Chevrolet - 1500 :: 2006 - Clunking And Grinding Front Tire
I have a 2006 Chevy 1500 Silverado. The driver side front tire is making a grinding and clunking noise. It started yesterday afternoon and has gotten worse. When making a left turn there is a grinding/rubbing noise. When I go over a bump,rough gravel, or pot hole a horrible clunking comes from this tire. I haven't taken to a repair shop yet.
View 10 RepliesSonata NF (2006-10) :: Slight Grinding Noise Coming From AC Pulley Area
I have a very slight grinding noise coming from the PS pulley area. Its possibly bearing noise although its hard to say. Is there a specific torque requirement. Any good parts...
View 1 RepliesChevrolet - Uplander :: 3.9 Hesitate When Accelerating
In the morning, when i go to pick up my news paper at local convenience store, the van is running rough and hesitate when accelerating.When i take the van 1 hous later, it will run smoothly and there will be no hesitation and i will be good for the rest of the day.
If i skip the trip to convenience store and the first thing in the morning i do a long trip, let's say 2 hours trip, the van will run rough all the way during those 2 hours.
When the van is running rough it will stay in this state until it's turned off, wait and restarted again.
When the van is running smoothly, it will stay in this state until next morning.
While driving, it never happened that the smooth running engine became running rough and the opposite is also true. It never hapenned while driving that the rough running engine became smooth.
I suspect that at engine start up, a parameter is stored and kept in memory until the car is turned off, wait and restarted again.
DTC code P0336 and P1174
Honda - Cr-v :: 2001 - Growling Or Low Pitched Grinding Coming From Rear Tire Area
Have a CR-V noise coming from rear tire area I think. It sounds like a growling or low pitched grinding. Noticeable at 30-40 mph up hills. I have changed trans fluid and rear diff fluid in the last 15K miles.
View 4 RepliesChevrolet - Uplander :: 2008 Starts Goes A Few Blocks Then Shuts Down
I have a '08 uplander. transmission & alternator installed within the last 6wks. battery purchased xmas 2010. car starts goes a few blocks then shuts down. Looking to alleviating this problem?
View 14 RepliesPrizm - Chevrolet - Wheels :: Noise When Car Is In Motion
I have a 1999 Chevy Geo Prizm a.k.a. Toyota Corolla. I am new to car ownership and don't know much about maintenance yet.
Recently, the back right wheel has started making a soft "wumm wumm wumm" noise when the car is in motion. The faster I drive, the more the noise speeds up, so it seems like something is coming loose or out of alignment. I've driven over a fair number of potholes in the last couple of months, and while I don't remember any particularly gnarly ones, I imagine that's what has caused the problem.
Any guesses as to what might be going wrong, how dire it is, and what I should expect to hear from the mechanic when I take it in?
Touareg :: Grinding Noise While Stopping Randomly
i have with my Treg. Occasionally, like once every two weeks, when I am slowing down to almost a standstill, i suddenly hear a loudish grinding noise that seems like it was triggered electronically. I seem to think it happens when the auto box is shifting from 2nd to 1st before the car comes to a standstill, but not every time. Obviously when I took it to the dealer it did not happen!
View 5 RepliesChevrolet - Uplander :: 2005 - Delay In Shifting Into Gear When It Starts To Get Cold?
There is never an issue when the weather is warm, but as soon as the first cold day in September in New York occurs, we usually have to wait 5 minutes or longer to shift the car into reverse or drive.We have taken the car to several repair shops to deal with this nuisance repair, and no one seems to want to investigate.
View 6 RepliesFord - Focus :: Lurch Forward Before Stopping / Grinding Noise And Loud Vibration
So I just bought a 2004 Ford Focus. I did not drive above 15mph when I tested the car due to the lake effect snow that was occuring. Now that I own the car I have noticed if you try to stop going over 20mph the car starts to stop but last second it lurches forward a little bit. There is also a grinding noise that sounds like its coming from the back and a loud vibration that sounds like its coming from underneath the middle of the car. I'm trying to figure out if it is the brakes, tires or a leak in a brake line (those are all things my dad said it might be).
View 4 RepliesChevrolet - Corvette :: 1994 - Clunking Noise Upon Stopping
I am having a couple issues with my 94 Corvette with Auto Transmission with 107k miles.. First, when I am coming to a stop, from like 2 mph to full stop, I am getting like a clunking that sounds and feels like it is coming from behind me and to the right (from rear middle of the car). It does Not do this if I shift into neutral b4 I get to low speeds.
The second problem is, I got caught in a very heavy rain last weekend, and the digital speedometer area started blinking off and on about once or twice per second, and the "idiot light" panel lit up like a Christmas tree. The car started sputtering but never stalled out...it was almost if it was turning itself off and on repeatedly. I pulled over under a canopy, and waited out the brief but intense downpour, and its been fine ever since (about 100 miles), but it has only been driven in nice weather since. I checked the battery connections (and that's about it) and they were tight and clean.
Lexus LS 2007+ :: Brake Performance Rotors - Mild Grinding Noise Or Rough Feeling When Stopping
I installed a set of Brake Performance rotors ( slotted ) with premium ceramic pads and have had a bit of strange stuff going on from day one. When I first got them installed there would be a mild grinding or rough feeling when stopping. It got better over the first couple of day but was still there. I also notice a loud whirling or humming noise when I stop from high speeds. I called brake performance and they saids that it may be that the ceramic pad is to hard for the system. It sounded a little odd. The weather in AZ finally hit 77 yesterday so I have been driving with the windows down and have been noticing more of the grinding sound even when the brakes are not pressed.
View 14 RepliesFord Super Duty (1999-2016) :: Grinding Noise In Left Front When Slowing And Stopping
TRUCK: 2003 F250 S/C Long bed 4x4 7.3 Diesel
PROBLEM: grinding noise in left front when slowing and stopping.
Starts as a howling noise, turns into a grinding as you brake and come to a stop. I feel it in the pedal and as it slows it feels like metal to metal brakes
WHAT HAVE WE DONE: Replaced both front hub assemblies (MOOG)... Replaced dust shields, rotors, calipers, pads as well as all new brake hardware.
At any speed when I brake hard it grinds and howls, I have taken out the 4x4 locking hub assembly and it does not change the situation. I am stumped!
Ford Super Duty (1999-2016) :: Grinding Noise And Clunk Felt In Brake Pedal Upon Stopping
I have a 2005 F-250 4x4 and recently i noticed a grinding noise while driving and then when I come to a stop I hear a clunk and the grinding stops. It sounded like it came from the driver side wheel so I changed the wheel bearing assembly. About 3 days later it started again. Now it sounds like it's coming from both sides. I am at a loss. The hubs are unlocked. It's hard to describe the sound but to me it sounds like 2 gears with a large chain rotating on them. I hope that made sense. The clunk can be felt in the brake pedal.
View 2 RepliesChevrolet - Uplander :: 2007 - Reduced Engine Power - Engine Light Came On
I have a 2007 chevrolet uplander. Yesterday it started giving a message of reduced engine power and the engine light comes on.
View 6 RepliesSonata NF (2006-10) :: Crunching Sound Coming From Tire / Wheel Well Area
My front end has given out. Getting a crunching sound that sounds like it is coming from the tire/wheel well area. With an 06 which has only 39,000 miles and an extended warranty until 2016 the Dealer just replaced the Strut Mounts? Sounded good, did no good. I'm going back soon, but shouldn't they have replaced the shocks and springs too? It sounds like the tires are rubbing while going over bumps, with a tearing crunch. I have known every noise in my Sonata since it came off the boat from Alabama and the car only got better over time. Since this noise seemed to happen on both sides all at once, what can it be? I did hear some noises V33 had posted, but it didn't sound the same as this screeching crunching new noise?
View 7 RepliesSanta Fe (CM - 2007-12) :: Noise From Rear Tire Area
A month I have heard this noise.
View My Video .....
I took this video while I shake rear seat area.
Passat (B7) :: 2013 - Faint Fan Noise From Right Rear Tire Area
When I turn off my 2013 3.6 I can hear a slight cooling fan noise coming from the right rear tire area. I opened the trunk to investigate where it might be coming from but it can't be heard from inside the trunk. The only place I can hear it is in the wheel well area. Any clue what this is?
View 4 RepliesDodge - Stratus :: 2006 SXT Rough Idle - Slight Sputtering Noise When Not In Motion
Today I went and test drove a used 2006 Dodge Stratus SXT from a private party. Everything about the car was great except it had a bit of a rough idle; there was a slight sputtering noise when not in motion, and the car itself vibrated very slightly. It didn't bother me too much while I was driving because it accelerated and shifted fine and the engine sounded very strong, otherwise.
When the test drive was over I pointed out the noise to the owner, and he admitted that he had mis-timed the timing belt slightly which was causing the sputtering (he is a mechanic and replaced it himself). I was worried about this, but I did some research when I got home and learned that this model of Stratus has a non-interference engine.
My question is this: should that timing belt be a deal breaker for me? Will this cause major mechanical issues down the road? I know it will reduce power but I only really need the car to commute, so I don't mind if I'm not toe-to-toe with a Challenger. I'm just worried it will eventually cause a costly problem.
Mercury - Sable :: Grinding Noise From One Of Pulleys On Belt Area
My 2004 mercury sable is making a noise it sounds like its one of the pulleys on the belt area, What it might be it a grinding almost....
View 3 Replies