Lexus GS 2006-11 :: Rubber Seal Between Doors Is Peeling Off?

The door seal between the driver's side front and rear doors on my car is coming loose -- the rubber piece that seals out wind/water/noise?/etc. between where the driver's side front door closes and meets the rear door by the B-pillar. I looked at the way it's designed and meant to be applied and was curious if using gorilla glue or some variant of high strength adhesive would do the trick? It seems to be drying up where the rubber meets the sheet metal.

View 3 Replies

Sonata I45 (YF - 2011+) :: Rubber Seal Around Window Of New Car Peeling

Just noticed today that the rubber seal around the window, a small part of the rubber seal, has peeled.

Talked to the dealer and initially they said that it could have been the tint shop's fault because they may have been their fault.

Called the tint shop and they explained their process and after doing little research of my own and watching youtube videos, it is unlikely that the tint shop could have done this.

Called dealer again and explained to them that i talked to the tint shop and after hearing their process and after researching their process, it may not have been the tint shop but just a small mistake on hyundai/dealer part. they said the best they could do is take a look at the car, but not guaranteed they will fix it.

View 9 Replies

Ford Excursion :: Rubber Seal Near Axle Joint?

I unstuck my front axles yesterday and while under the car spinning the front axles freely and enjoying my easy fix, I noticed a rubber seal (a thick squared edge round rubber seal) sitting loose and spinning freely. Its next to the axle joint, right before it disappears into the housing.

I'm guessing this is a dust seal of some kind. There is no fluid leaking out...

I'm wondering if I can just press fit this thing back into place or do I have to take the whole front wheel assembly (hub, bearing, axle, etc) to get the seal back into place.

I'm wondering if it broke off from a larger seal or if this is the whole thing? You can see how the seal isn't sitting quite straight. It actually just spins around.

View 9 Replies

Prius (2004-09) :: Strong Smell Of Burnt Plastic / Rubber

I'm possibly being paranoid, but twice, after hard driving, my Prius has smelt strongly of burnt plastic/rubber.

View 19 Replies

Sonata NF (2006-10) :: Burning Rubber Or Plastic Smell When Driving

I have a 2007 Sonata V6 with 198,000km (123,000 miles) and when I was driving yesterday I smelt a burning smell like burning rubber or plastic. The smell seemed to go away after a while and I was wondering what could have caused it?

View 2 Replies

Golf/GTI VI :: Rubber Seal Making A Squeaky Sound At Low Speeds

At low speeds - Like when I go over the soft-curb at the end of my driveway, I get a rubber seals making a squeaky (from friction?) sound when ever tire goes up or down the curb.

Or in a parking lot with uneven surface - I get it then too.

Just very annoying - but luckily no noise while driving the speed limit...

I never had a car that did this. Been driving VW's since 1986.

View 24 Replies

Lexus ES 2007-12 :: Rubber Seal Squeak From Driver Side Door

I have noticed a rubber squeak from my driver's door on my 2010 ES 350. It disappears when the rubber is wet so I am thinking perhaps there is a silicon product that I could apply or another fix for this? Any solutions out there?

View 4 Replies

Prius (Gen 2) :: 2007 - Driver Side Black Plastic Strip On Roof Missing

The drivers-side black plastic strip on the roof of my '07 Prius is 'missing'. Should I have a body shop take care of this, the dealer, can I do it? It looks pretty straight forward to replace, but I'm concerned about how it's molded to the windshield 'gasket', like it's one piece.

View 2 Replies

Lexus LX 2008+ :: Sunroof Not Closing - Slide To The Middle Then Open Again

I have a weird situation, when I open the sunroof then try to close it, it slides to the middle then opens again. After four trials the sunroof switches to manual then I close it manually.

View 3 Replies

Camry 2012+ :: Rear Door Pillar Post Plastic Is Sort Of Lifting / Buckling In The Middle

I just noticed on my wife's camry the rear door pillar post plastic is sort of lifting/buckling in the middle. The front doors pillar plastic is fine just on both rear doors it started to lift in the middle. When you push it back down it stays for a second or two then lifts up again. the car is 2012 and only has 10k miles Not happy.

View 14 Replies

Golf/GTI VI :: Rain Water Runs Into Cabin From The Roof?

It seems to rain every afternoon here lately, but by the time I get out to my car it's still quite hot. So I roll the windows down a little, and start to pull out of my parking space. However, as soon as the car moves, rain water just rolls right off the roof and comes pouring inside. There is a little lip between the roof and the top of the door line but that doesn't seem to be stopping it...does it have anything to do with the paint being new and still slippery? I've waxed my old mkIII GTI numerous times and never had an issue like this though. It's quite annoying having the entire door card and my left arm soaked every time it rains and I 'forget' not to put the windows down right away

View 10 Replies

Prius (2010-12) :: Sunroof Rubber Edge Fading / Cracking Unevenly

Model Year 2010 Prius, rubber along the front edge of the sunroof glass looks dry/cracking, but only on the left side of the car. Don't think it has anything to do with the location it is parked in, as that and the orientation changes daily.

View 4 Replies

Prius (2010-12) :: Sunroof Glass Edge Rubber Rippling / Tearing

Gen3 2010, 15 months on the road, 62 000 km. While washing the car today I noticed that the rubber edge bonded to the sunroof glass is buckling/rippling/tearing. Cosmetic only, as far as I can tell - damage/wear doesn't permeate far enough down to cause a problem, I don't think.

View 2 Replies

Golf/GTI VI :: Plastic Creaking / Noise On Sunroof Cover?

Having problems with sunroof cover making noise when going over bumps? It just sounds like the plastic is making all the noise.

View 8 Replies

Tiguan :: How To Remove Roof Rails

How to remove the roof rails? I'm planning on doing a Vinyl roof so need to get these things off!

View 3 Replies

Tiguan :: Installing OEM Roof Bars?

Is it possible to install the OEM roof bars on a S? The VW Parts guy says no.

View 5 Replies

Tiguan :: Headliner Separating From Roof?

Just noticed that an A-pillar plastic cover (on the right side) is coming apart from headliner. Inspected it further and discovered that the headliner is somewhat separating from the roof, so much that I can stick my fingers in there. Nothing like that on the left side. It seems that there are no clips that that I could push back in, it just hangs freely.

View 2 Replies

Lexus GS 2013+ :: GS350 Sunroof Seal Loose On Driver Side

Have had the puppy about a month. Getting about 31+ on the Hwy. Anyhoo for the real story, we got home today and noticed that there was a seal around the the sunroof, well on the driver side that was loose. Sort of a flex/accordion type. The other side didn't have one. Not sure, but it looks like it folds over to the outside under the slide track, but not sure. The other side is gone.

View 4 Replies

Accent LC (2000-05) :: Sunroof Won't Seal Properly - Gap Creating Wind Noise

My Accent has a manually operated pop up type sunroof. Last summer I removed the glass on a particularly hot day. Unfortunately, when I put it back in that same day it would no longer seat properly along the front edge. When the sunroof is fully closed the front edge of the glass is raised above the seal. This gap creates a lot of wind noise and I'm concerned about water getting in now that winter is here. I've removed and re-installed the glass numerous times and just can't get it to lock down in the front. The metal mounting tabs on the front of the glass are going all the way into their slots. The back edge of the glass is sealing well and sinking flush with the black rim of the opening. The rubber gasket is in good condition with no warping or dislocation. I'm looking for some input before I start doing permanent things like bending the metal tabs or the roof opening.

View 2 Replies