Subaru - Outback :: Dies Out While Stopping Or Coming To Stop And When Idling
My Subaru Outback is dying on me when I come to a stop and has happened when just idling. I have been told it is the torque converter and replacement is 2 thousand.
View 7 RepliesSanta Fe (CM - 2007-12) :: Whine Coming Up From Below The Gear Stick
Whine that I am getting coming up from below the gear stick ,is certainly seems that it is a noisy bearing as noise stops when car does so I think it may be the bearing mounted in the rear of the casing/gearbox just in front of the rubber coupling but the dealer cant seem to find it in his parts list.
View 1 RepliesCivic - Honda :: 1991 - Idling Roughly / Dies Intermittently While Approaching To Stop
In the Car Talk column on 1/3/2016, it sounds like Lynnette's 1991 Honda Civic wagon was experiencing very similar symptoms to my wife's 2001 Honda Odyssey (189,000 mi) a few months ago. Rough idle, engine almost dies sometimes at stops, groans during acceleration. Additionally, accelerating between 40-60 mph our Honda would feel like it was "loading up," running rich or in the wrong gear climbing hills. I replaced the idle air control valve, which fixed the rough idle but not the other symptoms. Turned out I needed to reset (power cycle) the ECM and go through a curb idle/rev warm-up procedure so it would relearn the throttle position sensor's operating range after replacing the IAC valve. I disconnected the battery, removed and reinserted the hazard fuse, then reconnected the battery. Then from a cold start held the throttle at 3000 rpm until the engine warmed up to normal or the electric fans kicked on. Since then it's back to smooth, strong acceleration we expect from the Honda we love.
View 1 RepliesFord F-150 (2004-2008) :: Dies While Coming To Stop?
I have a 2004 F150 5.4 Triton. When coming to a stop the truck starts a rough idle then dies like it ran out of fuel. The tank is full. It is an intermittent problem but is getting slightly worse. It mostly happens after reaching operating temperature. Also there is the dreaded ticking sound once the problem start. Brought it to the dealership and after they had it for four days they said it stalled once and recommended replacing the motor! They could not answer the question as to why to replace the motor. No codes or warning lights are coming on when it dies.
View 2 RepliesFord F-150 - 1997-2003 :: Truck Dies At Stop While In Gear - Code P0443
I have a 1997 Ford F-150 with the 4.6L auto trans 189,000 miles
Ok.. there was no problems until the other day when I unplugged the positive side of the battery to replace it's clamp. I Put the new one on and drove to the store but when I came to a stop, the rpm's dropped to 0 and the truck died. I restarted it and every time I would come to a stop it would die unless I give it a little gas also if I start the truck and leave it in park it idles fine until I give it some gas then let off.. the idle drops and dies! If I give it a little steady gas the idle will return to normal.
The check engine light works fine but never once lit up because of this problem! I used a code scanner and if the truck was off and the key forward, it would have no codes. With it running it had the code P0443. I found and replaced a blown fuse and still have the same problem but it reads no codes at anytime. I checked all the vacuum hoses and there seems to be no leaks and the mass airflow sensor looks clean. I have allot of miles but it has been taken care of well and has had a ton of parts replaced over the last few years.
I am wondering why this happened out of the blue and If there is something I am missing that I should be looking at. I don't want to replace the purge control valve if thats not the problem.
Ford Transmission :: 1992 - Dies While Coming To Stop - Disconnect TCC Circuit?
I have a quick torque converter question. I have a '92 F-250, 351W, E4OD. When I come to a stop the engine dies. I know it is the torque converter clutch staying engaged. I do have a TCC code stored. I'm wondering if there is a way to disconnect the TCC so it never goes into lock-up, since it only seems to happen after I've reached higher speeds and it goes into lock-up. I thought maybe a wire from the PCM to disconnect? I have All-data access, but it doesn't have wiring diagrams for the trans. Which wire, color and pin number, and if this will work? I know it's not the proper repair, but I have $17 into this truck, it's pretty rotted, and I'm just looking to get by until spring. I don't drive much, but occasionally I need to get somewhere.
View 14 RepliesSanta FE SM (2001-06) :: Steering Wheel Vibration In Park Or When In Gear But Idling?
Would bad harmonic dampener cause vibration when in park or when in gear but idling? Highway speeds no vibration..
View 2 RepliesPontiac - Grandam :: 1995 - Idling High While Driving And Coming To A Stop
My car is idling high while driving and when coming to a stop. I do not have a rpm meter so i don't know what my rpms are reading. What could be the problem?
View 1 RepliesCamry :: 2007 XLE - Idling Too Low After Plug Change / AC Is Not Working At A Stop
I have a 4-cyl 2007 Camry XLE. I changed out the plugs, simple enough. but now the car seems to be idling too low, just a tick below 500 RPM. Its causing some minor vibrations as also the AC is not working at a stop, it just blow warm air. As soon as i push on the gas the RPM jerk up pretty sudden, the air pressure from the vents increases and its cooler. So it seems the AC issues is related to the RPM being too low so once i get the RPM's back up it should be good to go.
These are the stock Denzo SK20R11 plugs that were in the car : [URL] ....
And these are the equivalent NGK IFR6T11 plugs i put in [URL] .....
So, I thought maybe because the ECU got reset maybe some re-calibration, but I have driven a good 100 miles on it and no change so i doubt that's it.
Santa Fe (CM - 2007-12) :: Vibration Hum Noise Comes And Goes When Idling
i have a 2.2 crdi 2009 santa fe and when my foots off the gas pedal it has this strange vibrating hum noise that comes and goes - it doesn't matter if its in Park or Neutral.
You can only hear it inside the cab so im thinking maybe its something up against the firewall but i can't see what?
Santa Fe (CM - 2007-12) :: Engine Would Jump Around Between 200 - 800 Rpm When Idling
I have a 2009 with 45,000 miles. It has been idling goofy for a while. Last winter when it was cold it the engine when first started would jump around between 200 - 800rpm when idling. I went and had the fuel system cleaned. It wasn't noticeable when it was warm out and it did not jump around as dramatically on cold starts. Lately it started bouncing on every start from 400rpm-800rpm. It drives fine, just idles bouncy. The other night it lost power while driving. The engine was running but when the accelerator was pushed it would not speed up. It was limping along at 20mph and the engine light on the dash turned on. After sitting for little bit, the engine light was off and drove normally again. I have an apt. for the dealer to look at it next week, but of course I will not be able to recreate the event and there are no error codes.
View 1 RepliesSanta Fe (CM - 2007-12) :: 2010 - Idling Much Rougher
I have a 2010 Santa Fe 2.2 crdi auto with 67k on the clock. It's hard to explain but recently the car is idling much deeper than usual, that typical diesel everything vibrating feel when sat at lights. Its fine when I'm on the move but once i drop below 1000rev and more so when in Drive, not as bad in Neutral. I went over a speed bump the other day and i can swear i felt something change when i went over the bump.
View 2 RepliesSanta Fe (CM - 2007-12) :: Engine Dies While Driving And When Stopped
I bought my 2007 Santa Fe with 112,000 miles in April. It ran fine until about a month ago. When I turned the key to aux, the radio and lights came on but when I tried to start it I lost all power. Turning the key off and back on had no effect, it acted like the battery was dead. I opened the hood and noticed the pos cable was loose on the terminal. As soon as I touched it I heard a click, the security light started blinking and it started fine.
A week later as I was driving on the highway the electricity started blinking in and out and the car would shutter as it lost and regained power, then eventually died completely but the radio was still on. I got to the shoulder and tried to turn it back on but even though the radio and lights worked, nothing happened when I tried to start it. I lodged a matchstick between the pos terminal and the cable to make sure the connection was tight and it started. Driving home the power would occasionally stutter when I hit a bump but it never died completely.
I used a battery and alternator tester that plugs into the cigarette lighter and both registered as fine. I've driven it to work, about 2 miles, several times since and the power sometimes cuts out at bumpy parts of the road and it has died completely twice while sitting still at a light. The clock doesn't reset when it dies so, knowing nothing about electrical systems, I would guess that the electricity isn't being entirely lost. Every time it dies the radio and lights still come on but I have to get out and jiggle the pos cable to get it to restart. While driving the battery and seat belt lights flash randomly. A friend told me to try removing the pos cable while it's running and that if it died, it was probably the alternator. Tried it and the engine died immediately. Don't know what this means since the alternator tested fine.
Santa Fe (CM - 2007-12) :: Whining Noise Inside The Cab And Idling Low
My santa fe was driving down the street and then it bucked and stopper. The starter would not turn over, nothing. New battery last weekend. Charged it up and the thing started. Even ran with the negative off the battery. It makes a whining noise inside the cab, and idling. Is the altn. going?
View 5 RepliesSanta Fe (CM - 2007-12) :: After Start Up Idling And Stalls - RPM Drops
I have a 2009 Santa fe 3.3L V6 (live Montreal, Canada), since the past week when I start it up, I've noticed that after 1 minute or so while the it is idling my rpm's drop from 1000 to about 650 for split second and it seems to want to stall. The same thing happens when driving for a a small distance when ever I have to make a stop my Santa fe rpm's drop (split second) so low it seems to want to stall. Could it be related to Throttle Sensor Position?
View 2 RepliesSanta Fe (CM - 2007-12) :: Erratic Knocking / Clicking Sound When Idling
My 2007 Hyundia Santa Fe has an erratic knocking/clicking sound when idling & has for about 6 months or so. Other than the clicking noise it drives just fine. I am wondering if this may be a result of a bad oil change experience I had in 2012. I'll explain ....
When driving home, once the car had warmed up, my oil pressure warning light came on whenever I came to a stop or idling. I thought this was strange but thought maybe it had to do with new oil fill & would go away.
All I knew was I didn't have the problem before the oil change - nor have I ever in all the time I have owned the car - seen the oil pressure light come on and stay on once the car is started. So I brought the car into Hyundai as soon as I could to explain the situation. They opened the oil filter compartment and quickly realized that whoever changed the filter neglected to put back a part that sits on top of the filter that regulates the oil pressure (only a $15 part without which the damage & cost of driving without is potentially huge).
There is more, but I think you get the drift. So, I am wondering if possible damage as a result of that faulty oil change might have something to do with my current problem or is it not possible given the time/km between when that happened and now? The car had just over 80,000 km at the time and currently has aprox 105,000. I have properly maintained the oil etc since that as well as prior to.
Santa Fe (CM - 2007-12) :: Rough Idling After A Long Drive In Park
Well all is ok now but I am not one to ignore or forget a symptom. After a long drive into the city over Christmas I pulled in to park at my destination. It was idling rough when I stopped. Vibration my be a better adjective but not too bad. It did not feel like ignition etc, not MIL on and putting it in Part did not change it. I shut it off and went inside for the festivities. Started it for the drive back and all was ok.
Whether some bad gas with water got in or something else I don't know as it as above freezing but I got thinking about this dam harmonic balancer pulley may have had on the 3.3L go. I have seen some post in in 2006 as well with this engine in other models. I got some 47L of quality Shell gas later on as well for the drive home days later. Still no issues but... IT HAPPENED AND I DON'T FORGET so I am thinking about it.
Is this a major problem on SF's some went as early as 30k from the owers. I had no other indicators and I doubt there is going to be much to see in the space with a light.
Santa Fe (CM - 2007-12) :: 2008 - Light Clicking Noise When Idling
Everything about my '08 2.7l Santa Fe seems/drives fine, but it always has a light clicking noise when idling and maybe even at higher revs. Is a little bit of this clicking normal or does the valve clearance need to be inspected and/or adjusted?
View 3 RepliesSanta Fe (CM - 2007-12) :: Check Engine Light Came On - Vehicle Jerks When Idling
My 2007 Sante Fe had problem this week. Took 6 attempts to start engine, then ran smoothly the rest of the night. The check engine light came on while trying to start vehicle.
Next day I changed the spark plugs but now find that the vehicle jerks when idling. Runs fine when going but jerks and bucks at stop lights and stop signs. Just added fuel injection cleaner to see if that may support the situation.
Engine light has come back on again since resetting. I have read several suggestions on internet regarding leak in vacuum line, Coil Pack damage due to faulty hose, even faulty 02 sensor.