Jimmy :: 1999 - When Driving Its Blowing Cold Air Thru Dash Vents One Minute Then Super Hot The Next
I just replaced the blend door actuator. But now when I am driving its blowing cold air thru the dash vents one minute then super hot air the next. Also I had a problem installing the actuator over the keyed shaft on the housing...
View 1 RepliesGMC - Jimmy :: 1999 Will Not Start After It Rains?
I have taken to mechanic- no codes, all reads well. have changed fuel filter, checked fuel pump, spark plugs, battery fairly new. after it rains, it cranks-engine shakes-wants to start but wont. Almost like gas or ignition will not kick in. if sunny, ok- This only happens after it rains..
View 3 RepliesIgnition - Gmc - Batteries - Starters - Jimmy :: 1999 - At Start Up Won't Crank / Run?
Starting one time in January, the SUV would have all ACC power but failed in every attempt to crank or turn. Nothing happened whatsoever when the key turned. No dim in the lights, the battery was fine. After about 30 minutes it started right up.
The issue started again this week, occurring twice. Both times while the vehicle had been sitting for more than 4 hours. I'm unsure what the issue is. I took it to Autozone to have them try and diagnose it to no avail.
Gmc - Jimmy :: 1998 - Automatic Transmission Sliding Into Neutral When Cold
I have a 1998 GMC Jimmy and until now we had little to no heat. In the morning when we first leave the house in the cold as we are speeding up we slip into neutral and we either have to pull over or shift the shifter into neutral and back to get it going again. We only notice this happening when it is very cold. How do we fix this before it becomes a bigger problem?
View 3 RepliesStart - Gmc - Jimmy :: 1996 - Won't Start Even Replaced Fuel Injector?
I have a 96 GMC Jimmy that will not start..... I have replaced the spider fuel injector and now I get the right fuel pressure. I have random non regular spark that is very week. I have replaced the ignition coil, spark plug wires, spark plugs, distributor cap and rotor, cam sensor, the ECM, and the ignition control module. The crank sensor checked out to be good. I do not know where else to check...
View 7 RepliesJimmy :: 95 Vehicle Hard To Start And Then Stalls
Well this just started a couple of days ago and has gotten worse would start just fine and idle fine put in gear and I have little to no throttle if you give it to much would stall out but would start right up now it s hard as can be to start like 15-20 minutes to start others starting fluid and will idle great but same thing go to drive little to no throttle I can hear fuel pump priming it was changed over summer as filter and have replaced so many parts ...
View 2 RepliesJimmy :: 2000 GMC Won't Start - No Crank When Turn The Key
I have a 2000 Jimmy and it just won't start. All lights come on and horn works. No crank when I turn the key. I had this problem before and the problem was a bad starter relay. I replaced the relay. The vehicle started up fine and ran fine for a few days. I went to start it this morning and it wouldn't. Battery is good, changed the plugs, wires, starter, cap and rotor within the last 8 months. Someone made a reference to my security system. Are there known electrical problems/interference between security system and other systems?
View 1 RepliesGMC :: 1994 Jimmy Will Not Turn Over / Start - No Power
My father tried to jump start my 1994 GMC Jimmy and it began smoking at the jumper cables and battery. We removed the cables. The battery was completely dead. So we went to get a new battery. Now the car has no power whatsoever. No lights, and will not even attempt to turn over. I was told that the car may be dead, for good. That perhaps the electrical is fried. Is there anything I can check to see if this is not the case. Do I need to check the alternator, or change the fusable link?
View 5 RepliesJimmy :: 97 GMC Won't Start - No Dash Lights / Stuck In Park
What is the problem need to fix have limited fundage....
View 3 RepliesGMC - Jimmy :: 1996 - At Start Up Crank For 20 - 30 Seconds Every Time?
1996 GMC Jimmy SLS. I've looked at the "starting issue" threads in this forum but none are quite the same as mine. When you initially try to start the Jimmy (cold or warm), it seems to just crank for 20-30 seconds before it even tries to fire. New plugs, cap, rotor, wires. Battery is 2 months old, and so is the alternator. What about the relays or starter. It's not an intermittent problem either. This happens EVERY time you start the vehicle. The jimmy sat for a good while before we bought it, but would that cause the starting issue? It seems to run fine after it starts, but hesitates (stumbles)a little coming up off idle when its warm.
View 5 RepliesJimmy :: 1995 Vehicle Won't Start After Heater Core Changed
95 jimmy change the heater core now won't start...
View 6 RepliesGmc - Jimmy :: 1999 - Jerky At 50 Mph - Cause?
what makes my car jerk when i get to 50 mph?
View 4 RepliesGmc - Jimmy :: 1997 - Won't Start When Moist Outside / Crank Till Battery Dies
1997 Jimmy, 4.3 ... This has gone on for two years and over two grand. I am slowly going insane. When it starts, it runs GREAT...but if it is moist outside, it is not going to happen...can crank it til the battery dies. I have replaced: spark plugs, fuel pump, MAF Sensor, distributor cap and rotor, stupid poppet fuel injection, battery x 2, and the ignition switch. It used to pull a random misfire code, but now has NO codes. I have been through five garages and four really good at home mechanics. When it is not starting, it has spark at the plugs and good fuel pressure. Last mechanic wanted to do a second fuel pump with the new injection system...I swear I think it is because I am a girl.
View 15 RepliesJimmy :: 1999 - ABS Light Came On - Alignment / Electrical Malfunction?
I replaced both front hubs on my 1999 Jimmy back in April because of a bad bearing. About 5 months later the ABS light came on. I had the code pulled and it was left front speed sensor. I could get the light to go off by messing with the wires that come out of the hub but the light would come back on again after a short drive. Took the hub back and got a new one but the ABS light was still on. Had it scanned again and it said right speed sensor curcuit open. I can get the light to go out if I turn the steering wheel all the way to the left but it comes back on when I go back to the right. The truck needs a front alignment bad. Could the alignment problem be causing the ABS light or is my right hub also bad? Or do I have an electrical problem.
View 1 RepliesFord Super Duty (1999-2016) :: Hot No Start Then Shut Off After Cold Start
I normally just troll the existing threads and find what I need, but I am stumped. Just had the HPOP replaced and ran fine for 2 months. Then I started getting a hot no start. So it sat for a couple of days. Then I went to pull it in the shop, it started, I backed up 10 ft and it shut off. I started it back up and it died. I am going to hook it up and figure out my AE software tonight. So question, can an IPR valve get clogged after the fact? Or could it be a bad HPOP?
View 12 RepliesJimmy :: 1999 - Where To Check For Leak And What Is A Vent Control Circuit
I have been smelling gas and noticing that I am using a lot of gas. I checked the codes. I got P0442, Evaporative Emissions System Leak Detected(small leak) and P0446, Evaportative EMission System Vent Control Circuit. Where do I check for the leak and what is a vent control circuit?
View 1 Replies1999 GMC Jimmy - Driver Side Power Window Does Not Move At All
I have a 1999 GMC Jimmy and the driver side power window has stopped working. When I press the button to lower the window, I hear a click-click-click noise for as long as I am holding the button but the window does not move at all. Fortunately, it is in the up position. I don't hear any motor noise either when I hold the button down.
Chances are it is a real easy fix. I'm not sure about this but I think this issue began right around the time I had locked my keys in the car and they stuck something down inside the door to pop the lock (I wasn't home so I didn't see what they did). I just wonder if they didn't pull a wire loose or something when they were fishing around in there.
GMC - Jimmy :: 1999 - When Turn The Key It Does Not Roll Over / Clicking In Kick Panel
I have a 1999 GMC Jimmy 4.3 Vortec. When you turn the key it doesn't roll over, all I can hear is a click in the passenger kick panel. I have checked the starter solenoid with a jumper and it is fine. After a ton of checking with a multimeter and swapping fuses and relays I found something- when I remove the 40A "ign A" fuse in the fuse panel under the hood and plug it back in, I turn the key and it fires right up and stays running. However if I shut it off and try to start a second time, it doesn't roll over and begins clicking in kick panel again.
View 8 RepliesFord Super Duty (1999-2016) :: Hard To Start When Cold - White / Grey Smoke At Start Up?
Truck: 1999 Ford Truck F 350 4WD Super Duty V8-7.3L DSL Turbo VIN F
Problem: Especially when it is cold outside . . . The truck takes forever to start and while doing so a ton of white/grey smoke comes out of the exhaust.
My starting schema: Turn the key on have the gas pedal pushed to the floor until the "wait to start" light goes out. Then, I turn the key off and back on while still pressing the gas pedal all the way down. When the "wait to start" light goes out again I remove my foot from the pedal and try to start it. I never leave it cranking for more than 5-7 seconds. If, after trying this process several times I will not push the pedal in at all. Also, sometimes I will leave the pedal pushed in while I am cranking it over.
The truck used to start after a couple of tries but lately it won't start at all, even after 20 tries. Sometimes it will spin up for a second as if the engine gets going but then just doesn't continue running. When it is warm out it will usually start after a few tries but doesn't seem normal to me. After I first bought the truck(used) it would start up within half a second after turning the key.This all started after I had to fix an o-ring that was damaged on the top/back of the motor that was dumping all my oil out of the top/back of the motor.