Ford Excursion :: Rear Washer Fluid Inop / Pump Works
Okay, So my rear washer is not pushing out the nozzle. Pump works, line from res checks okay, nothing frozen at this point. What route the line goes through the body, or what the diag steps are or the process to service it?
View 10 RepliesGolf/GTI VI :: Few Drops Of Fluid Occasionally Dripping From Rear Hatch Washer Nozzle
Having problem with a few drops of fluid occasionally dripping from the rear hatch washer nozzle? I notice it happening once a day or every other day after accelerating. Is there a quick fix or is it going to be a take it in, order parts, bring it back sort of deal?
View 23 RepliesGTI 337/20th Anniversary :: 2005 - Auxiliary Water Pump Works Intermittently?
Just want to make sure I'm naming the part correctly. It's a pump that between the radiator and the block. It stays on after the car is turned off. This is on a 2005 GLI 5 speed tip.
Lately, its not turning on. If it does, it's just for a brief moment and then turns off. After some searching, I've read post of other asking about by-passing it. Would that be a benefit? What's gained from that? I understand the pump is on while the engine is running, does it provide additional cooling? I'm planning on checking it out this weekend and wondering if it could be rebuilt? Could you guys indicate which vendor on the web has the best price?
Ford - Explorer :: 2003 - Motor On Windshield Washer Water Pump Shot / Check Gauge Light Go On
I recently purchased a 2003 Explorer. Two weeks after I bought it I found out the motor on the windshield washer water pump was shot. The dealership fixed it for free. About a week after I got it back when I was driving in the morning to work I noticed the check gauge light go on and saw that my temp gauge was pointed at HOT!! I pulled over and stopped immediately. As soon as I slowed down the temp gauge went back down to normal. It happened 2 or 3 more times and had it back at the dealership. They are stumped. They sent it to a Ford dealership and they couldn't find anything either.
They said they have checked everything and it is not overheating. They even put a thermometer on it while they drove it and it didn't get over 205* I am surprised it didn't do it to them because it happens almost every morning. I only work 4.3 miles from my house so its not like I am driving very far. It usually happens at about 3 miles. As soon as I see it going up (and I watch it a lot!!) I take my foot off the gas and start to slow down or barely press the brake it goes right back to normal. Then it stays at normal the rest of the day. Is it the sensor or the wiring or did the do something to it when the fixed the washer motor?
Phaeton :: Windshield Washer Nozzle Replacement
How to replace the windshield washer nozzle? If it makes a difference it's the driver side one. It's clogged and I'd like to try and soak it in some stuff to dissolve the clog and/or replace it myself. The dealer was going to charge me ~$150 to do this and trying to see if I can do it myself.
View 5 RepliesRodeo :: 1995 - Overheating After Water Pump Replacement
1995 Isuzu Rodeo. Replaced water pump, thermostat, timing belt & components. Now it over heats & no heat in cab. I was told to "burp" the cooling system but can't find the bleed valve. Is there even one on the V6 engine???
View 3 RepliesCamry :: 2009 SE - Windshield Washer Nozzle Is Not Spraying Just Flowing Out
I have an 09 Camry SE. My right windshield spray nozzle is not spraying, it's just flowing out. I ran a small wire down it and nothing changed. I called 2 dealers and looked up the part and there are 5 different angles listed the dealers said I had to remove it so they could match the angle for the pitch of the windshield. Seems ridiculous that they would not know,but the parts breakdown lists all 5.
View 4 RepliesPrius V :: 2014 - Windshield Washer Nozzle Freezing If Temp Is +20F Or Less
The windshield washers of 2014 Prius v (lowercase v for the Prius v) didn't work all winter if the temp was +20F or less. I'm using -30F or -40F washer fluid. I use the same fluid in my 1995 Previa, and its washers worked all winter. A friend has a 2014 Prius, which didn't have any washer problems.
I tried pouring warm water over the nozzles, but they're location makes it difficult to reach them. Is it the nozzles or is it the rubber hose that feeds them from the reservoir?
Elantra MD (2010-15) :: 2012 GLS - Windshield Washer Nozzle Adjustment
2012 Elantra GLS ... The windshield washer spray pattern is too low. The nozzles on the Elantra appear to be entirely plastic unlike the conventional ball which I can poke a needle in to adjust it. I ran the hand under the cowl cover and could not feel any kind of adjustment mechanism. How to adjust the nozzles to aim higher.
View 27 RepliesFord Excursion :: Windshield Washer Nozzle Stop Working?
Windshield washer nozzle stop working? Is there an easy way to unclog it or does it need to be replaced?
View 3 RepliesCamaro :: 1995 Chevy V6 3.4L - Overheating / Water Pump Was Leaking Fluids
My 1995 chevy camaro has been overheating. at first i thought it was the thermostat sticking because there was no spewing or smoking so i changed the thermostat and my car was still over heating. I finally found out that the water pump was leaking fluids. so I changed out the water pump and filled it full of coolant. i turned on my car and within 10 minutes the gauge went up to 260 degrees and went down a little bit but stayed around 260, there was no spewing or leaking or smoking again. I was thinking that maybe now it could be the sensor but im not sure.
View 1 RepliesFord :: 1995 - Coolant Leakage - Changed Thermostat / Water Pump
1995 Ford Van E150. So I've been trying to solve my overheating problem for months now. One morning I walked out of my house and all of my coolants was on the street. I could not completely detect the source of the leak after running more coolant through it. I also checked the dip stick and coolant on the ground for any sign of oil/coolant mixing. I started by replacing the thermostat.
I did a more thorough inspection and found a crack at the bottom of the radiator that I replaced less than two years ago. I replaced the radiator again and while I had the belt, intake and fan disassembled I switched out the water pump as well. The old water pump was gunked and the gasket was almost completely worn off. The van is still overheating and spitting out coolant at a much higher rate. I'm guessing because of the new water pump. A friend said it could be the intake manifold because of where the steam was coming from the motor.
Ford 6.7L Power Stroke Diesel :: Window Washer Nozzle Breaking
Window washer nozzle break? My passenger side broke last Friday and then today when inspecting the driver's side it broke in the exact same place. They broke near where the nozzle that is inserted into the hose takes a 90 degree turn up through the hood leaving parts of the nozzle in the hose. I was able to squeeze the rubber hose with pliers to break up the plastic nozzle so that it would fall out. Attempts to grab broken nozzle piece with needle nose pliers were unsuccessful. Of course they waited too break until 8 months after my warranty expired but not a big deal. 10 minute install. I got the last two that the dealer had in stock.
View 14 RepliesFord Super Duty (1999-2016) :: How To Remove Windshield Washer Nozzle
2011 F250 with hood mounted windshield washer nozzle. How do I remove the nozzle? In a campground with basic tools.
View 6 RepliesGolf/GTI VI :: Rear Window Washer Feed Hose Failed / Water Dripping On Package Tray
2010, 35k miles... didn't see that coming.
Looks like the hose is made of some plastic material that doesn't like flexing very much. I guess I opened the rear hatch enough times to break it.
Is this a common problem? Is there a proper size coupler available to fix this?
Volvo - 850 :: 1995 - Sagging Rear Bumper
My daughters 95 Volvo 850 had a sagging rear bumper. I prchased new mounting brackets and removed the bumper. It turned out the brackets were for a 5 door, and her car is a 4 door. I returned to the dealership and was told that they can only get the left side bracket and that the right side bracket is no longer available. The brackets look nearly the same except the mounting holes are opposite. I went ahead and ordered two left side brackets. I am hoping to be able to drill holes in one of them to fit it on. The bumper is now off the car and the old brackets are rusted to nothing.
View 3 RepliesHyundai - Elantra :: Pump Nozzle Keeps Cutting Off When Filling Gas Tank
Having trouble filling gas tank, the pump nozzle keeps cutting off. Have to fill by dribbling the fuel in until filled. What the problem might be?
View 5 RepliesPrius (Gen 3) Fuel :: After Filling 9 Gallons - Gas Pump Nozzle Starts To Clicks Off
My 2013 Prius fills with approx 10.5 Gallons, but around 9 gallons the gas pump nozzle starts to clicks off every 10 cents. Is this normal?
View 3 RepliesFord - Explorer :: 2001 - Wiper Only Works With Washer Cycle
My son just got a 2001 Explorer Sport. Among the minor issues that need taken care of is an interesting situation with the wipers. The wipers only function when you press the wash button. It operates fine with wash, it parks fine after wash cycle. However, I get no response from any settings in the normal wiper switch. Where to start looking? Bad connector? Switch? It does have a tilt wheel, wire pulled out of connector?
View 14 Replies