Subaru - Legacy :: 2005 - CEL On And Cruise Control Light Is Blinking
My 2005 Subaru Legacy 2.5i - the engine light is on and the cruise control light is blinking. This happened once before and it went away after I recapped the fuel cap. However, this time it did not work. The car is running ok.
View 4 RepliesSubaru - Legacy :: 2015 - Brake Light Started Flashing At 40 Mph
On the way home from purchasing this 2.5i Premium the BRAKE light started flashing when I got to 40mph. - yes, the emergency brake was off. Car was roaring like the brake was on-ablut 5 mi. to home. When I drove it back to dealer/service to get a few minor "We owe" things done, same thing happened again when up to 40mph. This was reported to service and car was driven by service manager. They reported a bad wheel bearing front R, and later in day found out rear R wheel bearing also bad. Yes, to be replaced..
View 19 RepliesSubaru - Legacy :: Dashboard Brake Light Flashing When Start The Car After Been Driving For A While
I have a 2011 Legacy Sedan with 40K miles. Three weeks ago, I drove the car 25 miles in 90+degree heat on the highway. I parked at a store, did not use the electronic parking brake and when I returned to the car 5 minutes later and started it, the dashboard BRAKE light was flashing. The brake was not engaged. I tried to engage and release it, but it would not engage, when I pushed the button the car 'chirped'. I drove the car home and garaged it. The next morning (after a cooler evening) the light no longer flashed. At that time I was able to engage and release the electronic parking brake and it worked as designed.
A similar sequence has occurred on four different occasions. When I start a cool car, no light. When I start the car after it's been run for a while, I'm getting the flashing light.
I've checked the brake fluid and it's fine. I've checked the OBD and it shows no codes.
Subaru - Forester - Xt :: 2007 - CEL With Blinking Cruise Light / Fault Code P1410
At a bit over 43K miles the check engine light came on with a blinking cruise light. Dealer has confirmed that both secondary injection pumps have failed for reasons unknown. I think this is part of the pollution control system.
View 3 RepliesSubaru - Legacy :: 1996 Sometimes Will Not Start Unless Brake Pedal Is Pressed
Sometimes my 96 Subaru Legacy will not turnover unless the brake pedal is pressed. Other times starts without my foot on the pedal. It seems to need the brake pedal addition more often if it has sat a couple hours or more without being started.
View 5 RepliesSubaru - Legacy :: Replace Transmission Valve Body Assembly Code
I started my Subbie and all the lights just start going crazy on my dash. So I pulled of the road and started freaking out, Never had a hint of a problem. So I pulled in AutoZone and they ran the codes and now I'm being told I have to replace the brain to my transmission WTH? I don't own a DODGE!!! Had 3 different dodges and the tranny went on all. So I wont own one because of transmission problems. Now my Subaru has been parked since it can only get worse. Is this normal? All the error codes are...
P0700 Transaxle Control System (MIL Request)
P2762 Torque Converter Clutch Pressure Control Solenoid Control Circuit Range/Performance
Subaru - Legacy :: 1993 - Auto Trans Brake Won't Release Shifter
1993 Subaru Legacy wagon AWD Auto, press on brake pedal & won't release shifter,unless you press the button at the bottom of shifter.
View 4 RepliesSubaru - Legacy :: 1999 - Cylinder 2 Misfire Code As Well As Random Power Loss
I had plugs and wires changed to try clear code. Car seemed to do some better but while trying to go up a steep hill car started stuttering and jerking. Power went out of car and check engine light started blinking fast.after let the car sit for bout 45mins car started running fine again and light stopped flashing but remained on. Code read cylinder2 misfire again.
View 10 RepliesSubaru - Legacy :: 1993 - Power Steering Died - Battery And Brake Lights Came On
My old and often very reliable '93 Subaru's power steering died the other day. I was driving and my engine suddenly started making a deep ticking sound. I pulled over and with it running, popped the hood. The sound was coming from the front of the engine near the visible belts. I decided to keep driving. After about 10 miles that's when the power steering died. Then my battery light and break light came on (which in the past has usually indicated that something is up with the battery or something is drawing from the battery more than it should). THEN I began to smell burnt rubber.
What I want to know is this: my boyfriend says that it's probably the surpentine (sp?) belt or the pump thingy that runs the steering. First, I want to know if I can drive it to the shop or if that is a dangerous thing to do. The steering is really hard but I can still make it work. I'm a grad student and I don't have the money to get a tow, but will will find the money if I have to. Second, is my boyfriend right and will it cost a lot? Again, poor grad student.
Subaru - Legacy :: Slight Rough Running With Cold Engine And Stumble Below 2000 Rpm / CEL Misfire Code
I have had some slight rough running with a cold engine and stumble <2000rpm. Finally it tripped a CEL which was read as a misfire code.
The mechanic swapped the coil and plug(recent) and no change. He did a compression test and air blew out the exhaust. So.......the car needs a valve job which entails motor removal and fixing the head and reinstall. He rough estimates this at $2000 and rate is $65/hr.
He mentioned looking at pistons and may be a bit more if rough.
This car well maintained (170,000 miles 2005 Legacy turbo wagon with manual)...
Subaru - Legacy :: Check Engine Light Turning On And Cruise Control Light Flashing
Had an issue with "check" engine light turning on and "cruise" control light flashing, intermittently. Dealer said we had dirty oil contaminating some solenoid valves in the system but we had just done an oil change and do so every 3-5K (car has 170K). They recommended switching around the sensors and doing an "oil flush" with another oil change. The warning light problem hasn't recurred, in the past month, since we started giving the gas cap a few extra turns after a fill-up. We're getting ready to buy a new car and don't want to give what might be a serious problem over to the next owner.
View 6 RepliesSubaru - Legacy :: Check Engine Light On And Off On 2001 GT
I bought my Subaru in 2004 with 14,000 miles on it. The check engine light began coming on soon thereafter. The Subaru dealer has replaced my catalytic converter (the so-called problem) -- 3 TIMES up to 85,000 miles. The check engine has continued to come on and it goes off since then. Mostly, it's on, but now and then, it goes off. I bought my own diagnostics kit because I got tired of taking it in every time the light came on. I'm told it's the usual problems plus they usually have me get the oxygen sensor repaired. I've also been told to make sure my gas cap is tightly closed. Still the check engine light continues to come on and now and then it goes off (it's currently "on").
View 4 RepliesSubaru - Legacy :: Sputter And Check Engine Light Will Blink On At 60 Mph Or Above Sometimes
My car will drive fine, then @ 60 mph or above sometimes it will sputter and the check engine light will blink on. I brought it to my mechanic and plugged it in. Miss-fire on some spark plugs. They replaced all spark plugs and wires. The car is sill doing the same thing. My mechanic plugged it in again and now just a miss fire on #2 plug. (even after new wires and plug) Only seems to happen once the car is warmed up. If left sitting for 15 hrs the check engine light goes off completely. Only to come on again, after driven 25 or more miles. What could be wrong?
View 10 RepliesSubaru - Legacy :: 2004 - Engine Light Comes On Along With Flashing Cruise Control
My mechanic can't find the problem. Engine light comes on. Along with the flashing cruise control. His diagnostic doesn't show him the exact problem as the voltage changes. He has checked everything related, changed out the bank 2 sensor 1 oxygen sensor, but can't find the problem. I don't know the diagnostic code. But he says that it doesn't give him an exact code. Can only the dealer do this? Car runs fine.
View 10 RepliesSubaru - Legacy :: Low Beam Lights Do Not Work And Dash Parking Break Light Will Not Go Out
I have a 2000 legacy wagon (245k miles) that has a light issue. The running lights and low beam lights do not work and the dash parking break light will not go out. Earlier I had just the low beams not working. They were both blown and I replaced them about two weeks ago. Now they are out again and the dash parking break light stays on. I checked the fuzes and they look good.
View 8 RepliesSubaru - Legacy :: Raw Fuel Smell Out Of Tail Pipe / Check Engine Light Intermittently Comes On
When I turn the key all the way over, I hear only one click, and no engine sound. Playing with park or neutral positions do nothing. Battery and connections are good. I am getting a raw fuel smell out of the tail pipe after it finally starts. The check engine light intermittently comes on, by now it is mostly on.
My guesses are: fuel pump/relay problems, starter/connection problems.
Subaru - Legacy :: 1995 - Engine Randomly Dies Frequently At Lower Revs Such As Idling At A Red Light
So I have a 95 Legacy sedan, FWD. It's been a kind of problematic car, and the engine was replaced about 5 years ago (I assume with an old unit, but I'm not sure though because though I was in the family I wasn't driving it then). But, it's held up and has continued to be at least roadworthy. But recently, it's developed an issue where the engine will just randomly die while I'm on the road. All/most of the dash indicator lights come on, but if I shift it into neutral and turn the key, it'll come right back up. Occasionally it'll die again almost immediately, but usually it'll be fine for at least a while. And anecdotally, It seems to happen more frequently at lower revs such as idling at a red light (though will occasionally happen while I'm moving), and when the engine is cold - generally once I've driven around for a while, it's not a problem anymore.
View 3 RepliesSubaru - Legacy :: 2003 - Replaced Clutch Now Reverse Light Going Out - Clutch Not Smooth?
I had the car worked on a while back. They replaced the clutch and the viscous coupling in the transmission. ('03 Subaru Legacy manual transmission) Things seemed fine, then I realized my reverse light was acting like it was going out. Fuses are fine. A while later the car decided the clutch didn't need to respond as smoothly. Then: "Nope, you're funny to think you can drive me. I'm not budging." The car started grinding gears. I have to slam it into gear for it to work so I can drive it home and let it sit. The car will go into gear when off, no problem. New fluid has been put in. Bled. Then some sort of SUPER LUBE was put in and it still grinds. What might be happening? I really don't have the fundage in order to buy a new car at this time. But at the same time I hate feeling like I'm chasing a rabbit down a hole..
View 4 RepliesSubaru - Impreza :: 2007 - CEL Suddenly Comes On And Cruise Control Light Starts Blinking
So I'm driving along with everything fine till I pull into a neighbors driveway to drop off some stuff. As I pull in, the check engine light suddenly comes on and the cruise control light starts blinking. As I have a scangauge II always connected, I put the car in park and check the code. It comes up as P0000. I get on my Droid III and google it - all I see is "null code" so I clear the codes and everything is fine. I figure "that's odd, but whatever". I drive home (about 1000 feet) and park and shut the car off and go inside to mull this over.
I go back out to check out the scangauge again and it requires starting the car to read out the codes. The car won't start. The battery is fine, and in fact it does the "rurrr rurrr rurr" strongly for 10 times before I figure it's not starting. I wait about 30 seconds and try again - same thing. I wait about an hour or two and try again and it starts this time right away, but then stalls right away. Start again and manually give it some gas and it keeps idling weakly. I'm able to back out and drive a short distance and come back without a stall. I let it sit for the weekend (no shops open anyway) and start it monday morning with my AAA card out... and it starts fine and runs fine all day. I basically forget about it.
About a week and a half later, I'm driving along a country highway at 55 Mph, and the same thing happens. Check engine light, cruise control light blinking and the cruise actually cuts out so I'm losing speed suddenly. I run the scangauge again and same code. The car keeps running fine though, I'm able to drive it back (w/out cruise control) the 5 miles home. Nothing out of the ordinary.
I go inside and google this some more, and there's some posts about the Scangauge causing this - but I've been using it for about 4 years w/out this happening. That said, about 2 months ago, there was a recall, and they flashed the ECU with some update so maybe that changed something, but still - worked for months before this happened. I had to get to work etc so I just cleared the code again, and so far 3 days without a recurrence. Currently I'm thinking about waiting to see if it happens again and going to Autozone and have them read the code to see if it really is the Scangauge not reading the code right or whatever...