Mazda - Mazda3 :: 2005 Making Clicking Noise
I have a mazda 3 and i just tried to start it but its just making a clicking noise. The radio works so does that rule battery out....
View 4 RepliesMazda - Mazda3 :: 2008 - Noise While Shifting Between First And Second
I hear a noise- what I can best describe as a metallic plucking sound - like a low metallic chord being plucked- when my automatic transmission 2008 Mazda3 shifts from first to second gear. It only happens the first time. I don't hear it after the car ihas been driving and is warmed up. Any thoughts on what could be happening?
View 2 RepliesMazda - Mazda3 :: 2008 Engine Noise At 1400 - 1700 RPMs When In Gear
I have a 2008 Mazda3. The car has a replaced engine with 24,000 miles on it. The engine was put in before I bought the car.The car and engine run like a top; except at certain RPMs and when in gear. When I have the car in any gear (auto), the engine makes a rougher noise at RPMs 1400-1700. As I apply more gas, the RPMs seem to get stuck at 1700, then it will break through and run smooth 2000+ RPMs. The engine sounds perfect at all RPMs except 1400-1700 when in gear. When I have it in park and rev the engine, the engine sounds perfect at all RPMs.
View 8 RepliesMazda - Mazda3 :: Slight Clicking Sound Every While Coming Out Of Left Turns - CV Joint Failing?
My wife's 2007 Mazda3 is making a very slight clicking sound every while coming out of left turns. It's somewhat intermittent, only happening every few turns. I did a quick visual inspection and noticed that there was grease around the CV boot. The problem started about five days ago (or at least the noise started appearing five days ago). Three weeks ago I had the struts replaced, so I'm wondering if they could have torn the boot while replacing the struts, or if they didn't notice the issue.
Is the CV joint shot, considering this is only an intermittent sound, or is there something else that could be happening? Also, what is a typical repair cost for a CV joint (or half axle replacement) on a 2007 Mazda3?
Mazda - Mazda3 :: Cutting Out While Driving / RPM Loss
My mazda 3i is cutting out while driving. I added fuel injector additive to gas and it still cuts out. Battery check is fine. What the issue can be. RPM loss
View 5 RepliesMazda - Mazda3 :: 2008 - Need To Be Jump Start After Car Wash
I have a 2008 Mazda 3, and I have been bringing it to the same car wash for about a year now. It's the kind where the guys take it, while I sit in the lil' cafe and read. Eventually they drive it around front, wipe it down, clean the inside and hand it over. The last two times, the car needed to be jump started, because the battery would not start after the wash. The manager assured me this was normal, but the other guys at the car wash always seem surprised. Should I be thinking about getting a new battery? Is this really normal?
View 9 RepliesMazda - Brakes - Mazda3 :: Brake Failure Driving Slowly In A Parking Lot
Recently, the brakes on my wife's Mazda 3 (5 door, 2.3, 2005, 67k miles, automatic) failed while she was driving slowly in a parking lot. The pedal went all the way to the floor, but the car did not slow down. She used her key to turn off the engine (I've since suggested she use the parking brake instead). The car shuddered (presumably the engine slowing the car?) to a stop. She re-started her car and had some braking power, which returned to normal after a few pumps of the brakes. Since then, the car has been looked at by our usual mechanic and the dealer. Neither can find anything wrong and the brakes have been performing normally.
For it's age, the car is in good condition, has been regularly serviced, and has spent it's entire life in southern California. The only unscheduled maintenance I can recall has been the refurbishment of the electric window switches for the driver's door and some modest body work following a hit and run on the interstate (just dents and scratches). It's only other issues are an occasional rough idle when stopped at a light and harsh shifting from first to second or second to third gear when the car is cold (it's done this "forever," and I've always figured one of the accumulators was a bit sticky). The car was not serviced immediately before the incident. Is the car safe to drive?
Mazda - Mazda3 :: 2008 - How To Stop Frost On Windshield Inside Of Car
I have a 2008 Mazda 3 with 63,000 km / 39 146 miles.I bought it last year used with 50,000 km / 31 068 miles. I park my car on the street.Last winter I noticed that I frequently got frost on the windshield on the inside of the car. Is there a way to stop this from happening?
This winter I want to avoid having to scrap the windshield on the inside with the heater on max.
Do installing a window deflector will work? I am thinking that if I leave one of the windows slightly open but covered with a window deflector that frost will not form on the inside of the windshield. Is this correct or just wishful thinking?
Mazda - Mazda3 :: Hard To Start When Driving At Highway Speed And Adding Fuel
I have a Mazda 3 5-door and I believe it is a 2010 model year, with between 50k-70k miles. I've been, I believe, consistent with regular maintenance schedules, and this is the first issue I've had, and I've been having it for a bit of time now (a few weeks). I've tried various things to try and understand the issues that bring it up.
First, I don't remember if this started before or after, but my "Check Engine" light popped on. I brought it in to have the code read and it was the one for the gas cap not being on properly. The person reset the diagnostic code, tightened the cap, and I went on my way.
A few hours later it came back. Okay, but that's not the issue, and I mention it only because of the other things I've observed.
The real problem is, after I've been driving for "awhile" at highway speeds, and I add fuel, the car has a very difficult time starting. I have to really press the accelerator down to get it to start, and even then it can take a good 5 seconds of holding the key to "start".
Things I've noticed:- If I fill up at the start of a trip, so that the car hasn't been running long, I can fill up and the car starts immediately.- I thought it might be a problem with fuel spilling over into the overflow, so I've added less fuel (so I ended with the needle pointing between 3/4 and full) but it still had trouble starting- After I start it, it runs rough for a bit and I feel like I have to rev it to keep it from stalling, though I haven't left it to idle to see if it actually will stall.- After the difficult start, if I drive as little as down a city block, turn the car off, and back on, it has no trouble starting, nor does it stutter like it does when I fill it up.- If I take a long drive but don't add any fuel, it starts up right away.
I've always used 87 octane fuel, which seems to work fine, and I feel as though that's the recommended grade, isn't it? I also try to fill it up when the needle reads 1/4 of a tank or a bit more, but I do notice that, if I allow the pump to auto-shutoff the car will accept 9-10 gallons (and I thought it was a 10.5 gallon tank, which is less than 1/4 left... I'm not sure how bad that is...)
What it could possibly be? Or even additional tests I could try to narrow it down?
Mazda - Mazda3 :: Loud Noise When AC Is On And Accelerating
I have a 2004 Mazda 3. I just had it inspected and cabin air filter replaced. Now, my car makes a loud noise when the a/c is on and I'm accelerating. The noise sounds like a fan is vibrating /something is blocking it or like a motor is rev-ing that shouldn't be. There definitely is something wrong that wasn't there before the filter/s replaced. I watched a Youtube video on it... a real pain to replace them, but it looked like the fithad to be pretty tight... Could the filters have been installed incorrectly or some part not put back together correctly?
View 2 RepliesMazda - Mazda3 :: 2008 - Burning Smell Intermittently From Left Rear Wheel?
A few months ago I bought a used 2008 Mazda3s sedan, and ever since I get an intermittent burning rubber smell from my rear left wheel. I recently got new tires, brake pads, and had the rotors turned, with no change.
The smell does not always happen, it will be there maybe one out of 3 or 4 times, and it is more likely to happen after long drives (e.g., one hour highway driving).
The wheel well also feels very hot. The obvious answer would be that the brake caliper is sticking, causing friction, heat, and the burning smell. However, if I touch the rotor it feels the same lukewarm temperature as the other three.
One additional thought is that this is caused by the exhaust, which is right next to this wheel well. I have noticed that the area of the floor of the trunk right above the exhaust gets very hot, which I had not seen in any other car I owned.
Could it be that the exhaust is causing the rubber of the tire (or something else) to overheat and smell bad? Visually, it does not look like the tire has a different wear or different appearance, compared to any other one.
This may or may not be related: my handbrake seems to be useless If I leave it on I can easily drive with little to no noticeable slowdown... I guess the previous owner did not read the part of the manual where it says you have to release the handbrake before you drive.
Mazda - Mazda3 :: 2010 - Makes Noise When Stepped On Clutch Pedal
The noise sounds a little like a baby Road Runner, a soft little "meep" sound. I usually notice it after the car has warmed up, when I come and go from a stop sign. In lieu of strapping somebody to the hood with duct tape, I've been trying to think of a tunnel that I could drive through fairly slowly with the window down while I attempt to replicate the sound.
View 3 RepliesMazda - Mazda3 :: 2005 - Sometimes Will Not Start
I have a 2005 Mazda3 with a 2.0 engine & a five speed transmission and 94,000 miles. Since June the car has twice not started, and so far three trips to two different Mazda dealers have not resolved the problem. The car had sat overnight, when I tried to start it the engine it turned over normally, and sounded normal, for just a second. Then it sounded like it started turning over much much faster than normal and the turning over sound changed to the sound of a high speed "whirl" (I don't know any other way to describe it).
In both cases the car just turned over and over and never sounded like it was going to start, resulting in a tow being needed. I've now found out that the dealer started the car by pushing the gas pedal to the floor, then cranking over the engine and then very slowly releasing the gas pedal until the engine started to fire. In the three months in between the non start days the car has started fine and it drives fine, lots of power, constant power with no surges or bogging down. The dealers have checked the compression, fuel PSI, and run computer diagnostics and everything appears to be normal. They also removed the value cover and say that as far as they can tell the fuel injectors seem to be functioning normally.
Mazda - Mazda3 :: Steering Wheel Vibrates A Lot
I have a 2006 Mazda3 with about 112K miles on it and what I have noticed recently is that the steering shakes a lot. I looked up online for a possible cause and have found that wheel balancing could be a reason. I got wheels balanced and aligned but still there is still some vibration in the steering, so what do you think could be the reason? I have got rotors machined once before, like a year ago.
View 10 RepliesMazda - Mazda3 :: Heater Only Works Using Recirculation
I've noticed this winter that my Mazda 3's heater is barely working using fresh air. It definitely gives out warmer air than the outside temperature, but not by a whole lot. If I turn on air recirculation, then the air becomes appropriately warm. What would cause the heater to work one way and not the other?
View 3 RepliesMazda - Mazda3 :: How To Test If Clutch Is Going / Slipping
I own a mazda 3 6 speed and im curious as how to test my clutch for slippage. I read on a old forum that to put the e brake up and put the car in 1st gear and release the clutch. When i did that my car tried to move but after a couple seconds i put it back in neutral. Another forum said to do the same but put it in 3rd as i released the clutch it stalled right away.
View 5 RepliesMazda - Mazda3 :: Leaking Strut / Need To Be Replaced?
My mechanic told me today that one of my struts on my 2006 Mazda3 (with 110k miles) is leaking and that the strut needs to be replaced. Is this something that has an impact on safety, or is it something I can stretch for a while longer? Is the strut going to break if it is leaking? Also, wouldn't I have to replace both of them?
View 19 RepliesMazda - Mazda3 :: Skipping Gears While Shifting
Is it ok/better/worse to skip gears while accelerating in a manual car? Example would be starting from a stop in 1st and going strait from 1st to 3rd gear. , I have a mazda 3 and i usually run 1st up to 3500 rpm or so and when i hit 3rd its around 1400 when I let the clutch out.
View 13 RepliesMazda - Mazda3 :: 2007 Tough Startup After Fill Up?
My 2007 Mazda3 2.0 engine had the CEL on. took to autozone... gas cap code cleared. After the code was cleared next times I filled up, whether empty or 1/4 tank, car wouldn't start unless gas pedal is pushed to floor. Took to dealer. Dealer said code was for gas cap and maybe a vacuum hose. Did something to gas cap and cleared code. Light back on 2 days later with hard start still there. Replaced vacuum hose... CEL off, now 2 days later CEL off but still has the startup after fill up problem. At $90/hr I'm hesitant to return to dealer.
View 3 Replies