Ford Wiring/Electrical :: 1972 F250 - Signal Stop Blinking When Put The Left Turn Signal On And Apply Brakes
I have a 72 F250. When I put the left turn signal on and apply the brakes, the signal stops blinking. I checked the bulb and it was fine. What is the likely cause?
View 2 RepliesFord Wiring/Electrical :: 1994 F350 - Location Of Turn Signal Relay?
Long story short, my truck's front turn signals and rear turn signals/tail lights won't work. I am thinking that the relay is burnt. Whenever I look in the manual I can't seem to find the location for this relay. Is is built into the flasher?
Also, I am just assuming because the rear turn signals and tail lights are the same bulb that fixing this should clear up both problems. Am I right in thinking that?
I have already checked all of the fuses. Also, the Hazards don't work either.
Ford Wiring/Electrical :: 2008 - Passenger Mirror Turn Signal Not Working
Swapping the 08 mirrors onto older trucks. Which wire I should splice into in the door sill for the right turn signals?
I have an 08, with the tow mirrors/turn signals integrated. On the passenger side, the turn signal does not work. I'm not getting power at the plug.
I traced the wire colors from the headlight and taillight turn lamps and tried splicing into the same colored wires under the passenger door sill. This didn't work (I did get it to work on park lamps though, just not the turn signal). I can't find wiring diagrams.
Ford Wiring/Electrical :: 1990 F150 - Turn Signal Fuse Blew?
I have a 1990 f-150 that periodically (and rapidly) blows the fuse for the turn signals. The brake/tail lights continue to work, but just the turn signals quits. Looking for a schematic of those systems?
View 1 RepliesFord Wiring/Electrical :: 2005 - Rear Turn Signal And Brake Light Won't Working?
I just bought an 05 F250 XLT. I noticed tonight that the rear turn signals and brake lights dont work.
the front turn signals work fine, although they flash fast. I know that usually means a light on its way out. neither taillight flashes though, which puzzles me.
my second issue is that, of the 3 brake lights, only the high mounted light illuminates when I hit the brakes.
Ford Wiring/Electrical :: Left Front Turn Signal Started Flashing Fast
2003 SCrew, 5.4, auto, 4x4.... Yesterday my left turn signal started flashing fast; checked and the front was not flashing. Picked up a new bulb, changed it, didn't fix anything.
I've tried:
-tilt wheel up/down in all settings-no change
-checked the wiring at the top of the column; still good and solid.
-swapped the bulbs left to right and vice versa-no change.
-swapped the sockets left to right and vice versa-no change.
Other info:
-the left front is the only one not flashing with hazards on.
-all original equipment, except I removed the stock side mirrors (w/signal) and installed manual trailer towing mirrors, but that was 2 or 3 years ago.
-the dash indicator light for left turn (arrow) does not come on at all.
-last trailer tow was over a month ago and all was good.
I ran out of daylight last night and at work now so I would like know which Fuse, Flasher, Relay, etc., I should check/replace and where to find them on the truck; under the hood (1st or 2nd stack of the fuse blocks); under the dash above the pedals; steering column???
Ford Wiring/Electrical :: Right Front Turn Signal Light Works But Hazard Doesn't
1994 Econoline E350. All the other lights work but on the front right the turn signal light flashes but the Hazard lite will not flash. I check for power at the wire at the light and there is none.
View 6 RepliesElectrical-wiring - Civic - Honda :: 1998 - Turn Signal Speed Varies With Headlight Usage?
My car is a 1998 Honda Civic. The left turn signal blinks at double speed when the headlights are off. When the headlights are on, it blinks at half speed. Should I replace the left-sided bulbs? Or the turn signal relay? Or something else? None of the bulbs are out in the front or rear.
One other fact: If the hazards are on with headlight OFF everything blinks in synchrony. If the hazards are on with the headlight ON the front blinkers flash alternating (left-right-left etc).
Ford Wiring/Electrical :: 1971 F250 - When Right Turn Signal Activated The Left Brake Light Does Come On
I have a unique problem with my newly acquired 71 F250. The left brake does illuminate when the brake is pressed but when the right turn signal if activated the left brake light does come on. The left flasher light also does not work. All other rear ligh function are normal. I am assuming I have a short or a wiring issue just wanted to know if there was any common item that might be know about this topic. The bulbs are all new. The reverse lights do not work either but pretty for sure its unrelated.
View 2 RepliesFord Wiring/Electrical :: 2005 F250 - Rear Turn Signal Signals And Brake Lights Don't Work
I just bought an 05 F250 XLT. I noticed tonight that the rear turn signals and brake lights don't work.
The front turn signals work fine, although they flash fast. I know that usually means a light on its way out. neither taillight flashes though, which puzzles me.
My second issue is that, of the 3 brake lights, only the high mounted light illuminates when I hit the brakes.
Ford Wiring/Electrical :: 1985 - Driver Side Brake Light And Turn Signal In The Back Quit Working
85 f150. My driver side brake light and turn signal in the back quit working. The tail light works tho which is a different filament. The bulb is good and I changed the flasher relay...the circle thing in the fuse panel. Everything else works just fine. looking for a starting point.
View 7 RepliesFord Wiring/Electrical :: 2011 Ford F450 Diesel - No Brake Lights Or Turn Signal
I am working on friends 2011 Ford F450 Diesel He has lost Brake Lights and Turn Signal/Hazards.
Turn signals work in front of truck. Running lights are working fine.
Same goes when trailer is connected on truck. What could be the problem.
Ford Wiring/Electrical :: 2006 E150 - Turn Signal Quit Working / Brake Lights Not Working
Turn signals quit working on my 2006 E-150. Swapped out the relay under the dash and it did nothing. Also noticed the brake lights aren't working. The headlights and taillight a are working. I pulled the fuses under dash for the lights and they tested ok. I did notice the flasher relay was making clicking sounds intermittently even when not touching anything.
View 3 RepliesElectrical-wiring - Ranger :: 1999 XLT Electrical Power Lost When Turn Key To Start Position
My 1999 Ford Ranger XLT, 6 cylinder, auto trans, with 134K miles has an electric problem. When I turn the key to the 'on' position, all dash lights show normal, headlights work, radio plays, etc. But when I turn the key to the 'start' position, all electric power is lost. The power remains lost until I disconnect and reconnect the battery ground wire. After reconnecting, I again have power until the key is turned to the 'start' position. I was able to jump start the truck, so I assumed I needed a new battery. I bought one a week ago, and was back to normal until today. The truck started, I drove 4 miles to the grocery store, and then I found myself back to square 1 (i.e., the no-start situation).
View 3 RepliesFord Wiring/Electrical :: 2000 - Beeps But Won't Lock By Key Fob - Driver Door Lock Switch Won't Unlock?
So, I got my explorer about 3 months ago and it has never locked, the door ajar light was always on and I fixed that by using some WD-40.
Now that the door light is off, the explorer beeps once when i lock it using the key fob but it doesn't actually lock. When I use the lock switch in the rear (by the spare wheel tools) it will lock and unlock. The driver's door lock switch won't lock or unlock, the passenger will unlock but won't lock.
Stock alarm system.
Ford Wiring/Electrical :: 1992 - No Left Rear Signal Or Brake Lights
I have no left rear signal or brake lights. The right side works fine and both left/right tail lights work fine, just no left brake or signal. I checked for broken wires and can not find anything. 1992 Ford E50 7.5L.
View 1 RepliesFord Wiring/Electrical :: 1994 F150 - 12V Signal To Indicate Engine Is In Start And Run Mode?
I have a need for a 12-volt signal to indicate the engine is in start or run mode. I would like to pull this from the engine compartment but I'm not sure what would be the best or easiest way to do this. The 12-volt signal is not used to power anything so it will draw very little current. I have a 94 F150.
View 8 RepliesJeep - Electrical-wiring - Wrangler :: Wipers Don't Always Work / Quit Without Warning
I have a 1999 Jeep Wrangler Sport 4.0L with a kind of serious problem. My wipers dont always work. Sometimes they work fine, sometimes they work fine to start with and then quit without warning, other times the only way to get them to turn on is to turn them on high and then go to the speed that I want to use. It has the intermittent option but I am not yet convinced that that has anything to do with my problem. They will quit working some of the time while using the delay but they also quit on low sometimes. I have been through and checked all of the plugs, and even went as far as to grease them up so I know they are making good connections. I'm at a loss, I would think if it were the motor or the switch it would just go out all together. And if it were a broken wire, wouldn't it come on and go off if I hit a bump in the road? They shut off on smooth roads so bumpy or smooth does not matter.
View 1 RepliesJeep - Electrical-wiring - Cherokee :: 1996 - Headlights Switch Off Unexpectedly
The problem is that my headlights on my 1996 Cherokee Jeep XJ switch off unexpectedly. I can get them to come back on for extended periods by fiddling with the control knob in certain ways. This is the kind where you pull out of the knob to turn the lights on, and can rotate the knob to brighten or dim the dash.
If I pull a bit harder on the knob, the lights come on; if I twist this way just so, then off they go; that sort of thing. The fuses are fine and the contacts in the fuse box are clean. High beams work great no matter what (these are controlled from the steering column). I think the problem is at the control knob.
Now, how can I keep my headlights on when I turn them on every time without having to fight the gremlins? I think my next move is to remove the bezels and so on as best I can and get in there with some proper contact cleaner to see it's just built up gunk causing havoc. If that fails, or if that's a bad idea, what's next?