Dodge - Intrepid :: 1996 Stalls / Refuses To Start
96 intrepid, 3.5 motor. Runs fine, no loss of power or odd behavior but will just die. Like flipping a switch. Refuses to start. I checked fuel pressure and it's good. No codes. Does this motor have a MAF? Sure can't find one. It has the odd split intake plenum. 1 air box but 2 separate inlet ducts to each side of motor. The motor is not transverse. It has 2 throttle bodies on the firewall side of motor with a shaft that runs between them. So eventually it starts. Idles fine. I watch it idle. And click, it shuts off.
View 2 RepliesDodge - Dakota :: 1996 V8 Not Starting / Click When Turn The Key To Start
i have a 96 slt v8 dakota im trying to fix myself. it wont start. put new batt. new starter motor. it just clicks engine wont turn everything in truck is working but when i turn the key to start its just clicks and my radio losses power. so i took out radio and still wont start...
View 2 RepliesDodge - Intrepid :: 1996 - Radiator Fans Always Running Even At Start Up On A Cold Day
The two Radiator fans are always running even at start up on a cold day. I have not had time to investigate as yet but I am assuming it is the temperature sensor located near the thermostat or a relay. No CEL on. What it likely is and how to approach the trouble shooting?
View 10 RepliesNissan - Pickup :: 1996 - Steering Column Clanking Noise
I have a 1996 Nissan Pickup that has been making a clanking noise (that's progressively gotten worse over time) in the steering column every time I go over a bump in the road. The sound is coming from the area between the steering wheel and the dashboard. It sounds like metal hitting metal. The steering seems to be functioning normally, other than the annoying noise. What's causing this?
View 2 RepliesDodge - Ram :: 1997 - Costco Gas Causing Pickup To Stall?
I've got a 1997 Dodge Ram 1500 pickup. It's got 145k miles. I've been using Costco gas in it for the last two years with no problems. One day, it randomly decided to start stalling out on me. It stalled out 3 times driving at low speed. I didn't have time to work on it, so I just put some good Exxon gas in there and hoped for the best until I could look into it further. Problem went away. I cleaned out the IAC for good measure. When I finished up that tank of gas a few days later, I went back to Costco. The truck begins stalling again. Is there a problem with the gas? Or is there something I should look at on my truck?
View 6 RepliesDodge - Ram :: 1996 - Intermittent Fuel Pump Malfunction - Have To Turn Ignition Several Times To Start
Intermittent fuel pump problems in '96 Dodge ram resulted in new fuel pump 50,000 miles ago. Happened again 100 miles ago, so another new fuel pump. Now to start car must turn the ignition on several times before going to the start position. It appears the latest new pump may have defective one way check valve, so the pressure is depleting after turn off. Any favorite brand of fuel pump for the Dodge "pump in the gas tank" arrangement? Or solutions such as installing an external pump to do the work of pumping the fuel?
View 1 RepliesDodge - Ram :: 1998 Pickup Dies On Turns - Oil Pressure Sensor Location
Our 18 yr old grandson has a 1998 Dodge Ram pickup that dies when he turns. Was told that
1) either the wiring harness to the oil pressure sensor is rubbing OR
2) the oil pressure sensor needs to be replaced -
QUESTION: Where is this located? Is it hard / expensive to replace?
Dodge - Ram3500 :: 2007 - Pickup Starting By Itself / Loud Crashing Noise
I own a 2007 Dodge Ram Pickup (3500). One day it started by itself while parked outside in the driveway. It drove into one of my other pickups and pushed it into my side by side. It finally pushed both aside and was headed toward the house but was stopped by a tree. I heard a loud crashing noise so I looked out the window and saw what was happening. I jumped into the pickup to try and turn it off but the key wasn't turned on. I put the clutch in and took it out of gear but it just reved up more. The horn was blaring and smoke boiling out. I turned it off by opening up the hood and unhooking the battery cable.
View 18 RepliesToyota - Tacoma :: 2003 Pickup Won't Start When Hot?
I have a 2003 Toyota Tacoma pickup. I bought it used in the spring of 2009. I drove it for a few months without any problems and one day this problem developed. It won't start on the first attempt. Or it will start and then immediately die. It will take two or three tries to get it running.
I took it in to my mechanic and he couldn't find anything wrong. I got a tune-up anyway and it drove like a champ. Until the next day when the problem came back. This persisted for a few weeks more and then went away.
This last summer it started happening again and continued up through October and went away again. I think the problem seems to happen when it's hot in the summer.
Pickup - Nissan :: Jerk-feel Like Trying To Start In 3rd Gear Instead Of First
We have a Nissan Pickup that anytime (in every gear) that the truck reaches 2700 rpm it begins to jerk-feels like you're trying to start it in 3rd gear instead of first. We have had it in a shop with someone who just repairs Nissan's and have been unable to find the problem for over a year. Have looked at the catalytic converter, fuel pump, and air flow meter...nothing has worked...
View 2 RepliesNissan - Pickup :: 1991 - Clicking Noise When Trying To Start Up
I have a 91 Nissan pick up that is just making a clicking noise upon trying to start it. I replaced the battery. The inside light works, radio works, dash clock works, but still just clicking upon trying to start. Is there a clutch safety switch that could cause this, or starter, or ???
View 8 RepliesPickup - Gmc :: Jump Start - Engine Cranks But There Is No Spark
What may have my son fried by reversing the polarity while jumping the battery in his 95 GMC pickup? The smaller wire coming off the + terminal was burned through,so I spliced that. The engine cranks but there is no spark.
View 3 RepliesPickup - Chevrolet :: 1993 - Cranks Fine But Won't Start?
A friend is stumped by a problem with his truck, so I thought I might get some insight here. I haven't actually seen the truck, all that follows is from what he described, I'm just the messenger here.
The truck had been running fine on a used engine installed about six months ago. Then he ran it out of gas, it hasn't run properly since. It cranks fine, but won't start. He says it WILL start when spraying starter fluid into the throttle body, but only while the starting fluid is supplied. He also says he disconnected the fuel line somewhere near the engine, cranked the engine, and got good fuel supply (but no fuel pressure gauge reading). He's done some logical things: new fuel pump, fuel filter, spark plugs and wires. No luck. Figuring that he'd sucked something ugly into the injectors, he decided to replace those with no change (yes, I cautioned him about throwing expensive parts at it with no clear reason).
He reasons that he must be getting spark based on the engine running with starter fluid, and there must be fuel based on his test with the open fuel line, so he thinks it's an electronic problem, presumably the signal to the injectors. This is out of my league...and my friend is a carpenter, not a mechanic. If he could get a scanner would this kind of problem register a code?
Dodge - Intrepid :: 1996 - Not Shifting From 2nd To 3rd
I backed out of the drive way with My 96 Dodge Intrepid yesterday and when I put it in drive I noticed the CEL came was on. Seemed like it came on with in a few seconds of driving forward. I was driving slow as that is what is called for in my neighborhood and all seemed ok. About 2 minutes later when I was going about 40 I noticed the Tach was at about 3k. I seems it will not shift into 3rd. I moved the shift lever several times and it did not seem to impact anything. I immediately drove home and used my other car to go to my appointment. It did seem to shift fine other than that.It never got to warm so I did not check the fluid but I did check it a few days earlier and it was ok. We had snow the previous day and I would have noticed any leaks on the drive way, which I did look for, and did not find any.
I know I need to get the CEL read. I need to drive about 10 miles to get somewhere to do that. Is there anything else I can check or try before hand? My guess is it is an electrical issue as it happened fast with out any warning. I don't have a lot of experience with transmissions but my guess is it is a solenoid not working. It may be fried or it is not getting a signal. Possibly VSS or something in the powertrain module or what every they call it in Chrysler world?
Toyota - Pickup :: 1987 - Charging Light Comes On But It Goes Out As Soon As Engine Start
I drive my pickup (87 Toyota 4-cylinder carburetor 5-speed Xtracab Deluxe) occasionally. When it's sat for a week or more it takes a few tens of seconds to start. I bought a booster battery. The charging light comes on, but it goes out as soon as the engine starts. I'm used to hard-to-start cars charging for a while after a long start. The voltage coming out of the alternator is okay. The battery is new; the density of the electrolyte is right.
View 19 RepliesToyota - Pickup :: 1993 Won't Start / Even With A Push - Engine Would Not Engage
When I turned the key to start my car, I got zero activity from it. No ticking, no lights, nothing. So I tried to do a push start, and the engine wouldn't engage. I took the key out, and suddenly my dome light popped on (though it was dim). I put my key back in and turned it, and dash lights looked normal and at full power, but as soon as I pressed the clutch down and tried to turn the key, everything went dead. I took the key out, put it back in, and turned it, but got nothing.
I pushed my truck up to the top of an incline, and turned the key. All the lights looked normal, so I thought I may be able to push start it. Key was in proper position, clutch was engaged, and gear shift was sitting in first. I got a decent speed, released the clutch... and everything went dead.
I can't decide if it's my starter or my ignition system, though I suppose it could be the wiring, or even something else.
Dodge - Dakota :: 1996 3.9 - Stalling And Backfiring?
I have had this truck in 3 different shops and none of them could figure it out. The codes say misfire in cyl 2 and 5 bank 1 too lean and primary and secondary circuits malfunctioning for ignition coil. I've replaced the ign coil cap, plugs,plug wires, rotor, pcv, fuel pump, pick up coil, cat, o2 sensors and all sensors under the hood. Switched out all vacuum lines, cleaned the IAC and checked the pulse ring. The truck loses all power and either dies or backfires and regains power randomly. If I drive at night, it will stall and keep cranking when trying to restart. Usually have to let it sit for ten minutes for it to turn back over. Last night it backfired and stalled every 50 ft for over a mile. During the day, it revs up and down at idle by about 100 rpms.
View 6 RepliesDodge - Grandcaravan :: 1996 - Dent In The Oil Pan - Should It Be Replaced
The 96 Caravan I bought a year ago came equipped with an aftermarket dent in the oil pan. It's a bent up generally flat, not all at one point, but there's no leak and no other apparent problem, though of course it does reduce the oil capacity. When I had some overdue warranty work done at a dealer, the service writer told me the dent is exactly where the the oil pickup is, which mostly sounded like the dealer looking for some extra work. I decided I'd replace the pan myself when I had enough miles on the car to see if it was worth the effort.
The pan has a lower sump area that measures roughly 5" x 7" and that entire portion is pushed up somewhat evenly. I'd estimate the deepest part of the deformation is almost an inch, so less than 35 cubic inches lost capacity. 35 cu in = .606 quart.
I can buy a new oil pan w/ gasket at Rock Auto for a shade over fifty bucks to add to an order I otherwise need to place with them. A used pan at the local junkyard would cost ten or twenty bucks plus my labor plus the gasket, which I judge as not enough cheaper to be worth my time and inconvenience (they want me to capture the used oil and take it with me). So it's either buy the new oil pan, or fix something else. Or pull the pan, bend it back to shape, and replace the gasket? It appears to me that the pan gasket may be seeping, though not enough to drip, so it's probably due for a gasket anyway.
Should I care about this, or learn to love the dent?
Dodge - Caravan :: 1996 - Misfires Then It Clears
My 96 caravan started misfiring and then it clears ..and then it misfires.. if I get on the highway it clears after a mile or so.. and stays running smooth till I stop and shut it of , thought i got water in the tank but that was 2000 Miles ago ....it's old but it's My work truck...
View 3 Replies