Jeep - Wrangler :: 1997 - Lurching Violently After Engine Warms Up
I have a 97 Wrangler 4 liter that lurches violently. It runs fine until the engine is warmed up. After the engine warms up it it begins lurching. When I put the clutch in, the lurching stops. When I let the clutch out, it is okay for 1-2 seconds (i can get power and advance the vehicle), then I put the clutch in and repeat that process. When I give it a little gas with the clutch in, the engine runs smooth - so it doesn't appear to be a gas problem. When I give it gas with the clutch out it lurches violently.
After pulling it into my garage I let it idle to about 5 minutes. It idles rough and is about to stall, when it apparently shoots a little more gas preventing it from stalling.The check engine light has come on. I took it to my local mechanic who cannot find the problem. The "computer code" indicates a faulty oxygen sensor. He also checked the fuel pressure which is okay.It has 120K miles and otherwise has been a great vehicle. It has been well maintained.
Jeep - Wrangler :: 1997 - Intermittent Feature On Windshield Wiper Stopped Working?
The intermittent feature on my windshield wipers has stopped working. I replaced the multi-switch and it still does not work. What I can do to get this feature working again?
View 2 RepliesJeep - Wrangler :: Shaking Right Around 50 Mph
I have a 2006 4 cylinder JEEP Wrangler. Right around 50 mph the whole car starts to shake pretty violently. I have to slow down back to 40 to get it back to normal. I can seem to get past this most of the time by waiting to shift into fifth gear until after 50 mph but not always!
View 1 RepliesJeep - Wrangler :: Excessive Oil Consumption
Jeep Wrangler Owners excessive engine oil consumption [URL] .... Caused engine failure with my Jeep. Chrysler aware of problem. Local dealership stating Chrysler may not honor 100,000 mile warranty due to 1missed oil change.
View 5 RepliesJeep - Wrangler :: 1991 4.0 Will Not Exceed 20 Mph
Vehicle will not exceed 20mph. Vacuum leak can be heard coming from around the intake area on the driver side. Cannot detect where it is coming from. All vacuum hoses seem to be connected.
View 3 RepliesJeep - Liberty :: 2002 / 3.7l - Overheats Sludge In Coolant Reservoir
It has 197k and change.It's not throwing any codes whatsoever. I can drive it all day and it wont overheat as long as I keep it under 2000 rpm.If I take it over 2000 rpm, it slowly heats up, but I can cool it down by slowing down. I can do like 50 mph max without it threatening to overheat. I've never let it get above 3/4 without pulling over and letting it cool off (I know how heads like to warp and crack).
Rubbery sludge in coolant reservoir (almost positive it's oil) but absolutely NO coolant in the oil, there never has been. I do all the oil changes myself and check it quite often. I've been keeping the reservoir full but it loses coolant daily (no leaks on ground anywhere, ever. I've already removed the reservoir and cleaned it out several times, but since it has more than one chamber it's almost impossible to fully clean without replacing. The hose that runs from the top chamber to the bottom blows off from time to time (I finally put hose clamps on it). I've flushed the cooling system several times but still the sludge comes back. I've removed and cleaned the thermostat (still good) and housing (had very little sludge). I flushed out the heater core but the heat is still weak.
Makes a loud whistling noise at idle, the noise literally stops every time I give it gas. (this is where I was thinking Intake Manifold Gasket, maybe vacuum leak) You gotta love these plastic manifolds. BUT it's idling low (650 rpm once fully warmed up) not bogging or sputtering whatsoever. Fans are working completely fine. It loses oil but again, no leaks on the ground whatsoever. I thought at first it was burning it (high mileage, worn piston rings) until I noticed the coolant reservoir was gunked (wasn't very long and I know I didn't mix different kinds. I check everything (more than regularly) and it loses quite a bit of oil.
Before everyone says head gasket, it isn't losing much power (if any at all), no white exhaust, and as mentioned before there's no coolant in the oil.Whatever it is, I can repair it myself but before I tear this thing a new one replacing gaskets and seals I'd like to be completely sure.
Jeep - Wrangler :: 1995 Jumps All Over After Bump
I have a 1995 Jeep Wrangler Rio Grande named El Burro.I have replaced the shocks and am awaiting an alignment next week.The Jeep doesn't shake or jump all over unless I hit a bump and then it jumps all over the place.
View 15 RepliesJeep - Wrangler :: 1998 Won't Start / No Noise
I own a 98 jeep wrangler. Love the little jeep. But....big BUT...at random it chooses not to start, not sluggish start, dead absolutely no noise. I have spent well over 1500. dollars on new starters, batteries, ignitions, ignition cylinders you name it I have replaced it. This last time it started every time for well over a month, then one evening it just didn't so I let it set for a couple of hours as usual and then it started and we came home. I love my mechanic he is patient and doesn't make fun of me when I ask dumb questions...but this he can't figure out.
View 2 RepliesJeep - Wrangler :: 2001 AC Is Not Blowing Cold Air
I have a 01 Jeep and the AC is not blowing cold air. When I went to get my oil changed they did a check over and said that it is in working order just lacks any freon to get it cold. So I went to get a bottle to do it myself. Doing what it said to do on the bottle I got nothing. The meter says that there is pressure in the system, but no cold air coming out. I noticed that it would engage and then stop after a second, but still will not fully engage or blow cold air.
View 5 RepliesJeep - Wrangler :: Transmission Won't Shift Out Of Second Gear?
when the jeep warms up the transmission wont shift out of second gear.it is an automatic.had solenoid packs replaced and no mechanic has an idea.external cooler has been mentioned along with replacing pcm.
View 2 RepliesJeep - Wrangler :: Wobble Very Subtle From 40 - 45 And Worst At About 52 Mph
I've been researching and trying to find an answer to the "death wobble" on my 2005 Jeep Wrangler. I've had it in to the dealer and two other repair centers and no one can identify the culprit, other than to say we can change out each piece of the front end a part at a time to see if that will solve the problem. I could buy a new Wrangler for that. I constantly have the tire balanced or checked for balance. The front and rear shocks have been inspected. The bushings in the front end have been inspected. The wobble is very subtle from 40-45ish. At about 52mph it is the worst. Above 55 and it returns to almost nothing. Braking does not increase the wobble. I've not modified anything on the vehicle. From what I've read on blogs this is a common issue for the Wrangler starting somewhere around 2000.
View 8 RepliesJeep - Wrangler :: 2006 Won't Crank / Not Even Click When Wet
I have a 2006 Jeep Wrangler Unlimited w/ 33k miles on it...4.0 engine. Have had it a little over a year. Last Fall, it started having issues whenever we had a lot of rain. Would not crank at all. Replaced the battery and clutch switch, which seems to worked, but is now doing it again. I turn the key and all of the lights come on, but there is not even a click. If I coast it off and pop the clutch, it starts right up. Once it dries out, will start w/ the key without an issue. Have an appt w/ the dealer, but they cannot get to it until Thursday, but I have to drive to work until then.
View 4 RepliesJeep - Wrangler :: Engine Pings Upon Acceleration
My 2008 jeep wrangler x 6 cyl pings upon acceleration. 62000 miles.
View 6 RepliesJeep - Wrangler :: 2005 - Won't Start - Battery?
I tried starting my 2005 Jeep Wrangler yesterday and there wasn't enough charge to get it started. I got a few slow revolutions and that was it. I gave it a jump and it started fine. Drove it for an hour or so and then went to restart it 3 hours after I shut it off and it was dead again. Another jump and I drove it for an hour (home). I was able to start it a few hours after that on its own, though it struggled to a bit.
Tried again this morning and it was dead from sitting overnight. A few other bits of info:
With the key in the ignition, the charge indicator is hovering just above 9V (it is a 12V battery) before I try to start it. When engine is running after start, it jumps to around 12V.
I am pretty sure I didn't leave the lights on or door open overnight. I haven't noticed the engine struggling to start leading up to the dead battery.
After I jumped it again this morning, it seems to be idling very low. In fact, the engine shutoff when I let it idle in neutral with my foot off the gas for a few seconds.
When I got in the Jeep this morning before trying to start it, it had enough charge for the radio and dashboard. When I turn on the lights/highbeams it struggled and the high beam indicator on the dashboard (blue light) was flashing. Battery is not too old. I don't have the receipt with me, but I think I bought a new one 3-4 years ago. The +/- connections are clean with no corrosion. I didn't look too closely, but I didn't notice any obvious connection issues from the battery leading into other components.
I'll probably go buy another battery, but wanted to check with the experts out there to see if there is anything else I should be checking. If I do get another battery
Jeep - Wrangler :: 1985 Cj7 Won't Start After Refueling
I have a 85 cj7 with a 258 straight 6 and recently when I have been refilling the gas tank she won't start right away and I end up waiting 1 to 2 hours before she will start up and then she drives fine until you have to put more gas and the cycle happens all over again. What the problem could be?
View 7 RepliesJeep - Wrangler :: 1982 - Alternator Installation On CJ7?
How to install alternator in 82 Jeep CJ7 with serpentine belt?
View 19 Replies992 Jeep Wrangler - Dashboard Gauges And Lights Not Working
I own a 1992 Jeep Wrangler that I'm currently trying to fix up. A major problem is that my the gauges and lights on my dashboard don't work correctly. My MPH and RPM gauges work fine, but my gas gauge and the three gauges next to it don't. they just sit at about a 1/4 full. Also the lights on my dashboard don't turn on when my headlights are on. So like when I'm driving at night with my headlights on my dashboard is pitch black. The lights have come on randomly before, but then don't work again the next time i drive with my headlights.
View 1 RepliesJeep - Wrangler :: High Rpm When Stopping Before Complete Stop
Jeep jk with hemi 7.2l manual ... Symptoms of high rpm when stopping before complete stop. And high room when shifting from one gear to another (usually bit drops between shifts). Recently I noticed that this happens only when shifting above 2500 rpm. So if the shifting happens before the rpm reaching 2500 it will be smooth and normal.
View 2 RepliesJeep - Wrangler :: 1995 Loses Power While Driving
Jeep runs fine for days and then it will have a bad day. Loses power for a minute or two and then revs back up. If you stay on the gas it acts like it wants to stall something makes a loud banging noise under the jeep and then it takes off only to do the same thing in 2nd gear 3rd gear etc. Would o2 sensors try to shut it down? Throttle position sensor?
View 7 Replies