Ford A/C :: Compressor Clutch Making Noise / Would Engage Or Disengage
The A/C in my truck stopped working last year, and this year I intend to fix it. I believe the problem is with the compressor clutch because it was making noise as it would engage or disengage. It was making this noise for a good year or so, and then one day the noise stopped and I have no A/C. So I am only assuming its the clutch.
View 4 RepliesAvalon 2005-12 :: How To Access AC Clutch Coil Without Removing The Compressor
What's the easiest way to get access to the ac clutch coil without removing the compressor. How do you get to the coil? how many snap rings are there?
View 3 RepliesHonda - Odyssey :: 2006 - AC With No Cold Air / Compressor And Clutch?
My 2006 Honda Odyssey lost the a/c last week. No cold air. After troubleshooting myself, I took it to the shop I use and they came up with it being the compressor clutch. But you can just replace the clutch, so a new compressor. My question is... What's a good price for this repair? In this vehicle the compressor replacement requires the alternator, etc... To come out first before you can even get to the compressor. So, I'm not really excited enough about it to do it myself. Which I think could, except for the discharging the refrigerant.
View 6 RepliesGolf IV / Jetta IV :: Intermittent AC - Compressor Would Engage Then Disengage
I have an 02' 2.0 Jetta Wagon, and the A/C is having some issues. Since I know close to nothing about A/C systems, I took it in to a few places to have it looked at. I've had the whole system Evac'd and recharged, and have had the low pressure fitting replaced (apparently there was a slight leak there), and the system is still not working.
The A/C worked fine when I first purchased the car a few months ago. Shortly after my 800 mile trek from Oregon, back to home, the A/C started to only work intermittently. The compressor would engage, then disengage, repeat...It seemed like a bad idea to keep trying to use it in its sad state so I stopped using it altogether. As I said, I had the system emptied and recharged, but it still only works intermittently. It sort of follows a pattern where upon start up it works longer, and switches on and off at shorter intervals, until it doesn't engage at all.
There are no strange noises from the compressor, and when it was hooked up to the machine, it proved to be performing its function well.
Prius (2001-03) :: AC Light Flashes And Compressor Disengage
I have charged system 134 ... Compressor works at start up until warm, then light flashes and compressor disengages. No noise and gets cold until motor gets heated.
View 5 RepliesGolf IV / Jetta IV :: Compressor Will Not Disengage Even With AC Off - Battery Draining
Clutch for the AC Compressor will not disengage even with the AC off. The only way I can daily the car is if I disconnect the power from the AC Compressor at the compressor itself. Seems the AC compressor has a constant draw if it is plugged in.
Plugged = dead battery...
Unplugged = good battery...
I'm getting ready to rip the damn thing off the engine and calling it a day, but that would defeat the purpose of me buying a new compressor.
Chevrolet - Caprice :: 1992 - Air Conditioner Is Chilling But Compressor Doesn't Disengage
My Chevrolet 1992 Caprice Air conditioner is chilling but the compressor doesn't disengage when reach the right temperature inside cabin... There seems to be a temperature control or a sensor and I don't know where is it...
View 2 RepliesSonata NF (2006-10) :: A/C Blowing Warm - Compressor Oil
My 2006 Sonata GLS 3.3 A/C started blowing warm, so I checked all the fuses and they were good. Swapped the relays and still nothing so I check the wire to the compressor and it was reading 14v. This would lead me to believe the a/c clutch is bad, I didn't want to replace just the clutch incase my compressor craps out on me later on so I'm just replacing the whole thing now. My questions is how much oil does a new compressor need?
View 3 RepliesSonata NF (2006-10) :: AC Started Blowing Hot Air / Compressor Isn't On
I've got a 2007 Sonata that has started blowing HOT air. It's like the compressor isn't on. In looking for the issue, I looked for blown fuses first because I find it hard to believe that the AC would work fine and then stop working minutes later. Sure enough, I found a blown A CON fuse in the fuse box under the hood. No problem right? Just replace it and everything will be A-OK. WRONG. Every time I replace the fuse and test the AC it blows. I'm thinking maybe something with the relay?
View 11 RepliesSanta FE SM (2001-06) :: Clutch Slipping And Won't Disengage
Ok santa fe 2006 (facelift) clutch was slipping. We've put new clutch kit in it (thrust bearing; friction and pressure plate). We discovered it had already had the DMF concersion to single mass. So we ordered the single mass clutch kit for it and fitted. All back together, clutch won't disengage and allow you to put it in gear!!! So took it all apart again to check the fitting as the inspection hatch it just didnt appear all fingers on the pressure plate was being pulled.. all looked correct, thrust bearing snapped in to place as it should... we got box back on (making sure the lever entered the thrust bearing correctly) and still no luck. When you press the clutch you can pull the rubber on the slave cylinder back and the piston moves all the way to the circlip. There appears to be movement on the pressure plate in the box. At a complete loss.......... what could have happened?
View 3 RepliesSanta FE SM (2001-06) :: Clutch Replaced But Won't Disengage
Santa Fe 2003 petrol manual 2.4
I had a slipping clutch so decided to change it myself.
I replaced the Dual Mass Flywheel the clutch pressure plate and clutch plate.
Re assembled and the car started first time but the clutch would not disengage.
Pressed the clutch peddle down and it went to the floor until the fluid had filled then it went solid.
I pressed it down again and the clutch did not release so pressed harder and 'pop' the master clynder went - but the clutch would not disengage.
Taken the gearbox back off now and the release bearing is in sit it just would not disengage -
Elantra XD (2001-06) :: Clutch Won't Completely Disengage
We swapped transmissions in 01 elantras.. We installed a new clutch kit . When we go to start the clutch won't completely disengage, it only pulls it some, not enough. We replaced Tran fluid and bled it. We swapped out the throw out bearing arm and at first it worked now it doesn't..
View 3 RepliesCivic - Honda :: 1995 - Clutch Won't Disengage
I have a 95 Honda civic with a d15b block and a d16z6 head millage unknown I put a new clutch in it already had a new slave and master I installed a few weeks ago and when the car is running with out the clutch pressed in I can run through all the gears shift with ease it's like the clutch is pressed in but it's not
I've tried dropping the tranny and checking the pressure plate the clutch disc throw out bearing pilot bearing all good and installed right I rebleed the system then I removed the slave to see if it was in the hydroelectric system and still no change what am I missing.
Ford - Mountaineer :: Cooling Fan Clutch Never Seems To Disengage
The cooling fan clutch never seems to disengage so I was wondering where can i find a clutch that is light duty so it will disengage easy and work with gas mileage napa list two different ones, maybe off a different vehicle....
View 3 RepliesFord - Explorer :: 1997 - Clutch Won't Disengage
Ok so I have a 97 Ford Explorer 5-speed manual transmission. When I start the truck up in first gear, with my clutch pedal fully depressed, the truck goes forward as if im not pressing the clutch pedal down at all. And if I start the truck up in neutral, with the clutch pedal fully depressed, I cannot get into any gear. There are no leaks anywhere and there is plenty of fluid in the reservoir. What the problem may be or where i might wanna start looking?
View 1 RepliesFord Transmission :: 2000 4X4 - Clutch Won't Disengage
2000 ranger, 4.0L 5spd 4x4
Recently my buddy's 2000 ranger's clutch stopped working, it wouldnt disengage. I checked the reservoir and it was empty, checked below and between the bellhousing and engine was soaked. I filled the reservoir up and attempted to bleed the system with my vacuum bleeder and it barely got any fluid out. Ordered a new slave cyl and just put it in today. You could see how wet the old one was when I took it out.
So today when I finished installing everything, I filled the reservoir and bled the system, lots of fluid coming through, everything seemed good, however the clutch still feels extremely light, and won't disengage. I looked at it through the inspection cover and there is maybe a 1/4" of movement total. I don't get why this thing is not working! How can you tell is the clutch master cylinder is bad?
Sonata NF (2006-10) :: AirCon Stop Working / Compressor Won't Turn On
I have an 06 Sonata 4Cyl
My air conditioner has decided to stop working. The compressor wont turn on. This has happened in the past a handful of times but it has always come back either after changing my cabin air filter or just by itself after a few minutes. So far its been 24 hours and it still doesn't work.
From reading online, I'm thinking one thing to check is the Evaporator Temperature Sensor. It seems like that could explain the behavior in the past..
In the manual, it says "Pull out out the passenger's crash pad center low cover". Where is this?
After watching this video: [URL] .... I thought I knew where it was, but when I look in that location, I don't see any connectors.
Santa Fe (CM - 2007-12) :: Clutch Does Not Seem To Disengage Until Very Close To The Floor
I picked up my Santa Fe yesterday. 7 seater Premium manual.
However the clutch does not seem to disengage until very close to the floor almost to the extent that I feel the gears crunch and r a little notchy in use because of this ???
Is this a characteristic of the manual gearbox for the new model ???
Chevrolet - S-10 :: 1997 - While Disengage The Clutch RPMs Rev Out Of Control
I have a 1997b Chevy S10 ZR2. When I disengage the clutch the RPMs rev out of control, I shut the truck off and restart it, sometimes this works till the next shift. It used to be only when I would come to a complete stop now it is every time I shift... I have my 1 year old granddaughter and this is unsafe to drive with her and I am at a loss... replaced complete clutch assembly just a year ago and as it is when disengaged not clutch??
View 11 Replies