Santa FE SM (2001-06) :: Won't Turn Over / Whining Sound When Tried To Start
I have a 2001 Santa Fe with around 140,000 miles on it. I've had my share of problems with it, but the last couple of years have been fine until this morning. I tried to start it and appeared to have full battery power, but it would not turn over. Instead of a clicking sound, it was more of a whining sound it made while it tried to start. I took the battery into AutoZone and they told me it was dead, so I bought a new one and replaced it after cleaning the connector cables. The same thing is still happening with the new battery. I've attempted to jump it as well.
View 3 RepliesSanta FE SM (2001-06) :: Whining Sound That Increases / Decreases With Speed
I have a problem with my 2006 Sante Fe. When driving (at all speeds) my SF has developed a "cyclical", repetitive whining sound in the engine compartment that directly corresponds with the speed of the car. The "revolutions" of the sound are slow at slow speeds and very high pitched and fast at high speeds.
It happens at all speeds, with or without throttle being applied. I do NOT hear it when the car is in park or in neutral and I rev the engine so it has something to do with the rotations of the wheels/axles/drive shaft/gears or something that rotates in synch with how fast the car is going. I still hear it when coasting.
We recently put on new tires a few months back and I thought maybe it was just the sound of the new tread on the road but now I am almost positive this sound is coming from somewhere in the engine compartment. It is possible that it is coming from under the car but the problem is a can't confirm that because I only hear the sound when the car is moving. So far, it's just an annoying sound, it does not affect the performance of the car.
Santa FE SM (2001-06) :: Whining Almost Electric Motor Like Sound Coming From Rear Of Engine
I have an 03 Santa Fe, 2.7 l AWD. Recently I've begun to notice a whining almost electric motor like sound coming from the rear of the engine. It get more noticeable the longer the trip. The weird thing is that it seems to respond to throttle input more than speed. If I'm cruising at say 65 I can ease off the throttle, reapply the throttle enough to increase RPM but not speed and hear it. I've had the differential, brakes, bearings checked. My mechanic has had it in the air 4 times and has spent atleast 4 hours on two occasions trying to find it. He can hear it. My thoughts are that it could be the Fuel Pump, or the exhaust.
View 11 RepliesSanta FE SM (2001-06) :: Clunking Sound When Shift Into Drive Or Reverse - Bad Motor Mounts?
I have a 2002 santa fe 2.7. I just had the transmission rebuilt and since then have noticed a clunking sound when I shift into drive or reverse. It seems to be the lower motor mount is making noise from the motor moving the mount. I look at the mount and it appears to look good, but was wondering how I can really tell if a motor mount needs replacing or not.
View 3 RepliesJimmy :: 2001 - Strong Vibration When In 4WD / Front Drive Shaft?
2001 Jimmy 4wd, 115,000 miles; Recently I noticed a strong vibration when in 4WD, no vibration in 2wd. I found that the rear joint (at the transfer case) of the front drive shaft has play in it. I am assuming that this is the problem. It has the appearance of a CV joint. Is that joint rebuildable or do I need to replace the shaft?
View 1 RepliesCamry 2012+ :: Clicking Sound When Turning - Front Drive Shaft Assembly Replaced?
On my 2012 Camry XLE with 22,500 miles, just had the drivers side drive shaft assembly replaced, under warranty. Was getting a clicking sound when turning. Not too happy, car comes off warranty in September. They also updated computer on a recall for the torque shutter.
Then he tells me I need an oil change (was just done, oil shiny clean). He said oil looked dirty. Also said I needed a fuel injection cleaning (at 22.5k?), and new tires. OEM tires are garbage. Wheres the Toyota quality and integrity?
Santa FE SM (2001-06) :: Balance Shaft Oil Seal Replacement?
I have a 2001 4 cylinder Santa Fe. And atm I'm trying to replace the balance shaft oil seal but am having major problems getting it out.
View 2 RepliesSanta FE SM (2001-06) :: AC Compressor Replacement - Shaft Seal Is Leaking
After 9 solid years of service, my a/c compressor finally failed. According to the shop, its leaking at the center seam of the compressor. If the system is charged, then the compressor will operate until the low pressure switch shuts it down. My question is this: Can this compressor be rebuilt? If so, where can I get the parts (I'm assuming the shaft seal is leaking).
Also, a quick search on eBay provides several compressors that fit my car; however, some of them are listed as HS-17 compressors and others are HS-18. My car (according to the A/C sticker on the hood) says I have an HS-18 compressor. Are these two interchangeable? I'm asking because if the current compressor can't be rebuilt, then I will have to buy either a reman. or new unit.
Car: 2002 Hyundai Santa Fe, GLS, 2.7L V6
Santa FE SM (2001-06) :: Code P0340 Cam Shaft Sensor Fault
I have a 2005 crdi diesel santa fe that i have a strange problem with it starts up first time no problem in the mornings and can drive all day long. However if i switch it off and leave it sit for about a half hour no way will it start again until it cools off. It will start though with a push start instantly!
I got only one fault code P0340 cam shaft sensor fault, i replaces sensor and made no difference. Is this a common fault???
Santa FE SM (2001-06) :: Input Shaft Speed Sensor Connector
I have a 2001 Santa Fe GLS 4WD, I've had my Auto Transmission Speed Sensor replaced and will have the output speed sensor replaced to have speedometer/odometer and cruise control fixed. While having the first sensor replaced my mechanic noticed the Input Shaft Speed Sensor Connector (the plug on the wiring harness) was cracked. I've been looking everywhere for this connector. I don't want to buy the complete wiring harness because I've heard it is very expensive. I want just the connector. What is the part number of just the connector?
View 2 RepliesFord - F250 :: Loud Whining Sound / Truck Refused To Go On When Shifted From Drive To Reverse
I am not the sharpest tool in the box. I was driving my 1979 f250 with a full load of fire wood going about 45mph when I shifted it from drive to reverse (I thought I was in 1st) the truck mad a loud whining sound then refused to go on. Now when I shift it in gear it feels like it wants to move and if I revved up high it will rock back and forth. A friend jacked up the rear end with the wheels off the ground the tiers spun in all gears including park and I was told they could stop the wheels by hand with the car in drive. He then took the cover off the rear end and found it to be low on fluid but no signs of damage. What I broke?
View 9 RepliesSanta FE SM (2001-06) :: 2003 - Front Shaft On Vehicle Right Side Makes A Noise
The bearing supporting the half shaft on the vehicle right side makes a noise. I don't hear the noise in the wheel bearings so I believe the noise is isolated to the support bearing.
The SF has 175k mi. The right side cv axle was replaced and it had some looseness in it but it did not eliminate the noise.
Additionally, I don't discount that some noise is generated by the tires as they are not new.
2003 Santa Fe 6cyl ....
Santa Fe (CM - 2007-12) :: 2011 3.5L - Whining Sound From Engine
I have a 2011 Santa Fe 3.5L with about 108,000 kms (roughly 65,000 miles) that seems to have produced a bit of a whining sound from the engine. It will do it in park, or in gear, and the sound seems to increase slightly with an increase in RPMs.
View 7 RepliesFord Super Duty (1999-2016) :: Front Drive Shaft Spinning While In 2 Wheel Drive
I have a 1999 Ford F250 super duty 4wheel drive, lifted (really a leveling kit but had to lift rear to compensate), 5.4l. Im having a problem with my front shaft turning while in 2 wheel drive. Hubs aren't locked and its in 2 wheel not 4. I've taken hubs off and the bearing spins free soo I know its in auto. Why is the drive shaft still turning???????
View 5 RepliesSanta FE SM (2001-06) :: Whining Noise After Extensive Driving
My girlfriend has a 2005 Sante Fe 2.7L v6 AWD. Lately I've been noticing it more and more but when the car is driven for a good amount of time we hear a noise. I'd say maybe an hour or so (I've never measured it though) the car makes a whining noise when trying to turn the wheel or even accelerating. I feel some resistance in the wheel when it happens too but majority of the noise comes from turning the wheel. Also when this happens the car seems to want to pull to the right, i can feel the wheel starting to pull. If I let the car rest and cool down for like 20 minutes or so it will go away but then slowly come back. From what Ive been reading I think I can narrow this down to a power steering fluid issue, either its low, leaking or the screen in the bottle is clogged. I don't see any leaks, nothing pouring out the bottom of the car either.
View 11 RepliesSanta FE SM (2001-06) :: Whining Noise When Vehicle Is Traveling
What is probably a common Santa Fe issue. I have a 2005 V6 2.7L model which has traveled 81,000 miles (131,000km). The power steering is and has been working fine, but over recent week has developed 2 symptoms :
a) The reservoir overflows (see pic)
b) There is a whining noise when the vehicle is traveling and when turning the sounds modifies to more of pressure-release type sound. When the vehicle is stationary, the noise is very evident when turning the steering wheel (See video here : Power steering noise - YouTube )
Other things to report are that the reservoir is full but has not needed a top-up for months. The power steering pump appears to be leak free. I have a slow drip from the rack & opinion area (detected at Hyundai first service - about a few drips per day and they decided it didn't warrant fixing)
I have read on this forum the issue may be related to the reservoir filter becoming blocked and this ties in with the fact the rack and pinion has a known drip leak, but I never need to top-up the reservoir.
Santa Fe (CM - 2007-12) :: Strut / Shock Failure - Knocking Sound From Front
My 2008 Santa Fe (3.3 2WD) produces a knocking sound from the front every time I go on a bump while the wheel is turned. I can pretty much reproduce it at will. Occasionally, I hear the same sort knock from the rear as well, but I cannot confirm that it is consistent.
I do suspect that something is wrong with the struts. The only issue is that the car has 67k KM (41k miles), and to me, that seems a little early for that sort of thing to happen. My driving is pretty standard on standard roads, although winters up here tend to produce potholes that I sometimes cannot avoid.
I've had my struts fail on my last car (2000 Mazda Protege), but that was 9+ years old and with almost 3 times as much mileage on it.
Santa FE SM (2001-06) :: 2002 2.4L - Timing Belt Whining Noise?
I just installed a new timing belt, balance belt, idler, and both tensioner pulleys but am getting a little whine. I adjusted the balance belt but the noise does not change. No other belts or items are hooked up yet this was a dry run. Car seems to run fine and idles well. The hydraulic unit seems to be working fine and it's a OEM Hyundai piece.
Anything common I can look for that should stand out? 2002 Santa Fe 2.4L
Santa FE SM (2001-06) :: 2004 2.4L - Whirring / Whining Upon Acceleration Whenever AC Running
For about 3 years, our SF (about 125,000 miles) has experienced the whirring/whining upon acceleration whenever the AC was running. I didn't do anything about this as the AC still worked well.
Just a few days ago, while running the AC for a "recharge" during our recent cooler weather, I realized that the AC was not cooling below outside ambient temperature, nor was the whirring present any more. I assume that the compressor finally seized. (?)
To keep repair costs low, and based upon the description above, where should I begin to look to see where the problem lies? Is it most likely a seized compressor/clutch? I am unsure if this is the issue, since even when driving with the AC turned to "Max", I now notice NO detrimental effects upon the engine/power output, which makes me wonder if the compressor actually seized. Wouldn't a seized compressor actually be very hard for the belt to turn, or possibly burn the belt?
I know the compressors and AC systems on these cars are notorious for dying too soon...