Santa Fe (CM - 2007-12) :: Headlight Dim When Transmission Shift Down
When I am driving and I start to slows down to a store my head lights dim when my transmission shift down (A/T). At first it didn't bother me but now since I have noticed it, it is annoying. Although the dimming in not super dangerous but I am worried there might be a bigger issue.
2009 Automatic Santa Fe
Santa Fe (CM - 2007-12) :: Transmission Shifting Harshly - Stuck Mid Shift
We've got a new 2010 Santa Fe AWD LTD with about 2800km on it. About once or twice a week, under normal driving, we've noticed very harsh shifts. It seems to be the 2-3 shift and is around 40km/h. Just normal acceleration from a stop sign. And just recently a new issue. It seemed like it got stuck mid-shift...
I was accelerating slowly from a stop and on the 2-3 shift the engine revved up above 3000 as if it was in neutral. I eased off the gas and then it completed the shift. My wife took it into the dealer today, but I'm worried they'll send it back as "unreproducible" as we've only had about 1 problem for every 10 hours of driving. We'll see what they say. As you can imagine, I'm not very impressed that we're having these issues before our first oil change...
Somebody mentioned that maybe there's something sticking in the transmission and it builds up enough pressure and then finally makes the shift. But I'm not a transmission expert by any means...
Santa Fe (CM - 2007-12) :: 2008 - Transmission Won't Shift And RPMs Climb Really High
My parents are having trouble with there 2008 Santa fe 3.3 L. The transmission won't shift and the rpm's climb really high. Does that mean the transmission is going or is it something else.
View 15 RepliesFord Transmission :: Truck Won't Shift Properly?
I bought a truck a week ago and finally got it running. I got into the truck put it into drive and nothing happened. It is a 59 2wd with an automatic transmission. All the linkages are moving all the way to the transmission. There is a second arm coming out of the transmission in the same spot where it is hooked up now. Should it be hooked up to something? Is the transmission done for?
View 1 RepliesSanta FE SM (2001-06) :: 2002 - Code P0715 / Car Won't Shift Properly
My brother and father just finished with all of the small issues after throwing in both a "new" engine into the vehicle and a transmission..both have around 80K miles (chassis has around 180K). There were some issues with codes after both were installed, but then everything was diagnosed and fixed, vehicles codes were gone and vehicle was able to be registered, afterall.
Anyways, now the car threw a P0715 code and has issues with shifting. It appears that the Santa Fe is stuck in a single gear (appears to be a higher gear). The car won't shift properly, especially noticed at higher speeds in a main road. Using tiptronic does not seem to make a difference. After the car sits and is taken around the neighborhood, it seems to drive fine, until it is taken out into a main road...I'm guessing once it heats up?
So, what should be looked into? A sensor? Is it maybe because this "new" used trans was swapped in and all of the trans fluid was replaced with new fluid? What could the issue be? I guesss the car's been a headache but they're trying to get it finished to avoid any further codes/issues.
02' Santa Fe 2.7 FWD
Honda - Accord :: 1992 - Transmission Won't Shift Properly
Okay just got a 1992 honda accord automatic and sometimes when you stop at a light it will downshift to first and take off other times it wont downshift and stay in overdrive on take off...
View 6 RepliesDodge - Dakota :: Transmission Does Not Shift Properly Sometimes Going Into Second Gear
My 2003 Dodge Dakota does not shift properly sometimes going into second gear and it only happens in second gear. I have to lift my foot off the accelerator for it to shift into third. If I don't it just screams at a high RPM and sounds as if it is about to blow. It has a hard time making it up a small incline such as an off ramp. Truck will not shift properly when going up grade. Engine will rev at 4500-5000 rpm but will not shift until I slightly release the gas pedal. Truck will also perform multiple hard up shifts whether in cruise control or not in cruise control, going upgrade. Took the truck to the dealer reprogrammed the computer with a "flash update" that was no luck. Not once has the ENGINE LIGHT ever come on.
So a lot of the comments that were presented to me I have done. Here is a list:
Changed govner senors and solenoid. Did not work.
Checked for exhaust leaks and other leaks. No leaks.
Checked all vaccuums. No problems there.
Had engine checked and dyno tested. No problems there.
Had transmission rebuilt. Same problem. (dealer did work)
Had new transmission put in. Same problem. (dealer did work)
Also, sometimes when I put the truck in reverse, it seems to about to stall, but it doesn't. It also does it sometimes when I put the truck in drive it seems that it wants to stall.
I just recently learned that my truck has a Transmission computer module, Transfer case computer module and of course the main computer. Is there a way to test those modules out?
Golf IV / Jetta IV :: 09a Transmission - No Reverse / Car Doesn't Shift From 1st To Second Properly
Bought a 2003 golf gti 1.8t as kind of a project. Car had no interior no exhaust and some shifting issues. To fix the shifting issues rather than replacing solenoids I just got a rebuilt valve body. After installation the car still doesn't shift from 1st to second properly and now I don't have reverse. (It's an 09a transmission)
View 1 RepliesChrysler - Towncountry :: Transmission Not Working Properly When Shift Into Drive From Reverse
When backing up in reverse I come to a stop and shift into drive. About 60% of the time it slams into gear (Drive). It feels as if someone rearended me. It's a 2012 Chrysler Town and Country with 40K miles. 2 dealers worked on it, reprogramed the computer and replaced 2 seloniods and the problem is still there. What is wrong but said thats typical on that 6 speed. What to do next?
View 2 RepliesDodge - Sprinter :: 2006 - Won't Shift Properly - Change Transmission Fluid?
I drive a 2006 Dodge Sprinter, 3500 with dual wheels. When changing from park to drive, the gears would not automatically shift from first to second gear. The engine kept revving, so I stopped the vehicle, and started it again. No problem. I spoke with a retired mechanic (friend of mine's father) and he said we should probably change the transmission fluid. When I called the dealer, he said they could do it but that he also saw problems arise when the fluid was changed on vehicles with high mileage (it has 225,000 miles on it).
Should I go ahead and change the fluid, or not?
Santa Fe (CM - 2007-12) :: A/C Won't Working Properly As Producing Mildew Smell
I have been having a mildew smell when using AC. I purchased a foaming cleaner that is mean to be sprayed by inserting a small tube in the evaporator pan drain, but the design on my santa fe drain hose prevents the tube from making it to the core. It always gets jammed up at firewall because of a 90 deg bend. Is there a port on the housing that allows access to the core?
View 15 RepliesCamry :: 2007 Transmission Not Shifting Into Gear Properly
I have a 2007 Camry V6 XLE with a rebuilt transmission. Since the rebuild I have had an intermittent problem with the transmission not shifting into gear properly from park. When shifting from park into drive, sometimes the transmission will pause, leaving the vehicle in neutral, then slamming into drive.
The transmission was replaced in April of 09 with a leaking transmission seal. Since this time I have has this problem but have not been able to get it to be reproduced for Toyota to observe.
Purchased: February '08 (ish)- New
First Transmission Replacement- April '09- 35980 Miles
Transmission Repair- Internal Temp Sensor/leaking o-ring/Transmission Flush- 9/13/11- 101k miles
Santa Fe (CM - 2007-12) :: 2009 A/C Malfunction Blowing Hot Air Randomly - Control Not Working Properly?
My wife drives a 2009 Hyundai Santa Fe Limited which we bought new back in 09. she has put roughly 140,000 miles in that time span. We have religiously followed all required maintenance routines; this is the first major issue we have EVER had with our Santa Fe. The issue we are having involves the AC unit. Instead of blowing ice cold air, the air vents are blowing hot air as if the heater is on. I have check all major AC components and everything is working properly. I believe we are having a controls issue.
At one point, all vents would only blow hot air. The other day, the passenger side vents started blowing ice cold air while the driver side still blew hot air. The driver's side has not blown cold air since this issue started about a week ago. We do have dual climate control; I have tried every possible combination of controls to see if it's a particular switch or button; however, I have not had much luck.
Santa FE SM (2001-06) :: Transmission Won't Shift From 1st To 2nd
I have a 2003 Santa Fe automatic transmission that sometimes will not shift out of 1st gear. Sometimes it works great. I took it to my local garage and he told me that it needed a transmission control module and to take it to the dealer. I took it to the dealer and they said nothing wrong with it at all. I brought it home and still some days it works great and some days will not shift out of 1st gear. What part needs replacement?
View 2 RepliesSanta FE SM (2001-06) :: Hard To Shift Gears (Manual Transmission)
I have a 2004 manual transmission Santa Fe. I've maintained it very well since new.
About 6 months ago I noticed it was getting difficult to manually shift gears. It wasn't grinding or anything, just "hard" to get it to go into the various gears while driving. Before, I could shift into any gear with just 2 fingers on the gearshift and it was smooth as silk.
I went in and had the gear oil changed. This was something I didn't even know needed to be changed and the guy said most people never do. They showed me the oil they took out and it looked more like black water than oil and smelled kinda funky. They changed the gear oil out, but still no difference, and in fact it's getting worse.
The best way to describe it is the only way I can really shift gears now is to find that "sweet spot speed" where the gears will change on their own (so to speak). I find it particularly difficult going from 1st to 2nd, such as when starting from a stop light. People almost rear-end me now as it takes me longer to get it into 2nd gear.
Once in gear it runs perfectly, no problems. The clutch seems to be working normally, except perhaps while stopped in 1st gear, it sometime seems to jerk a bit, and I find this most noticeable if I'm stuck in very slow moving heavy traffic with the constant stopping and then moving forward slightly and such.
It is almost impossible to "gear down" into a lower gear unless I'm at the speed where it would normally go into that lower gear on it's own. The best way to describe it is how it is possible to drive a standard transmission car WITHOUT a clutch if you shift at just the right time/speed. But I DO use my clutch, but if I'm not close to "that speed" it's really, really difficult to force it into another gear, and the few times I do try and force it, I'll often get a bit of grinding.
Santa Fe (CM - 2007-12) :: Sluggish To Shift From P To R / D - Inhibitor Switch?
Model is 2008 Hyundai Santa Fe GLS 2.7L
A month ago I started noticing it was sluggish to shift from P to R/D but i had no issues starting in P mode and the car would drive fine. I thought it might due to cold weather so didn't think of it too much.
Two weeks ago it was really hard to shift the gear from P mode and I nearly got stuck in middle of the road unable to shift from R to D. I applied a lot of force on the shifter and it finally budged into D and car drove with no issues. I parked and did my chores came back and the car would not start at all.I put the car in N and it started and was hard to shift back in D but I drove home without any other issues.
It died again in my drive way but this time the gear was nearly impossible to shift and I thought I almost broke it and the panel was not registering it was in P and the key was stuck in the ignition. After messing around for some time I was able to get it into N and put my hand brake on left the key in the ignition and disconnected the battery.
Today I opened the center console & battery tray these are my findings. The inhibitor switch was slightly misaligned from the N position.
1. The shifter moves freely once the linkage is disconnected by removing the tiny pin.
2. The inhibitor switch was slightly misaligned from the N position. Once I manually adjusted it I was able to start the car.
3. I reconnected the linkage pin, make sure the inhibitor switch was in N position and started the car but it was again nearly impossible to switch to P/R/D
4. My brake lights work fine.
5. I was able to remove the key once I completely disconnected the battery.
What can be the issue here ? Inhibitor switch ? The shifter assembly ? Linkage?
Santa Fe (CM - 2007-12) :: Cover For The Shift Lock Release Is Gone
While driving today I noticed that something didn't look right in the gearbox of my santa fe. It turns out that the cover for the shift lock release is gone. I have no clue what happened and for some reason its bugging me so I need to get one.
View 7 RepliesSanta Fe (CM - 2007-12) :: Rough Shift Going Uphill And Downhill
I have a 2008 2.7 all wheel drive santa fe automaic. It has 110 Kilometers on it. It is stop and go traffic everywhere, terrible roads, and lots of hills. I have actually only owned it for about 14k kilometers.
It has been fine since I bought it a year ago up until about 2 months ago. I was coming to a stop and as I got right to the end of my stop, the car jerked and made a clunk sound. No smell. I could tell it was when the tranny was coming down from 2nd to 1st. I tried to replicate it but got nothing. Ignored it but then it happened again. It seemed more prevalent when I was moving from 1st to second to stop over and over.
As I began to pay attention more and more, it happens much more when going up a hill or down a hill and almost always happens when I am about to make a u-turn and the wheel is turned all the way to the left. When it happens, it isn't always a big jerk. It never happens at speed, the other shifts are fine, and if I shift from reverse to drive too fast and accelerate, I get a clunk as well.
Santa Fe (CM - 2007-12) :: 2008 - How To Take Gear Shift Knob Off
I'm new to this and not really sure if I'm doing it right. I need to know how to take the gear shift knob off my 2008 santa fe.
View 3 Replies