Ford Fuel System :: 1986 Ranger Starts Only When Spray Starter Fluid Into Air Intake
My 1986 Ranger 2.9 starts only when I spray starter fluid into the air intake. It does stay running and it drives fine. The engine will not fire up unless I do this process. I have cleaned out the fuel rail, fuel injectors, purchased new fuel filter, and tested fuel pressure (which is good).
View 9 RepliesDodge - Ram1500 :: Starter Does Not Crank At All
I have a 1996 Dodge Ram 1500. The starter does not crank at all. I put the key in and turn it and nothing, just a click. I have replaced the starter/solenoid with a new one and I have charged the battery and it is good (battery is only 8 months old). It still does not crank, nothing.
View 19 RepliesCaravan/Voyager :: 03 Dodge - No Crank From Starter
I've been fighting with these vehicle for months, and I've only been able to narrow down the list of possible issues. Tried replacing the ignition switch, battery terminals and cables, starter, and even a PCM since according to the dealership it was bad. I've checked all the fuses and relays, and they're all ok.
I'm getting fuel and spark, but no crank from the starter. The voltage going to the hot post on the starter is 12.7, but the voltage from the igniton wire is only reading around .5-.6, fluctuating a bit. Before I spend the money on taking it to a mechanic I wanted to know what your opinions were on what the next step is. I know a bit about electrical systems in cars but I'm no expert.
Dodge - Avenger :: 1998 - Starter Relay Will Not Crank?
Already replaced the starter relay will not crank from the key but even when I jump the starter the car still wont start and the switch is in the on position I checked all the fuses and replaced the ecm ....
View 15 RepliesToyota - Camry :: 2002 - Hard To Start / Starter Would Crank Just Fine But Engine Would Not Fire
Camry 2002 LE (4 cyl Auto), 140K mi
This morning, for the first time I can recall, the car would not start right away. Had been sitting in the garage for 2+ days. Starter would crank just fine, but engine would not fire. No lites were left on overnite. Finally (after about 6+ attempts), engine started -- runs fine now.
Took it to TOY dealer. Their diagnosis: weak battery, alternator low output.Happy, had recently (6 mos) replaced battery after 4 years of use, so got a new battery N/C.TOY ran a charging system check and it shows "Alternator Condition: OK" (midway between shitty and great I recall).
Funny, but my first thought when it would not start was the fuel system (fuel pump) or dirty ignitors. I did ask my regular mechanic for an opinion, and he thinks it might indeed be the fuel pump -- perhaps a clogged filter.
Ford F-150 - 1997-2003 :: 1998 5.4L Engine Won't Start / Starter And Crank Pulley Turns
I just got a 1998 F150 5.4l 4x4 autotragic. Was sold to me as needing trans, wouldn't start. Tossed in a new starter and solenoid, now I can hear the the starter turn crank pulley turns maybe a quarter inch and when I let off the starter it goes back to the same spot.
Fear is motor is locked, but question (i don't know automatics) is there any way that a bad trans could keep a motor from turning over? Truck rolls in neutral or drive, pulled the drain plug no water just oil. Tempted to just buy a running 5.4 with trans but if I can avoid that I'd prefer to.
Dodge - Ram - 1500 :: How To Remove Spray Paint Off
I bought this used Dodge Ram pickup. It looks like there were a few scratches in the paint and somebody hit it with some spray paint. It doesn't look horrible, but it would sure be nice to have a nice shiny uniform finish to it. I hit it with some rubbing compound and a lot of elbow grease. There is nice looking paint underneath. I just wonder is there a faster way to take that spray paint off? I'll be at it with a month with the rubbing compound. Maybe a fine sandpaper? I just don't want to damage the factory paint.
View 3 RepliesCamry :: 2007 Spray Fluid Went Behind The Radio Lens
I just purchased an 07 Camry LE. The dealer was sloppy in detailing it, and while spraying the dash, got fluid behind the radio lens, which now has run marks on the back. I need to remove the radio lens safely, The lens moves around a bit, so I think it should be able to be removed.
View 11 RepliesCamry :: Washer Fluid Won't Spray On Windshield When Lever Pressed
When I press the lever to spray washer fluid on the windshield none comes out. I hear the motor and the wipers work.
View 2 RepliesPrius (2004-09) :: No Wiper Fluid Spray To Keep Windshield Clear
Troubleshooting the wiper fluid spray system in my 2007 Prius. So today, after the big winter storm here in New York, I had to go out and run some errands. Everything was working fine, used the wiper fluid spray a few times during my drive to keep my windshield clear. When I was about to get home, I tried to spray the windshield one last time, but no fluid came out. Also tried the rear sprayer and no fluid came out of there either. The first thing I did when I get home is to check the wiper fluid reservoir, and there is plenty of wiper fluid in there.
I can hear the pumps whirr when I tried to activate the wiper fluid spray, (tried both front and back, both have the pump whirring sounds), but no fluids sprayed out.
I'm thinking maybe something got clogged in the wiper fluid spraying system somewhere. Is this something I can try to fix myself?
Celica :: 1991 1.6L - No Startup With Just The Key / Spray Fluid Into Throttle Body
So I have a 91 Celica 1.6L and the problem Im having is that it does not want to turn on with just the key. If I spray Starting Fluid into the throttle body then turn the key, it'll turn on and stay on and even drive without any hesitation. I did the diagnosis test with the jumper wire and the codes I got were :
Code 22: Water Temperature Sensor Circuit Fault (New Sensor)
Code24: Intake air temperature signal fault
Code 32: Air flow meter circuit or vacuum sensor signal fault
I never owned a toyota prior to this so I don't know where to start looking for a solution.
Passat (B6) :: 08 Lux Wagon - When Spray Windshield With Washer Fluid Wipers Don't Come On
I have an '08 Lux wagon with rain sensing wipers and automatic headlights. When I spray the windshield with washer fluid, the wipers don't come on to wipe it away. This occurred today, and the wipers would not activate no matter what position I put the control stalk in. Then, after a few seconds, they came on and cleared the windshield. I have not noticed any other issues with the wipers. What might be going on here?
View 7 RepliesElantra XD (2001-06) :: 2005 - Washer Fluid Will Not Spray Onto Windshield
I have a 2005 Elantra and the fluid will not spray onto the windshield. The washer motor is good and the switch is new. What is the problem? Wipers work fine.
View 3 RepliesToyota Corolla :: 2003 - No Crank No Start / Battery And Starter Both Test Ok
Car was fine, then wouldn't start one day, after driving fine a couple of minutes before. Did this a few times previously, just tried a few times then it started again. There is no cranking when I turn the key, just a click. Lights work fine, stereo etc, no dip in power when turn key. I assumed it was starter motor so took it out and tested it - fine. Also tested battery - fine. Looked at a spark plug, fine, oil level fine. Don't see a reason the engine should have seized, as it was driving just fine, then wouldn't start suddenly, but I haven't tried manually turning the crank. I then looked at the switch on the clutch pedal that gets pressed when you push the clutch in, and allows it to start. Looked ok, but pulled the wires and bypassed it with a cable. Still nothing. Can the starter test ok but still be bad? Toyota Corolla 2003 80,000 miles ...
View 19 RepliesFord F-150 (2004-2008) :: Starter Click But No Crank - Truck Would Not Start
I have an 04 f150 and just changed the alternator yesterday, and 4 hours later it wouldn't start starter clicks but no crank.
View 3 RepliesCamry :: 1997 V6 - No Power To Starter / Engine Won't Crank
1997 Toyota Camry V6. The car won't start, the engine won't crank. I've checked for 12v constant at the starter and that's good. Next I checked for a 12v trigger at the starter. That wasn't present at the starter.
I went to the starter relay. Pulled the starter relay and tested it by applying 12v across two terminals and checked for continuity across the other two. It checked fine.
So I checked for constant 12v into the starter relay, that's present. Checked for 12v trigger into starter relay, that was present also. Next I jumped 12v through starter relay terminal into the starter and the starter cranked the engine. Next I checked for ground into the starter relay, I didn't have continuity.
So I'm guessing it's either a bad ground wire coming into the fuse box or maybe even a bad fuse box? Is my thinking correct? Or is there something else that it could be? Maybe a main fuse or something, IDK, this is the first time I've encountered a problem like this.
What wire is the ground source for the starter relay? I found a wiring diagram from Chiltons (which I've attached to this post for reference) but I'm not really sure which wire is the ground for the starter relay. I don't have the car or relay in front of me to look at the terminal numbers.
Prius V :: Windshield Wipers Not Activating When Spray Washer Fluid Quickly
Curios problem with my car. When I spray washer fluid quickly the wipers do not start. I can literally empty litres of fluid on the windshield and they still will not activate. Now on other cars I have had you can play chicken and pull quickly on the lever and this I can do a off a couple of times without activating the wipers but not constantly. I had it in for service and the mechanic said he has never seen this problem before and does not even know how to fix it. It does get annoying that you have to waste a lot more fluid to activate the wipers "auto" function by holding it on a few seconds longer than needed.
View 7 RepliesToyota - Corolla :: Starter Motor Having Too Much Current - Crank The Engine?
Any explantion for how a "bad" starter motor can crank the engine, but use too many amps in the selenoid circuit?
I had this problem when I installed a rebuilt starter motor in an early 1990's Toyota Corolla recently. It was one of those offshore rebuild starter motors. When I installed it, and turned the key to start, nothing. ARRG .. I have to take it back, and it takes me about 2 hours to install it, and another 1 hour to remove it! It's not like changing a lightbulb!
Anyway, first off, before removing it, I checked the voltage (that comes in the smaller cable from the ignition switch,not the one in the thick cable direct from the battery) right at the starter selenoid, and it was only 8.6 volts. At first I thought it was a weak battery, but the battery voltage was 11.8 volts under the same load at the battery. And the voltage at the ignition switch was 11.6 volts. It was loosing 3 volts in the wiring path from the ignition switch to the starter motor! Then I noticed the wiring harness was getting warm that held that wire. Oh Oh.
For the life of me I couldn't figure out what was wrong. Unwilling to throw in the towel and remove the unit, I decided to completely bypass the ignition switch and the entire wiring harness, so I wired it up with my own switch I bough at Radio Shack and my own 16 AWG (the wire in the harness is 18 AWG) wires clipped direct from the battery to the starter selenoid. This is all from the front of the car. I just wanted to see if I could get it to turn and crank the engine. It worked, it cranked ok and everything, but the second time I tested it with this experimental configuration, it melted my 10 Amp Radio Shack switch! The switch was supposed to be able to handle 10 amps! Remember, this is the selenoid circuit, not the main power circuit from the battery.
So I then DID throw in the towel, and took it out, took the starter motor back to the auto parts place. ( I had a little dust-up with the parts place manager; he at first refused to refund my money. He wanted me to take another rebuilt one, but I'd lost trust in their rebuilt units and I just wanted my $$ back. We compromised on a voucher for future purchases.) Anyway, the parts place tested the problem starter motor I had returned to them, and they said it tested "bad". So the one they sold me was indeed no good. (Why they didn't test it before they sold it to me is another question.)
But here's the mystery: If the rebuilt starter motor tested "bad", and it indeed was "bad", how could it have cranked the engine with the experimental heavy guage wiring ? Any explantion for how a "bad" starter motor can crank the engine, but use way too many amps in the selenoid circuit?
Dodge - Stratus :: Smoke Coming From Under The Engine - Starter Burnt
I have a 2005 Dodge Stratus. 2.7 Engine. It died the other day and wouldn't start up. I tried to jump it and noticed smoke coming from under the engine. When I checked the starter was burnt so I replaced it with a new one and it does the same thing. It almost cranked once and then just makes a woo-woov kind of sound.
View 7 Replies