Sierra :: 1991 GMC 1500 Won't Start - Not Making A Clicking Noise
I'm working on getting my GMC seirra 1500 5.0 L running. Last fall When I was making a trip to another town, it broke down. When it broke down it smelt like plastic was burning, I was unable to figure out what the smell was.
First I though it was a bad battery connection, or that the starter had went.
I changed the Battery, made sure the cables were good. changed the starter and it still doesn't work.
I know the battery is working for sure because There is power to the lights so I can turn on the brights. There is no power to anywhere else on the dash though other then the icon that shows the brights are on.
When I try to turn the engine over, nothing happens at all. Doesn't even make a clicking noise.
Passat (B5) :: 2002 GLX Won't Start - Clicking Noise When Key Turned
Just got back from the supermarket. Unloaded groceries and my Passat wouldn't start when I went to park it. Turned the key and it just makes a clicking noise - clock and trip odometer reset themselves also. If I turn the key the car just makes a clicking noise and the lights on the dash all flash on and off.
I am going to see if it starts after being jumped in a few minutes.
Other potentially useful info - I was testing a radar detector for work the other day and it has a battery voltage meter. It was reading in the 11.0 - 11.6 volt range. Is this too low - just wondering if the alternator was not supplying a sufficient charge. Not sure how accurate these are. The battery was changed around a year ago so I'm sure it's not the battery. I am assuming starter or alternator.
Lexus GS 2006-11 :: GS300 Rapid Loud Clicking Noise When Car Turned On And Engine Won't Start
I own a 2006 GS300 for 4 years and I have about 90k miles on it. Just suddenly today when I went to go turn the car on, I hear a rapid loud clicking noise and the engine will not start. I've done some googling and one possible solution is to disconnect the battery to let the car reset and then connect it back. What the cause is? I've replaced the spark plugs a few months ago, but I didn't replace the battery.
View 13 RepliesPassat (B5) :: Clicking Noise When Start 2001 Wagon GLS V6
2001 Passat Wagon GLS v6 - 83k
Just replaced the drivers-side taillight and hood strut. Been a week or so since the vehicle has last been started as it is sitting in the garage. When I start the vehicle, it will turn over a bit, cranking away, then start clicking (pretty quickly).
If I pay careful attention while it is turning over, I can hear the door locks making some noise, kinda like they are trying to decide whether to lock or not. I will also get dash light flickering on/off. turn-turn-turn / click-click-click
I know it is not the battery. All power works fine when the key is just in the on position, no dimming, etc. Though it seems to be something electrical with the weird noises I get while trying to start.
Passat - Volkswagen :: 2001 - At Start Up Clicking / Clanking Noise?
So it only happens when I start the car, I'm thinking its the starting needing to be replace. The car starts everytime, Just when it cranks it makes a the noise, but fires up right away. The noise is gone once the car is started.
View 3 RepliesFord Excursion :: 2001 - Really Loud Clicking Noise And Won't Start
I have an 01 Excursion. I tried to start it this morning and the radio and lights came on, but all it would do is make a really loud clicking noise. If the battery was dead would the lights come on? My friend who picked me up to take me to work also told me my battery connections needed cleaned...
View 7 RepliesGMC - Sierra :: 2001 - Won't Start When The Engine Is Hot
I have a 2001 GMC Sierra with a starting problem: When you've driven it long enough for the engine to reach about 210 degrees, if you stop the truck it won't start back up until the engine has cooled down to about 200. It only does this when it's over 80 degrees outside, though.
View 5 RepliesLexus RX 2004-09 :: On Start Up With Acceleration Hear Noise Like Marble Shaking Around
2005 LEXUS RX 330 5w/30 oil. Warm weather state...
On first start up with acceleration I hear what seems to sound like a marble shaking around in my engine/transmission.. It is present when i accelerate and not when I am at a stop position.
It goes away within 2-3 minutes of driving... Timing belt and water pump has already been done. the car has almost 100k
Sonata I45 (YF - 2011+) :: Clicking Sound When Key Turned But Car Won't Start
The 2011 sonata gls won't start - i put key in, turn, lights come on but there is a clicking sound and the car won't start. Is this a battery issue?
View 28 RepliesFord F-150 - 1997-2003 :: 2001 Truck Will Not Start And Clicking Noise Coming From A Relay In Cabin Fuse Box
I am having trouble with my 2001 F-150. Starting yesterday it would not start. At 1st i thought it wa the battery, so i took it off, charged it, put it back in the truck and still no start. There is a clicking noise coming from a relay in the cabin fuse box, disconnected the battery, removed relay to inspect and everything looks good. After plugging it back in, and connecting the battery, the truck still wont start and there is a clicking sound coming from the dash near the radio. Rhis is my work vehicle!!!
View 3 RepliesCavalier :: 2004 - Clicking Noise When Heater Turned On
I've got a 2004 Cavalier and when the heater is turned on it makes a clicking noise (sounds like someone on a snare drum playing over and over again) You can feel it if you touch the bottom of the Heater/AC module on the passenger side of the car above your feet. It stops when you turn the heater control to the recirculation position.
My guess is it's the recirculation door actuator motor, but I can't find it through NAPA or any automotive parts online sites, what the Chevy part number is for this, and/or a parts blowup of the HVAC module? Also, the factory service manual I've got says that the entire HVAC unit needs to be drained of 134 and removed from the vehicle to replace this actuator, does it can be done without removing the entire unit? From the few pictures it shows of where the actuator is, that part appears to be near the top (that's why I'd like to see a parts blowup if possible).
Golf IV R32 :: Clicking Noise After Turn Signal Turned Off
So the other day driving to work i was driving my car to work, i put my turn signal on and after i turn it off it still kept doing the clicking noise. At first i thought i was just hearing stuff cause it was early and i was tired, so after work i checked it out again i sure enough it was doing it. It even does it sometimes without even first putting the turn signal on. My buddy and i thought it was a relay or a fuse. Is that right?
View 7 RepliesPassat (B5) :: 2002 GLS Will Not Start - Loud Clicking Sound When Ignition Turned On
I have a 2002 Passat GLS and when I tried to start my car this morning, it would not start. When I turn on the ignition, the car gives off a loud clicking sound. The interior and exterior light works, the panel light works, and the radio works as well. What might be the problem?
View 4 RepliesTrailBlazer :: 2002 - Loud Clicking Noise When Rear AC Turned On
I Have a 2002 Trailblazer and when i turn on the rear A/C there is a loud clicking sound coming from the back of the truck. It is on the passenger side up by the interior light in the third row. If i turn off the Rear A/C or turn the knob and have both the overhead and the feet blow out it does not click.
View 3 RepliesBatteries :: Rapid Clicking Noise - Lights Flashing When Turned Off
Went to go turn on my car today and it made a rapid clicking noise. When I turned it off and locked it, the lights keep flashing on and off...
View 4 RepliesCamry :: 2008 - Clicking Noise When Turned Left / Need Replacement Of Hub And Bearing
I have an '08 Camry LE 4cyl with 80,000 miles.
I was hearing a clicking noise when I turned left. Which I thought was the CV joint, but turned out to be worn struts. Then I began hearing a roaring sound from the front end. I replaced the struts & that fixed the clicking sound but not the roaring. So I thought maybe it just needed an alignment. I took it to dealer After fixing that one they call & say right one was so loud they couldn't hear that left one was roaring too. So they say I need to replace that hub & bearing also.
Are these issues happening very prematurely? What could have caused these problems?
GMC - Sierra :: 2007 - Engine Hot AC Turned Off Warning
I have a 2007 model, new body style Sierra wt, that has a 4.3 v6, it has 62000. miles, and it has been giving me a (enjine hot a/c turned off warning) and will not let the ac work,
This problem is not a true over heating issue and is happening intermittently, even on a cold start it will sometimes give me this error message and when this is happening it will not register the temp on the gauge, but will activate the electric fans.
I am thinking this is a short at some point or a loose connector but where to look.
Ford Super Duty (1999-2016) :: Rapid Clicking Type Of Noise Out Of Vents When AC Is Turned On
So my truck is making a rapid clicking type of noise out of the vents when the ac is turned on.
The noise sounds like a thin piece of paper getting hit by a fan (that's what I hear) It started during this past winter when I would cold start the truck. but as the heater warmed up it went away completely. well now since its warm out I am running the ac now, and it blows cold but doesn't have a lot of volume to it it seems. but being the problem was when the truck was cold running the cold ac makes the noise permanent.
The blend door acutator is working as should (i can only assume the blend door is ok) the vacuum lines are good and vacuum signal is good.
Gmc - Sierra :: 1991 - Only Runs When Steering Wheel Is Turned To Left / Right
I just bought this nicely used 1991 GMC Sierra 1500 series pickup truck for $650. It started up and ran fine when I gave the seller the money - the few leaks in the break lines.
Easy fix right!
So my son (19 that knows it all) and I went and changed all the brake lines (made everything one size 3/8 line.) Filled it up with break fluid and started the truck. I had my so pumping the breaks and holding them (his first time) I bled the far rear (passenger side) then I had him turn the steering wheel to the right so I could bleed the front driver side.
He turned, and turned and turned until the engine died.
Now the truck only runs when the steering wheel is turned all the way to the right or all the way to the left.
Going to pull the codes to see what the heck is going on....