Chevrolet - Blazer - Transmissions :: 2000 - Won't Start In 1st Gear?
2000 Chevy Blazer 4.3 (automatic) - When I bought it used, it shifted fine, has no issues other than the transfer case wouldn't engage every time. A few months later my overhead console display lights went out, then all the dash lights such as engine, 4x4, the gauges started lighting up and acting weird randomly, then a week later the truck started shifting funny.
Now 90% of the time, the truck won't start in 1st gear, it starts in 2nd, then while accelerating up to 30-35mph it will shift up way too soon and bog down, then shit back down to 2nd, then shift up again, and continue until it hits 30-35, then it fails to shift into overdrive. Also when coming to a stop, it kicks down a gear (into 2nd I assume) pretty hard and clanks pretty loud around 2mph just before a complete stop.
Weird thing is every once in awhile, it will go away and shift normal but the engine light is usually lit up during normal shifting.Could it be the ECM causing all these weird things?
Chevrolet - Blazer :: Automatic Transmission Won't Go Into Reverse Or Neutral
1986 S10 blazer automatic transmission won't go into reverse OR neutral! It goes fwd in both reverse and neutral. It goes into park just fine. The fluid is full and not burnt. It will drive forward when in reverse and in neutral. I turned the engine off and checked neutral, it was not in gear but tried to go forward as soon as I started the engine. I have never seen this!
View 11 RepliesCavalier - Chevrolet :: 2004 - Replacing Door Jamb Switch?
It looks like the door jamb switch no longer pops open so I am wondering how in the world do I replace it? Someone suggested grabbing pliers and just pulling on it till the tabs break off and it comes out. Is this the correct way? This is a 2004 Chevy Cavalier and some of the symptoms of my problems include the radio not turning off when you open the door after getting out of the car. Nor do the dome lights come on when I open the door to get in.
View 7 RepliesFord F-150 - 1997-2003 :: Water In 4WD Vacuum Actuator
I have a 2003 F150 supercrew 4x4 and I'm on my 3rd - 4wd vacuum actuator this winter so far. Somehow water is getting into the actuator itself mounted on the axle and then when it gets cold enough it freezes up and won't work until the heat from the engine thaws it out and then the 4x4 will engage.
Every time I've changed it I have found the part to have about a quarter cup of water in it. and can't figure out where the water may be entering these things. There also was no moisture in the vacuum lines when I blew them out.
I've been using the Dorman brand replacements from O'Reilly, they have a lifetime quarantee but I'm sick of swapping them out every month...
Vacuum Diagram For A 2000 Blazer?
Looking for vacuum diagram for a 2000 blazer 4.3 need to trace a leak?
View 2 RepliesFord F-150 (2004-2008) :: FWD Not Working - Actuator Is Not Allowed To Engage By Vacuum Pressure
I have a 2004 FX4 4x4 ... Four wheel drive is not working!!!!! Turn the dash switch to 4High or 4Low and the lights come on in my dash gauge cluster. So my 4x4 lights come on as if the 4x4 is working but my front wheels do not turn. What I have done:
Drove the truck forward while I watched the front drive shaft going from the transfer case to the front differential. Did this in 2WD and then in 4WD high. While driving forward in 2WD the front drive shaft did not move. Once put into 4WD high and driven forward the front drive shaft was turning. I guess this tells me that my transfer case and shift motor are working?
I jacked up my driver side front wheel and turned the tire by hand while the truck was running in 2WD. The tire spun freely and the CV axle (half shaft) did not turn. Then turned 4x4 dash switch to 4WD high and turned the tire again by hand and the CV axle turned while turning the tire. I guess this indicates that the IWE actuator was working....I guess???
Repeated the process above for the front passenger side of the truck and the tire would always spin freely regardless if in 2WD or 4WD. I could not get the CV axle to turn while spinning the tire on the passenger side when the truck was running and switched to 4WD
I checked the vacuum solenoid near the battery mounted on the firewall. The vacuum line supplying vacuum to solenoid was working and pulling vacuum. I did a series of test in conjunction with the dashboard 4x4 selector and the Vacuum Solenoid seemed to be working properly.
Crawled under the truck while the engine was running and pulled the vacuum line off the nipples of each IWE Actuators (drive and passenger side) put my finger over the lines and felt decent vacuum at each end of each vacuum line.
So dash switch and 4x4 light works stays on solid and bright does not flicker
Vacuum solenoid and vacuum lines seem to be working
Transfer case and shift motor seem to be working
Driver side IWE actuator seems to work
Front passenger side Actuator does not seem to be working??? Why I am so confused about this is because in HOURS of Internet research it seems that this Actuator is not allowed to engage by vacuum pressure. When I disconnect the vacuum line to the passenger side actuator I expected to hub to lock, but it did not, the tire would turn but the CV axle wouldn't? If I replace the passenger side IWE actuator will this fix my four wheel drive? Or is there something else I am missing??
Camry :: 2008 LE - Replacing Trunk Latch / Actuator
Recently, after using the key fob to gain entry, my 2008 Camry LE trunk latch refused to "catch" when closing the trunk lid. Can I replace the trunk latch (for non-keyless entry models) at $65 without having to fork out the $200 for the trunk latch/actuator combo piece for keyless entry models?
View 1 RepliesSanta Fe (CM - 2007-12) :: Security Alarm Not Working After Replacing Actuator
Security alarm not working after replacing front drivers side actuator. Paid a local Mechanic to replace actuator and now the security alarm when you press the door lock twice on the door remote is not arming. When I press the door lock on the remote once, the doors lock. When I press it a second time to enable the alarm and to hear the horn nothing happens at all. Light doesn't flash and horn doesn't sound.
View 5 RepliesS-10 :: 1988 Blazer 2.8 4x4 Automatic - New Engine Won't Start
1988 s10 blazer 2.8 4x4 automatic. I just upgraded to a 3.4 v6, all machine work done, engine has all new internals. I have spark, i have fuel, but it will not start. I have checked the timing over and over, it is fine. I need a checklist or something to look for, all sensors seem to be hooked up and it still wont fire.
View 6 RepliesFord :: Shifting Automatic Transmissions To Neutral At Red Light
I shift my auto trans to neutral when approaching a red light. My theory is it reduces brake wear, reduces tranny and motor wear while sitting at the light and uses less fuel to remain in neutral until the light changes. My wife thinks it may harm the tranny.
View 19 RepliesDiesel - Brakes - Manual-transmissions - Cylinder - Mercedes-benz :: 1978 - Leak In Vacuum System?
When the brake pedal is first depressed, it sounds like air is being pushed out of it, sort of like flatulence, and are less responsive. When i pump the brake, it fills with air and tightens. The brakes work when I depress the pedal all the way down. Also, I have to pull my driver-side door shut a few times before it will close and lock with the vacuum system. Otherwise it won't close. Eventually the door closes and I can lock it when I shut the door just right. (My mechanic and I are working together to find replacement locks from junk yards) Is this the master cylinder? Or could this be due to a leak in the vacuum system since my door does not readily close? Or is it something else entirely? 1978 Mercedes 240D...
View 4 RepliesFord - Transmissions - Explorersporttrac :: 2007 - Slams Into 2nd Gear After Trans Flush
I recently had my Transmission flushed at 90K (beyond the 75k). I had my Struts replaced and Full differential service. They found the Carrier bearing Center Ring was blown out said my truck was fine to drive until the part came in. I drove my truck home and it wasn't until I put about 20 miles on my truck did my truck start to slam into 2nd gear. It goes gentle if I accelerate slowly and eases with I turn the OD off ( but I only tried a few times). I have tried a few forums and there are so many things that it could be.
Everything was fine until I had this servicing and they took my truck apart. On a separate unrelated issue I have a check battery light on, but it is a brand new battery. I had my stereo changed out a year ago and the shop said it was the battery failing (only 1.5yrs old). Just though I would throw that in just in case a COMPUTER issue gets thrown out there. My truck has been running fine before all this SERVICING was performed...
Ford Super Duty (1999-2016) :: 2001 - Won't Start But Radio On Even With Key Out - Ignition Switch / Actuator?
I have a 2001 f350 this morning I went to start the truck the key turn but I heard a click sound all the lights and everything came on but the truck won't start just silence I could turn the key back in the off position and put the key out but the truck is still on radios on it's like the truck is still in the run position or on position there is a lot of play between off and run but like I said the truck will not start, could be not sure if it's the ignition switch or actuator rod..
View 2 RepliesPassat (B5) :: How To Do Burnout With Automatic Trans
Can I do a burnout with the automatic transmission? Does the car have enough torque?Some people told me that you have to rev it hard in neutral and then quickly switch it into drive. But I know for certain that, that messes up your transmission really bad.
I tried holding the brakes and pressing the gas, but I think that the Passat has a rev-limiter that it won't let you get past 3,000 rpms without moving. It's not like I want to do a burnout for minutes at a time, I just want to try it for a few seconds.
Chevrolet - Blazer :: 1994 - Can't Go Over 45 Mph?
Been doing a lot of repair's on our 1994 Chevy blazer. It's a 4.3 v6. We finally got her running and now it seems like it can't take high speeds for very long without over heating and eventually smoking some. Had to bypass heater core, it's clogged. That worked with temp. Also replaced radiator and cap. Replaced both heads, took thermostat out. That worked with temp too. It has a new water pump, new exhaust manifolds, has good spark plugs, oil changed and oil filter. Kind of at a loss.
View 16 RepliesTrans Sport :: 1992 Pontiac - Huge Vacuum Leak And MPG Loss
One of the '92 Pontiac Trans Sports (3.1L V6 engine) had developed a huge thirst - the fuel consumption had doubled along with a serious loss of power. All ignition components - distributor cap, rotor, spark plug wires and oxygen sensor are new ACDelco's.
ECM is not throwing-up any fault codes but we suspect a vacuum leak since this engine runs better with the air intake covered-up almost completely.
Is there any way to trace and fix this kind of issue? Any vacuum diagram for this car - I couldn't seem to find it in the GM Service Manual... How would you suggest we proceed?
Ford - Explorer :: 2000 - Trans Stuck In 1st - Small Vacuum Leaks?
My parents 2000 Explorer is having issues...It started with check engine light...came back to Oxygen sensors...Replaced all 4....light came back...still a couple of same codes...P1151 and P0153...smoked the intake with Evap Leak Detector...have several small vacuum leaks...little at EGR (No EGR codes)...little at TPS (No TPS Codes)...Little at throttle shafts...and some coming from what looks like underneath throttle body....none of these are as much of a concern as the next thing....NOW the trans will not shift out of 1st...unless you manually shift it from Drive to 2nd...then no other gears...Reverse works fine.....
View 13 RepliesChevrolet - Blazer :: Headlights Coming On By Themselves
The Headlights on my 2001 Chevy Blazer will come on by themselves. The Headlight switch is in the off position. It will Switch between the daytime running lights and nighttime lights. What Is causing This?
View 2 RepliesChevrolet - Blazer :: 2000 4wd Won't Engage
Our 2000 blazer LT 4.3L 4 door 4wd has 190,000 km (about 115,000 miles). 3 Button dash control. Transmission was rebuilt at 100,000 miles (main troque converter spline was shot). The 4 wd will not engage in either hi or lo.
Whether moving or not, press 4 wd lo, light stays on. but nothing happens. I cannot hear the transfer case engaging.
Had a previous problem, (withflashing light): found the vacuum hose under battery case was worn through.
I do have a service engine light on the dash. This may be unrelated, because 4wd stopped working long before service engine light came on. I have changed the Oxygen sensor, but no reset the fault yet. Where to start.