Santa Fe (CM - 2007-12) :: Clunk Noise When Increase Or Decrease The Speed
My Santa Fe is doing a pop sound, like a clunk, when I increase or decrease the speed. It is just one time noise every time the speed changes. Like when the "gravity center" changes from the car front to rear or vice-versa.
I notice already that doesn't happen when it's shifting, neither when I go over a speed bump.
It happens in all gears, but is more noticeable up to the 4th gear.
Also, usually I can hear this noise, a little bit lower, when I'm stopped and change the gear from P to R or vice-versa.
My Santa Fe is a 2011 model with 70K kilometres ....
Santa Fe (CM - 2007-12) :: 2009 - ESP Light Appears Off And Can't Increase Speed More Than 40 Km/h
i have 2009 Hyundai Santa fe 3.3 , My problem ( sometimes when i turn on my car, ESP Light appears off on my dashboard after 8-9 mile and Car speed can not increase more 40 km/h
View 5 RepliesSanta Fe (CM - 2007-12) :: High Speed Vibration Come From The Rear
I had this item of concern as a response to another thread but I thought I'd open up a new thread and see if I could get any more attention.
I bought a used GLS and upon initial drives I have noticed a high speed vibration that seems to come from the rear (I don't feel any in the steering). In the colder weather recently I've noticed a pronounced vibration at a lower speed (just before shift points). between 2nd and 3rd. This seems to be worse with short drives or in morning.
Vibration seems to be worse just after a tighter right turns or even some left turns. I notice the most vibration right around 25mph. I also get it with moderate acceleration into a certain torque range. Like driving at 45 and accelerating up to 60. What is going on? It seems like it is linked to acceleration (torque) and possible pressure from turns. CV joint / axle? Wheel bearing? It seems like a tire would be worse as speed increased and more consistent.
Santa Fe (CM - 2007-12) :: High Speed Wipers Not Working
Ever since passing on an opportunity to trade in our 07 Santa fe for something new, and deciding to keep this car until the end, we have come across a few electrical issues.
The highest speed setting on the windshield wipers have stopped working. The wipers just freeze. The drivers door lock no longer auto locks when you hit the lock button on the way out of the car.
Ford Super Duty (1999-2016) :: Tranny Codes P0750 And P0733 Came On?
i have p0750 shift solenoid A error and p0733 gear 3 ratio error and i was woundering how i fix them problems
View 9 RepliesSanta FE SM (2001-06) :: High Revs While In Park
05 Santa Fe, 2.7 liter, 71,000 miles
Prior to today it had revved high, up to 3000 RPM, once or twice upon start-up but then settled down once I started driving it with no issues at stop lights.
Today, however, no issues upon start-up but within 1 mile it started acting badly. Pulls strong under load, i.e, accelerating. Once cruising speed is achieved and the right foot is relaxed, it loses power, slows and bucks.
At stop lights revs are down to below 800 while in drive and is slow out of the gate. When put in neutral at stop lights, it revs to 3000 then falls to 2000 then back up to 3000. It does not stall.
Replaced the IAC and it ran fine in park for exactly 2 minutes then began revving again.
Lexus LS 2007+ :: Clicking Noise That Would Increase With Fast Speed
About 2 months ago i was driving and heard a clicking noise that would increase the faster i drove, i 1st thought it was something in the tire. after checking my right front tire and saw nothing was there for some reason i figured it was the brake.....so my personal mechanic the next day took off the wheel i told me i had to replace the braking kit because one of the pins was rubbing on the rotor, in the mean time he pulled it to try to realign it into place.....after he did that i realized the steering wheel shuddering when braking at highway speeds....figuring since i needed the braking kit that when replaced, this new problem would b solved.....braking kit replaced problem still there....
View 11 RepliesElantra MD (2010-15) :: 2013 - Occasionally High Engine Revs At Low Speed
2013 Elantra has occasionally high engine revs at low speed. No check engine light. Transmission is not slipping .... Just high engine revs in traffic at low speed ( under 40 mph).
View 10 RepliesFord - Fusion :: 2007 - Rubbing And Wobble Sound That Increases In Frequency As Speed Increase
I have a 2007 Ford Fusion SE 2.3L 4 cylinder. It has approximately 94,000 miles on it. I purchased new Sumitomo tires with a 100,000 mile warranty in February of this year. They were balanced and aligned at the time of install. So far they have been very smooth and quiet with great grip. About 2 months ago I started hearing a noise that sounds like uneven tire wear, a sort of rhythmic rubbing or wobble sound that increases in frequency as the speed increases. It is most noticeable at speeds between 30 and 50mph. I rotate the tires every other other change (at least twice a year) and had the alignment done again in late October. I am hoping that there is nothing wrong with my virtually brand new tires. Is there anything else it could likely be?
View 2 RepliesSanta Fe (CM - 2007-12) :: Engine Periodically Revs While Driving
I own a 2010 AWD Santa Fe. It gets factory scheduled maintenance at the dealership. Since owning ( i bought it used from Dealer, it was driven by dealer) it has periodically revved while driving. Often at lower speeds while accelerating from a stop. The engine will rev and the car will act as if it is in neutral. Then, after a few seconds there will be a sharp jerk as the transmission(?) engages and the car lurches forward. My dealer told me it is normal. This does not seem normal.
View 1 RepliesSanta Fe (CM - 2007-12) :: Small Jerk From The Car When Pulling Away At Low Revs
Over the last few months I've noticed that there was a small 'Jerk' from the car when pulling away at low revs. It seemed to happen around 1200 RPM/20 MPH put only when pulling away very gently. It has been getting worse in the past two weeks. The car needs a service and I was going to get the fault looked at when in for service. Last night the 'ESP OFF' and the 4WD fault indicator came on (4WD lamp flashing). Since the fault lamps have illuminated, the car has stopped 'Jerking'.
View 3 RepliesLexus LS 2007+ :: Car Vibrated With High Revs - White Smoke Poured Out
Three weeks ago got in the car, started it and it immediately began to vibrate with high revs and white smoke pouring out and would not stop. Turned it off and restarted it with same results. Then I drove it around the block and it finally stopped. This has not occurred since. Took it to dealer and they could find anything wrong, since not any of the warning lights came on during this occurrence.
It is a 2008 LS with just 38,000 miles on it.
Santa Fe (CM - 2007-12) :: Screeching Noise From Gearbox Area At 2k Revs
Finally got my Auto Santa Fe on the road after buying at Auction and changing engine. If you drive reasonably gears change quietly but it you rev over 2k revs before you get to 5th gear there is a screeching noise (like a belt slipping) from the gearbox region of the car. Once in 5th gear or in Neutral there is no screech. Have it booked in with a gearbox specialist next week but have a 300 mile trip on Friday. Is there anything obvious I could have a look at before then?
View 10 RepliesSanta Fe (CM - 2007-12) :: Significant Judder When Setting Off In 1st At Low Revs And Worse When Reverses
I have a 2.2 CRDI Manual - new 2010 model - bought from new approx 16 months ago. Live in UK. Quite a few problems, which is a shame as I love the car. Tonight's question is about the clutch. Became increasingly difficult/impossible to get into 1st when cold, and wasn't clearing so car would slightly jolt forwards. Dealer had it in and replaced ?Slave cylinder. No better. Went in yet again for a week. This time ?replaced Clutch ?wheel (staff not that communicative, or apologetic, and ps had to also replace both front drive shafts too as clicking ++). Now at least the car is easier to get into gear, but pedal rather sponge like and significant "judder" when setting off in 1st at lowish revs, and worse when reverses. Surely this can't be normal - it's a new car after all. Back to the dealer later in the week, but what do I do if I become unhappy with the dealer?
View 4 RepliesSanta Fe (CM - 2007-12) :: Whine At Cold And Pitch Being Raised As Engine Revs
My 2.2 crtd is the first ever diesel car i have bought, but i have noticed a whine especially when cold, pitch bieng raised as engine revs. Is this a characteristic of this car or am i in for a bill further down the line.
View 3 RepliesElantra GD (2013+) :: Revs Suddenly Increase From 2200 To 2700 Rpm - No Accelerator Pedal Movement
I've noticed when encountering a moderate hill at 60 mph in cruise the revs might suddenly increase from 2200 to 2700 rpm, then back down slowly as I crest the hill. If I'm in manual mode it stays in 6th gear, but almost feels like a downshift. I also feel no accelerator pedal movement. Is this a two stage intake at work?
View 3 RepliesSanta FE SM (2001-06) :: Blower Only Working On High Speed
Blower only works on high speed. From what I have read the problem is either the switch or the motor resistor. I am leaning toward the resistor which is behind the glove box. Where can I find directions for removing the Glove box?
View 1 RepliesSanta FE SM (2001-06) :: 2004 2.4l Engine With High Idle Speed
2004 2.4l engine has high idle speed aprrox. 1000rpm.
View 2 RepliesSanta Fe (CM - 2007-12) :: Codes P0021 And P0022 After Oil Change And Alignment
I took my 2009 Santa Fe Limited in to Firesteone last Friday. After the oil change and alignment, I drove out without any issues. Current mileage is 61k+.
I was running some other errands and drove about 20 miles to the next destination and parked. Came back within 45 mins and started the car when 2 lights came up on the dash - malfunction indicator lamp and engine oil pressure warning light.
I called the Firestone service center who suggested another location closer to my current position. The guy at the other location checked the error codes with the scanner which came up with P0021 and P0022.
Now, I am not very handy with anything car related and my vehicle is just out of factory warranty by 3 months and 1200 miles. I am concerned that these error codes point to expensive repairs.
Are these issues common in my model? The car seems to run fine. Could this only be the sensors or oil valves?
Assuming the worst case scenario, how long should I be able to drive before immediate need for repairs or without making the issue worse?