Passat (B6) :: 2007 - 2.0t Placement Of Resonator
I have a question about the placement of the resonator. I have searched but I would just like confirmation due to the fact that I only found 1 thread with pics.
Following the tips, what is the correct order. I believe that it is tips, muffler, and then the large resonator. Meaning that the resonator is the closest to the engine. Also, correct me if I'm wrong but there is only 1 resonator in the b6 2.0t right.
Honda - Passport :: 1999 - Procedure For Removal Of Intake Manifold
I'd like to know the number of bolts and locations for removing intake manifold for 1999 Honda Passport.
View 4 RepliesFord Ranger / B-Series :: 1987 V6 - Intake Manifold Removal?
I was working on my friend's '87 Ranger with 2.9 L V6, and a little bit of dirt fell into the intake manifold through the injector ports and intake ports. I should've cleaned the top of the engine with a shop vac first. Anyway, should I remove the intake manifold, or try to vacuum the bits out? It's pretty oily inside, and they might be stuck to the inside of it, so the vac might not do much. If I have to remove it, do I have to de-mesh the distributor gear to remove it, or does the distributor attach to a splined shaft? After looking at the diagrams, the answer was unclear.
View 1 RepliesFord Ranger / B-Series :: 2001 4.0 SOHV Upper Intake Manifold Removal
It doesn't look anything like the illistration in my Haynes book.Where are the bolts located and how many?
View 14 RepliesFord F-150 - 1997-2003 :: 2001 F350 - Air Intake Removal - Alternator Starts Up To 12?
I have a 2001 f350 7.3 diesel, I am looking at switching out the air intake? Also, I have an issue with the code for a dual upper and lower generator fault.. I checked and only have one generator not a dual system.. The alternator is running strong at 14.1.. But I have noticed when I start it up it is down to 12..
View 1 RepliesSanta Fe (DM - 2013+) :: Cold Air Cabin - Intake Always Hot?
It's been quite hot here for a while now (30-34 degrees C, summer) and I noticed that even in the evenings when the outside temp as dropped to a pleasant 25-28 degrees C (still nice for on the beach) that if I do not use the aircon that the normal air blower/vents blow pretty hot air. Like a hair-dryer hot. Certainly hotter than the air outside.
I suspect that either the pollen filter is getting hot because it's in the engine-bay and that filter heats the otherwise cold air from outside.
Trying to save the environment by not always using the A/C
So the question ; if it's hot outside, and your engine is warm, do the vents also blow hotter air into the car than the normal outside air?
Santa FE SM (2001-06) :: Fluid Leaking At Intake Manifold
2.4 Santa Fe ... I just took my Car to MOT inspection and found out there's a leak at my intake manifold and it's coming out of this place. it feels like brake fluid but my brake fluid is full?? I have seen many cars but never seen a part like this before. what is it doing there and why is it leaking ?
View 6 RepliesSanta FE SM (2001-06) :: Passenger Side Drive Axle Removal
I have a 2003 3.5 liter, AWD and I'm attempting to remove and replace the drive axle on the passenger side. I have the one end out of the hub, but the transmission end will not come out. I removed the bolts holding the bearing plate, and have been trying to pry out the axle with no luck.
View 3 RepliesSanta FE SM (2001-06) :: 2003 - Ignition Lock Cylinder Removal
A few days ago my ignition key would not budge when I tried to start my 2003 Santa Fe. I tried all the tricks like turning the wheel. dry lube, etc but no luck. All indications are that I need a new ignition lock cylinder but I can't figure out how to remove it. I removed all of the plastic and metal shrouding below the dash but can't seem to find a hole to release the cylinder. I have also tried to remove the whole cylinder body assembly by disconnecting the wires and loosening the bolt that secures the "arm" from the ignition cylinder body to the steering column but that also seems to be secured in a way I can't figure out.
View 3 RepliesCamry :: 2007 - Replacing Broken Air Intake Box?
On a 2007 Camry CE i4. My air intake box broke, either age or the mechanics that worked on my car broke it. And ones on ebay cost 100+ dollars. Either a customer cai will be cheaper, or the junk yard. I know a cai does nothing but changes the sound of your car.
View 2 RepliesAccent MC (2006-11) :: 2007 GLS - Oil In The Intake Going Towards The Engine
2007 Accent GLS. I have oil in the intake going towards the engine. I know a bit of a mist is normal but mine drips once I remove the intake. I changed the PCV valve but its still there. Intake filter was also changed and I got an oil change. The car also feels like it staggers once I take my foot off the gas.
Also after driving on the highway for about an hour the car wants to stall if I go above 100km/h but its fine below 100km/h.
I have new spark plugs, got the fuel system cleaned at the Stealer, changed the coils, new air intake filter.
Passat (B6) :: 2007 - Where Is The Exterior Air Intake Filter
I'm at 101k miles, and haven't changed the exterior air intake filter on my 07' B6. I'm experiencing a slight loss of power, and the engine is relatively loud/"gruffy". Had coil packs and spark plugs replaced, oil is changed, as well as PCV work performed. So I'm thinking that the filter could be the problem. Maybe carbon build up too?
View 4 RepliesGolf V R32 :: Installing Tampa Mod Resonator
Got my Magnaflow resonator in the mail today. Called up my exhaust shop and they are willing to tackle it but were wondering "where to cut" and "what about the internal baffles". Do you cut and shorten the center of the resonator by 7 inches or do you cut at one of the ends and shorten it from there 7 inches?
The picture I saw on TampaVW's thread shows it having been rewelded from the exit side (IIRC) but what about the internal baffles?
Golf IV R32 :: How To Undo Resonator Delete Mod
I am looking at buying a MKIV R32 and it's in great condition, almost completely stock, and less than 50k miles on it. Although It has the flapper mod, and resonator delete mod installed. I know how to undo the flapper mod, but I was wondering how I could undo the resonator mod.
View 8 RepliesLexus SC430 :: EG Light On After Resonator Delete?
Have the resonator delete with engineer light on when step hard ?
View 7 RepliesPassat (B5) :: 1999 - Delete Resonator / Loss Of Pressure?
a buddy of mine suggested I get a res delete recently but i inquired earlier about this to a sears auto mechanic and he said i'd have problems because of the loss of down pressure, is that a big deal? i have a 2.8 30 valve v6.
View 5 RepliesGTI 337/20th Anniversary :: Rattling Noise Coming From Middle Of Car / Resonator
So I really don't drive my car much during the year since I'm away at college. Once I got back home a couple weeks ago and drove my 20th, i heard a rattle coming from the middle of the car. Jacked it up and starting banging around. The sound is coming from my resonator. Its either the clamp that is busted or the resonator itself. I have to get in closer to see which it is. But I do have a few questions. If I just cut the resonator cut off and weld a straight pipe to that will it be much louder. I have a stock 20th and I'm not really looking for a loud exhaust at the moment. Is it much louder without the resonator? I know if you put a straight pipe in place of the muffler it is MUCH louder so I'm just curious.
View 1 RepliesGolf V R32 :: Exhaust Suddenly Got Super Loud / Broken Resonator
Was driving to work this morning and my exhaust suddenly got super loud. I did not hit anything. I was cruising through the interstate. Took the car to the dealer to find out my resonator is broken. I have a GHL exhaust. Why would this happen?
View 24 RepliesPrius (Gen 2) :: Exhaust Louder - Water Drip Out From Engine Side Of Resonator
Noticed a louder sound to my exhaust. Cuts out when ice shuts off. Haven't got a good look at the whole exhaust system from underneath but did see water drip out from the engine side of the resonator when the car was warming up. The sound is coming from about midpoint between the taiI pipe and the engine. I suspect the weld at the resonator junction is breaking. Is this common? 2008, Canada, 130000 km.
View 7 Replies