with a 4.2 liter 4x4 and what I believe to be a 4r70w transmission (u code on the door sticker)
The original transmission went at 105k miles and was replaced with a new factory ford transmission by a ford dealer 3.5 years ago. The new transmission only has 10k miles on it.
Now the new transmission only has reverse. reverse works like normal but no forward gears. the idle will change when i put if in gear, but will not move, acts like it is in N . There is no strange noises.
It's hard to believe a new trany is shot already, no towing, or off road use.
My question is : is there ANYTHING that can go bad that would cause this? The trany fluid is clean and clear bright red, and no burnt smell.
I want to check everything I can before calling a tow truck to have it looked at. I will have it repaired if needed, but I don't think I want to replace another tranny.
Ford F-150 - 1997-2003 :: 1999 - Have Only 2nd And Reverse Gears?
The trany is less than a year old rebuilt by a local shop.
Starting two days ago when i put the shifer in anything but reverse and 2nd it acts like it is in nurtral. 2nd and reverse are strong and do not slip. do you think its in the linkage? Or is my tranny dead?
its a 99 f250 256K auto 4x4 xl
Passat (B5) :: Hard To Shift In Gears Especially 1st / 2nd And 3rd
After driving around hard for a couple minutes I got home and the car smelled like something is burnt then I went out to drive normally to get the smell out but didn't work. Then I realized my gears were hard to move into especially 1st, 2nd, 3rd. Its hard to change into those gears now. what could be the reason? What do i need to do for my gears to move smoothly again? I just got this car, my first.
View 5 RepliesGmc - Envoyxl :: 2004 - Lost Gears / No Reverse When Driving On Highway
While driving on highway lost gears no reverse or any gears. check fluid ok no burnt smell
View 2 RepliesChevrolet - S-10 :: 1987 - Transmission Slips In Forward Gears And Can't Go In Reverse
My '87 Chevy S-10 transmission slips like mad in forward gears and I can't go everywhere in reverse. The truck is gaaged in southern Virginia about 60 miles from my home and is used on some country property. The local transmission shop wants $1600 to rebuild the trans. He says he used sturdier parts than the replacement GM parts. I'd like to fix the truck because it comes in handy and was my dad's old mode of transportation around the Va. countryside, so it has sentimental value.
View 3 Replies