Sonata NF (2006-10) :: Check Engine Mass Airflow Sensor?
Got a check engine light and ran the codes and here's what I got.
P0174 fuel system too lean bank 2
P0171 fuel system too lean bank 1
P0174 fuel system too lean bank 2
P0171 fuel system too lean bank 1
P2187 fuel trim malfunction system too lean at idle ( additive )
P2189 system too lean at idle (additive) bank 2
Suggested parts maf sensor.
So im not getting any of the usual signs of a dirty or bad maf sensor. Power is fine engine is responsive and gas seems to be doing alright.
Volkswagen :: Dirty Mass Airflow Sensor Symptoms Detected
I've got a 2000 VW Lupo, essentially a small Golf, with an 1.4 motor, automatic. 40,000miles. The car's got the symptoms of a dirty mass airflow sensor but, when I removed what the manual said was the air temperature sensor all I saw was the open end of a small metal tube. No mass airflow sensor. The mechanic at the VW dealer was also perplexed as the specs for my motor (apq) says it has one. At any rate, the car suffers from sluggish performance going up even moderate hills and doesn't get the gas mileage that it should. What else could be causing this? Also, does one need to clean the air temp sensor in the same way as the MAS?
View 4 RepliesPassat (B5) :: P0171 Engine Code - Mass Airflow Sensor Failed?
I've been getting this error code recently ("Fuel Trim,Bank1 System too Lean"). I have a Scanguage, which let me get the error code, and I used it to reset the message - it came back about a week later. I took it to a local repair shop after the second time, but as I'd already cleared the message, he couldn't do anything. It came back about a week later, and this time I took the vehicle in as soon as the yellow light showed up (without connecting the Scanguage).
The mechanic said that he found both P0171 and P0172, and that the problem was a loose vacuum hose AND a failing Mass Airlow Sensor. They reattached the hose and cleaned the sensor, but said that the latter fix may not last - the light came back on two days later. I took it in again (this time, checking the codes, and found only P0171) and he said this confirms the problem with the sensor and he'll have to replace it ($280 for the part, plus labor, less a discount on the labor equivalent to the labor he put in to clean the sensor.)
Silverado :: Check Engine Light Came On - Mass Air Flow Sensor
Ok so I just replaced my mass air flow sensor about a week ago. My check engine light just came back on and when I scanned it it said mass air flow sensor. What could be causing this to happen again? The codes are P0102, P0440, P0440.
View 4 RepliesJetta - Volkswagen :: 2001 - Check Engine Light Stays On
I have 2001 Wolfsberg Edition 4D jetta (gas) with 180,000 miles, manual transmission. The engine light has been on for years and years. Usually what I do is take it in for an oil change just before a smog. They re-set the codes. I drive it to my office and back and the light would stay off and I could smog it. Until recently. In April, I took the car in for an oil change. And when I picked it up, it ran terribly. It was lurching like crazy. I had to keep slip the clutch to drive it until it warmed up and the it would mostly start running OK. I took it back to my mechanic and he thought it was a timing belt. I had already changed the timing belt at 119,000 miles.
It seemed odd to me that this procedure needed to be done again after 60,000 miles, but I went ahead and had it done. That did not fix the problem. Then the mechanic replaced the air mass meter. That didn't work. Then he replaced the coils. That didn't work. My mechanic has had the car for a month and can't seem to figure out what to do. He keeps getting different error codes - codes that don't seem to make sense to him. The car needs to a smog (my registration date is June), but he can't smog it because we can't get the check engine light to stay off long enough.
Pontiac - Bonneville :: 2004 - Location Of Mass Airflow Sensor
I'm wondering where the mass airflow sensor is located on a 2004 Pontiac Bonneville?
View 6 RepliesPassat (B5) :: Check Engine Light On / Code 16486 - Mass Air Flow Sensor Circuit Low Input
I cleaned my k&n air filter on my 02 passat 1.8 turbo let it dry oiled it very lightly, and 50 miles later I get a check engine light on, pulled the code 16486 and it says Mass or Volume Air Flow Circ Low Input. Cleared the code put a frame in until I can get it filter. Why that would throw me that code, k&n oil gumming up my sensor??
View 2 RepliesChevrolet - Lumina :: 1996 - DTC Code P0101 - Mass Airflow Sensor Malfunction
So I have a 1996 Chevy Lumina (3.1L V6 engine) and I keep getting a DTC code P0101, which is a Mass Airflow Sensor malfunction. It's rather annoying because every time this happens, my engine shuts off. I'm talking no power steering, no power breaks, no acceleration, nothing. So I replaced the mass airflow sensor and it continues to stop about every five minutes. However, it does something odd and that is that the car drives just fine when it's in Overdrive and stops when it's in regular drive. I don't know if that's important, but I thought it might diagnose the problem.
View 4 RepliesBuick - Regal :: 1996 - CEL Code P0306 Cylinder 6 Misfire Plus P0102 Mass Airflow Sensor
Ok, my 1996 Buick Regal is acting up. I got a CEL, which was a P0306 (Cylinder #6 misfire), took the car to my shop, and they diagnosed as a faulty Ignition Control Module. Fast Forward, a day later, the car now has a hard start problem and throwing the same code, plus a P0102 Mass Airflow Sensor.
So my questions are:
1) Could a faulty ICM cause a single cylinder misfire, did they just replaced a random part? I would think a bad ICM would a multiple misfire considering on this car each coil controls 2 cylinders.
2) Are the two codes related? ie fix one, and the other would go away? or are they separate issues?
3) What could be wrong with my car?
This mechanic has been in my family for years, however, I'm not very pleased that a day later, my car seems to have more problems than before. Am I being too harsh?
Ford - Explorer :: 1998 - High Pitched Whine Type Noise Coming From Mass Airflow Sensor
There's a high pitched whine type noise coming from my Mass Airflow Sensor. I can get it to go away temporarily if I goose the gas pedal, but it comes back after a minute or two. Has not affected drive-ability, but it's pretty annoying. It sounds like the hot wire is probably vibrating. Is there any fix for it, or do I have to replace the sensor to get rid of it?? Have tried cleaning it, but that did not work.
View 6 RepliesGolf IV / Jetta IV :: 5 Engine Fault Codes - Cam Position Sensor / Knock Sensor / Secondary Injection Pump And Mass Air Flow
I recently picked up a 2000 jetta vr6 for a very good price its a glx I have owned a vr6 before and done timing chains myself on it this one is a glx , I am having 5 fault engine codes on my vagcom they are cam position sensor , knock sensor, secondary injection pump, and mass air flow it ran fine 100 miles yesterday this morning the epc came on then went off and ran bad can these codes all be related or do I have to replace each sensor individually..
View 9 RepliesJetta - Volkswagen :: 2010 - Check Engine Light Came On?
I have a 2010 Jetta with the 2.5L 5-cylinder that recently threw on the check engine light for 2 days, then the light shut off. It began once I started the car on a coldish (~20F) morning after it had been sitting curbside for several days with the passenger side wheels sitting on about 6 inches of snow so the car was listing to the side. The car fired up immediately but ran extremely rough for about 10 seconds (the engine throbbed sharply about 2-3 times per second, which could be felt through the steering wheel & seat, accompanied by a muted clunk) before I turned it off.
During this time the CEL flashed on and off and then stayed on. I popped the hood, peered stupidly at the plastic engine cover, and restarted the car about a minute later and it ran normally, but the CEL stayed on. I drove it for two days (~50 miles) with the CEL on, but on the third day (today) the CEL did not turn on. The car has been running normally for all three days. What might have caused the rough idle/CEL and whether I can pretend it never happened since the car seems to be running normally for the third day in a row and the CEL has turned off on its own?
Jetta - Volkswagen :: Check Engine Light On After Filling Up With Gas
Whenever I fill up my VW bug it has trouble starting .... Starts fine in the morning or if just sitting BUT when I stop and put in new gas it has trouble starting AND then when it does finally start the check engine light comes on and the code says "misfire" which I am sure is a correct code since in fact it has such a hard time starting but why? Why only after filling up with gas ? And what can I do about it ????
View 6 RepliesJetta - Volkswagen :: Check Engine Light Blinking And EPC Light Is On
It's a 2010 vw jetta. Check engine light is blinking and the epc light is on the car is not paid off yet have no.
View 19 RepliesJetta - Volkswagen :: Check Engine Light / Hard Brake And Rough Idle
a 2011 jetta. brake pedal is hard no pumping action. The car show check engine. The idle is not smooth.
View 2 RepliesJetta - Volkswagen :: 2003 - Check Engine Light Has Been Staying On Solid / Code P0674
I have a 2003 VW Jetta TDI and the check engine light has been staying on solid (not flashing) for a couple of months. I took it to my local dealer who tested the computer and said that it was the thermostat and a related sensor. That answer didn't seem to make sense, and unfortunately I didn?t get the code from the dealer at the time. I did though have the code read recently at another shop and it said: "Code P0674 which is #4 glow plug circuit - Q13 - electrical fault sporadic." What this means?
View 6 RepliesPassat - Volkswagen :: 2001 V6 Cranks But Does Not Catch / EPC And Check Engine Light Come On
Recently I bought an 01 Passat with a V6. Intermittently, when I go to start it, it cranks and cranks and doesn't catch. When this happens, the EPC and check engine light come on.
Other than that it is a fine car, I'm the second owner, and it was thoroughly maintained at VW dealerships and specialist. Recently there was a new oil pan and starter put in (w/in a month--previous owners).
Engines - Lights - Jetta - Volkswagen :: 2003 - Flashing Check Engine Light / Burning Plastic Smell
Last night I was driving in my 2003 jetta on the intersate at 65mph with the cruise control on. As I came into a turn I had to tap the brakes. As soon as I did the check engine light came on. The car was doing fine so I drove home from school. Today I drove the car to work which is a five minute drive, and back with no problem. I later went to grab lunch and bring it home and then I noticed the check engine light started flashing. I then felt the engine start to stutter, as if it was misfiring. We had the windshield defrost when we started to smell a rotten egg smell. Luckily we were pulling into our drive when we smelled the odor. I immediately turned off the car and got out. I couldn't smell the rotten egg smell, but I did smell burning plastic. I didn't see any smoke and could not pinpoint the cause of the smell.
View 4 RepliesJetta - Volkswagen - Sensors :: 2001 - Engine Light On - Sputtering / Bucking
I drive a 2001 VW Jetta and have had many issues with this car but have had this particular issue many times. It starts when all of a sudden my car feels like it's going to stall when idling. When I go to drive it in this state the car has difficulty excelerating, bucking and sputtering (like the engine isn't getting enough fuel) and the engine light comes on. I have taken it to many shops and they usually replace an oxygen sensor saying that it is clogged etc. I have also had a couple of tune-ups because of it but after about a year the issue comes back and I shell out more money. I was told by one mechanic to use only super gasoline and that it should prevent it from happening again which I did and it held it off from happening again to about a year and a half but now it's back.
View 5 Replies