Sonata I45 (YF - 2011+) :: Wobbling When Apply Brakes At 60 Mph
2011 Hyundai Sonata SE 2.4L .... I have 82,000 miles. Bought with 65,000 miles.
Now when I apply brakes at 60 mph or above i get wobbling (Vibration) on my steering wheel these days. Is it the rotors or pads or both or any alignment issues?
Sonata I45 (YF - 2011+) :: Squealing Only When Lightly Apply Pressure On Brakes Slowing Down
Me and a friend changed just the front brake pads on my hyundai sonata 2012 limited turbo (about 55$ ceramic Wagner thermo-quiets)about a week ago . This was the first ever brake job done for the car so I assumed the rotors were fine . We made sure it was greased up everywhere it was supposed to (Didn't replace or turn them) since then my front brakes have been squealing only when I lightly apply pressure on the brakes slowing down , and goes away completely when pressed down harder. I realized I should have probably changed or turned my rotors after I already drove with the new pads on the old rotors for about a week so it's probably too late now. I am just wondering whether this noise go away eventually (what I initially figured it would) from the pads perhaps wearing back into the old rotors ? Or am I better off not waiting for this because the noise won't to away and I should just change the pads again along with the rotors!?
View 43 RepliesSonata I45 (YF - 2011+) :: 2012 - Steering Wheel Used To Shake When Apply Brake
I have 2012 sonata and she has about 43000 miles. I replaced 4 tires at 40000 miles. Soon after, steering wheel used to shake when I apply brake. So, I got front rotors resurfaced and got new front brake pads which solved the problem of steering wheel shaking. I also got alignment right after installing brake pad.
Since last week, I realized there is a vibration coming from front of my car when driving over 30 mph to about 70 mph.The vibration is present randomly and weird thing is that the vibration stops immediately when I apply brake. What may cause this problem?
Sonata I45 (YF - 2011+) :: Getting Increasingly Louder Noise Originating In Left Front Wheel
So I've been getting on increasingly louder noise that's originating in the left front wheel. It sounds like you're driving over road patches (rough spots). It does it worse when shifting the weight to that wheel by taking a right curve. I rotated wheel front to back no change. Brakes look ok. I was thinking wheel bearing but I have no play when I check it. Also it sounds like a general bearing rotation whine that matches road speed.
View 2 RepliesSonata I45 (YF - 2011+) :: Thumping Noise From Rear Driver Side
Whenever my car go over a bump or uneven road, it causes a thumping noise in the rear driver. I have ultra racing rear sway.
I have re-lubricated the bushing, and changed the oem end links to moog.
Acura - TL :: 2005 - Thumping Noise From Front Wheel Area
I replaced both 1/2 axles last week after one CV boot pretty much disintegrated. Since it is a 2005 Acura TL with 146K miles, I changed both axles completely. BTW - I had NO forewarning, noises, etc. before the axles died last week! I only perceived an increase in road noise, but did not hear noises squeaks, thumps, clacks, etc.!) The first day I drove the car after the new axles, I noticed a thump, thump, thump from the right wheel area when I made a sharp, slow turn out of my driveway. It only happened once, but it was a quick trip.
The next day, I noticed it again as I pulled out of my driveway and later as I pulled into a parking spot. There are no other symptoms and it only occurs when the wheel is turned to an extreme (80-90 degree) at little to no speed. I tested it in an empty parking lot - slow circles in either direction will cause the thump, primarily coming from the right wheel area. I immediately drove to the repair shop and made an appointment. Why I'd develop a new thump immediately after getting new axles? I'm thinking something isn't right with their installation. Of course, they say nothing is wrong with what they did - the problem now is that I need stabilizer links?! Sounds like BS to me - why all of a sudden do I need BOTH stabilizer links immediately after repair work?
Nissan - Sentra :: Steering Wheel Shakes Sometimes When Apply The Brakes
2013 Nissan Sentra, 2.0L 62,000 miles. Sometimes when I apply the brakes, the steering wheel shakes. It usually happens on the highway when slowing down from speeds above 40mph. I thought that it might be the rotors, but it doesn't happen all the time. The severity of the shaking also differs from time to time.
View 3 RepliesSonata NF (2006-10) :: A/C Blower Power Goes From High To Low When Apply Brakes
When I accelerate A/C is fine but when I go to brake (RPMs go down and car downshifts) my A/C blower power goes from high to low and then fixes itself and if I brake again same thing but it does it intermittently. What it could be?
View 11 RepliesSanta Fe (CM - 2007-12) :: Steering Wheel Will Shimmy When Apply Brakes At High Speeds
I have a 2007 Sante Fe Limited that has 93k on it. Within the last year I have noticed the steering wheel will shimmy when you apply the brakes at high speeds, it's slowly came to the point now that anything above 40mph will cause the steering wheel to shake while applying the brakes. I am guessing I have warped or unevenly worn front rotors. The car supposedly had a break job done at 74k and this started happening at about the 90k mark.
I was looking at these : Front Performance Brake Rotors Posi Quiet Ceramic Pads for Santa FE 07 09
Second question, any tool list or required sockets sizes to complete a front rotor and pad replacement? I have a floor jack, jack stands, a set of 3/8 deep metric sockets. I also have a breaker bar. This is my only car so I want to make sure I have everything I need before I start taking stuff apart.
Toyota - Highlander :: 2002 - Rear Right Turn Signal Don't Work When Apply The Brakes
I have a 2002 Toyota Highlander. The rear right turn signal and break light don't work when I apply the brakes. When I use the turn signal or brakes while driving or parked there is no problem, but once I apply the break the back right side does not work. The light bulbs also burn out faster on that side.
View 4 RepliesFord Excursion :: 2000 - Popping Noise Coming From Rear End When Apply The Brakes
2000 Excursion V10 4x4. I'm getting a popping noise coming from the rear end when I apply the brakes and come to a complete stop and when I release the brakes to take off. It only happens the moment it comes to a complete stop and the moment it takes off. Not when I'm putting it in forward or reverse or accelerating or decelerating. U joints are fine. I was laying under the truck poking around the other day and when I roll it back and forth in park the few inches it'll go, when it comes to the end of it's travel the axle wraps a little and it seems like the transfer case output shaft flange is moving in and out of the transfer case and causing the noise. I'm assuming there is a snap ring holding the output bearing in place. I didn't have time to drop the driveshaft but am planning on it this weekend to see if it still does it when I roll it and to inspect the transfer case. I need to check to make sure the driveshaft splines are not seized up but they seem to have a little free play to them.
View 2 RepliesSonata I45 (YF - 2011+) :: Heavy Rust On Rear Wheel Wells
I have a 2011 Sonata Limited, I'm noticing some heavy rusting in the wheel wells especially in the rear (not sure if wells are the right term), what can I do?
It's very ugly, It has very heavy surface rust, the car is 2011, I don't remember seeing this much damaged when I purchased the car last winter. I took it to the dealership, they said they cant change it because it is purely aesthetic and the components still work.
I'm researching rust proofing, but that seems more like a preventative action than a remedy, what can I do, it really annoys me every time I look at it. I don't know why Hyundai chose such poor material inside the wheels that rusts so easily. I have compared it to other Sonatas I see on the street, mine is a lot worse.
Sonata I45 (YF - 2011+) :: Hammering Sound Getting Louder With Speed
This is my 2011 2.4L Hyundai Sonata with around 78,000 miles(no warranty). For the past two days car wasn't accelerating as it used to and all of a sudden today it started to produce hammering sound. Sounds gets loud with speed. Gears are switching like normal. There is a warning signal also that is attached in the picture below.
[URL] ....
I want to know where is the sound coming from? Should i fill any oil? If so what brand and where is the nozzle located.
Honda - Cr-v :: Loud Thumping And Grinding Sound - Rear Brakes Rusted
In February 2014 I purchased a 2011 Honda CRV. I often travel and am gone for about a week. Every time I come back the rear brake are rusted. They have a loud thumping and grinding sound. I immediately took the car back to Honda dealership (2 time) both times they 'shaved' the roaters. I then contacted Honda headquarters to report the issue. They told me to deal with the dealership and take it to a local mechanic for other opinions. Car Talk will be my second opinion. Honda dealership told me that this is just the way it is. This is my third Honda, I have NOT had this problem before.
View 8 RepliesSonata I45 (YF - 2011+) :: Rattling / Thumping Coming From Under Driver Side Floorboard When Car Started
A couple of weeks ago I started hearing this rattling/thumping coming from under the driver's side floorboard when the car is started. Almost sounds like a loose exhaust pipe. You can hear just little rattling under idle but it goes away (or you can't hear it) while driving.
Both shops (Pep Boys and dealer) told me it's quite expensive to replace. I just started looking around and I do see aftermarket cats for a few hundred. How hard can this replacement be for the average driveway mechanic?
Toyota - Sienna :: Thumping Noise From Right Rear Wheel Whenever Brake
I have a 2002 Toyota Sienna van. My garage failed to check the brake shoes as requested, so I gouged the back brake drums and had to have them replaced. Shortly afterwards, whenever I brake, in the last 2-3 seconds before I stop there is a thumping noise from the right rear wheel. It will thump a few times, maybe 2-5 times, perhaps one thump per wheel rotation. I don't feel any pulsing in the brake pedal, and except for the noise braking seems normal. Could this be due to the shoe adjustment being too loose, so the shoe has room to pulse inside the drum?
View 2 RepliesSonata NF (2006-10) :: Knocking / Thumping In Rear When Accelerating Or Braking
When accelerating and/or braking, a thumping or knocking noise comes from the rear of the car. I do not believe it's my shocks, as there is no noise when going over bumps, only accelerating and stopping. What may be the cause? Control arms maybe?
View 7 RepliesSanta Fe (DM - 2013+) :: Wheel Bearing Type Noise Coming From Rear And Gets Louder As Go Faster
I just bought a used hyundai santa fe sport 2.0t. i noticed it is fairly loud inside compared to my 2011 sonata. I don't know if im hearing tire noise or maybe a wheel bearing type noise. It's coming from the rear and gets louder as I go faster. I'll admit O am paranoid and probably making this sound worse than it is.
View 12 RepliesLexus RX 2004-09 :: RX330 Rear Wheel Bearing Type Noise Gets Louder With Increasing Speed
I have a rear wheel bearing type of noise that appears to come from the rear. My vehicle is front wheel drive and has 135K miles.
I checked the rear wheel bearing/hub assys on both sides and they had no play but I changed them anyway. Noise did not change at all. Rear tires have normal wear, no cupping or anything. Noise gets louder with increasing speed up to a point and then remains a constant level.
My next thought is to check the front wheel bearings/cv joints.