Ford F-150 - 1997-2003 :: Big Cloud Of White Smoke Came Out When Going About 55 MPH And At 2800 RPMs

The truck is a 98 4.6l with 188,000 miles on it and yesterday i was driving up over a pretty steep grade hill, i was going about 55 and turning maybe 2800 rpms at the top a big cloud of white smoke came out (either tailpipe or just out of motor on hot pipes)and also some in the cab. It didn't run any different though so I kept driving about 3 mile and stopped where i could take a look and and saw fresh oil around the starter area running down where the motor meets the tranny. I checked the oil and it was at a good level and also not milky. I checked level again today and it seems well and there is no drops of oil on the ground i ran it home about ten mi and it runs good. What could have happened?

View 2 Replies

Golf IV / Jetta IV :: 3rd Gear Will Grind When Driving For More Than Half An Hour / Over 2800 RPMs

I noticed through careful investigation that my 03 GTI 1.8T (180,000 KM's or 111,850 miles) will grind 3rd when in these conditions:

1. When the car has been driving for more then half an hour and everything is hot

2. When the car is over 2800 RPM's while hot (ie. getting on a highway)

Now I know lot's of people blame syncro's and yes I could see that my car has had 8 previous owners so I can't say they all shifted perfect. But what I do know is that when I downshift from either 4th or Neutral it will never grind even when I don't Rev Match or "Blip" the throttle. So it can't be syncro's in my opinion.

So what I've done to the car to rule out some problems were:

- Change the gear oil from what ever it was before to Royal Purple 75W-90 (NO luck.)

- Then I added a short shifter and adjusted my cables properly (still No luck)

- Finally I noticed my shifter was sloppy and one of my bushings were torn so I bought 42 DD's metal bushings and the shifter did stiffen up a lot, however!!! (No luck)

I know it's not my driving technique because I watch my foot depress the clutch fully and then I gently push it into third. I also know I'm shifting correctly because I can double clutch and normally shift through every other gear properly without any grinds or clunks. Just the devilish 3rd gear.

I would like to hear the solution. I'm going to change the oil one more time to Redline MT-90 and see how that goes, but if that doesn't work I might just tear apart or get a new tranny.

View 3 Replies

Ford Fuel System :: 1991 F150 - Idles High At Around 2600 - 2800 RPMs

I just bought a 1991 F150 with a 302 (5.0). It idles at around 2600-2800 RPMs. The previous owners replaced the TPS and IAC, but it still idles fast. Ford dealership told them it was a vacuum leak. Are all the vacuum lines close to each other? How easy is it to locate/fix the problem?

View 2 Replies

Toyota - Camry :: 2003 - Hiccups On Acceleration At 2800 RPM When It Is Hot Outside

The particulars are 2003 Camry, 4 cyl, manual trans. When it gets to be 90 degrees or hotter outside, the car hiccups when accelerating through 2800 rpm. That is the most common scenario. Pretty much any gear and the problem gets worse the hotter to outside air. It never throws a code or check engine light. It doesn't stall although it feels like an instantaneous loss of ignition. I can set the cruise control and it will periodically happen when driving through the desert. It repeats as often as it wants to....no overall pattern, uphill or flat, no difference. Dealer says nothing is wrong since it won't throw a code. No issue in the winter, only hot summer driving.

View 3 Replies

Ford 6.0L Power Stroke Diesel :: Lack Of Power When Going Up A Hill On The Interstate At 2800 RPMs

While I'm cursing at highway speed everything is fine. But when u punch it it pass someone it's like I actually slow down, same from a red light. I've got a livewire programmer in it and this problem is somewhat new. It just seems to keep getting worse, I was going up a hill on the interstate this morning and at 2800 rpms I was actually slowing down. I'm not sure if the fuel pump is going out or if the transmission is slipping or what.

View 7 Replies

Avalon 2005-12 :: Pulsing During Braking At Highway Speeds

I ask because my father's 08 Avalon is pulsing during braking at highway speeds but only sometimes. When it does it we can feel it in the steering wheel. I suspected maybe one of the caliper pins was seizing. So I pulled the front wheels. The pads and rotors look great. I removed the pins, cleaned and greased them. On the test drive it pulsed two times for me but was totally smooth on the rest of the drive.

View 6 Replies

Accent LC (2000-05) :: Bogs Down When Under Load Between 2700 - 2900 RPM

2002 Hyundia Accent -- 1.6 DOHC 2D

When I get to 2700-2900 RPM Under load my car will chug out (basically lose power all together for a brief second) then it will come back and chug out again. I am able to max out RPM's while doing this however under load it still chugs along. WHEN not under load it rev's up fine and purr's like a kitten.

So I went and got a new motor for this car same model as was in the car before a 1.6 DOHC. However upon replacing it (also attached still was the timing belt and clutch assembly, never taken off)

So it seems to be getting spark just fine. and I replaced the MAP sensor thinking it was a intake issue however still problem exists when I am under load between 2700 - 2900 RPM it bogs out for a second losing all power.

View 1 Replies

Avalon 2005-12 :: Missing When Driving Down The Highway Around 65 Mph - Code P0354

Got a 2007 XLS back in Feb 2011 with around 65k. First problem happend today with around 76K. Noticed a miss driving down the highway around 65 mph. A few seconds later noticed another miss. The MIL and VCS went on with the first miss. Pulled the codes with my trusty INNOVA 3100 scan tool. Although I got a lot of use from it with my 2000 XLS, I am still learning how to use all the features.

Pulled the following codes. P0354 "ignition Coil D Primary/Secondary Circuit". Also got about 20 other codes that I assumed came from the primary P0354. Learned that the 'D" cyl was in the middle (4) next to the radiator. I cleared the codes, and plan to swap the (4) coil with the (6), and see if I get a P0356 which would confirm that the coil is bad. I checked to see if the wires got nibbled, but did not see anything.

View 7 Replies

Avalon 2005-12 :: 2013 - Wind Noise In Rear Passenger Doors During Highway Driving

Having wind noise in the rear passenger doors when highway driving? I checked the rubber door seals and they appear to be ok. 2013 Avalon.

View 12 Replies

Passat (B5) :: Normal RPMs At Highway Speed

Just curious. Are my RPM's running high? Currently I'm running 3000 rpm's at 76 mph. Is that high? Someone told me it was. (My speedometer shows I'm running 80mph but both my gps show 76mph, stock tires, 1.8T). Pretty sure I'm in range.

View 2 Replies

Elantra GD (2013+) :: Revs Suddenly Increase From 2200 To 2700 Rpm - No Accelerator Pedal Movement

I've noticed when encountering a moderate hill at 60 mph in cruise the revs might suddenly increase from 2200 to 2700 rpm, then back down slowly as I crest the hill. If I'm in manual mode it stays in 6th gear, but almost feels like a downshift. I also feel no accelerator pedal movement. Is this a two stage intake at work?

View 3 Replies

2014 Avalon Limited - Freeway Exit List Does Not Show Major Interstate Highway Exits

When driving on a freeway, the navigation system splits the screen to show a list of upcoming freeway exits. For some reason, the list does not show major interstate highway exits, e.g I95, I495. So, for example, if the exit for I95 is exit 5, the list goes from exit 4 right to exit 6 without listing exit 5.

I have read every page of the owners manual several time looking for a setting that may correct this, and have searched Toyota Nation archives looking for a solution, but I can't find anything.

This is for a 2014 Avalon Limited.

View 3 Replies

Accent MC (2006-11) :: RPMs Very High While Doing Highway Speeds

I have a 2006 accent 1.6l dohc. While doing highway speeds the rpms are very high considering the small engine. There for it give me a result of bad fuel mileage with 480km per 40l tank. I'm curious is there is any 6speed transmission I can swap out my 5 speed with in order to give me that extra gear to bring the rpms down.

View 10 Replies

Ford Super Duty (1999-2016) :: 2003 - Flat Spot From 2700 - 3000 RPM Especially When Going Up A Hill

2003 7.3 Sd Has a flat spot from 2700 - 3000rpm especially when it changes down, say going up a hill , if I decelerate and let it change back up it will pull again but if I leave it changed down it will not rev anymore. No CEL , put it on the scanner , only code that came up is " intake temp Low " which would not effect it. Have just installed new up pipes , new HPOP hoses , in the past it has had a new IPR and HPOP . It had this flat spot before and it would bring up low boost pres hence the up pipes . Have checked all flanges and intercooler boots etc.

View 2 Replies

Celica :: 2000 GT - High RPMs On Highway When Going Around 70 To 90 Miles On Fifth Gear

I have a 2000 GT with over 120K miles on it. The car works perfect, just a minor issue with O2 Sensor that I am going to replace soon

My question is, when I'm on the highway going around 70 to 90 miles on fifth gear, her RPMs are about 4K to 5K, is that normal??

View 7 Replies

Corolla / Matrix 2009-13 :: High RPMs On Highway Speed (65 - 70 Mph)?

I'm new to owning a Toyota. I just financed a 2010 black Toyota corolla S with 36 miles on it from a local dealership after i decided my last car was pretty much a money pit (2001 expedition)...blew the head gaskets, then after that was fixed developed a bad knock...anyhow i just decided i was overdue for a new car. Its a 5 speed manual and at highway speeds (65-70mph) I've noticed the rpms are bit high...like around 3grand. Is that normal? Just seemed really high to me, I really think this car would do great with a 6 speed. Also is the corolla governed? I was on a long stretch of road and i quickly got to 110ish with no sign of a governor kicking in...?

View 14 Replies

Accent MC (2006-11) :: High RPMs When Driving On Highway In 5th Gear

I have a 2006 accent gls manual and when I am on the highway in 5th gear my rpms are high. if I am cruising at 110km my rpms will be almost at 3500..

View 13 Replies

Golf IV / Jetta IV :: 2002 Running At Insanely High RPMs On The Highway

I don't own a VW, but my friend does, and she knows absolutely nothing about cars. She drove me home from a friend's house today, and I noticed her car was sitting at insanely high RPMs, even though we were only going like 60-65. The car was ranging from like 4500-5200rpms the entire way home, and the engine sounded like a lawn mower.

Don't know many details on the exact model of 2002 jetta it is (I'm a subaru guy) but it's an Auto. I was convinced she had it in 3rd the entire way instead of drive. I asked and she said it was in drive, but I was sitting in the back so I couldn't quite tell. Not sure how being in 3rd works on an automatic, but she could still come to a full stop. The car was pretty much constantly sitting at above 3k whenever it wasn't at a full stop though. Like, after letting of the brake at a stop light, and pressing the gas, it'd pretty much immediately flick up to 3k and never go below.

So, not sure if this is normal for these cars, but I thought it'd be worth asking since it would suck for her if this could have been fixed earlier. My subaru sits at 3k when I hit 60, and only hits 4k if I'm going like 80, so I just thought this seemed pretty weird.

View 8 Replies

Neon :: 2000 Automatic - RPMs Jumping At Highway Speed - Engine Tone Change

2000 neon automatic. My wife was complaining about the rpms jumping around when on the highway going about 65mph. The rpms are around 3000 and jump very slightly up and down and you can hear the engine tone change when it happens. Checked tran fluid and it was low about 3/4 of a quart and added some fluid, changed spark plugs and wires and the problem is still there. Doesn't happen all the time. She says it seems to only do this if the car has been sitting for a few hours or longer. There is an code for the downstream sensor which needs to be changed.

View 2 Replies