Santa FE SM (2001-06) :: 2004 2.4L - Turn Ignition Key Get A Click And Engine Will Not Turn Over
We have a 2004 2.4L 4 cyl Santa Fe. Turn ignition key get a click and engine will not turn over. Push key in harder and engine may start fine. If it is the key ignition switch or something else. is there somewhere I can look to see how to remove the ignition switch?
View 4 RepliesSanta FE SM (2001-06) :: No Click On Starter When Put / Turn The Key In Ignition
I have a 2006 Santa Fe with 137K miles on it. Has been best car I ever owned, but have recently experienced a strange issue where it won't start, meaning I put the key in the ignition, turn it to the right and nothing, not even a click on the starter. I have found if I move the shifter around from P to R to D, etc. and then try it again it will start. Is there a safety interlock switch in the shifter that could be going bad and is therefore not satisfied/happy when I try to start the car? Or could the ignition hardware where I insert the key be the issue.
View 1 RepliesSanta FE SM (2001-06) :: Car Won't Start - Key Wouldn't Turn In Ignition
I have a 2003 Santa Fe with AWD, automatic, and 3.5L engine. Saturday I went to get in and key wouldn't turn. Tried to mess with shifter and steering wheel but no go, Wife got it to turn after I went to work. Won't start. Waited for a new ignition lock cylinder then replaced today. Still won't start. There is no chip in the key as far as I know and the kill switch thing is still plugged in. Jumping does nothing. Doesn't even try to start or do anything when I turn the key all the way. What am I missing here?
View 5 RepliesSanta FE SM (2001-06) :: Check Engine Warning Do Not Turn On
Recently I changed the spark plug and I made a mistake crossing the spark plug wires. here I noticed that the check engine warning don't turn on.
Also I had other problem with idle air valve and also the check engine warning don't turn on.
The light is working fine because when I acct the key it is turning on. The problem is detecting a fail it don't turning on.
Santa FE SM (2001-06) :: Key Ignition Cylinder Light No Longer Works
2003 Santa afe 2.7 litre: So for some reason the key ignition cylinder light no longer works, but no issues with the ignition at all. What powers the light, is there a specific part of the cylinder I need to check or replace or do I have to replace the whole cylinder. Would a another cylinder I pick up from the junk yard work?
View 11 RepliesSanta FE SM (2001-06) :: 4wd Warning Light Started Flashing
Looking for some info about the 4wd system.
My car is a 2004 Hyundai Santa Fe 3.5 and several times i've seen the 4wd warning light start flashing. It happens right when i start up the engine, however if I turn the engine off and on again, the light will be off the next time it starts up.
I'm just trying to figure out what kind of problems this warning light would indicate, in case it stays on sometime. I like to plan ahead my car repairs and know what's going on with it. The car has like 190K + miles so it's getting there.
Also I try to avoid the dealer, so I was also wondering if a typical scan tool that most mechanics have could read the codes, or if would need to be done by Hyundai specifically.
Santa FE SM (2001-06) :: Brake Warning Light Intermittently Turns On
I just installed new front brakes and rotors on my 2004 2.7L AWD, and since then the brake warning light on the dash comes on occasionally. Typically, it will turn on when applying the brakes. Usually for a longer period of time to a stop. (Rolling up to a stop sign/stop light, rather than slowing down for a turn). It will either stay on for about 15 seconds or not go off until I hit the brakes again. My e-brake handle is all the way down.
View 1 RepliesSanta FE SM (2001-06) :: A/C Light Will Turn Off Intermittently
I have a 2001 Santa Fe with manual (knob) A/C control panel. the problem i am having is that when i turn the A/C on the A/C light on the control panel comes on and it works fine but in the last few months i have noticed that the A/C light will turn off intermittently. This almost seems like the A/C button has a bad contact because i just touch it and the light comes on and I feel cold air again.
1. I have not taken the panel our but is this serviceability or do I need to replace the whole control unit?
2. Also is this a dealer or junk yard part only or are the there third party manufacturers for it?
3. Since i have the manual control and if i have to replace the unit can i order the digital (push button) control and just easily connect it or is it more involved that that. like i might have to replace other components for the digital control to work or modify the opening or what not.
I do not believe this is the compressor because it seems more related to the the A/C button itself. I checked refrigerant and everything seems ok.
Santa FE SM (2001-06) :: How To Turn Off Check Engine Light
How can i turn off check engine light (hyundai santa fe 2003 3.5) by fuse ? I do not have any code scanner.
View 10 RepliesTouareg :: Warning Comes On When Turn Off The Ignition With Directional On
Has noticed that if you turn off the ignition with the directional on, a warning will come on and the directional will stay lit? I wonder why it does that?
View 1 RepliesSC/SL/SW :: Warning Chime Would Not Turn Off Even With Keys Out Of Ignition?
I drive a 99 s/w 2 and this mourning when I arrived at work I got out of the vehicle and the bell that chimes when you leave the headlights on or the key in the ignition the warning chime would not turn off even though the keys were out of the ignition and the headlights were off, however it stops chiming when you shut the door.
View 2 RepliesSanta FE SM (2001-06) :: Instrument Panel Has No Light When Turn Headlights On
I have problems with my SF 2002. When i turn on my headlights, the instruments panel (odometer, shifts indicator and others) has no lights. Turning off them, the shift indicator lights again.
I have notice that when days ago, i have changed my radio the problem began. Maybe the problem is related with this.
Santa FE SM (2001-06) :: TCS Off / ABS Lights Turn On And 4WD Light Starts To Blink While Driving
I have a '06 santa fe 3.5L My "TCS OFF" light "ABS" light turn on and my "4WD" light starts to blink while I am driving. Also my Transmission shifts hard and the engine revs funny (hard to describe what it actually sounds and feels like) when the automatic transmission shifts from 2nd gear to 3rd gear. It shifts find from 3rd to 4th and down shifts from 3rd to 2nd just fine. Just have problems shifting from 2nd to 3rd and it only seem to happen when the lights I mentioned above turn on. What going on? Is this all being caused by a speed sensor? My ABS also seem a little touchy activating when road conditions are not that bad.
View 1 RepliesSanta Fe (CM - 2007-12) :: Key Would Not Turn In Ignition
I am currently driving a 2012 Santa Fe Sport (Canadian). Over the weekend I encountered a problem with the ignition - the key would not turn. It happened once in the morning but it turned after I jiggled it a few times. It happened again in the afternoon but this time it would not turn at all. I had to call roadside assistance. They had me try a few things (pumping the breaks, shaking the steering wheel) but I couldn't get it to turn. They had to send a tow truck. When he arrive he fiddled with it for 30 seconds and got it to work but could not really explain why - only suggested that I take it to the dealership to have it looked at.
The vehicle is only a few months old (5200km).
Santa FE SM (2001-06) :: Transmission Started Going Into Limp Mode And Causing Check Engine Light To Come On
2002 Santa Fe, 2.7 AWD
The transmission has started going into limp mode and causing the check engine light to come on.
The codes given are p0750 and.... I think p0751, for shift solenoids C and D. There is also the generic Transmission Control Module code.
Limp mode only occurs at higher speeds although shifting feels a little rough at times in lower speeds.
If operated in manual mode the vehicle can be driven normally at all speeds without going into limp mode.
Fluid levels are fine.
With limp mode occurring in automatic but not occurring in manual mode, is it more reasonable to believe the solenoids are malfunctioning or the control module itself? I'm inclined to replace the solenoids but find it odd that the vehicle operates normally in manual. Also, can the solenoids be replaced without removing the transmission? It looks like I could get the pan off but am unsure if there is room to get the work done once it is removed.
Santa Fe (CM - 2007-12) :: Ignition Does Not Turn Over / Hesitation
I have a 2009 Santa Fe Limited with 47,000 Km on it.
Over the past 2 weeks I have noticed that when I go to start up the car, the ignition doesn't sound the same. Meaning, that typically when I start the car, I hear a quick turn of the ignition and away I go. When I now start up the car, the ignition does not turn over as quick and I'm now hearing a bit of a hesitation.
Santa FE SM (2001-06) :: New Key Stuck In Ignition
I have a 2002 petrol, manual, 2.4 Santa Fe
It only had one key when I got it so I ordered a replacement key online -uncoded and uncut. When it arrived I got it cut - looked good. Before getting it coded I thought I would just test the cutting. Opened doors ok so tried it in ignition - fitted and turned engine over - did not start as not coded I presume.
However, when I tried to get the key out again it would not come out. Could this be to do with it's transponder not being coded? Any way I can get it out??
Santa FE SM (2001-06) :: No Turnover Occurring When Put The Key Into The Ignition
I got up on a rainy monday morning to go to work put the key into the ignition and no turnover occurred. Not even a click. Looked like the car had plenty of juice though. Right now my poor car is just sittin' in the driveway. 2005 Hyundai Santa Fe 3.5L V6
View 19 RepliesPrius (Gen 2) :: Key In Ignition Warning Light And Beeping After Taken Fob Out
I have a 2007 Prius. Today it began showing an warning indicator light (car w/key symbol) and sounded the beeps it usually does when I forget to take the fob out of the ignition when leaving the car. However, I had taken the fob out.
Eventually, the battery drained as it does when leaving the fob in the ignition without running the car. Later, the warning light continued to blink, but the beeping stopped. The battery still drained. The local Toyota dealer said he has never heard of something like this.