Ford Super Duty (1999-2016) :: Massive Clunk Sound When Shifting From Reverse To Drive Or Vice Versa
I continuously read that people with 6.2 F250s averaging 13 mpg or so in a combination city/highway driving. This 2014 4x4 barely has enough power to move itself (honestly, I'd rather have my Ram 1500 back) and barely gets 10mpg. Basically have to give it about half-pedal to even get up to freeway speed and floor it if i want to pass anything. Is it just that much of a POS or does this not sound right? Other than a massive "clunk" sound when shifting from reverse to drive or vice versa, no indication of any problems.
View 14 RepliesFord Wiring/Electrical :: 1999 - ABS Light On With A/C Off And Vice Versa?
my 99 f250 sd ABS light comes on and the A/C stops, when the ABS light goes off, A/C comes back on. Any clue as to what is happening?
View 5 RepliesSonata NF (2006-10) :: Dies When Switching From Forward To Reverse And Vice Versa
My sonata 3.3 dies when switching from forward to reverse and vice versa. Suspecting the fuel pressure regulator. Have seen conflicting sites saying its on the firewall and some saying in-tank. What else may be causing this.
View 2 RepliesFord Transmission :: 2001 - Trans Hesitates Going From 1st To Reverse And Vice Versa?
2001 7.3L I purchased used with 200K on it. Trans hesitates going from 1st to reverse and reverse to 1st. It seems more pronounced going from 1st to reverse. Fluid is clean.
View 2 RepliesTiguan :: 2016 - Key Fob Malfunction / Only Driver Door Lock All Other Unlock And Vice Versa?
2016 push button start, need to confirm something? It's cold up here in these parts this time of year and I have been letting my car run for a few minutes when it's frosted over in the morning. The issue I'm having is that I start the car and go back into the house. When I come back out to get in, The driver's door is unlocked but the rest of the doors are not. When I press the unlock button on the key fob, nothing happens. Is this how it's supposed to work or do I have an issue?
View 4 RepliesFord Brakes/Suspension :: 2008 - Steering Tight When Turning From Left To Right And Vice Versa?
I have a 2008 f350, crew cab,6.4L. with 27,173 miles. may have a problem with the steering, seems to be tight when turning from left to right or right to left, doesn't seem to center, if I turn a little to left or right it stays there. I can go in complete a circle. Raised front off ground turns ok no binding, nothing loose on the front end.
View 1 RepliesSanta Fe (CM - 2007-12) :: Thump Noise When Start To Move / Continuous Beep Sound
I'm using the 2011 Santa Fe.Got few question to ask.
1.When start to move there is a thump noise and sometimes it feel like going over something from the rear area.Happen only when start to move.
2.Using the keyless remote. Sometimes push the rear trunk button to lock and arm the car there but will be a beep sound continuously. Sometimes the rear trunk button are unable to open or arm the alarm system.
Santa Fe (CM - 2007-12) :: Clunk Noise When Increase Or Decrease The Speed
My Santa Fe is doing a pop sound, like a clunk, when I increase or decrease the speed. It is just one time noise every time the speed changes. Like when the "gravity center" changes from the car front to rear or vice-versa.
I notice already that doesn't happen when it's shifting, neither when I go over a speed bump.
It happens in all gears, but is more noticeable up to the 4th gear.
Also, usually I can hear this noise, a little bit lower, when I'm stopped and change the gear from P to R or vice-versa.
My Santa Fe is a 2011 model with 70K kilometres ....
Santa Fe (CM - 2007-12) :: Driveshaft Clunk Noise In The Front Of Vehicle
Got a 2007 Santa Fe CM (Europe) with 160k km. I'm currently trying to figure out how to fix the clunk noise in the front of the vehicle. I am aware about the TSB 12-DS-002 where they recommend changing the drive shaft washer, but since that's a lot of work I want to make sure that this is really the problem.
The noise is not always there. Sometimes you can hear the clunk when decelerating, but not always. You can also sometimes hear a clunk when going from D to R. It sounds like a driveshaft has some play, and a change in the direction of the force causes it to slam into the other side. However, you can't feel it, so there is definitely not a lot of force behind it. You can only hear it.
However, I asked some guys to shift between R and D while I'm outside so that I can figure out where the sound comes from. However, murphy's law, it didn't made any clunk. And after shifting between R and D for like 20 times I felt bad for my transmission and stopped it.
The clunk is not always there, just sometimes. It doesn't really make sense to me, if its really play in a driveshaft it should be always there? Also the clunk started at about 155k km, now I got 160k.
Is there any further diagnostics I could do?
Santa Fe (CM - 2007-12) :: Clunk Noise From Front Left Tire Area
I got a few clunk noise from front left tire area. I think it happens when I turn my steering wheel to left almost max.
And then, turning back to straight(to right). then, "Clunk"!
Today I got the clunk when I made U-turn on a street. A month ago, I heard it when I parked with fully turned front tires.
Santa Fe (CM - 2007-12) :: Loud Clunk Noise When Turned The Steering Wheel Fully Left
I have a UK 2006 Mk2 CDX+ which I was driving last night - seemed ok, got to our driveway, turned the steering wheel fully left so I could manoeuvre the car into the driveway when I heard a loud "clunk" noise.
I thought I ran over a bottle or something so carried on reversing, when I got out I noticed the car was parked diagonally! Thought this is strange, I don't park like that and tried again, a bit better but still not parallel! I then noticed the steering wheel was hard to turn, a grinding like noise is heard when I turned so I decided I would need to take into the local in the morning.
Started the car today and drove out and got immediate sensation that steering was not connected to the wheels, the SW was off centre by miles and turning left/right was very sluggish. Lucky the garage is only down the road (but it's not Hyundai specialist) from me as I would not risk driving it down main roads in this condition. Guy at garage asked me to fully turn the SW left to right and we can see that the front of the car actually moved during the process. He is going to take it up on the lift to look underneath.
Ford - Explorer :: 1999 - Loud Clunk / Thump Noise - Shifts Into Drive And Revs But Won't Move?
My boyfriend bought a 1999 ford explorer, he put about 2,000 miles on it in four months... I believe it now has roughly 110,000... Now the other day, he was pulling out and shifted from reverse to drive, we heard like a loud clunk/thump noise... It shifts into drive, and revs but won't move, it feels like neutral... If you shift to second, first, or reverse it's fine... Tranny fluid is good... O/D is always engaged...
View 3 RepliesSanta Fe (CM - 2007-12) :: Gear Shifter Very Difficult To Move When Put Car In Reverse
Here is what I have:
2009 Santa Fe 3.3L AWD
70k KMs / 43k Miles
Temp has been very cold, -20C / -4 F
Car starts up without any problems. Try to put car in Reverse and the shifter is very hard to move, if it moves at all. When I am able to get it into Reverse, I then try to put it in Drive and it does not "engage" the "D" and the car behaves like its in Neutral. Moving the shifter back to Park, Neutral, Drive is very difficult and sometimes it will not go into Park. The dash lights do not illuminate the selected P, R, N, D.
However, once the car is warmed up (no longer on C on the temperature gauge) I can with a little effort move the shifter freely (but more effort than it should take) and the car behaves normally. Gear shifts are smooth and in general it is operating normally.
The dash lights do illuminate the selected P, R, N, D. I've checked the Trans fluid level and it appears to be normal and was planning to change it this w-e but I'm no longer sure it will work. Even if it has never been changed.
Also note that I have recently changed a wheel/hub bearing due to a noise that sounds a lot like loud tires on a highway. The bearing change did not eliminate the noise and I assumed that I've changed the wrong one. The noise does not appear to be coming from the Trans, but I cant be 100% sure. The noise is speed related and occurs only after about 20KM/h 16MPH. Unsure if they are related..
Santa Fe (CM - 2007-12) :: Shifter / Gear Select Hard To Move
Got in to go to work this am, and the gear shifter was difficult to move. What to check?
I drove 70 miles to work and didn't seem like any issues with the transmission shifting.
Got in to go to lunch and it seems even more difficult to move...
Shifting back and forth in the selector seems to loosen things up a little.
A friend move the selector while I looked at the linkage and the bracket that support the cable is flexing while shifting between gears....More likely a transmission issue or something with the linkage?
Santa Fe (CM - 2007-12) :: 2011 - Gear Stick Won't Move From Park
I have a Santa Fe Style CRDI Auto from 2011 which is not covered by Warranty and has only done 6000 miles.
The problem is that the Gear Stick Won't Move from the 'Park' position (with the engine on and brake fully pressed down).
There have been issues over the last couple of weeks where it was difficult to move the gear stick at times but it was fine after waiting a few seconds. Now it seems completely stuck.
Santa Fe (CM - 2007-12) :: 2009 - Power Seat Will Not Move Towards Back
My power seat will not move to the rear, only forward. Looking for a wiring diagram that would show how I can use jumpers to move it back?
View 9 RepliesSanta Fe (CM - 2007-12) :: 2.7 Engine - When Put Trans In Gear Car Won't Move And Has Grinding Sound
I put the trans in gear it won't move and has a grinding sound and rolls unless I use the emergency brake. I bought this used from a friend at 80k miles, now it has 130k miles and has been factory serviced regularly.
View 1 RepliesSanta Fe (CM - 2007-12) :: Windows Clunk When Reach The Bottom
When I put down the rear windows on my 2010 they clunk when they reach the bottom. I've had similar happen on other vehicles and it was the rubber stoppers that needed to be replaced. Wondering what the cost would be (car has 94,000 kms so probably out of warranty).
View 2 RepliesSanta Fe (CM - 2007-12) :: Clunk In Front End Most Noticeable When Traveling Under 30 Km/h
My 2007 Santa Fe with 48K km developed a clunk in the front end that was most noticeable when traveling under 30 km/h. I made an appointment with West Edmonton Hyundai. This was not the dealer I purchased the vehicle from as I moved to Edmonton after I purchased the vehicle. The dealer had it fixed up within 3 hours....both sway bar end links were worn out. Just wanted to point out the good service I got. The entire bill was covered under the standard vehicle warranty.
View 19 Replies