Ford Ranger / B-Series :: 1994 Truck Will Shut Off When Slowing Down And Push On The Clutch
I have a 1994 Ford Ranger Supercab with 180,000 miles, 4.0ltr 6cyl and it is in relatively good condition. When I bought the truck the check engine light was on. The previous owner said that it was something in the gas tank that has gone bad but it was not a big deal and the truck could be driven with no problems.
My mechanics have tried several times to read the error code but their diagnostic tool won't tell them what is wrong.
I have noticed over the past few days that when I am slowing down and riding the clutch (I was making a u-turn this morning) that the truck will shut off. It starts right back up but it keeps happening.
I have been considering replacing the IAC, new spark plugs, rotor and wires and fuel filter but I am not 100% this will fix my problem. I am NOT a mechanic but know plenty of them so it will be a situation where I buy the parts and a buddy puts them in.
Golf IV / Jetta IV :: Grinding / Knocking When Turn And Occasionally Make Bong Sound When Reversing
My 2003 Jetta GLI was making a terrible grinding/knocking noise when i would turn and occasionally make this "Bong" sound especially when reversing. I took it to my local shop and they say my spring in the front left is "either broken or unattached" and that i need spings/struts. I have like 150k miles on this car so the timing is probably right. So my question is, how much should they charge for this? Also, what should i have them order and install? Im not trying to lower or anything like that, OEM or a slight upgrade is what im looking for....
View 9 RepliesFord - Ranger :: 1994 - Slight Knocking Sound From Engine Rod?
I've been noticing that my 1994 Ford Ranger 2.3L, 4 banger has a slight knocking sound. It is really faint compared to any other rod knock I have heard. An engine compression test shows mid 140's on all cylinders except one of them which is at 125. I'm guessing it isn't receiving enough oil. Can I prevent catastrophe by fixing this early on before a rebuild or replacement has to happen?
View 19 RepliesJeep - Cherokee :: 2004 - Transmission Started To Make A Clicking Sound
I have a 2004 Jeep Grand Cherokee with about 105,000 miles. The transmission (or transfer case) recently started to make a clicking sound. It usually happens in 2 wheel drive mode and gets louder as the car warms up. the clicking sound occurs in all gears except park. It also gets faster with car speed. If the car is put into 4 wheel (full time) mode the sound seems to go away or is not as audible. When you shift back in 2 wheel drive mode the clicking sound comes back.
View 1 RepliesLexus RX 2004-09 :: RX400h Transmission / Engine Make Low Groaning Sound And Very Rough
Between about 20-30mph, on light throttle the engine/transmission of my 2006 RX400h makes a low groaning sound, sending a vibration through to the cabin. The engine just seems to be very rough at this speeds, like the engine is labouring. After exactly 30mph, everything is very smooth. It is also very smooth when running in EV mode at any speed.
The harshness/vibration only comes on when accelerating, so have ruled out tyres etc. The mileage is 85,000, and it has had a recent major service at a Lexus dealer. I use premium fuel.
The Lexus dealer had a look at the car for 1 hour and inspected the exhaust, engine mountings etc. but could find no faults. I went on a test drive with the service technician and he did notice the vibration.
Elantra MD (2010-15) :: Transmission Seems To Give A Jolt / Make A Clicking Sound When Downshifting
I have a 2011 Hyundai Elantra GLS... Few months back I refueled my tank with degraded fuel (of course i did not know about it and some refueling stations in our country mix oils) and the problems started to arise with my car.. initially it all started with jerks and cracking sounds from the engine.. I then took it to the dealership and cleaned everything except the injectors but the jerking and cracking problem was solved.. but it still had a pickup problem.. whenever i tried to accelerate from 40km/h to above, the transmission seems to give a jolt make a clicking sound when downshifting.. and the acceleration compared to before has degraded.. I took it to the dealership again and their answer was drive it for 300 km more everything will b fine.. but i have driven the car for 1000 km more but the problem is not solving.. I don't know.. my warranty period is over.. in our country they only provide for 12000 km or 1 yr warranty.. now i have checked online and it seems Elantra transmission has bugged a lot of ppl..
View 19 RepliesSierra :: 2002 - Alternator Started To Make Some Noise And Battery Light Flashing
I have a 2002 with a 4.8 ... My alternator started to make some noise, and my battery wasn't holding a charge very well so i decided to change the alternator today before it went some were out in the boonies. After i put the new alternator in, the battery light started flashing in the "message center" but everything seems to be running fine. The voltage gauge in the dash is reading about 15. So from there I turned everything on in the truck and the gauge barely dropped. At this point I'm not sure what to do, I'm going to put the old one back on and see if it goes out, oh I also put some tension on the belt to make sure it wasn't slipping.
View 3 RepliesGMC - Sierra :: 1994 - Tuning Up - What To Change
I have a 94' sierra with a 350 cubic inch TBI. I've already replaced the thermostat, spark plugs, clutch and had the oil changed. when I bought it it looked like the plug wires and distributor cap had already been replaced recently. the big question is, other than replacing the air filter (which doesn't look like its in to bad of shape) what else should I look at doing to tune it up a bit? this is my daily driver/work/scrap hauling truck so I want to keep it running well and for a long time. there was a small metal hose that ran from my intake to the heat shield around my exhaust that got mangled pretty bad and just removed, what was it for and is it worth the expense to replace it? also I've seen ads for throttle body spacers, are they worth it? and would I need to make any changes to the ECU at all if I put one on or even put performance headers on it?
View 13 RepliesFord 6.0L Power Stroke Diesel :: When Sitting At Idle In Park And Truck Starts Knocking / Horrific Sound
So was sitting at an idle in park and truck starts knocking, horrific sound. So shut checked oil, good, went to work came out 8 hours later, started up still knocked. Pulled into drive hit the pedal, knock went away, stopped at red light, knock came back...... Truck has been parked for 3 days, still knocks at an idle but soon as tap the pedal and give fuel it goes away... Tried unplugging injectors one at a time to eliminate, still had knock.
2003 auto, 4wd, studded,deleted, coolant filter, sct with innovative tunes 108,000 miles.
Volvo :: 1994 940 Turbo Won't Rev Up Past 2500 Rpm In Drive
I have a 1994 volvo 940 turbo, the transmission has been fine, but today out of nowhere the car will not rev past 2500rpm. But only when its in drive, if i drop it to 1st or 2nd it will rev fine?
View 1 RepliesSierra :: 1994 GMC Running Rough - Surging / Dies
I have a 1994 gmc sierra 4x4 5.7 with a rebuilt engine 2 yrs ago and it has started having a rough idle(surging/dies) I have replaced fuel pump, fuel filter, maf sensor, iac sensor, tps sensor, top half of the tb and injectors, distributor, ignition module, plugs and plug wires and still no change. Yesterday I cleaned the iac and seemed to straighten up a little but then got in it to go to work today and it was back to running rough again and seemed worse. I am at a loss.
View 4 RepliesGmc - Sierra :: 1994 - Driver Side Track On The Bottom Of The Window Rusted Out?
The driver side track on the bottom of the window has rusted out on my 1994 GMC Sierra pickup. Every place I've talked to that is supposed to handle glass repairs either doesn't fix this kind of thing or just plain doesn't want to attempt to fix it. The only advice one place would offer is to buy a new window with a good track on it, but how to get the old one out without breaking it or putting a new one in. I know they sell just the track for these windows, but I don't know how to remove the old one without breaking the glass.
View 24 RepliesVolkswagen - Routan :: 2010 - Knocking Metal Noise When Slowing Down
We recently purchased a (used) 2010 Volkswagen Routan with approximately 40k miles. Almost immediately we noticed a loud noise whenever we began to slow down in city traffic. The noise is loudest after the car has been driven for a while. It sounds like metal knocking around. The dealership claims the brake pads are causing this noise. They said the pads are perfectly good but are two different brands and this is what is causing the sound. I do not believe brake pads would continue to make this noise after 3 months if they were good. I am also not convinced it is the brake pads at all.
View 1 RepliesFord Exhaust System :: 1994 Ranger - Loud Exhaust Sound In / Outside The Truck And At Idle
I have a 94 ranger 4L. I am looking for a more loud exhaust sound in/outside the truck and at idle. I have had a cherry bomb turbo on it and it was ok but not loud enough for my liking. I just picked up a flowmaster 40 2 days ago and it sounds good but again just not loud enough for my taste and kinda a lot more. I was looking for a louder muffler that is not a glasspack and would like to stay under like 80 or so.
I also thought about getting a high flow cat which i think might make some more sound but was not sure. Im running the stock pipe which is 2" and end in back of the wheel on the right. I look at the Hooker Headers Maximum Flow Muffler which i thought would be louder b/c it's more straight through the muffler so it would put off more sound better. What would u recommend for something more loud ?
Passat (B5) :: 2002 - Clicking / Knocking Noise When Make Turns
I've been hearing a clicking/knocking noise when i make turns recently and was wondering if it could just be hums in need of replacement... I have a 2002 Passat, so I think its a bit early for it to go but ya never know. If they are the hubs, what causes them to wear out so quick and around how much they'd be to replace (in parts...labor varies). The noise is only when I turn, no noise at all when driving straight.
View 2 RepliesSubaru - Forester :: Knocking Noise When Make Slow And Sharp Turns
I have a 2010 Subaru Forester and it has started to make a weird noise when I make slow and sharp turns, like when I am pulling out of a driveway or entering a parking spot. It is not exactly a knocking noise, it is similar to the one when a small piece of rock is stuck on the tire threads, but it is in the center of the car.
View 3 RepliesChevrolet - 2500 :: When Trying To Start Truck Will Just Crank Over As If It Is Not Getting Gas
I have a 1998 Chevy K2500 with a 350 engine. 220,000 miles. It starts fine when cold and drives fine. My problem is when I shut the engine off say to get gas or run into a store. When I return to start the truck it will just crank over as if it is not getting gas. If I pump the gas pedal it will fire up after a bit. It will start to stall if I put it into drive but will recover if I continue to pump the throttle. Once I am under way it drives fine until I make another stop. The check engine light is not on.
View 6 RepliesSierra :: 1999 GMC / 2WD - Truck Headlights Cut Off While Driving
1999 GMC Sierra - 2wd
Truck belongs to a co-workers son so I might not have all the info I need. Just within the last couple of days - he's driving at night and the headlights cut off. Pulls over and waits a bit - restarts - lights work for 1/2-1 mile then cut off again. He has changed the headlight relay switch.
No DRL but does have automatic headlights. First noted this Tuesday night and the weather since Tuesday has been either rainy or foggy. He had higher intensity "blue" bulbs installed but has swapped them to regular bulbs and the problem continues.
Sierra :: 1992 GMC Truck Fuel Pump Went Out
I have a 1992 GMC step side, short bed, 350 engine, Sierra, auto trans, factory air, factory exhaust, power steering.......
Three years ago the fuel pump went out. I have to work alone so I lowered the tank after draining and went through a lot of agony with floor jacks, supports, etc. but finally got the job done in 3 days.
The replacement was a Bosch fuel pump.
It went out today while I was at Sams stores. I got a pull home and it is in my driveway.
It started up once I got it home, but that is what it did the last time it went out, 3 years ago.
Question...should I check the ground first to make sure it is not getting intermittant ground or just do the job with a new pump?
Also, can I do this job by raising or sliding the bed after I unbolt it? I have heard war stories but no actual person that has done it.
Also, when moving the bed either up or sliding it back, isn't there a concern about wires that go to the tail lights?
I cannot afford the 500 dollar shop fee to have it towed and fixed.