Yaris/Scion & Vitz :: 2006 - Clunk When Moving Off And Transmission Takes Up
Our Vitz 5 door hatch has about 127000km on it and sometimes when moving off makes a clunk as the transmission takes up. What could cause this it also dosent appear to have a transmission dip stick unlike our Platz. Both cars have the 1.5 motor but both are different years the Platz is 2002 and the Vitz 2006. The mechanic said the Vitz has a sealed for life type gearbox. The engine mounts appear to be okay. So where do I look now?
View 6 RepliesYaris/Scion & Vitz :: Occasionally Starts For A Brief Moment But Then Instantly Dies
I have a 2002 Toyota Echo that had been sitting for a few months. Recently I tried to start it and it will not start. It sounds like it is wanting to start and occasionally starts for a brief moment but then instantly dies. I have been doing some research to see what could be the problem and my guess is that pulley on the ac compressor is not turning.
My first question I guess is whether that sounds correct or could it be something that I am overlooking.
My second question is, if it is the compressor, how can I fix it. I do not want to replace the compressor, I have seen how much this can cost. I would prefer to just eliminate the ac all together. I saw a question on yahoo in a similar case where someone mentioned a bypass pulley, but I haven't been able to find any for my vehicle.
Yaris/Scion & Vitz :: 2004 - Unlock Doors With Remote Then Starts Only?
2004 Echo........
When I use my key to unlock the car door, I can turn the key and get all the dash lights but I don't hear a sound.
When I use the remote unlock, and try the same thing, my car starts. Is this a problem with the security system?
Yaris/Scion & Vitz :: 2003 Toyota Echo Starts And Runs Good But Stops When Warm Up
I have a 2003 Toyota Echo with 250,000 miles. It has been a great car as I commute 90 miles to work. I have had no major problems with the car. Unfortunatly it recently died on the way to work. It was running great and then all the sudden it sputtered and killed. When I first tried to start the car it would just turnover but after waiting 10 minutes it started back up (this was a cold morning). When it started it was running great again. I drove it another 15 minutes and it all the sudden died again. This happened 3 times.
I have hooked up to a scan tool and a camshaft position sensor code displayed. I replaced that but had no change. Another code came up as mass air flow sensor. I purchased a used one of those and still no change.
I have started the car up numerous times and always have the same results. It starts right up, idles good, speeds up good and runs good at full throttle. The problem becomes when it warms up the car kills. If I run it at idle to a slow acceleration it takes longer to kill than if I run the car at full throttle. Once it kills it will not start up until the car cools down, but once it cools down it will start right back up.
Yaris/Scion & Vitz :: 2012 - Buzzing From Back Speakers When Play Low Bass Tones
I purchased a 2012 Yaris a few monthes ago, and experienced strange buzzing sounds from the back speakers (on the passenger doors) when playing music with deep low bass tones.
When checking the symptom carefully, it's very difficult to pinpoint the source of the buzzing - sometimes it comes from the doors' plastic, sometimes from the speaker area itself.
Again, this only happens in very low bass tones.
Yaris/Scion & Vitz :: Grinding Noise When Turning Left?
Yesterday I replaced what I thought was a bad front passenger wheel bearing, I removed the hub myself and took the hub to a local dealer to press out the old bearing and press in the new one.
Took the part back to the shop, got everything all assembled and took it out for a test drive. Right away I notice I still here the same noise, possibly even worse then before.
It was already late in the day so I decided to clean up and call it a day. During my trip home I notice everytime I turned the wheel to the left I here a horrible grinding noise, I did not have this sound before changing the wheel bearing.
Second guessing my own work, I took the car to the mechanic down the road today, not the same place that pressed the new bearing in. The mechanic inspected my work and couldn't find any problems at all. Even the ball joint I thought I had ruined was fine.
He inspected both from wheels for play, no play in either wheel. He then put the car up on the hoist while I remained in the car turning the wheel and accelerating. We were not able to reproduce the sound with the vehicle on the hoist, even with his stethoscope he could not here any noise coming from bearings on either front wheel. Everything sounds great with the car in the air, it's just when it's on the ground when there are problems.
Rotated all tire just to make sure it wasn't an oddly loud broken tire belt, once again no change.
I did replace the stabilizer link kit as well since the old one broke while during the wheel bearing replacement. Is there anyway I could have done something wrong with the stabilizer link that could cause this noise? I doubt this is the case since the mechanic did have a look at it.
I'm still assuming it's the front passenger wheel bearing, but don't wan't to go replacing parts I don't need. (I put a new fuel pump in my TJ 2 weeks ago only to discover all I really needed to repair was the broken wire going to the pump )
So just to be clear my car only makes this noise when it is on the ground, when the car is in the hoist I can turn the wheel and accelerate without any noise.
Yaris/Scion & Vitz :: High Pitch Noise When Using Heater
2008 Yaris high pitch noise when I used heater this morning.
View 1 RepliesYaris/Scion & Vitz :: Scrapping Noise When Wheel Turned To Right
When I turn my wheel to the right, there is a scraping noise. Like, metal on metal. The more I turn, the more intense the sound. Does not affect driving performance, but it does sound problematic. As I turn the wheel, it starts making a scrape-scrape-scrape noise. It sounds like it could be a shield or wheel bearing, but I'm really not sure.
View 1 RepliesYaris/Scion & Vitz :: Suspension Noise When Turn The Wheel At Low Speed
In my 2001 Toyota Echo I have a noise in my suspension but I don't know where it is coming from. I made a video of me pushing down on the hood to produce the noise. I notice it when i turn the wheel at low speed, or even just driving at low speed. There is enough power steering fluid. The sound is a groaning, kind of like a rusty hinge.
Video with suspension noise ....
Suspension pics ....
Yaris/Scion & Vitz :: Excessive Road Noise And Wind Vulnerability
I'm looking for a practical , reliable and economical car for work. I drive around 50-70 miles a day in new York city traffic. I'm going to look at a 2000 Toyota echo with 80k on it tomorrow. I need my next car to last me 5-10 years. I have done some research on these cars and I haven't really heard anything bad about them except for excessive road noise and wind vulnerability. Is the echo going to be the right car for my needs? Anything I should know going in to tomorrow?
View 11 RepliesYaris/Scion & Vitz :: 2001 - Whistling Noise Under Light Throttle
I have a 2001 Echo 5-speed that I bought it November. Loving it so far. One thing I've noticed is an electronic-like whistling sound whenever I'm applying light throttle. The sound goes away if I left off the throttle, or if I give it more gas. When I say light throttle, it's when I'm applying enough pressure to maintain maybe 1500 RPM in neutral, so not much. It's only at that specific point that I'll hear the noise, and it's in all gears and not related to vehicle speed. I've searched through the usual channels but didn't find anything related.
In the few months before I bought it the previous owner had the MAF sensor, alternator, and water pump replaced by the dealer so those components are covered under the 1 year/20k parts warranty if they may be a culprit. I'm hoping to narrow down what the problem could be before I take it in for routine service anyways.
Yaris/Scion & Vitz :: 2008 Toyota - Grinding Noise When Braking And ABS Light Is Off
I have a 2008 Toyota Yaris Hatchback with only 60,000 KMs.
I have been having a lot of problems with this cars ABS and brakes. For a few months now, the ABS Light and "!" will come on and off throughout my drive to work and home. Also, sometimes when I hit the brakes it makes a LOUD grinding noise and when I'm holding down the brakes the car doesn't stop as fast, it kind of like skids. Now, I've noticed that this noise only occurs when the ABS light is OFF. When the ABS light and brake light come on, NO noise what so ever.
I've gone to multiple mechanics and replaced almost everything you can name for brakes (pads, drum, rotor, etc.). I've also tried replacing the ABS sensor wires, but still I am experiencing the same problems. It's really frustrating because the noise only happens sometimes, and of course it never makes the noise when the mechanics in the car with me.
I've made a video of the noise it makes, you can check it out here ......
Yaris/Scion & Vitz :: 2004 Echo - Grinding Noise While Turning At Low Speeds
I have a 2004 Echo with the 5 speed manual. Everything is factory original on this car except the tires. (159,000 km). While turning hard to the right at low speeds or pulling away from a stop and turning right, I get a harsh grinding/scraping noise and it seems to be coming from the drivers front wheel. If it was a CV joint, or wheel bearing, wouldn't it make noise all the time?
View 3 RepliesYaris/Scion & Vitz :: Toyota Echo 2002 Noise When Driving In Reverse
I have an automatic 2002 Echo. Like 2 or 3 days ago I started hearing a noise when I drive in reverse. Is a mix of friction and vibration and it gets louder the faster I drive, only in reverse. I read that this could be the symptom of a bad engine mount but I haven't been able to pinpoint it.
View 1 RepliesYaris/Scion & Vitz :: Toyota 2010 - Popping Noise When Steering On The Spot
When I turn the steering wheel on the spot without the car moving, I get a popping noise which sounds like its coming from just behind the steering wheel. It sometimes happens when im turning and reversing out of my driveway. No noise coming from engine bay or wheels.
View 2 RepliesYaris/Scion & Vitz :: 2002 - Popping Noise And AC Immediately Stopped Being Cold
The other day I was leaving work and I switched on the ac. I heard an audible popping noise and the air immediately stopped being cold. I pulled over and popped the hood, it smelled like freon and I'm sure it was mixed with compressor oil as there is oil stains all around the compressor now. Did I blow my compressor? Is there a blow off valve that could have been tripped? The compressor is not kicking on now, I don't know if it is blown or this is due to all the freon spraying out? It had been squealing on startup for a little while, I assumed it was a belt.... 2002 echo....
View 4 RepliesYaris/Scion & Vitz :: 2007 - Mechanical Noise And Cold Start Squeal
I've already replaced the Alternator and Water Pump today and I still cannot get rid of the noise and cold start squeal. The squeal goes away after the engine is warmed. A/C Compressor?
[URL] ....
Yaris/Scion & Vitz :: Thumping Noise From Front Left Wheel Related To Speed
I have a 2002 toyota echo and about 2 months ago my front left wheel came off while driving and ever since it has been making a thumping noise that is related to the wheel speed. I have replaced the front struts and brakes but the noise is still there. There is also a whirring noise. I have ruled out wheel bearings, ball joints and tie rods. I noticed vertical play in the right cv axle. It moves up and down coming from the trans and not the knuckle. Could that be the noise?
View 1 RepliesYaris/Scion & Vitz :: Clicking Noise Coming From Passenger Side Like Springs Are Loose
I just replaced the drums, shoes and hardware.
Everything went together with out issue but now when I put on the brakes there is a clicking noise coming from the passenger side, kind of like something is hanging up. sounds like one of the springs are loose. But when I took the drum off everything is tight and nothing is out of alignment.
Do drums need a break in period? Wondering if maybe there is a sharp edge and its making the shoe uneven on the drum and causing if to hang up when I put on the brakes.