Ford A/C :: 1999 - New Blend Door Actuator Won't Working?
I have a 99 EB Expedition 5.4 with EATC climate control. I replaced the heater core that had been leaking severely. When I got the dash back on I adjusted the controls with the engine running while watching the blend door actuator under the dash. it moved but not as much as I thought it should. So I drilled an "inspection" hole behind the glove box and into the plenum cover. I watched the blend door open and close when the hot/cold buttons were adjusted, but the movement was intermittent.
I'd checked the blend door for cracks prior to installing the heater core and found none. I left things alone for a day while I drove as normal. When I had time to work on it again, the actuator quit working. I figured it was damaged from the coolant leaking into the cab so I decided to replace it. It was indeed full of coolant. I bought a Dorman actuator (part #604-216) and plugged it into the wiring harness to test it before installing it. I adjusted the controls with the ignition in the "run" position and nothing happened. I'm at a loss as to what could be the problem. I've searched for this problem, but the only threads I find are incomplete or deal with the "manual" controls. I checked all my fuses and they are all good.
My questions are:
Could I have bought the wrong actuator? Would the harness fit the "manual" actuator? The part number was identified as being for the main blend door for "automatic" controls. Is there a possibility the EATC head unit is bad? It still sends air to the panel, floor and defrost when adjusted.
How do I test the voltage at the connector? I just bought a multimeter but I'm not sure which wires in the harness deliver power to the actuator. I know there are a lot of people on this site who've gone through the heater core/blend door ordeal and have lived to tell about it. What I should do next.
Silverado :: 2008 - Passenger Folding Mirror Quit Working
My passenger folding mirror quit working,not sure when it happened because I hardly ever use this option but I noticed it earlier today.
View 9 RepliesC/K :: 2000 Silverado Driver Side Window Quit Working
Truck was sitting for a month, now drivers side power window has quit working. tried switching circuit breaker. can hear clicking sound in switch and lights dim but the window will not roll down. All other electrical is working fine.
View 14 RepliesFord F-150 - 1997-2003 :: 2002 - Heater Won't Working - Replace Blend Door?
Over the last few days I have read several threads about heaters not working and blend door replacement. My '02 4.6 F-150 has 250k+ miles and I've always done regular maintenance on it. With the cold front moving in I've noticed that the heater is not blowing hot air. I flushed the radiator and flushed the heater core several times to make sure the core was not clogged. I also replaced the upper radiator hose because of the "crunchy" sound when squeezed. I also replaced the thermostat. Still, the heater is not blowing hot. I assume like many others that the blend door needs to be replaced. My question is do I need to replace the door only or the door and the motor (actuator)? I guess I need to test the motor before buying a new one. I saw a video where you remove all the components on the transmission hump and can actually stick you finger in the motor opening to see if the shaft has come apart.
View 8 RepliesFord Super Duty (1999-2016) :: 2003 - Heater Blend Door Not Working?
My ex-has the electronic temp control. I've noticed there is very little difference from full hot to turned down less than 1/2 way.
(I'll convert to Fahrenheit here) Example - lowest temp setting is 60. If I am on heat, turning it from 60 to 66, gives me almost full hot. A slight difference is felt turning it to 68 and 70, but basically, 70 is full HOT. Continuing to turn it up to 88 makes zero difference.
I figured the blend door actuator might be toast, but it is in fact moving. I pulled the heater core cover off and here is what I noticed.
At 60, the blend door is fully open (correct, pulling cold air from outside) turning it to 66 the blend door almost fully closes. then the last little bit gets closed when going from 66-70. Anything hotter than 70 is of no use because mechanically it IS on full hot at 70. So basically I get full cold, or full hot, nothing in the middle. I pulled blend door actuator out, cleaned all the built-up crud around the shaft, took it apart and cleaned it, (no broken gears) no effect.
Santa FE SM (2001-06) :: 2004 - No Heat, Might Be Caused By Blend Door
My wifes 2004 Santa Fe has no heat. From what I have read, a common cause of this is the blend door. I pulled the glove box, but was unable to locate the blend door. On the parts diagram it appears to be on the bottom of the heater box. Every tutorial I have seen show it on the right side, and easily accessible.
View 16 RepliesFord Super Duty (1999-2016) :: Power Windows Not Working - Door Locks And Interior Quit Working?
Troubleshooting a problem with friend's 2000 F250. His power windows aren't working and are causing problems with his door locks and interior lights. When he tries to use his drivers side power window, his power door locks quit working. If he puts the switch to raise, the interior lights flash. From what I've read, it sounds like the GEM to me, we've inspected the wiring and it all looks good. I pulled it out today and it looks good inside, no sign of water leaks on it. If it is the gem, how much do they cost and do they require programming?
View 5 RepliesChevrolet - Silverado :: Electronics On Passenger Door Not Working
I have a 03 silverado 1500. I was putting in new speakers for the doors so I took the panels off and unhooked all the connectors.once I hooked it all up again and put it together the window,power mirror,mirror turning signal, and locks won't work for the passenger side. I can't work it with the driver side controls either. i've unhooked the battery and let it sit for an hour to reset the computer but it hasn't made any difference.
View 7 RepliesLexus SC430 :: 2002 - Navigation Door Quit Working
My navigation door quit working, tilt function also, and it's stuck open. The Nav unit works fine. Dealer is telling me thousands to replace it - but I suspect it's like the Mercedes dealer where my SL was missing a $10 clip - and they wanted to replace the dashboard... I'm hoping it can be repaired. It makes a little "ping" sound then I turn the car off, but I don't hear the door motor.
View 14 RepliesToyota - Camry :: Heat / Defrost Door Quit Working
The door in the dash wont go to defrost. It just quit today. I assume its vacuum controlled. What do i need to do to fix it? I thought about pulling the dash vent where i can reach in there n have a look but it doesnt want to come out. 1992 Toyota Camry....
View 7 RepliesFord Excursion :: 2002 - Door Locks Quit Working?
I have a 2002 excursion xlt 4x4 v10
The door locks quit working. The previous owner did the tin foil repair... I replaced the four door actuators today. Now all of the doors lock and unlock on the manual buttons. The fob doesn't work on any door.. when i try and use the door code pad, the locks go into a cycle.. the keep trying to operate by themselves. I had to disconnect the battery to get it to stop. I can't find the door lock relays. I have most of the dash out. Where these are?
Ford Aerostar :: Driver Side Door Lock Quit Working?
My drivers door lock quit working.all the others still respond to the drivers door switch.the motor works when on the bench.one of the wires has broken or lost connection. Where to check first?
View 4 RepliesVenture :: 2003 Passenger Side Power Sliding Door Quit Working
My passenger side power sliding door on my 2003 Olds Silhouette (147,000 miles) Occasionally will quit working. We can open it and close it manually and sometimes it will start working again, other times it won't work for several days and then all of a sudden it works again.
View 1 RepliesIS F (2008-2014) :: Door Sills Don't Light Up Anymore / Quit Working After Battery Replaced
The blue illuminated sills were already installed when I purchased the car...I just recently noticed that both sides don't light up anymore. I'm not sure when exactly they quit working, but i recently had my battery replaced. I checked every fuse in my car and can't find one that is blown. Is this a fuse problem? or did both sills just decide to crap out together? I checked both connections and they're solid.
View 14 RepliesFord Wiring/Electrical :: Power Windows And Door Locks Suddenly Quit Working
1997 Ford Expedition 4x4
When I push the switch for the drivers window I can hear the relay in the fuse block make a click but window doesn't move. If I push the switch for any other window (on the drivers door or any other door) no click at the relay and no window movement. I've swapped the relay with other relays in the fuse block but nothing changed.
I've tested the driver side window motor by running 12 volts directly and the motor works fine. When I press the PDL switch I hear a buzzing sound coming from the passenger floor area behind the glove box but the locks do not go up or down. I started the truck and when I put it in gear I can hear the PW relay in the fuse block clicking repeatedly. Put the truck in Park & the clicking stops.
I was told (on another forum) that the problem is most likely my GEM module. Bought a used 1 on eBay and installed it today but nothing changed.
Ford - Explorer :: 2003 - Power Door Unlock On Driver Side Quit Working
My 2003 Ford Explorer Power Door Unlock on the drivers side quit working. I can unlock the doors using the fob, unlock them from the passenger side or unlock it manually. I have replaced the Power Door Lock switch but still have the same problem.
View 2 RepliesFord Super Duty (1999-2016) :: Driver Side Rear Door Quit Working / Won't Open
Driver's side rear door quit working today - opens about an inch or so. What is the remedy?
View 7 RepliesFord A/C :: Blend Door Actuator - Clicking
What is the difference between :
Part # XF2H-19E616-FA and
Part # YL5Z-19E616-AA?
The middle numbers are the same. And they look the same? the first one is mine. Blend door actuator out of a 2000 ford windstar. Will another part # work? If the connection is the same?
Explorer :: Clicking From Under The Dash - Blend Door Stuck
Recently when I adjust the temperature, there is a clicking from under the dash. It sounds like the Blend door is stuck.
View 7 Replies