Ford F-150 - 1997-2003 :: Constant Whine - Rear Axle Pinion Bearing Replacement
I have a constant whine going down the road with foot on the gas. Back off and it quiets up. At 2-3 MPH i think i can here a " tick- tick". Took the drive shaft off, wheels off ground, cover off and oil out. Spin wheel and i can hear a tick - tick, I think around the pinion bearing. No play up and down or in and out, but it appears to have 2-3 times the backlash i would expect. I used the screw driver- stethoscope--- still think its the bearing. This is a 9.75 axle. What kind of luck would I have pulling the yoke off and going in from the front without removing axles halves and ring gear? I thought I had read that here before. Never done one that way .
View 2 RepliesToyota - Tacoma - Suspension - Noises :: Clunk Upon Acceleration Occasionally
I have an '04 TRD Doublecab 4x4. I first started hearing a "clunk" upon acceleration, but only occasionally. It started getting worse and would happen pretty much every time I accelerate (although it never got louder, just more frequent). It usually only happens after a full stop (or near stop like in stop an go traffic), and I'd hear it pretty much right when I step on the gas. It seems like it has something to do with the A arms moving forward and back. When you accel, the rear wheels push the vehicle, essentially "sucking" the front wheels back slightly. When in 4wd, the noise is still there. It is quite obvious it's coming from the front right corner. I'm usually pretty handy with a wrench, so I decided to swap the upper A-arm bushings and upper ball joint (ball joint was leaking grease). Noise is still there. I ran out of time/motivation, so I took it to the Toyota dealer.
Here's what they did: -replaced front right coil-over, said it was "loose". That didn't work, so they put the old one back on. -tightened bumper etc..., didn't work. -then they removed the REAR drive-line and put it in 4x4 and drove it around. They say that "fixed" the problem since the noise went away. They were pretty adamant it was the drive line, but I didn't believe them since the noise is OBVIOUSLY coming from the front right. It just seems odd that it'd be the drive line. I took it home and tried what they said, I took the drive line off and drove it around in 4wd. They weren't lying, the noise went away. But since a good friend has an identical truck (but an '03) I switched our drive lines and the noise came back (HA! I was right!!). Driving in "front wheel drive" (no drive line) makes the front wheels "pull" the truck forward, vs in rear wheel drive, the rear wheels "push" the truck, and thus the front wheels will move backward slightly because of wheel/bearing friction.
I think it has something to do with when the front wheel is forced "backwards" but as far as I cal tell, all the suspension components are intact and show no signs of looseness. I can now occasionally hear the noise when under slight accel going over studder bumps like street reflectors or something (but only rarely, it's almost impossible to duplicate that on command. Makes me think a suspension piece is loose (shock/spring or loose bushing), but I NEVER hear the noise under braking, and rarely hear it on those studder bumps (and only for a split second). If it were a loose bushing, wouldn't I hear the clunk under accel AND decel (A arm moving back and forth)??? So I'm basically stumped (so was the dealer!). Ball joints appear fine, wheel bearing has no slop (that I can tell), and it has brand new upper urithane bushings and a new upper ball joint. I KNOW it's not the shock/spring, b/c I even swapped the left/right, and the noise is still there (and didn't move to the other side).
Toyota - Tacoma - Belts :: 1997 - Loud Roaring And Whistling Noises Mostly When Idle
My Tacoma makes very loud roaring and whistling noises mostly when I am idle and the brake is engaged while the clutch is depressed. Sometimes, she'll rear and balk continuously --- even more loudly --- depending on the outside temperature and her level of activity. I need to get her fixed, but live in the New York City area and am a broke graduate student terrified of getting ripped off. Do you think it's just belts? My transmission (sometimes I can feel the noise in my gear shifter)?
View 10 RepliesLexus GX 2004-09 :: Rear Axle Whine Above 70mph?
Experienced a rear axle whine above 70mph? I've noticed a whine while just slightly on the gas above 70mph (maintaining speed). Does the GX have a regular ring and pinion set up or is it a more complicated affair?
View 14 RepliesFord Excursion :: Whine Noise Coming From Rear Axle
I had the rear axle seals replaced less than 1000 miles ago. Now the axle is getting whiny. First I thought maybe that the tires made noise but now I'm pretty convinced it comes from the axle.
With a seal replacement, what do they do that might impact the axle - over tighten the bearings?
I also had the rear diff fluid replaced - perhaps they put in the wrong stuff...
Should I replace fluid and see if that stops or should I simply take it to the dealer and let them deal with it?
Ford F-150 (2004-2008) :: 2005 - Rear Axle Whine Over 25 - 70 MPH?
had a leaking rear driveshaft seal at the axle and replaced it and fluid. 75W145 full synthetic as recommended. it was changed at 128000 and I've started to get an axle whine over 25 MPH up to 65-70MPH. quites down around 80 MPH. I just checked it after 2 months (whine just started) with 133000. Any TSB. does this fall under TSB 05-23-3? Noise sounds like I've got really aggressive tires on the truck. Only have Dayton HT all season. Did not add the XL3 additive. Would this work at this juncture.
View 5 RepliesJeep - Liberty - Noises - Transmissions :: 2007 - Gear Noise Coming From Rear Axle?
I have gear noise in my 2007 Liberty 4 X 4. It sounds like it is coming from the rear axle and is more pronounced under acceleration or decelleration.
View 5 RepliesToyota - Tacoma :: 2003 Pickup Won't Start When Hot?
I have a 2003 Toyota Tacoma pickup. I bought it used in the spring of 2009. I drove it for a few months without any problems and one day this problem developed. It won't start on the first attempt. Or it will start and then immediately die. It will take two or three tries to get it running.
I took it in to my mechanic and he couldn't find anything wrong. I got a tune-up anyway and it drove like a champ. Until the next day when the problem came back. This persisted for a few weeks more and then went away.
This last summer it started happening again and continued up through October and went away again. I think the problem seems to happen when it's hot in the summer.
Toyota - Tacoma :: 2003 - Terrible Gas Mileage
I just bought a 2003 Tacoma 2.4l engine and it has terrible gas mileage.I haven't checked the numbers yet, drive for but it cost medrive for 2 hours. Where do I start looking? The air filter is clean, the tires have plenty of air.
View 5 RepliesToyota - Camry :: High Pitched Whine From Rear Of Car
My 2009 Camry with 72k on it has started to make an intermittent high pitched whine from the rear of the car. It's only noticeable while accelerating or maintaining speed.
View 1 RepliesToyota - Tacoma :: Brake Pedal Felt Mushy / Swoosh Of Air Coming From Rear Of Engine Near Firewall
05 Toyota Tacoma without traction control but has ABS. A few weeks ago I noticed the brake pedal felt mushy. I had my wife step on the brakes with the engine running. I could hear a swoosh of air coming from the rear of the engine near the firewall but more towards the passenger side. I did the following tests:
With engine off pump brake pedal and it built preassure and stayed firm.
With engine RUNNING held foot on brake and turned engine off. The brake pedal moved slowly to the floor.
Check the check valve in the brake booster and its good.
So, I replaced the Brake booster, bleed the air out of the master cylinder and bleed the brakes. Now it feels great for about the first 20min of driving but then goes soft again. and I'm still getting the swoosh of air escaping from somewhere in the same place as before.
I'm wondering if I have a vacuum leak somewhere before it goes into the brake booster? the connection is good where the vacuum hose comes from the engine to the brake booster. OR should I replaced the master cylinder?
Toyota - Tacoma :: 2003 - Rolls Backwards On Hills?
I am the 2nd owner of a 2003 Toyota Tacoma, 2wd, 140k miles. I've only recently noticed that when I stop on an upward bound hill, and remove my foot from the brake, I will roll backwards while still in DRIVE when at STOP signs, etc. I know that Toyota came up with some 2 peddle fix in later years, but is this to be expected in the 2003? Yea, I know...Tom & Ray would say "keep your foot on the brake stupid", and then move on to the next call...but neither of us is that TOM or RAY now, are we?
View 2 RepliesToyota - Tacoma :: 2003 - Gas Mileage Is Little Off - Fuel System Flush?
I recently bought a 2003 Toyota Tacoma with the 2.4 L engine and 160K miles. It seems to run fine. I took it into my Mechanics Files mechanic to have a couple of things done and he recommended doing a fuel system flush for like $300. My daughter has a 2008 Yaris w/ 100K. She took it to her mechanic recently (on the other coast) and he recommended a fuel system flush (for about $150!!--and she's on the West Coast, I'm in VA). She thinks her gas mileage is a little off (only getting 38 mpg !! ??), but otherwise the car is running fine. If these vehicles are running well, is there any reason to get this flush done? The idea that it may increase gas mileage if otherwise running well seems doubtful to me.
View 19 RepliesToyota - Tacoma :: 2003 - Constant Shaking Type Of Vibration Between 25 And 35 Mph
My 03 Tacoma TRD is showing her years! The truck has about 215k and has some serious vibrations and noises going on. First off I have a constant shaking type of vibration between 25 and 35 mph, but it is also present in the higher speeds of 55 and above but sometimes it gets drowned out. I work at a ski resort so when Im coming down the mtn using 3rd gear or so to slow down I feel the vibration is the most apparent then. So far I have had 2 shops look at my driveshaft and both concluded there is nothing wrong with the u joints. I had a CV shaft installed because one of the boots was torn so I went ahead and had that replaced.
What the vibration is.....2nd is more of a intervalled whooomping sound almost like a bullfrog-like interval. As I increase speed the intervals get faster but it is a drawn out whooomp whooomp not a fast sound. It actually rattles the change in my ash tray to the bpms of the sound. Also I have a metallic clunking sound happening when I put the truck in gear (manual) or start and stop at slow speeds without using the clutch. I was driving around a parking deck the other day in first gear and it would make the sound whenever i hit the gas AND when I let off the gas. ONE MORE THING, whenever I am starting off under load in any gear, the truck jerks.....it hesitates and lurches but only at low rpms and again in any gear.
2003 2.4L Toyota Tacoma 2wd - Rapid Metallic Clicks From Engine Compartment
I replaced my fuel filter on my 2003 2.4L toyota tacoma 2wd. 65k miles. At the same time I checked the valves. No valve adjustment needed. Then i started hearing 4 to 6 rapid metallic clicks from the engine compartment when I start the engine cold. Clicking lasts 1 to 2 seconds. Sometimes happens when engine warm. This fuel filter is not original equipment.
View 1 RepliesToyota - Tacoma :: 2003 / 3.4l Engine Surging - Loosing Power When Accelerating
I have a 2003 toyota tacoma 4x4 with the 3.4l engine. Recently I have noticed that while accelerating I am losing power. I first noticed it would surge while going slowly uphill and since it has started happening all the time. I especially notice a serious dip in power during freeway acceleration at around 3000 rpm. The truck has 100000 miles on it. I have changed the plugs, run injector cleaner (the stuff you buy at the gas station), cleaned the throttle body, changed the air filter, and cleaned the mass airflow sensor. I have played a little with the throttle position sensor and that seems to have some affect on the timing of the surge but it is hard to tell. Of course toyota doesn't service the TPS for that year but rather try to sell you a new throttle body $1100.00!!! Could this be the catalytic converter or maybe a faulty injector? Also, I have not changed the timing belt yet.
View 3 RepliesToyota - Tacoma :: 2003 - Engine Cooling Before Spark Plug Change
How long should I let my engine cool down before changing the spark plugs? I have a 2003 Toyota Tacoma 4cyl 2.4l. My drive home from work is about 10 miles and I would like to change my plugs after work but I am not sure how long I should wait before working on the vehicle.
View 5 RepliesToyota - Tacoma :: 2003 - Clutch Not All The Way Disengaged When Push The Pedal To Floor
The clutch on my 2003 Toyota Tacoma has been acting funny for a while. I have to pull the pedal back up with the top of my foot about half the time, otherwise it acts like the clutch isn't all the way disengaged when I push the pedal to the floor. The master and slave cylinders have both been replaced as well as the clutch pedal mechanism itself (thought it might be the spring). I adjusted the push rod a little bit and it seems to have worked slightly but it's definitely still a problem.
View 3 RepliesFord - Explorer :: 2003 Whine At Rear End Between 50 To 65 MPH
I have a 2003 explorer with 6000 original miles, the truck was only used to go to the corner store by my past in laws, the tires which I have just replaced were the original Michelin with the date code 0303, the problem I am having is a fairly loud whine/hum during acceleration between 50mph and 65mph, I live in the Florida keys and trust worth mechanics are far and few between so I brought it to my Ford dealer which I buy body parts from all the time, after a test drive the service adviser said that they will have to remove the pumpkin put it on the bench and inspect it, I said ok, they called me back into the shop and showed me the unit, the tech said that I had metal filings in the unit and it was out of alignment, I saw the filings, which included the ring, pinion all inner bearings, the two outer shaft bearings and the two dust seals and oil, I verified this and the price seams to be right....my question is the labor they want to charge me 8 hrs to do the work. The rear end is a 355, not Limited and not traction.
View 3 Replies