Golf V R32 :: Squeaking Noise By Right Rear Quarter Panel Inside Cabin
I am hearing a squeaking noise by my right rear quarter panel inside the cabin. How to safely remove the panel. I tried searching but the instructions were vague.
View 3 RepliesGolf/GTI VI :: 2012 / 2.5L - Rear Quarter Panel Access For Dent Repair?
getting access to the back of the rear quarter panel for paintless dent repair? This is for a 2 door 2012 Golf 2.5L.
I've heard from a few people that there's likely some sort of access point for this car but I haven't gotten any specifics. I'd rather not have the PDR guy drill a hole in the wheel well for the needed access.
I do see what looks like factory hole with rubber cover behind where the door closes (lower part) ..
Here's the location of the dent (dent itself is not visible at this resolution, but it's right at the point of the crease):
Prius (2010-12) :: Removing Interior Trim On Rear Quarter Panel?
How to remove the interior trim on the rear quarter panel?
View 1 RepliesFord - Explorer :: 2008 - Gasoline Smell Around The Driver Rear Quarter-panel
2008 Ford Explorer with 100,000 miles on it. My wife's car, and the last couple of times I've driven it I get a whiff of gasoline every now and then. I've looked at the engine and underneath the vehicle and have found no visible signs of a leak. Last night I walked by the car and smelled gasoline around the driver's rear quarter-panel. That is the opposite side of the fuel tank filler tube but it makes me think it could be fuel tank related. Where to start looking? Maybe a pin-hole in a line somewhere? Fuel filter? Fuel pump?
View 3 RepliesFord Excursion :: 2001 - Rear Vent Quarter Panel Windows Stuck Open
I have 2001 EX with the 7.3 and my rear vent windows stuck open and I am stumped as to what might be the culprit. There isn't any power getting to the switches in the overhead console.
I replaced the relay 204 in the engine compartment, I believe that is the correct one.
Where the actual fuse is located for this and its number? Because both of them are stuck open not just one side.
Passat (B7) :: 2013 - Crunching Noise When Turning Left
As the title suggests, I am getting a crunching noise when I turn left on my 2013 Passat SE. It sometimes occurs when turning right also, but doesn't happen as often as turning left. Hard to describe it any other way. What could be causing this noise?
View 9 RepliesPhaeton :: Crunching Noise When Rear Driver Window Go Up
I was putting my rear driver window up yesterday, and I hear a crunching noise.....it struggled, but I was able to get it back up. What should I do? I'm thinking it's the regulator, or a clip came off of the window, etc.
View 11 RepliesSanta Fe (DM - 2013+) :: Squeaking Noise From Rear End - Suspension?
Rear end Suspension noise, '13 Santa Fe Sport 2.0T? I purchased a new '13 Santa Fe Sport 2.0T in Sept. 2013. Shortly after I noticed the rear end of the car creaks/squeaks when the suspension compresses thru it's travel. This happens when driving over tall speed bumps at 2-3mph or into/out of steep driveways at 2-3mph. Rear end noise/squeak at anytime?
View 49 RepliesFord 6.7L Power Stroke Diesel :: Tailgate Rubbing On Right Quarter Panel
I just identified an annoying squeak as the right side of the tailgate, right at the hinge, rubbing on the section of the rear passenger side quarter panel (one with FX4 decal) where it curls around to the rear. Any way to easily adjust the tailgate slightly to the drivers side? When the tailgate is up, the gap is noticeably smaller on the passenger side, and when down, the edge of the tailgate rubs the edge of the quarter panel, paint to paint.
View 1 RepliesSanta Fe (DM - 2013+) :: Rubbing And Popping Noise From The Rear Of Vehicle
I have had my Santa Fe since middle of January and have some issues with rubbing noises and popping noises from the rear of the vehicle since then. The rubbing noise has been resolved, but the popping noise appears to be more of a challenge. I have had the vehicle looked at 4 times.
The way the mechanic at the dealership explained it to me is that between the outer body panel and the inner trim panel there is a piece of sheet metal that is flexing and popping. This is most noticeable at low rates of speed and more when turning left or right.
The past two times the dealer has reposition the pieces and the noise has went way for a few days, but always returns. So today I asked if maybe there was a wield missing or what we do if the problem continues after the latest fix.
One suggestion was to fill the gap between the sheet metal and the body panel. They mentioned foam or cardboard.
Toyota - Corolla :: 2008 - Rust Spots On Back Quarter Panel In Front Of Wheel Well
I just noticed 2 rust spots on the back quarter panel in front of the wheel well on my Corolla. Then I looked on the other side, and found rust in the exact same spot. It looks like the rust is near some bolts that are holding on (what looks like) a small plastic mud flap (I'm not really sure if that is the correct technical name). Anyway, is that normal to have rust in the same spot on both sides, or is it defective? This is the only car I've ever purchased new so I was planning on keeping it, like, FOREVER. I think I've taken pretty good care of it so I plan to have it fixed. Just wondering if I should bring it to Toyota.
View 15 RepliesSanta Fe (DM - 2013+) :: Wheel Bearing Type Noise Coming From Rear And Gets Louder As Go Faster
I just bought a used hyundai santa fe sport 2.0t. i noticed it is fairly loud inside compared to my 2011 sonata. I don't know if im hearing tire noise or maybe a wheel bearing type noise. It's coming from the rear and gets louder as I go faster. I'll admit O am paranoid and probably making this sound worse than it is.
View 12 RepliesSanta Fe (DM - 2013+) :: Grinding Noise Coming From Rear Of Vehicle On Sharp Turns Under Moderate Acceleration
I own a Canadian 2013 Santa Fe sport AWD 2.0l turbo. Back in June/ July 2015 I noticed a poping / grinding noise coming from the rear of the vehicle when ever I made sharp turns under moderate acceleration. I brought my car into the dealer as it was still under warranty. They diagnosed the problem to be my viscous coupler apparently it was defective.
The part was ordered and replaced about 3 weeks later. After the warranty work was completed in still noticed a noise coming from the back end. I took my car back to the dealer. They found that the rear tires were "cupped" they recommended to get a 4 wheel alignment to solve the cupping issue.
In my past experiences tire cupping is usually caused by a worn out suspension component such as bad shocks. So to avoid conflict of interest I took my car to Canadian Tire to get the alignment checked and adjusted.
Sure enough the front wheels only were slightly out of alignment and a minor adjustment was made. No adjustments made to the rear. The technician advised me that due to the minor adjustment, the alignment would not cause my rear wheels to cup. The complete suspension was checked and no problems were found.
So...would a bad viscous coupler cause wheel cupping???
My Santa Fe had 48000kms at the time of the original noise was detected.
I do not tow a trailer or haul overloaded loads.
The majority of kilometres made Is done on highway.
The rear tires have now been rotated to the front.
Santa FE SM (2001-06) :: Gas Level Stuck In The 1st Quarter
I have a santa fe 2002 2.7 gls 4X4 automatic. I put today for the 1st time supreme gaz and the level of the gas stuck in the 1st quarter even if i turn the engine off...
View 1 RepliesSanta FE SM (2001-06) :: Fuel Light Will Come On With Quarter Tank Of Gas
Here is my problem I own a 2006 2.7l santa fe and I will be sitting there with a quarter tank of gas I then my gas light will come on I will look and I am outta gas then it will go back to a quarter, I am noticing it more often.
View 2 RepliesSanta Fe (CM - 2007-12) :: Cranking Time With Fuel Below Last Quarter
I am having this issue if it's one. With the fuel level below last quarter, I'm having the time of starting the engine longer (cranking time). I tried several times, leaving the fuel level reach the last quarter, with same result. Reaching that level of fuel the problem appears.
Another issue is that sometimes when the day is hot and the fuel level is not necessary below quarter, the starting time is longer too. It's a Santa Fe AWD 2.4L Automatic.
Santa Fe (CM - 2007-12) :: Hand Brake Not Releasing / Crunching Sound?
I've got a 2011 santer fe auto with a foot hand brake. i park the car on my drive which is on a slight incline, when i put it in reverse and then release the hand brake there is a crunching sound and the rear offside wheel locks. It eventually releases after a number of revolutions but it sounds very mechanical clunky.
View 5 RepliesSanta Fe (CM - 2007-12) :: Climate Controls Won't Change - Gurgling Noise Behind Panel As Mechanism Switched
2008 base model. A couple of years ago, I noticed whenever I changed my climate controls to defrost or bi-level, there was a 'gurgling' noise coming from behind the panel as the mechanism switched. Several months ago, the gurgling stopped as did the ability for me to change where the fans vents. Right now it is stuck on bi-level. something similar happened in a work truck the other day and I easily traced it to a small tube that had detached from a plug. I am wondering if the climate controls in the Santa Fe are also vacuum controlled and, if so, where might I find this tube?
View 2 RepliesTiguan :: Rear Door Panel Making Creaking Noise
My rear door panel has been creaking ever since I got the car. The creaking noise seems to get worse every day. Ca a dealer will be able to isolate the noise and gent it fixed. Scheduled an appointment already for next Friday.
View 6 Replies