Santa FE SM (2001-06) :: Shifting Really Hard Into 2nd Gear When Going Uphill
I have an '03 AWD, automatic Santa Fe and it started shifting really hard into 2nd gear when going uphill recently. It also seems to take a while to shift into 2nd from 1st, but it doesn't bang like it does when downshifting.
In other threads on this site is seems like either the throttle position sensor or shift solenoids may be responsible for this. What's causing it, and how to go about fixing it?
Santa FE SM (2001-06) :: Tranny Slipping - Power Loss When Going Uphill And Has To Downshift
I just recently bought an 06 Santa Fe with a 2.7l v6. It was a rebuild. It had been hit in the left wheel. The lot put a new fender, suspension parts, axle, etc. It only has 25k actual miles.
We took it on a 100 mile trip today. I noticed if I am going up hill and it has to downshift, it feels like it looses power. The car continues to slow... Like the tranny is slipping. I stopped at Walmart and found the tranny fluid wouldn't even register on the dipstick. I bought Valvoline max life tranny fluid that matches the sp3 specs in the manual. I had to add almost 3 quarts before it was full. I think they may have forgot to add fluid back to replace what leaked out after they replaced the axle It didn't seem to work though when I continued to drive. After I stopped and let it cool about 30 minutes, it did seem a little better.
I guess my question is should I replace the tranny fluid? If so, what should I replace it with? Is there anything else what could be causing this now?
Saturn - Vue :: XE 2008 Lack Of Power - Engine Struggle On Highway
My new XE Vue 4cyl 164hp engine seems to struggle in highway situations. The 4 speed engine seem late in shifting from 4th gear to 3rd when asking for more speed as in a passing situation.
View 6 RepliesSanta Fe (CM - 2007-12) :: Cruise Control And Gear Change Advisory Indicator Not Working
2010 UK Santa Fe manual box, suddenly will not set Cruise Control. At same time gear change advisory indicator also stopped working. OBDII tester will not initiate to check things out but first time I have tried this. Fuses checked all OK (I think).
View 1 RepliesSanta FE SM (2001-06) :: How Necessary Is A Transmission Fluid Change
I have a 2003 Santa Fe 2.4L (automatic) with 200,000 miles. Auto shop is recommending I change my transmission fluid. I've heard that changing the transmission fluid on a high-mileage vehicle is potentially dangerous. I haven't noticed any symptoms of "bad" transmission fluid.
View 5 RepliesSanta FE SM (2001-06) :: 2003 - TPS Won't Change Gears
I made a mistake, detached TPS from throttle, thought it was purge valve, then I put it back and today my car won't change gears, I messed something up, never had problems with my transmission. Santa fe 2003 3.5 ....
View 2 RepliesSanta FE SM (2001-06) :: Jerks At 40 Mph - Change The Plug?
I changed the purge valve because it was hard to fill up. It idles fine but when I drive it at 40 and just cruise without a load on engine it starts to jerk or misfire. I'm going to change plugs even though they don't look bad and wires.
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Truck Struggle Even On Flat Going 65 Mph And When It Comes To Hills It Really Slows Down
I have a 2001 F650 7 speed with 7.3l powerstroke and I am pulling a 15,000 pound fifth wheel. It is very new to me and just doesn't seem to have the pulling power. It seems to struggle even on flat going 65mph and when it comes to hills it really slows down. Should I be looking into power chips? If so, which one? Is there something else that may be preventing the full power?
View 8 RepliesSanta FE SM (2001-06) :: Knocking Noise In The Engine After Oil Change
2004 Santa Fe, 2.7 L V6. The oil was changed approx 5-7k miles ago (not really sure as I bought it from someone else) and I just changed it today. There's a new knocking noise in the engine. I used normal castrol GTX oil, 5w-30.
I drove it about 20 miles and the noise is still being made, so it's not a circulation problem.
Santa FE SM (2001-06) :: Won't Start After Spark Plug Change
I somehow managed to kill my 04 Santa Fe 3.5 while doing the dreaded spark plug change and looking for pinpointing and rectifying the problem.
A quick rundown of the car... My mom bought her new in late 03, decided to get a BMW X3 a couple of years ago. I bought her with 65k miles. I just recently had the timing belt replaced by a reputable shop at 79k (yes I know I let it go too long.) I just hit 80k and decided it was also time to do the plugs as I had noticed a decrease in performance and gas mileage of late. Other than the recent dip in performance the car has been extremely reliable and has had no previous issues.
I researched as much as I could knowing that the 3.5 isn't the easiest engine to work on. I bought the recommended Champion plugs that came in the car from the factory as well as the oem Hyundai wires. I also replaced the plenum gasket.
I took my time replacing everything but despite my best efforts, I accidentally cracked the plastic on the radiator reaching over to the back bolts on the plenum. Other than that mishap, the only other issues was the #5 plug sticking which finally came loose after some begging and pleading to the car Gods. Unfortunately, my begging and pleading was enough for them to allow the car to start.
After reading a thread on here, I believe the problem is that I removed the TPS sensor to get to the bolts on the EGR valve, I know now that this was a big mistake. I checked and double checked every connector and can not find one that was missed or disconnected. The car would try to start but would not crank over. I was unable to get any OBD2 codes from my code scanner.
I decided to try a TB from a junkyard and swap it on to see if that was the issue. After swapping it on, the car started and ran like crap for about 15 seconds and stalled out. I was however able to pull some codes in this short time.
The codes I received are:
P0102: Mass Airflow Circuit Low Input.
P110 & P1172: ETS Improper Motor Current.
P1192: ETS Limp home - Target Follow Malfunction.
P2127: Throttle Pedal Position Sensor "E" Circuit. Accelerator Position Sensor 2 Voltage Too Low.
I'm not sure if these codes are left over from before I swapped out the TB or not. I reset the codes after I wrote them down and researched them to see if they reappeared but the car will not start again so I can't get the codes to reappear.
Santa FE SM (2001-06) :: Trans Fluid Change Interval
What is the interval when trans fluid gets changed? I need to take a trip....round trip will be about 4600 miles I probably have less than 1500 on the current fluid now.. and before that had changed it 2 other times within 1000 about 8 mo. apart just to rotate the fluid. I am planning to do it as soon as i get back.
View 8 RepliesSanta FE SM (2001-06) :: At Cold Startup Ticking Noise - Change The Oil?
Its been getting quite cold here lately at night and in the morning when i go to the santa fe it makes a ticking noise for about 2-3 seconds and everything is fine again. I was thinking of dropping a quart of transmission fluid in the crankcase run it for a bit and change the oil?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: 2001 F250 - Black Smoke When Towing Uphill
I have always seen other trucks blow black smoke with towing up a hill but mine for the most part has not. I pulled my 5er to CO this summer and notice my truck starting to blow black smoke. I consider myself a very conservative driver. I always stay around 65 MPH while towing and never push my truck up the hills. I always try to keep the RPM around 2000 and let the MPH fall where they may until I reach the summit. With the black smoke I'm starting to see what is my truck trying to tell me? It's not bad but would like to fix now before it becomes something more.
2001 F250, 4X4 crew cab, 7.3 with 205,000 miles.....
Golf/GTI VI :: Power Dips For About A Second And Then Comes In When Try To Change Gear Quickly
I have a problem that I can't work out. The problem occurs when I try to change gear quickly (say for a 1/4 mile run). between 2nd and 3rd, as soon as third engages, the power dips for about a second and then comes in. Its not like the revs drop, its just for that second it feels like the turbo is spooling up or something and the car is at best pulling like it has the low range torque of a Honda!
It doesn't happen always, but i would say at least 50% of the time. I have been driving stick for 15 years and have had 3 gti's but none of them have done this. I have tried to change gears at different rpm and experimented with keeping revs up and different release points for the clutch but it doesn't seem to make a difference. my friend also tried it in my gti and he felt the same thing.
Is it a gti thing? maybe the turbo spooling up? I have noticed it since stock clutch and apr stage 1, I honestly thought the clutch would fix it but it hasn't. I have a mk6 gti 2012, apr stage 2 (carbonio intake) with dxd stage 2 daily clutch, short shifter and BB downpipe. Working towards k04 but not there yet!
Santa FE SM (2001-06) :: Stuck In 2nd Gear
Its not my car but my sister in laws. She stopped by our house tonight to pick up her kids and when she put the car in drive it showed both drive and 2nd gear. we tried disconnecting the battery so she could at least get it home (3 min away) but it didn't change anything.
She left with it still in 2nd thinking she could make the short drive without any problems but half way home it shifted down to first and it wasn't even driveable. Everything i have read on the web (which was not really specific to the santa fe) was say that its stuck in safe mode. What could have cause the problem? So far no check engine light has come on.
Santa FE SM (2001-06) :: Vibration When Goes Into Gear In Rev
ok, I had quite bit of work done, prob over yr ago All oem parts, timing belt, crank sensor, idler pulley, some other things while in that area. So when he was done I got this vibration when it goes into gear never in park only in rev. or drive but only in cold weather and after it warmed up it was go away. No Trans service was done. He kept it overnight outside, had the timing cover off rolled it in the garage, started it and seen that the belt was flapping crazy. So he thought it was that. well every cold morning I have to wait till it is warm to not hear that sound. it only happens during cold mornings never in summer. He had back in his shop 3 times after parts were installed. and its to this day isn't the same. its unfortunate that I didn't have many cold mornings when he had worked on it. but after I had it and the next cold morning it was there.
View 7 RepliesSanta FE SM (2001-06) :: Stuck In First Gear
2003 Santa Fe 41,000 stuck in first gear.
View 1 RepliesSanta FE SM (2001-06) :: 2003 Won't Start In Gear
Two times in the last month my 2003 Sante Fe would not start - the radio, air conditioning will come on but nothing from the engine - not even a click - no check engine light. Had it towed both times - as soon as it was towed it would start up. It seems to happen in 2 week intervals. Now I realize bc they had it in neutral to get on the truck that is what required to start. It hasn't happened in a week but I know it will again.
View 3 RepliesSanta FE SM (2001-06) :: P1528 Error - Gear Box Don't Go Up 3rd
I have Santa Fe 2002 v6 2.7 and it's have been in the mechanic for 2 months now.
Suddenly my gear box don't go up 3rd, the error that the diagnostic reader is P 1528. What it can be? How to Fix it?