Honda - Accord - Noises :: 1998 - Gurgling While Accelerating?
My 93 previa recently went in for brakes, shocks, and tune up. 320,000 miles original owner. Afterwards it ran rough. The o2 sensor needed replacing. When I got it back it ran rough. Mechanic assured me it just needed a little time. It has the following issues:Left front would shudder like an out of balance tire between 50-70. Replaced tire. Now it hesitates and stutters at 70. Feels like its choking out. Won't climb hills without shifting a lot. No pick up. Gets 12 miles to the gallon instead of 20. First three minutes of driving are okay, after that it rides terrible. I have him looking at it now. He swears it is just because it's old.
View 19 RepliesCivic - Honda :: 1998 - Gurgling / Losing Power Under Load / CEL On
My car is a 1998 Honda Civic DX hatchback 5 speed manual. About 180,000+ miles. For a while now the car seems to have a problem with power under load. If I am on an incline the engine will start making a metallic gurgling noise as I push on the gas. It increases as I give it more gas, or the hill gets steeper; at which point the car usually begins to slow down depending on my speed. It is most noticeable when I shift into a higher gear and then my speed drops into the range where I could downshift. It also happens often however at 60 mph+. On inclines at that speed, the car will gradually lose speed down into the 50's if the hill is long enough/steep enough even with the gas pedal floored. I'll need to shift into fourth to keep at 50 mph until I'm over the hill.
I've been told by a few friends/mechanics that it may be the catalytic convertor. Hard to test it or just weld on a new one though since the cat is integrated into the manifold, etc. So I took it to a trusted mechanic who did a bunch of work. He said it was only firing on three cylinders instead of four due to carbon tracking, but wasn't concerned with the cat. He did a tune-up and replaced the distributor cap and rotor, spark plugs and wires, valve cover and gasket (leaking), air filter and fuel filter, and cleaned the throttle body. Also replaced both rear strut assemblies.
Until now there had been NO check engine light signaling a problem. I got the car back and it felt good at first, but still seemed to make the noise albeit quieter. The power was better, but only for maybe a couple days. The engine again started making the noise more often and losing power in the same ways. Also, the check engine light came on a few days later. Blinking the first time, then it would come on for a couple of days, then off for a couple, etc. Now it has come on and stayed on constantly for a couple of weeks. I had the engine codes read and got three codes:
P1456- the usual emission control system leak... fuel cap possibility, etc. I'm guessing it isn't this for the most part...
P0141- "secondary HO2s12 (Heated oxygen sensor- bank 1, sensor 2) circuit heater malfunction.
and the strangest of all since I'd expect it to be fixed...
P0301- "cylinder number 1 misfire detected" ...
So it could be something else with the cylinders going on, O2 sensor having to do with cat. stuff, etc.? I also will be due for a timing belt change soon I believe, but that would not be causing any of this I don't think. I'll be bringing it back to the mechanic to have a look again, but haven't had the time yet.
Honda - Accord :: 1999 EX - Moonroof Made Straining Noises
I have a 99 Accord EX. The other day while closing the moonroof, the motor in the moonroof made straining noises, the moonroof itself stuttered/stalled a bit, then died. I can open the moonroof without difficulty using the button, but closing it is another story. I checked for any debris in the tracks, there was none. I checked all my fuses and they were fine. What this could be? I don't think it's a motor issue since the motor works fine to open the moonroof.
View 3 RepliesHonda - Accord - Noises :: 2002 - Getting Loud Clunk While Reversing
I have a 2002 Honda Accord, manual transmission, 135k miles.When I reverse, turn the wheel all the way to the left or right, then accelerate (in reverse), I get a loud clunk from the front. I'm assuming it's something from the front suspension, but I wanted to see what more knowledgeable minds thought.There's no clunk when in forward or in reverse while the wheel is not turned.
View 1 RepliesHonda - Accord - Vibration - Noises :: 2006 VP - Vibrating And Sound When Driving At 50 Mph
I have owned this car for about 6 months now and cannot get to the bottom of this sound/action. I have taken it to multiple shops, including the dealer where I bought it from, a Honda dealership, and two other shops (Firestone Complete Auto Care, and a local shop which is goodyear backed.) Here is the deal:
When I accelerate past 50 mph and up to 75 miles per hour, and also when I cruise at any speed between those numbers, my car has a very distinct vibration in both the seat and steering wheel. It also has a sound that matches the intensity and magnitude of the vibration itself. The sound and vibration intensifies and decreases with changes in speed, the sound changes pitch when turning the wheel from one side to another, and the vibration gets worse as I drive up or down hills. This sound also gets louder if I apply the brakes suddenly, but also decreases with the speed of the car.
Things I have had checked:
Ball bearingsRims (One rim was actually bent (steel rims), and now is replaced.)Alignment (This was actually done at least 4 times since I've had the vehicle)Replaced tires (to rule out tire noise, and also the tires were going bad from what I believe is this problem)
I have had this car test driven to try to get opinions and either the shop denies that they hear anything, or say they do not know what the sound could be. It sounds like it is coming from the front right. I have been told by the dealership from where this car came that the sound is "road noise" and should be ignored. I disagree, because if it is "road noise" then it should go away when driving on different surfaces. When I have had my alignment checked, Firestone found that my camber on my front right and left rear were off to the right, but were still within specifications. They also said there was nothing they could do, and suggested if I wanted it fixed, I should take it to a body shop.
Included are a scan of the alignment results from Firestone, and a sound clip of the sound that is captured on my phone. Also, the sound can be heard throughout the recording, but is especially clear at around the 42 second mark.
Honda - Accord - Noises :: 2001 - Grind On Passenger Side At Startup
My friend has a question about his 2001 Honda 2 dr. Accord, V6. After he first starts the car and backs straight or turns, there is a bad sound near the passenger front side, maybe in near the wheel. Once the car has been started, say, and he goes forward and then backs up there is no noise. But the first time out of the parked position, it is very noticeable. He said he has noticed it almost a year. Is the transaxle a problem? Is it dangerous.. only on the first startup and back up and it ends shortly, but sounds bad. It is not with brake application either, so not a brake pad I don't think and he has those checked and replaced, so don't know what to think.
View 2 RepliesHonda - Accord - Noises :: Inconsistent High Pitched RPM Related Whine
I have a 99 Accord, automatic trans with over 197,000 miles, appropriately maintained.
What is the most likely cause of a very high pitched whine that comes up when throttle is being added? Here are some facts: -This is not a constant, or even a daily occurrence. Very randomized. I think I first noticed it over a year and a half ago (20,000 miles).-The sound will continue if the transmission is put in neutral and the RPM maintained (usually 2,000 - 2,500).-If the A/C is on when the sound happens, it will go away when I turn the A/C off.-When the sound is happening, there are no adverse symptoms to go with it. The car runs and drives quite well. Well, this issue is just that inconsistent.
Honda - Accord - Noises :: 1994 - Resonant Humming / Growling Sound Coming From Engine At 2000 Rpm
Sounds like I may have a problem that is not all that uncommon i have a 94 honda accord with 100k miles, runs great, handles great
Just last week I noticed a resonant humming / growling sound coming from the engine - it's very "vocal"it only occurs around 2000 rpm, and is more pronounced when decelerating there's no apparent loss of power or fuel efficiency the sound occurs with or without the transmission engaged and seems to be worse after the car has heated up a bit
Cat converter? Intake manifold?
Honda - Accord :: Revs By Itself Only When Upshifting / Accelerating
I have a 2007 Honda Accord EX (4-cylinder) manual. When upshifting, after pressing the clutch and my foot is OFF the gas, the engine stays at 2000 rpm for a few seconds before falling back; often it even INCREASES speed with my foot OFF the gas. This happens only when upshifting/accelerating and even when the car is warmed up. Is it a bad sensor, computer or throttle control?
View 1 RepliesHonda - Accord :: Shaking Beginning At 55mph When Accelerating
I recently purchased 4 brand new michelin tires. They are approximately 3 months old now. Beginning a couple weeks ago, my car started shaking profusely at 60mph when accelerating. When I let off the gas, it would stop. I went and got a tire balance thinking that was the problem... but it's still happening, and now it starts at about 55mph. I have no clicking sounds when turning the wheel, and my car runs great besides this! What this could be?
View 2 RepliesHonda - Accord :: 2003 - Shakes Violently Whenever Accelerating Between 55 And 65 MPH
I drive a 2003 Honda Accord and it shakes violently whenever I'm accelerating between 55 and 65 mph. If you put a shaker on the passenger seat, you'd have a martini. Approaching 55, it's fine, and then it shakes as I go up to 65 and then smooths out when I pass 65. If I am cruising, but not accelerating in between 55 and 65, it stops shaking, but once I hit the gas, it shakes.
The same phenomenon occurs in both third and fourth gears, so it doesn't appear to be related to what part of the power band the car is in. This model Accord had a recall on the engine mounts, which I had replaced at no small cost already.
Honda - Accord :: 2006 - Car Accelerating While On Cruise Control
I have a 2006 Honda Accord that just today started acting weird. I was driving 70mph on the highway and noticed the car was "tugging" a bit. I looked down and the RPMs kept revving up to 5-6k and accelerating while the cruise control was set at 70.
View 7 RepliesAccord :: 1998 Honda EX V6 Stays On Without Key
So I have a 1998 Honda Accord EX V6. When I turn off the car all the lights in the Dash are on without the key and sometimes the car stays on without the key. The only way I can turn off the car is by pressing the brakes. Don't know what exactly it can be. Also the doors and the battery light in the dash will flash when rolling the windows up or down.
View 4 RepliesHonda - Accord :: 2006 - Engine Or Transmission Noise When Accelerating?
My wife's 2006 Honda Accord makes a strange noise when accelerating. The best I can describe it is that it sounds like Woooo. It does not make this sound when driven at a constant speed. The car is in great shape and does not appear to have any mechanical or electrical problems.
View 2 RepliesHonda - Accord :: 2009 - Jerking / Hesitation Chug While Accelerating
I have a 2009 honda accord, v6, auto, 46k. It has recently started to chug, most of the time, not always. I feel it in the gas pedal. Kind of a jerking, hesitation chug while accelerating. It only chugs between 20-40 mph, disappears after that. Someone suggested a spark plug problem, but I can't imagine it's that since it disappears after 40mph. Could it be a transmission problem?
View 9 RepliesHonda - Accord :: 1998 Only Start When It Is Warm
My accord 1998 only start when it is warm (between 12:00 and 3:00). I changed the fuel pump, spark plugs, and fuse. but it is still the doing the same thing.
View 4 RepliesHonda - Accord :: Tac Momentarily Jumps Various Hundreds Of RPMs When Accelerating And Shifting
I have a 2012 Honda Accord EX with a manual trans. It's a fly-by-wire system. When accelerating and shifting, the tac momentarily jumps various hundreds of RPMs when the clutch is in. That used to mean you weren't coming off the gas when the clutch was in. I've been driving manual trans cars for 45 years. I know how to shift. But, it was a new car, so maybe... I paid close attention and was not screwing up the shifts. Apparently the computer doesn't realize the clutch is in and the gas pedal has been released. Is this normal for these cars? Is it a problem? (other than wasting a half thimble full of gas and over-reving the engine?)
View 4 RepliesCivic - Honda :: 1998 LX Not Moving When Accelerating
I have an issue with my 98 honda civic lx, with 197000 mils. Recently I had my Check engine light on. I ignored it for a day. The next day started my car and in the middle of the road it stopped moving, meaning in spite of accelerating it doesn't move. So I stopped at the shoulder, turned off the engine. After a while I started again, the car moved but later on it stopped moving when I was accelerating. The Engine did not turn off during the stall. Couple of weeks back the car was shaking on the front side when I was driving, it felt like the car was about to stop as if it was short of fuel.I changed the spark plug 15000 miles back. Water pump and timing belt was changed 25000 miles back.Car has a highway mileage of 32 mpg.
View 4 RepliesHonda - Accord :: 1998 - EGR Insufficient Flow Detected
I have a 98 Honda Accord, automatic, with a 3.0 VTEC engine with 189,350 miles. It was diagnosed with cod P0401: EGR insufficient flow detected.I was told and apparently in the instructions it states the following to repair/fix the problem:
Unplug the EGR Port in the Intake, remove upper portion of Intake Manifold, drill EGR port, install Sleeve and replace EGR Valve. Instructions also indicated I need a EGR Pipe kit: 06175 P8L-A00 which contains a special tool to drill manifold and install Sleeve: Kit 07ZAO-P8AA000.
Is this a easy job? I'm also confused about needing the special tool (I believe it's a drill bit) and drilling the port. Are either one of these two Kits I mentioned really needed? What do you recommend I use to clean the port? I thought I could just clean the port (hole) and replace the manifold gasket.