Prius (2004-09) :: Check Engine Light Turned On For A Few Hours Then Turned Off
I always take care of my car oil changes on time. And in the last week my check engine light turned on for a few hours then turned off. And today it turned on again. I kinda regret getting rid of my scan gauge now.
View 11 RepliesChrysler - Towncountry :: 1997 - Service Engine Soon Light Turned On / Codes P0700 And P1775
Yesterday afternoon the "Service Engine Soon" light turned on in our '97 Town & Country (3.8L engine). A few minutes later (while I headed to Autozone to get the code read) the light went out. They were still able to retrieve 2 codes: P0700 and P1775. Internet searches suggest a possible bad solenoid pack for the transmission.
More background: The van has 161,000 miles, and the original owners got the transmission replaced at 40,000 miles under warranty (4 speed automatic). The transmission fluid was replaced (pan drop method) at about 153,000 miles and at 112,000 miles, etc., with Chrysler ATF +4 fluid. The van got new plugs and wires about 15,000 miles ago. (It also got a new radiator and hoses yesterday morning which I think is unrelated.) Another possible clue: On long trips sometimes the 2nd transmission shift will become slightly rough but it still shifts and after it has rested everything returns to normal. This occasional shifting issue has been going on for over 5 years and again when it manifests itself it is very slight.
Chrysler - Towncountry :: 2006 - Check Engine Light Comes On When Wet Outside
We have had an engine light that comes on when it is wet out. (Usually from rain) Until recently, the codes were not stored in memory. The last time we tried this, there was a 420 code set. Our mechanic said it was the catalytic converter. This vehicle is a 2006 and only has a 100,000 miles on it. Neither of the oxygen sensors have been replaced. The car doesn't seem to run any differently when the engine light comes on.
View 10 RepliesChrysler :: 1989 - Check Engine Light Came On - Running Roughly
Recently, my car has started to run rough with the check engine light on. I cycled the key 3 times and checked for codes. I got a code for the MAP sensor and a code for the 02 sensor. I got no codes for a misfire, so I guess the plugs and wires are okay. I bought a new MOPAR Map sensor and installed it. It still runs the same and the check engine light is still on.. My question is, is it necessary to disconnect the negative on the battery when doing this and for how long? I did disconnect it for about 2 minutes and it still was the same.
View 7 RepliesSebring - Chrysler :: Check Engine Light Is On / RPM Too High While Driving
I have a 2004 Sebring my check engine light is on and the RMP's are really high while Im driving. What could be going on?
View 11 RepliesC/K :: 1994 Chev C10 4.3L V6 - Check Engine Light Comes On
I have a generic question about the check engine light on my 1994 C10 pick up. I have the 4.3L V6 auto and the check engine light comes on after I run it for around five minuets then it goes out after around ten minuets. My question is, does it have a change oil reminder and if so how do I reset it?
View 1 RepliesChrysler - Sebring :: 2002 - Check Engine Light Came Driving Down The Highway At About 70 MPH
I drive a 2002 Chrysler Sebring convertible with about 130,000 miles on it.
I was driving down the highway in early November when the check engine light came on my car. I took it to Aamco who did some diagnosis and replaced a solenoid assembly in the transmission. The light went off and I was on my way. I never got the exact code.
About a month after that, the light came on again. This time, I got a low end code reader and scanned it myself. I got a "P0700" code, which I've read is a generic code that the transmission system sends to the computer or something. So I used my reader to erase it. However, the light came on 2 days later while I was driving down the highway at about 70 MPH.
So I went to an auto parts store to get a more detailed scan with a better tool. This one came up "P0740 Torque Converter Clutch Solenoid Circuit".
This feels weird, because the solenoid assembly was just replaced a month ago (and is still under warranty).
The car seems to drive okay. I don't notice any actual problems in shifting. The tachometer seemed to get up to about 3000 RPM on the highway. But I've seen practically new cars do that. The last time I had serious transmission problem it would rev up to about 5000 or 6000 RPM on the highway and still only getting up to about 40 MPH. That was 3 years ago and at the time I had a fairly expensive transmission repair (which included a new torque converter).
But like I said, the car seems to be driving okay. I don't drive much. Maybe 100 miles a week? And even that is mostly optional in town driving. I'm not looking to keep this car for more than another 20,000 to 25,000 miles though for the time being I cannot afford a new one.
What are the possible causes here? What are the consequences of ignoring this? Like I said, it's still driving fine and as the old saying goes "if it's not broke, don't fix it".
Chrysler - Towncountry :: 2003 - Check Engine Light Is On / Misfire On Cylinder 1
I have a 2003 Chrysler Town & Country and the check engine light is on. I brought the van to my mechanic and he told me there was a code that told him there was a misfire on cylinder #1. He started out with replacing the wire to cylinder #1, no change. He replaced the spark plug, no change. He installed a new fuel injector, no change. The van runs a little ruff at idle and when at a stop light.
View 9 RepliesSebring - Chrysler :: Check Engine Light Came On And Code Came Out As Catalytic Converter
2004 Chrysler Sebring Sedan, 4 cylinder dual-overhead cam. My check engine light came on this morning and the code came out as the catalytic converter. The car seems to be running fine, at least no recent changes. I'm debating replacing this vehicle soon, and I'm wondering if it's worth working on the catalytic converter. I recently replaced the cam shaft position sensor as well.
View 5 RepliesRam / SRT10 :: 1994 - Code 35 On Check Engine Light
Just got a 35 on my check engine light. From the list of codes this has to do with a radiator fan control, but the fan is not electric. It's a 1994 Ram with 5.2L 318 engine. I'm confused, what does this mean?
View 7 RepliesVolvo :: 1994 Keep Getting Code 241 And Check Engine Light
1994, 960 ... The vacuum controller has two "vacuum lines" attached to it. Should both lines have vacuum present? I keep getting a 241 code with sporadic idle and check engine light.
View 3 RepliesChrysler - Towncountry :: Check Engine Light Comes On / Code P0404 - Clogged EGR Valve
2007 Chrysler Town & Country with 74K. The check engine light comes on and the parts store diagnostic says P0404, a clogged EGR valve. On my model, replacing the EGR valve involves taking out the alternator, which involves removing the passenger wheel. That's beyond my skill set.
So, can I just replace the EGR tube and pour some Sea Foam motor treatment directly into the EGR? Would that hurt anything?
2001 Chrysler Concorde - Check Engine Light Start Flashing When Put Pedal Down To Floor
When I put the pedal down to the floor for a little fun my check engine light will start flashing. I'm not sure how many times or for how long but it worries me.. The check engine light has been on but the car does have 233,000 miles on it but new engine was put in 100,000 ago
View 1 RepliesChrysler - Towncountry :: Check Engine Light - Car Runs Lousy After Real Cold Weather
My Chysler Town and Country started fine on a morning when it was 9 degrees. (no garage, so it was out in the weather.) I let it run for a couple of minutes so things would begin to thaw and then I drove to work. It ran really rough. I figured that once it warmed up, it would smooth out, but it did not. Even after the weather warmed up into the 50's 5 days later, it still runs rough. Now, I am also getting a check engine light. What could be wrong?
View 3 RepliesJeep - Grandcherokee :: 1994 - Check Engine Light And O2 Sensor Malfunction
So this little gem of an SUV has been good enough to me over the year that I have had it, but it is one of those used vehicles that has me scared to look underneath cause there is always something a miss.
I have been having some power problems and the OBD check engine light has been coming on. The engine like to putter like if it's not getting enough fuel from a clogged fuel filter when it gets going, hot or cold. Have confirmed that the fuel pump is with proper voltage and pressure. Though haven't noticed a big difference with the new filter. The check engine light cycles a code of 21, which is refinanced to the O2 sensor, both upstream and down stream. That tells me that there are TWO O2 sensors for this model. And research has confirmed this. One ahead of the cat and one behind the cat.
Here's the kicker, I only have one O2 sensor at the head of the cat and the location of where the second one would be located is only a solid section of pipe from cat to muffler. I haven't been able to track down the plug connection for the second sensor and these codes and problem only came after I gave the Jeep a tune up.
1994 Jeep Grand Cherokee Limited V8
Passat (B5) :: Check Engine Light Turned On Whenever Put Gas In Car
I have a 2001.5 passat and the check engine light turned on. It just so happens that whenever i put gas in the car.... and try to start it back up, it won't start! it takes about 3 or 4 tries for it to start up.
View 3 RepliesGolf IV R32 :: Check Engine Light Turned On
Bought an R32 yesterday. used of course.. was doing fine feels like a brand new clutch. got it from a ford dealership, and the check engine light just turned on. I will go back for the 14 day policy but i was wondering if it could be my clutch.
View 8 RepliesLexus SC430 :: Check Engine Light Turned On
My check engine light just turned on recently. Just hit 115K miles on my SC430 a few weeks ago. Is there a service that I'm missing? Running absolutely fine, oil change recently as well.
View 14 RepliesPrius (Gen 1) :: Check Engine Light Turned On - HV ECU Malfunction
This morning, I tried to start the 2003 Prius and got a 'check engine' light and nothing. The cabin lights were bright so the 12V looked OK. After three tries, I used the VOM and measured 12.55 V on the battery. But the traction battery level looked unusually low.
So I tried again and it started. Using the ScanGauge, no codes were displayed. So I turned the car off and on three times and cleared the "check engine" light. Then I connected the Auto Ingenuity and read out:
P1636 - HV ECU Malfunction on the HV ECU to ECM bus.
C1213 - HV ECU Communication Circuit Malfunction between HV ECU and Brake ECU
P3002 - HV ECU Communication Malfunction on the HV ECU to Battery ECU
So it looks like there was an HV ECU problem that 'cleared while testing.' Certainly it makes sense to inspect the HV ECU connectors and re-seat them and clean out any debris.