Santa Fe (CM - 2007-12) :: 2008 - Rear Door Won't Open - How To Remove Interior Trim
My 2008 Elite has a door that won't open. The rear door on the driver's side.
It is an Australian Elite model. I can hear the click when the remote is pressed. How can I get the door open to remove the intyerior trim?
Santa Fe (CM - 2007-12) :: How To Remove Headlights
Looking for a tip on how to remove headlights. I have followed owners manual for my '08 Sante Fe Ltd on removing the two screws on top and retaining nut on back of light and unplugging the wire harness but the---- thing doesn't want to slide out. Is there a clip or screw that I am overlooking? I have watched the video on the Sonata. It feels tight on the tapered side(turn signal). I afraid of muscling it too much because there is so much plastic.
View 12 RepliesLexus ES 2007-12 :: Water On Carpet Of Driver Side All The Way To Backseat After Heavy Rain
In my 07 ES350 I had water on the carpet of the drives side all the way to the backseat! I was gone for a coupla days when this happened and with the heat it sure did have a musky odor when I opened the door!
I have looked all around the sunroof and cleaned the edges could not see anything that would leak although under the sunroof at the front there was water in the tray.
Then I looked all around the windshield. Could not see anything that could cause a leak. Lightly hosed off the car today and had water dripping down the driver side pillar and the covering for the pillar was wet.
This car has never had a leak anywhere until now. Gonna have to have the carpet removed and steam cleaned I guess to get rid of the odor, but not until I stop the leak!!!!
Ford F-150 (2004-2008) :: 2007 XLT - How To Remove Floor Console
I recently got myself a 2007 F150 XLT Supercab, love the truck, but I find myself needing to make a few mods. First up is the floor console. This is the small console sits atop the hump between the jump seat and the dash. It contains two cup holders and the 4x4 floor shifter.
First how does one remove the 4x4 shift, you need to in order to get the floor console off, the console itself lifts straight up, but the boot for the shifter is attached to it, so the only way I can see to remove it. However I can't for the life of me figure out how to remove it.
Ford F-150 (2004-2008) :: 2007 XL - How To Remove The Headlight Switch
I have a 2007 F150 XL that has the power windows and locks, I have the sensor on the dash for the auto headlights so I'm curious if I just need the auto headlight switch for this to work on my truck. I need to remove the headlight switch so I can try to connect the DB/OG and the DB/WH wires to see if this will make the circuit complete for the auto headlights. Anyway, I don't have a manual. How to remove the switch so I can get at the wires?
View 3 RepliesSanta Fe (CM - 2007-12) :: 2008 - No Response To Key
The other day, I had occasion to try to start my '08 Ltd, and there was no starter response to the key. Everything lit up and didn't dim when turning the key. Jiggled the key a few times, no change. Jiggled the shift lever a few times, no change. Turned the key a few more times, and it started. Yes, the vehicle was definitely in Park at the time.
This one has an automatic, so I'm assuming it was either a shift interlock switch (aka Neutral Safety Switch) or possibly the ignition switch itself, but as noted, neither responded to my ham handed approach to solving the problem. First time, it took about half a dozen start attempts. The second time, only three.
Haven't had the problem since then, but then again, I haven't been cycling the ignition as much as I was that day (probably 20 start stop cycles). Now I'm just wondering where and when it will bite me again. Some of the places I take this vehicle to the boonies in the Rocky Mountains would cost me dearly in tow charges.
Encountered this on an earlier CM model? I don't recall ever seeing this mentioned here over the years.
Santa Fe (CM - 2007-12) :: 2008 - Hum Noise From Driveline
Have 2008 Santa fe with a driveline hum noise. Originally thought is was a wheel bearing so I replaced what I thought was the suspect ones (1 in front and 1 in the back). Noise still there! Carrier bearing on the drive shaft? Front axle shaft? I'm at a lose.
View 7 RepliesSanta Fe (CM - 2007-12) :: 2008 - Misfires On All 6 Cylinders
Just replaced all 6 plugs after getting p0300-p0306 codes. Still getting all codes, always starting with p0305. Was told coil was bad cause the shop only was getting p0305, but I have all misfire codes. We have over 95k on it, have owned since 2008. Its the 2.7 in it.
View 11 RepliesSanta Fe (CM - 2007-12) :: 2008 2.7 - Misfire On Cylinder 3
Motor missing has 61k. Code reader says # 3 misfire. got new plugs. 2 people say its probably the coil on #3. Its center in the back. Need step by step to replace the coil for #3 and plugs while I've got it apart and where is the best place to get a coil?
View 3 RepliesSanta Fe (CM - 2007-12) :: 2008 2.7l Misfire / Flashing CEL
2008 GLS AWD, 2.7L w/ 66500mi. This happened on my way home from work this AM. Vehicle cold started normally, but I noticed a stumble as I idled out of my parking spot after a 12hr shift. All gauge indications looked OK. A few hundred yards down the road (and deep in the hood no less) I can feel an intermittent vibration/stumble and now I get the *FLASHING* (misfire) check engine light.
5am Sat morning and I'm already on the highway for my ~35mi ride home. The vehicle behaved OK, but you could feel a definite power loss, indicative of not firing on all 6. I hated to, but I had to drive it the whole ~35miles with the flashing CEL. I couldn't smell rich exhaust, nor did I notice any black smoke, etc.
Now I'm SOL. I have no warranty since I'm a subsequent owner (3rd owner of vehicle). Of course I lent out my generic code reader 2yrs ago and never got it back. My garage is currently upside down, tools packed away..etc. We just had a baby a few weeks ago and moved to a new house. Perfect timing.
Santa Fe (CM - 2007-12) :: 2008 Vehicle Pulling Towards Right
When driving I seem to be constantly applying pressure to the left side of my steering wheel to keep the vehicle from moving to the right. I've had the car aligned made sure my tire pressures were correct and had my mechanic check the undercarriage to make sure ball joints tie rod ends etc. are all in good working order. Despite all this the vehicle seems to want to wander right and I'm constantly putting pressure on the left side of the steering wheel.
View 4 RepliesSanta Fe (CM - 2007-12) :: 2008 - Both Low Beam Headlights Out
I have a 2008 Hyundai Santa fe and have recently had both low beam headlights go out. The running lights and high beams still both work. I read both bulbs as sat 0.5ohm(left) and 0.5ohm(right). Connections were right. I also read fuses in engine compartment HLP LO for both RH and LH. Still I swapped them both with the HHP HI and both worked for high beams but no change for low,on,either side. My next idea is the switch but I am not sure how to test it.
View 5 RepliesSanta Fe (CM - 2007-12) :: 2008 GLS Stalling On Highway
I was driving home on the highway doing about 60 mph in rush hour traffic the other night when it completely stalled out. When I started the car as I left work I noticed the engine noise was louder than normal but was in a hurry to get home. I was driving and noticed a change in the way the car was riding almost like a hiccup. I pressed the gas pedal to the floor and the car continued to decrease speed. I jumped off the highway on the next exit and the car slowed as I pulled on the shoulder and stopped.
As I stopped and put the car into park the battery, oil and check engine light came on. My headlights were still on as was the radio but the car would not restart. It was dark, raining and about 35 degrees outside. The local highway assistance showed up about 20 minutes later and gave me a battery jump. The jump lasted for about one mile down the road again and then died. The motorist assistance employee said that my belts were not turning so he thought it was my alternator.
My car was towed and kept in the shop for 3 days, no error codes, started right up and no problem they can find with alternator, tensioner, belts, or battery. The week prior I had my entire fuel system replaced as my gas gauge had stopped reading. The shop checked my fuel pump and did not find any errors. I don't know what else to look at and the shop is out of options...they have driven it repeatedly and cannot find anything. I have read on many threads about the crankshaft position sensor. Could this be the issue?
Santa Fe (CM - 2007-12) :: 2008 - Vibration At Various Speeds
I'll try to keep this brief. I bought a 2008 Sante Fe AWD 7 passenger 1st week of Sept 2008 from Jim Pattison Hyundai in Nanaimo BC. Vehicle had a pronounced vibration at various speeds but was most noticeable at around 85 kph which seemed to vibrate frame, not steering. I called service department at the dealership. They said they would look at it during the trailer hitch install in 2 weeks.
After dropping off vehicle for trailer hitch installation I mentioned problem again. Later that day I picked up vehicle and asked about vibration. I was told "mechanic didn't feel anything". Got service manager to take a ride with me, vibration now felt by service manager.
Santa Fe (CM - 2007-12) :: 2008 - Low Beam Horizontal Adjustment
Does 2008 Santa Fe have horizontal lowbeam aim adjustment? After driving my Dad's Santa Fe, I notice the low beam casts a U-shape light pattern on the ground, makes it extremely hard to see what's on the ground right in front of the car. I've attached a picture of what it looks like driving it at night.
View 10 RepliesSanta Fe (CM - 2007-12) :: 2008 Will Not Start, Battery Is Good
I recently had a new coil pack put in my 2008 Santa Fe, about a week ago. Got up for work this morning and it would not turn over. It makes the clicking noise but will not catch. I jump started it and it worked. Got out of work and it wouldn't start again, got a jump start and took it to pep boys where they tested the battery as good. Could it be a shortage somewhere from the previous work done?
View 5 RepliesSanta Fe (CM - 2007-12) :: 2008 - Grinding Noise When Restarting The Car
I have a 2008 Sante Fe with 165K mileage. At times, not regular, when restarting the car we hear a grinding noise. Immediately we turn the car off and re start, noise goes away. Could this be the starter going bad? Dealership wants 400 to fix.
View 27 RepliesSanta Fe (CM - 2007-12) :: 2008 - Water Pump Is Leaking
I have a 2008 sante fe 3.3 the water pump is leaking. I have the replacement pump, however I'm not sure how it is designed to come out due to clearance issues. It's easy enough to unbolt a pull loose, however clearance between the car frame and pulley is 1/4 inch. How does it come out of the compartment?
View 6 RepliesSanta Fe (CM - 2007-12) :: 2008 - How To Take Gear Shift Knob Off
I'm new to this and not really sure if I'm doing it right. I need to know how to take the gear shift knob off my 2008 santa fe.
View 3 Replies