Yukon :: 1998 Vehicle With 5.7 Shut Off While Driving
I have a 98 yukon w/ 5.7. Was driving the other day and it killed. Restarted with no problem. Happened again the next day but this time would not start. Upon getting it home to check it out i tested the vehicle wire for the fuel pump with a test light and get nothing from the wires (the key was turned ). Tested all fuses and they are good. So now I'm stuck....
View 4 RepliesYukon :: 1998 Hood Released Inside The Truck, Broke The Cable
I went to check the oil this morning , and pulled the hood release inside the truck and I think the cable broke. I can't get the hood open at all, and now I'm afraid to drive the truck, fearing the hood might fly up as I go down the mountain pass I live on. How do I repair this and get the hood open?
I tried pulling cable and pushing on hood wont work.
GMC - Yukon :: 1997 - No Clicks / Groans When Turn The Key
Battery is fine, turn the key and nothing (no clicks, groans, nada). At first it only did this when the engine was warm, wait 30 min and it would struggle as if the battery was weak but it would start. Had battery tested and it was fine. Now, it will also do this when the engine is cold. If I remove the connections to the starter and reconnect them, it starts right up and works normally hot or cold but at some point, same problem.
View 8 Replies1998 Chevy Blazer Won't Start When Turn Over The Key
When I turn the key over to start the vehicle, the clock resets to 1:00, the back latch clicks and the car kind of makes a grinding sound but not like a churn as if it wanted to start. I don't know if it is just a dying battery or if it would be something else but my car will not start at all.
View 1 RepliesIntrepid :: 1998 - Motor Will Not Turn Over / No Start
We have replaced the pcm : Still no motor turn over -no start !
New Battery and cables !
All-- fuses and relays-- were checked and are ok !
No ignition to the starter - motor will not turn over !
Jumper wire from control center starter relay -then motor turns over !
We are at a Loss here - Could it be the ignition switch? Neutral safety switch ?
Ford - Contour :: 1998 SE Will Turn Over But Won't Start
I have a 1998 Ford Contour se 2.0. The alternator went out in the beginning of January. Had it replaced, got it back it ran for a couple of days and it just died on me and wouldn't start. So back to the shop it went, fuel filter was clogged so they changed it, and I got it back last Friday. It ran until Saturday morning and as I was driving down the road it just died!! Just like that...died. Got it to run for a few seconds...it would die.
Finally got it back home and now it won't start. It will turn over, but won't start. If it does start it won't stay running longer than 2 or 3 seconds. I've had the fuel pump, fuel injectors, and spark plugs checked. Everything is fine. Oh and yes, it has 3/4 of a tank of gas in it. What is wrong with this thing?? It also has around 151,000 miles on it.
Chevrolet - S-10 :: 1998 2WD Won't Start / Clicking Only When Turn Over
My dad has a 1998 S10, 4.3 2wd. He said it gave all clues to a starter going out. We replaced the starter and solenoid, charged the battery and got clicking. The lights turn, radio, etc. When we turn it over, we get clicking and that's it. Not sure where to go from here?
View 3 RepliesSC/SL/SW :: 1998 Saturn Will Not Start - Turn Over Fine But Will Not Fire
My daughter's 1998 Saturn S-series will not start. It will turn over fine but will not fire until I shoot some starter fluid down the intake. Then it fires up and runs fine. It consistently will not crank unless I shoot the starter fluid to it. I can hear the fuel pump prime up when I turn the switch on. The Saturn dealer says it may be the ECM but I have my doubts. The ECM will cost my $800 from Saturn.
View 14 RepliesToyota - Avalon :: 1998 Won't Start Randomly When Turn The Key
I have a 1998 Toyota Avalon with 125K that has a new battery, new battery terminals, and new cables. However, at random times it will not start when you turn the key. You turn the key...all the lights come on but nothing. It does not turn over, make any noises nothing. If you continually turn key off/on it starts most of the time. On the occasion it does not start after a few off/on turns it jump starts easily. This occurs about 2-3 times a week. What could be happening? Could it have anything to do with the security system?
View 3 RepliesFord - Explorer :: 1998 - Turn Over / Sputter And Die But Will Not Start When Hot
1998 explore will not start when hot will turn over sputter and die, after 15 minutes it will start right up that was last monday when it was 80 outside it now colder outside has not done it again, the only thing i have seen that temp gauge is not going past cold never getting to center it will try and drop back down...
View 11 RepliesYukon :: 2001 Denali Is Making Slight Knock When Turn Right Or Left
My 01 Denali is making a slight knock when I turn right or left, and I can feel it just a bit in the steering. To my knowledge nothing has even been replaced. It has 134,000 miles
View 6 RepliesGmc - Yukon :: 2007 4WD - Grinding Noise In The Front When Make A Sharp Turn
I'm having 4WD problems with my Yukon, but the dealer keeps telling me there's nothing wrong with it (this has been going on for 2 winters now), which is either code for, "let's wait until it's extended warranty expires, so we don't have to pay for it," or "the computer says nothing is wrong, so that's all we're going to look at." When it's in 4WD, anytime I make a sharp turn or even turn a corner there's a grinding noise in the front, if I try to back up, it will only go as far as one revolution of the tires then stop (I have to take it out of 4WD to backup), eventually the "Service 4WD" light comes on, but apparently nothing gets recorded on the computer. It has 32,000 miles on it.
View 6 RepliesGMC - Yukon :: 1997 - CEL Doesn't Come In - Clock / Turn Signals / Bulb Won't Work
I have a no spark no fuel situation. But my check engine light does not come on and my clock does not work. My turn signals dont work on the dash and the bulbs. But my hazerds work fine. 1997 yukon 5.7L...
View 7 RepliesFord Ranger / B-Series :: 1998 3.0L - No Crank No Start - Only One Click When Turn The Key
1998 Ranger, 3.0 liter manual transmission. The vehicle recently has had the engine replaced. Still a 3.0 Liter, but possibly is from a 1995 or 1996 Ranger. Replacement motor from a wrecking yard, appears to have been sitting for quite some time prior to purchasing. I had a friend change the motor out after getting the vehicle a few weeks ago.
Ranger drove fine for a week, but this morning it wouldn't start. One click is all it would give when you turned the key. Thinking the culprit was the all in one starter/solenoid, I replaced it with a new one this morning. Now the solenoid will click continuously when the key is turned, starter still will not rotate then engine.
Battery tests good - 12.4 volts; connections appeared fairly corroded.
Here is what I have done:
- Clipped off the first half inch of corroded terminal leads, replaced both sides with new battery connectors and wire brushed connections off at battery and starter.
- Replaced Starter
- With "S" connector disconnected, attempted to bypass starter connections and short terminals to see if a faulty clutch position sensor was to blame; shorting did not produce anything other than turning the key did.
- Paralleled an additional cable from battery to starter terminal to see if corroded wire connections were to blame; still just clicked repeatedly when attempting to start.
Crankshaft does rotate manually, does not appear to be seized up. Unsure of what else to check for. Not confident in friend's engine installation abilities, he may have screwed up something I'm not thinking of. On the other hand, I don't believe I would have been capable of swapping out the motor myself.
Yukon :: 1999 Denali - Rear Brake And Turn Signal On Driver Side Not Working
As the says I have a 1999 Yukon Denali that the Rear Brake and Turn signal on Drivers side are not working. Also brake light on trailer DOES work but not the turn signal on that side.
I tested the Tail light circuit by plugging it into the passenger side and it works so that rules out that. What wires to test under the dash to test the combo / multi switch?
Also the tail lights or park light do work (both top and middle bulb lights up when the vehicle is running) its just brighter filament does not light up when breaks are pressed or turn signal is on.
Ford F-150 - 1997-2003 :: 1998 - Turn Key But Won't Crank / Start - If Started Then No Radio?
I have a 1998 F150, had this truck for just shy of 200,000 miles, never a major problem and now she's killing me. Turn the key, no crank,no start, the same time this started the radio also quit working. I can start her with a screw driver at the soleniod (new by the way) runs perfect after that. By the way it's a 2 wheel drive with the 4.6 v-8
View 1 RepliesYukon :: 2004 Would Not Start / Coolant Leaking
Why a 2004 Yukon Denali would not start. It's leaking coolant. The battery was replaced less than 2 weeks ago and it doesn't jump start. I was told that the water pump is cracked and when you turn the key the lights and radio come on but that's about it.
View 4 RepliesGmc - Yukon :: Starter Spins Fine But Engine Won't Start
'99 Yukon. Starter spins engine fine but engine won't start. Spray a quick shot of starter fluid or drip some gas on the air filter and it starts fine. After sitting idle for a half hour or so the situation returns. Car will run highway speeds (70-80mph) fine and will handle stop and go in town. Local mechanic wants to replace the fuel pump, which was replaced a couple of years (30,000 miles) ago. This seems an expensive first step with no diagnostics done.
View 4 RepliesYukon :: 1999 GC Suburban Shut Off / No Start Next Morning But Will Crank
1999 gmc suburban shut off no start next morning will crank then act's like it loads (cranks hard for a second then back to normal) has good spark has a fuel vapor out of exhaust but will not fire.
What I've checked
Spark on every plug. Good and new
When I pulled the plugs they were wet with gas
Distributor turns new cap & rotor
Checked time manually (TDC looked at distributor rotor Pointing cylinder at # 1 cylinder
Will check fuel pressure when I get home