Ford Transmission :: CEL Came On And OD Light Flashing When Turn The Key And Engine Started
working on a 2000 F-150 (5.4L & 4R70W). the truck was towed to me with the complaint it would not go forward.
I found 6 transmission trouble codes set. I cleared the codes and was able to drive the truck for about 30 miles. It shifted perfectly and had all 4 forward gears, codes did not come back. I parked the truck to check the fluid level (it was full) waited about 15 mins and went to move the truck, As soon as I turned the key and started the engine the CEL came on and the OD light started flashing, the transmission would engage in forward gears but would just chatter when you tried to accelerate.
I checked the codes and found P0743, P0750, P0755, P1747 and P1760 set. I tried clearing the codes again several times and come back instantly when the key is turned on.
I doubt all the electrical solenoids in the transmission have failed at the same time. I suspect the internal connector and/or harness maybe faulty. what is the best course of diagnosis on this? where so I start?
Impreza :: 2000 2.5RS Misfire - Check Engine Light Came On Again And Started Flashing
I've got a problem with a 2000 Impreza 2.5RS 5spd. It started with the check engine light coming on. A trip to Auto zone revealed that the O2 sensor was the problem. But on the way home, the light came on again and started flashing. All the while the car started acting like it had a misfire. It idles really rough and the exhaust smells like it's running really rich. I've replaced the plugs and wires, and all corners of the ignition coil check out properly as well. Can the O2 sensor cause a misfire in one or more of the cylinders? Or is something else that I should be interrogating as the cause?
View 5 RepliesTouareg :: Parking Light Switched On / Loud Warning Sound?
In the last week our Egg has begun to randomly decide to turn on a "parking light" on the passenger side of the vehicle when the car is turned off. This doesn't happen every time. But when it does, the amber light in the front and one in the cluster in the rear (both on the passenger side) turn on while the car is off. Also in the display in the instrument cluster you get "PARKING LIGHT SWITCHED ON" and a very loud warning sound.
I wasn't aware that our Egg's had a "parking light" feature and how to turn it on or off. More importantly I don't understand why this is coming on when it does. When it comes on, I can restart the car, turn it off and most times it turns off.
Yaris/Scion & Vitz :: Check Engine Light Came On And Dash Lights Started Flashing
A couple of weeks ago I was driving my 2008 Toyota Yaris and the check engine light came on. Soon after the check engine light came on every dash light started flashing. The Car down shift into second while I was going 55 miles an hour! We took the car into a service center where they said it was the speed sensor which they replaced. We got the car home. I drove it to work the next day and while going to lunch the check engine light came back on! The car seems to be shifting fine though! They mentioned that if the speed sensor didn't fix it, it could be the "cluster"! What the heck is that?
View 4 RepliesSubaru - Forester :: 2006 - Check Engine Light Came On And Cruise Control Started Flashing
I just bought a 2006 Subaru forester with 130K miles. Recently, the check engine light came and at the same time the cruise control started flashing. I brought it to the mechanic who said I had a bad catalytic converter. The car seems to be running just fine and now a day later the engine light is off.
View 3 RepliesFord - F150 :: Check Engine Light Started Flashing / Cylinder 4 Misfire Code
1997 Ford F150 - 133K Miles - 6cyl - 4.2L. This is a truck that gets less than 2K/year put on it. Has had "issues" with worn bearings and holding oil pressure for a few years now. Yesterday, the check engine light started flashing (as opposed to solidly lit) and the code came back as a cylinder #4 misfire (only the one code). The truck was clearly not firing on all cylinders and at idle, ran terribly (couldn't be driven). I just did a compression test on all the cylinders and all measured around 140-145psi except the #4 which read almost 170psi. I rechecked this a few times as well as a couple of the others and am now sure of the results. What could cause this one cylinder to have a higher compression ? Is whatever is causing this increase in the compression, also be the cause of them misfire ?? I'm stumped here and quite frankly, expected the compression on the #4 cylinder to be really low as opposed to the others.
View 13 RepliesFord F-150 - 1997-2003 :: Check Engine Light Started Flashing / Running Rough Then Went Off
Ok on the way the my 1997 f150 4.6 L 180,000 check engine light started flashing and running rough and then the light went off, Also we took the Aftermarket Dynomax muffler off of it earlier today if that makes any difference, it still has the Cat Converter, New Plugs and Napa Wires.....
View 12 RepliesFord F-150 (2004-2008) :: 2006 - Check Engine Light Started Flashing As Accelerated Uphill
2006 F150 Triton 5.4 Motor... It's been over a months journey with fixing this truck....
How it started: had an oil change, a while back, on long drive after, check engine light started flashing as I accelerated up hill so I pulled over and in a while it was ok, but couldn't get on the gas too much, or it would cause that flashy light thing.
So fast forward to now, after driving it with an intermittent miss for a while, was driving it to work and the miss became a shudder, and she stopped going over 30-40, and runs extremely rough.
Steady but loud idle.
Replaced all plugs with motocraft plugs and new coils all around. No change.
Finally hooked it up to a computer and got random misfires, now it's saying
P0174 bank 2 too lean,
But it's bank ONE that's the only side misfiring.
Here are the freeze frame details:
Frame 1 Mod $00
MIL Status Off
Troub Code P0174
Abslt TPS 24.3%
Eng speed 1665
Baro PRS 71 kpa
Calc Load 100%
[Code].....
Touareg :: Engine Light Came - Idle Erratic After Car Started?
I know its a shot in the dark but my engine light came on the other night. Its a 07 v8 with 25k mileage. i started it up idled fine for 30 secs, then the idle started to get erratic up and own for 15 secs leveled off and the car ran fine. I drove for 10 minutes turned the car off for a couple of hours came ack started her up and engine light came on no rough idle or anything.
View 8 RepliesTouareg :: Exhaust Light On For 1000 Miles But Engine Just Started Stalling After Filling Up
I have 120K on my 2004 V6 and have been driving with the Exhaust light on steady for about 1000 miles. Tonight after filling up at my usual Chevron with Techron Premium gas station, my engine started stalling and I lurched the 2 miles home. I took off the gas cap to see if reclosing it changed things and it did not. I had the coil pack recall work done 30K miles ago. I'm thinking fuel pump, having it towed to the shop?
View 2 RepliesElantra XD (2001-06) :: 2005 Hesitates To Start / Check Engine Light Flashing
This issue has only happened twice to me.
I go out to start the car, it cranks and cranks and cranks. I stop turning the key. I then try again and it hesitates to starts. I give it a little gas and it starts. When it does this, the car begins running very rough and idling rough. When I give it a little gas while it's parked, the check engine light begins flashing at me.
I turned the car off and came back to it the next morning (maybe 10 hours apart). It started right up no problem, no CEL either.
Avalon 2005-12 :: 06 XL - Radio Sound Never Comes On When Car Started
When I turn the car on, the sound to the radio will not work. Occasionally the screen will light up but will have no information on it. Sometimes it will turn on just fine and have all the info. Regardless the sound never comes on. All other functions are working fine like the controls for fans and climate control.
View 3 RepliesSebring - Chrysler :: 2005 - Wiper Motor Not Working / Gauges Started Flashing On And Off
It's a 2005 Chrysler Sebring with a 2.4 DOHC. A couple weeks ago I tried to use the wipers and nothing happened - at all. The next day the gauges inside the car went hay wire, started flashing on and off. Turned out the car needed a new battery and alternator. Replaced both and the car has been perfectly fine - except for the wipers. I checked the wiper fuse and it wasn't blown so I pulled the cowl, unplugged the motor, turned the key on, turned the wiper switch to full speed and then tested for voltage at the plug and got almost 12 volts when testing several terminal combinations.
I thought for sure I had it figured out so went ahead and bought a remanufactured wiper motor but nothing happened when I plugged it in. I thought maybe since I didn't mount it it wasn't grounded so went ahead and did that and still nothing. Thinking maybe it was defective I returned it and went to a different auto parts store and bought another one, hooked it up and got the same results. So then I tested all nine relays in the relay control center and they all passed. So now I'm thinking the only thing left to test is the wiper switch. Am I correct?
And also I'd love to bench test the original motor just to verify that it works but don't know which terminals to connect to. I've searched the internet with two different browsers and came up with nothing. The motor in question is a Bosch 05-02-14 41. And then underneath it has 0390 241 7411 12V 058 written on it. The terminals are labeled: 31b, 31, 53 and 53b. And since the OE replacement motor for this car is a Cardone 40-3026, which terminals to use to bench test that one, I could then figure out which terminals to use on the Bosch.
Lexus GX 2004-09 :: Radio Switched From 107.3 To 107.1 While Driving
I have a 2005 GX470 with 28 k miles. Purchased in April 2005, so the original battery is just shy of 6 yrs old.
Recently, the radio has be acting funny. For example, if the radio is tuned to 107.3, left to sit over night, there is a good chance it will be tuned to 107.1 in the AM. My wife also reported that while driving to the store the other day, the radio switched from 107.3 to 107.1 out of the blue while driving.
I can assure you we're not inadvertently hitting buttons by accident or anything like that. I've also seen this scenario with other stations 105.9 to 105.7, etc, and thought this could be a strange sign the battery is becoming weak (realistically, I should have changed it a year ago anyway).
I'm not interested in having the radio pulled out or anything like that.
2005 GX470 (28k)
2008 GS460 (2k)
Ford Super Duty (1999-2016) :: 2005 F250 Started Chugging And Check Engine Light Came On
I have a 05 f250 with a 5.4 I'm having issues with I was driving along the truck started chugging along and the check engine light came on so I checked it with my bully dog the codes that came up were p0192 which is fuel pressure sensor circuit low the next one is p0452 is evaporative emission pressure sensor switch low also came up with p0191 tonight haven't dug into that yet.
I change out the pressure sensor switch from a buddies truck didn't make a difference put my sensor in his truck his worked fine I clean the throttle position sensor and The maf also put a new air filter on not throwing a misfire code but seems like it may be. A little background on the truck it's a 5.4 3valve with a bully dog tuner, mufflers been removed added straight pipe mechanically that's all that's done
Touareg :: 2005 - Radio / Steering Wheel Buttons Peeling
I have an 05 touareg and I started to notices that the rubber coating is peeling off the buttons. Is this a common problem or an I just touching them to hard?
View 3 RepliesBuick - Lesabre :: 2003 - Radio Has Red Flashing Light?
I purchased a nice 03 Buick lesabre with only 40,000 miles mint , well after driving and enjoying it now for 2 months, I now have a red flashing light left top side of my radio. However it still works and it does go off when I start the engine, what does this mean because I pulled out the manual and this is what I have, is it a normal thing that was just delayed in happening for some unknown reason?
Buick radio flashing light : JPG1023x697 75 KB
Ford 6.0L Power Stroke Diesel :: 2004 F350 - Check Gauge Light Came On And Tow Haul Light Started Flashing
Friday I pulled my steel gn 3 horse trailer about an hour each way. with the horses it weighs right at 7000 pounds. no issues. Saturday morning I drove to town, no issues. Saturday evening, I got in it to run down the road and about 2 miles from the house, the check engine light came on and the tow haul light started flashing and the temp gauge is dead. drives and shifts normal, tow haul button still functions. Truck is stock except for an EGR delete. No tuner, FICM was rebuilt. I had it on a battery minder before I left and was thinking about pulling the batteries and letting it sit for a while to see if it clears. Scan Gauge II shows no codes.
Sunday: So I let it sit all night, batteries connected and it was completely normal this morning. will see what happens when I drive it to work tomorrow
Later Sunday evening: So I just took it out for a test drive, went a couple miles down the road, shifting normal for a cold start. Temp gauge is working, just as I am almost back home. 5 miles at the most, temp is coming up to normal, gauge goes dead and check gauge light comes on and tow haul starts flashing. I think it might be the sensor.
This morning: I got about 6 or 7 miles from home, trans just got up to temp, pulling up a hill, it shifted out of overdrive, tft gauge went dead, check gauge light came on and the tow haul light started flashing. still shifts like it always has and the tow haul button still functions.
I am thinking it is just the temp sensor. Truck has 159k on it.
Lexus GX 2004-09 :: TPMS Light Started Flashing
A couple of days ago the TPMS light started flashing on my 2004 GX. This morning I took it to a trusted tire shop. They checked each sensor, including the spare, and found they were all sending a signal. At 11 years old, and they are original as far as I know (I've owned it about 7 years), the tech said the signal may be too weak for the ECU to pick up. He didn't want to start changing sensors in the event it is an ECU issue. Not sure what to do for now, other than leave it alone. Is there a way to confirm the ECU is good? Do the scanners tell how strong the signal is?
View 14 Replies