Yaris/Scion & Vitz :: 2000 - Fuse Blown While Installing Aftermarket Stereo
I put in an aftermarket stereo. It has been a while since I have done that and somewhere along the wiring process I made a mistake and blew a fuse. I knew the lights around my speedometer weren't working but what I didn't realize is that my running brake lights weren't working, it took me about two days to realize this.
I fixed my wiring mistake and started looking for the blown fuse. I found one (I believe #19 inside the vehicle) and replaced it. This fixed my running brake lights and half of my instrument cluster. The lighting on the right side of my speedometer seems to work but to the left of it seems to be no light.
Also, I have an automatic car starter and before I jacked things up when I use to start it and the blinker lights use to come on and let me know that my car was running. I have checked the majority of the fuses(I believe all of them) and it doesn't seem that I have anymore blown fuses.
[URL].............
Passat (B6) :: Installing Factory Satellite Antenna?
Installed the factory antenna on a car without one from the factory?Is the wire already in place?
View 8 RepliesTouareg :: Car Resets All Programs To Factory Defaults
I've had my T-reg for almost a year with no problems....until now. I recently bought another car with a tire pressure monitoring system. When I park the two cars close together the TPM on my T-reg picks up signals from the other car, gets confused and (apparently) resets all programs (lights, locks...everything) to factory defaults. I took it to the dealer for this problem twice and they are clueless.
View 4 RepliesSanta Fe (CM - 2007-12) :: Heating The Rear Seats Via Pillar Outputs
Well I have climate control AC/heater systems. It seems to be working correctly in the front. Although I don't see any way of keeping the AC from running and still have the fan circulating air. OFF kills everything AUTO & manual modes still appear to activate the AC since the air appears cooler than the cool outside temperature. Not need if you're opening the sunroof to run the AC as well. Seems like an oversight.
Anyway reaching around the back with heat coming out the dash vents its just cool air out those column outputs. Maybe it has to run longer or engine much hotter. I pulled the manual and re read it again but its saying where air will go in various mode selections. I omits entirely if there is heat to the rear when the floor is the only output selected as it is in AUTO.
When they get heat out the columns on their system. This is a Limited.
Touareg :: Installing New Brakes
Check brakes light came on at 46000 miles the other day. Not really sure what replacement brake rotors and pads to put on? Should I go with OEM or aftermarket? put on rotors and pads from Hawk? and how do you like them? Are aftermarket better than OEM parts?(longer lasting, less dust, ect..)
View 12 RepliesTouareg :: Installing DVD In Rear Console
While I'm waiting for my new Touareg (a few weeks...), I'm asking if it's possible to install a DVD reader in the rear console (between the two front seats, useful for rear "children" passengers). I'm talking about this kind of DVD reader "all-in-one", with the 7" screen included (it folds inside when not in use). The size of the equipment is the standard A1 for Europe: 70 inch wide, 19.6 inch height and 73 inch deepth. Obviously, I'm thinking to install inserted in the rear console, below the air vents, in place of the controls for the 4 zone air conditioner that I didn't ordered.
View 5 RepliesTouareg :: Turn Off TPM System After Installing New Wheels
I installed new wheels and the TPMs do not fit. Is there a simple way to turn off the TPM system? Or do I have to go to the dealer?
View 3 RepliesTouareg :: Installing XM Commander In The Ashtray Area
I am attempting to install an XM Commander in the ashtray area.
I have Spockat's wires and all the proper stuff, but then realized that I have never tried to pull apart the TReg to expose behind and underneath the console, ashtray and footwell area. There seem to be two main things:
There is a horizontal piece of plastic that runs the length of the side of the center console. At the footwell end of it there is a cut out piece that is locked back into place. I assume this somehow snaps out and allows you to pull off the plastic trim. How this piece removes?
Then just above the gas pedal there is an odd screw that holds the carpeting in place. It has three "holes" in it and it appears it takes a special screwdriver to remove it. Taking this out and pulling back the carpet seemingly would allow me access underneath and behind the center console area which is where I was wanting to place the brain.
I didn't want to start jerking and pulling on pieces hoping that they just "pop apart"...
Touareg :: Hood Indicator On After Installing Radio
i just installed a low level adapter for a subwoofer in my Egg (non-vav). As i was reinserting the radio the hood indicator came on about 1" before "clicking" into place. I heard this could be a microsensor telling the alarm the radio is missing. I also had the interior lights shut on and off as i was working on to fix the problem.
View 8 RepliesTouareg :: Check Lights Warning After Installing Smoked Tails
Just installed the smoked tail lights on my '07 Treg. Installation was very easy per the instructions on OEMplus. I did a great job from that standpoint.
Got one issue, I check the 'Check Lights" warning and I think its due to the fact I tested the lights before I had all the new ones installed and hooked up. Do I need to take it to the dealer to have something reset via a computer or will the check light go away with some driving, which is what the dealer said.
Touareg :: Lamp Fail Light Is On After Installing Euro Headlight Switch
I need Vag-Com to reset a failed lamp warning light . . . I'm assuming because I ended up pulling the switch out too far, which commands the rear fog light to come on, which doesn't exist, I caused the "lamp failure" warning light and chime to come on and NOT GO OFF (I installed my new Euro headlight switch last night).
I checked and have no dead lamps. I put the old switch back in for a bit but it's still reporting a failed lamp. I searched for this problem before posting but the search engine on this site is extremely poor ... .Couldn't find anything in the manual either. It assumes we're idiots because it says a certified mechanic should change the lamps but oh, carry extras with you !!??
Touareg :: 2005 - Clicking Noise From Driver Door Speaker - Installing IPod
have a 2005 Reed Green V6 w/Equipment Package #1 (Includes Sound System I and Bi-Xenon Headlamps).
The only trouble I've had so far is a very low "clicking" coming from the front driver door speaker when the radio is on. Otherwise, I've enjoyed the vehicle a lot.I am also looking to install my IPOD so that I can play it through the radio...
Prius (Gen 3) :: Lower MPG With Aftermarket Tires
I recently replaced the factory Yokohama 195-65-15 on my 2011 Toyota Prius II with a set of Michelin Defender. MPG has dropped to 45 mpg for city driving. With the Yokohamas, I was averaging 49 mpg.
View 15 RepliesPassat (B7) :: Adding HID To Aftermarket Fog Light Setup
I'm ordering the parts to add fog lights onto my TDI SE and want to increase the light output so that I can drive with the Audi style LED headlights in the parking light setting with the fogs on and still see where I'm going. I have a few questions regarding the setup:
1) Since it is an aftermarket setup on my SE do I need to get a CANBUS HID kit or a regular one?
2) I know there is an increase in light output when installing regular H11s in place of a H8 bulbs. Is it the same with an HID setup?
3) I'd like to find an affordable 5000k HID kit with decent quality.
Touareg :: Installing Reflector On Right Rear Side Of Lower Rear Bumper?
How to remove/install a reflector on the right rear side of the 'lower' rear bumper? I don't see any screws. So, can I pop it out with a screwdriver? Or, is it attached from the inside?
View 2 RepliesCamry :: Aftermarket Wheels Making A Grinding Sound
I have a 2011 Camry LE with American Racing aftermarket wheels. I had the car serviced last Saturday for its 70,000 mile check. When I got in the car to drive home, I felt that somehow the car was making a different sound and did not "feel" right. I did not drive the car for a few days, but when I did the left front wheel was making a grinding sound, checked underneath, for any kind of debris I might have picked up. Nothing. I took it back to the dealer. They put the front wheel on the back and the noise and vibration were gone. They said it was a defective hub on the rim. Then tonight, coming home from work, the right side was making the same sound or worse. I pulled into a tire service center, had them do the same to that side, and the sound and vibration stopped. A friend thought it might be the weights have moved and due to the tighter spacing on the front wheels they are hitting the calipers as the wheel moves.
View 7 RepliesCamry 2012+ :: Upgrade Factory Non Entune Radio 57076 To Factory Entune Radio?
Want to upgrade my factory non entune radio 57076 to the factory entune radio. what model number radio am I looking for and will I encounter any issues with data for fuel and tire pressure sensors.
View 3 RepliesGen 2 Prius (Audio/Electronics) :: No AM Reception After Installation Of Aftermarket Radio
So I just installed my Pioneer 4400BH - Took several hours and all went well - EXCEPT - no AM reception after I installed the radio. FM seems fine.
Two possible guesses:
1. Did not push the antenna connector in far enough.
2. Gen 3's use an antenna amplifier. I did not think that Gen IIs used on so I did not connect the Power antenna lead to anything.
Lexus GS 2006-11 :: Plastic Connected To Aftermarket Fog Light Started To Melt
I put aftermarket fog light bulbs and after a while I realized that it was melting the plastic piece that that bulb connects to. I realized it when my light went off then when i play with the socket it turns back on which is a bad connection. I called the dealer up and asked what do I need to do and he told me that I need to change the whole entire wire that connects from the harness, which will run me about a grand.
View 14 Replies