Camry :: 2004 XLE Pulls To The Left When Driving - Alignment Is Correct
04 Camry XLE, 63k miles. Since we bought this car, it has pulled to the left. I've taken it to two shops I trust and they showed me the report showing that the alignment is correct. This leads me to believe there is a worn joint somewhere that allows the front wheels to aim a bit left when driving. Where would be a good place to start troubleshooting?
Background: So far, I've called Toyota to verify that our car is up to speed on all TSB's and it is.
I've put my hand over the intermediate steering shaft upper joint while my wife moves the wheel side to side. There is some play there, but not much. I'm not sure how much there should be.
Mitsubishi - Lancer :: 2009 Pulls To The Left Even After Alignment
My 09 lancer pulls to the left even after alignment what are some of the reason its still pulling and when i apply the brakes it also pulls to the left....
View 8 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Truck Pulls To Right When Driving And Pulls To Left On Braking
My 2003 F250 6.0 pulls to the right when driving at any speed. In order to keep it going straight the steering wheel must be slightly tilted to the left, not much but a little. When the brakes are applied hard it will go to the left slightly if you are not holding the wheel good. Neither of these are terrible, just a nuisance. I'm worried about uneven tire wear too. One front wheel bearing was replaced a few weeks ago. It had this problem before that and still does after. Does this sound like an alignment or maybe something more?
View 13 RepliesLexus IS 2014+ :: Alignment Check - Car Pulls To The Right When Driving
I started noticing about a year ago that when I drive my car, it pull to the right. This occurs at any speed. Every time I've gone in for service, I've asked them about this and multiple customer service reps have basically said "that's how this type of car drives". I've had them actually check the alignment as well, and only a couple of times have they had to adjust it, but it still seems to pull towards the right.
Driving a 2014 Lexus IS F Sport.
Golf IV / Jetta IV :: VR6 Pulls To The Left While Driving
2000 jetta vr6 145k.
So when I bought this car it was not driving and hasn't been driving for a year or so, needed time chains and the whole 9 yards. Did that, everything is up and running as well as new brakes all around, snow tires until I can afford some all season.
While driving, only in gear, the car pulls to the left. Even with a touch of the gas pedal it's pulling left. As soon as I let off its going right. If I coast in neutral it holds straight like an arrow. I have replaced the bushings for the dogbone and trans mount with polyurethane thinking with the high mileage it would be the culprit. The control arm bushings seem to be ok, neither side has any play, no wheel bearing play, no tie rod play....so I'm stumped.
Ford Excursion :: 2001 - Acceleration Pulls Left / Deceleration Pulls Right
2001 Ex 7.3 4x4 with 4" lift (6" with 37" Pro Comp tires)
All new front end steering components.
All new Shocks (bilstein)
All tires properly inflated to same PSI
All new brake rotors, calipers, caliper mounts, and pads.
When under hard acceleration the vehicle pulls to the left and I have to compensate by steering to the right. Under deceleration the vehicle pulls to the right and I have to compensate by steering to the left.
I am about to change all four brake lines to Braided Stainless Steel lines, replace all leaf spring bushings with polyurethane, and install a rear anti-sway bar. I'm going through this methodically enough or am I just building a brand new truck one part at a time?
Camry :: 2007 SE - Installed H&R Springs Now The Car Pulls To The Left
I had my dealer install a set of H&R springs the mild drop option. He put it on the rack and reset the alignment. I drove it and it pulls hard to the left. The car has never done this before. He then took everything back off recheck the suspension and found nothing wrong. He realigned the car and it still pulls hard left. The car is a 2007 Camry SE.
View 11 RepliesLexus ES 2007-12 :: ES350 Pulls Left / Steering Seems Stiff
Recently had 2012 ES350 aligned at about 14,000 miles. Drives fairly straight at lower speeds on most roads, but on interstate has sharp left pull in left lane at around 65 mph and above. I am aware of road crown, but, in contrast to left lane pull, car has virtually no pull either way in right lane and tends to drive straight; steering at least seems to be stiffer than when I bought it and much stiffer than it seems an ES350 ought to be.
View 10 RepliesAcura - Tl :: 2007 - Aligned Twice But Still Pulls Left At Highway Speeds
I own a 2007 Acura TL (3.2) with 130K miles. Last October I hit a pot hole which blew my front driver side tire and bent my rear driver side wheel and upper control arm. After replacing both tires, wheel, control arm and having the car realigned twice by two different Acura mechanics over the past 6months, my car still pulls left at highway speeds. I've noticed that the tires have gotten louder while driving and that both passenger side tires have worn significantly but only on the outer most edge (left side facing car). Before I buy any more tires and spend more $ on alignments, why is the car pulling left? What else could wrong with my suspension?
View 10 RepliesLexus ES 2007-12 :: Shaking And Pulls To The Left On Highway Speeds At 120km/h
I just bought the car a less then a month highway speeds car shakes at 120km/h. I just complained to Toyota dealer ship and they put on brand new front rotors and did alignment at highway speeds the car still is shaking and it pulls to the left can it just be tires alone or back rotors because they didn't replace those.
View 6 RepliesFord Super Duty (1999-2016) :: F250 Pulls To The Left When Driving / Front Outer Tie Rod Bad
1999 F250 SD 4x4 7.3 PSD ... My truck has 198K miles on it. It pulls to the left as I drive it. So I took it to a shop to have the alignment checked. They told me that the front outer tie rod was bad and needed to be replaced. And of course they said they needed to put in a set of caster camber bushings to do the alignment. They quoted $400 to change the tie rod out. I said I would do that. They gave me the print out from the alignment but reading it the only thing that was out was the toe. Left tire was toe out and the right tire was toe in, which to me would cause it to pull to the left.
I got under the truck and the steering link, piece that goes from steering box to right side/tie rod, is not tight...I can move it up and down and it clunks when I roll it up. I have a clunking noise when I drive it and go over bumps also. Could this be the clunking noise? Also, if I replaced the ends of the steering link, that would tighten up but possibly push the steering back to the right some to straighten out the tires? I have read alot of threads talking about the clunking being tied to the sway bar bushings being bad but the clunking I get by rolling the steering link up and down sounds alot like the noise I am hearing.
Also, when looking at the axles where they go into the knuckle, there is a loose plastic ring on both sides. Is this part of the dust shield or an oil seal?
Lexus LS 2007+ :: Car Pulling To The Left - Wheel Alignment?
I just bought a 2006 LS460. It's pulling strongly to the left (this is a UK RHD car). I'm assuming this is just a wheel alignment/tracking thing, but just in case it's not, are there any other potential causes that I should be aware of ?
View 9 RepliesCamry :: 2007 Hybrid Alignment Check / Right And Left Mismatch
Recently I took my '07 Camry Hybrid for a free alignment check since I had never gotten an alignment done before on this car, which I bought used an year back. They found the Left Rear Toe at 0.01 which their system showed to be out of spec. They fixed it and gave me a print out with the before and after as usual. The "after" numbers read:
LEFT RIGHT
FRONT
CAMBER -0.9 -0.08
(0.1 to -1.4) (-1.4 to 0.1)
CASTER 2.8 3.0
(3.7 to 2.2) (2.2 to 3.7)
TOE -0.05 0.04
(-0.08 to 0.08) (0.08 to -0.08)
REAR
CAMBER -1.3 -1.9
(-0.6 to -2.1) (-2.1 to -0.6)
TOE 0.18 0.21
(0.08 to 0.24) (0.24 to 0.08)
No Caster applicable for the rear I guess.
My question is: is it alright that there's a mismatch between the right and left values? Is there something in the suspension that makes things even even when the right and left individually are at different angles?
Santa Fe (CM - 2007-12) :: 2008 - Pulls To Right When Shifting To 4th Gear
Just had a new set of tires and a front end alignment done on my 2008 Santa Fe with 86,000 miles. Now when it is shifting into 4th or 5th gear it feels like your hitting a patch of Ice. The Truck veers off to the right for a quick second. It just seems like you can feel it in the left wheel. Other than that the truck does not pull and drives straight.
View 5 RepliesLexus GS 2013+ :: Car Pulls To The Right After Alignment
I got my alignment done today and everyone went into factory specs but the front camber. Both the front left and right are at 1.0. But the thing is that the car pulls to the right and I have to turn the wheel a little to the left to compensate
I have a tanabe spring install with 20x9.0 in the front with nitto 555 245/35/20. And 10.5 with 275/30/20 in the rear.
Do your cars pull to the right? Will the tires wear wrong? The car was back into specs except the cAmber in front.
Santa Fe (CM - 2007-12) :: 2008 - On Highway Car Pulls To One Side When Accelerating
I'm noticing more and more on the highway when i accelerate that my car seems to pull to one side then when it shifts it snaps back. I'm not really sure if I'm even describing a transmission issue or a power steering issue. Basically, it just seems to pull and snap back fairly strongly, enough to cause a slight swerve as it shifts during acceleration. Where to start on something like this? (no error codes or check engine lights. Also no vibrations or other sounds).
View 11 RepliesCamry :: Pulls To The Right After Wheel Alignment And Tire Rotation?
So I had a flat a couple weeks ago, finally got around to patching it (professionally) and decided to get a wheel alignment and tire rotation at the same time. No prior problems whatsoever (drove straight as an arrow) but roads in Hawaii suck so I decided to have it done while my car was in. Got my Camry back and it pulled to the right, with the steering wheel a little crooked to the right too. Talk about leaving something well enough alone, which is what I should have done!
Tried to take it back the next day, but they were super busy so I went to another location (same chain) and they said they suspect it could be my tires, but if not, they'll realign. They ended up doing the alignment again. My car pulls less but the steering wheel is crooked to the LEFT instead of right now when driving straight.
Question: Do you think it could be the patched tire? The nail was 1-.1.5" from the sidewall. This tire is on the right rear. Looks fine, and was fine up until I got a nail in it. Right front tire looks fine too.
I asked my mechanic, along with my cousin who worked with cars and did alignments himself in a past life, and they both told me they don't think it's my tire(s). They both told me to take it back and have the alignment redone.
Is it possible to just have two bad alignments at two different locations with two different techs?? The chain I'm going to is locally owned and has been around forever, and my last alignment was from them so I don't know what's going on this time.
* I have Michelin Pilot Exalto A/S tires all around, with about 20K miles on them.
Ford - F150 :: 2008 - Truck Pulls Right After Alignment
It's an 08 Ford F-150. 4x4... Truck was pulling hard to the right. Took it in and got the alignment done, they told me front right was worn and would still pull slight right. When I drove it, still pulled just as hard. Took it back and had tires rotated, they test drove it multiple times and made small adjustments then told me it was good to go. Drove to work today and still pulling. Not quite as bad but definitely more than a slight pull. What's my next step? What else could cause this?
View 19 RepliesFord Brakes/Suspension :: 1981 F100 Pulls To The Right After Alignment?
1981 f100 2wd 4.9 L6 c6 9" rear w/ front discs and rear drums. went through and fixed all leaks after I got it running. Then I got to steering and suspension. Replaced all tie rods. only thing i reused were adjusting sleeves. Taped off thread protrusion on oem steering parts so i could measure and get the new rod ends in the ballpark. Did a simple shadetree toe adjustment so i could drive it to get it aligned. I should mention i already replaced front rotors and bearings as well. Mic'd the spindles so they're in spec.
I am however running used tires but they balanced out pretty well. all torque application was strictly adhered to by the maintenance manual. made sure tire pressures were up to snuff and greased everything that could be lubed to include kingpins. the kingpins are the only thing i have not rebuilt....but i did check the radial and axial play....nothing out of spec. So I took the truck in for alignment. picked it up and it pulls to the right just as bad as it did when i drove it to the shop. the tech tried to tell me it was just a bad tire and that i needed a new one....of course i knew that was wrong.
Swapped tires from side to side, and magically the truck still pulled to the right. So I've narrowed it down to either the steering box maybe, or just a shade tree alignment tech that doesn't know his fourth point of contact from his elbow. It does not have a steering stabilizer installed, but i would think that shouldn't matter?