Santa FE SM (2001-06) :: 2003 V6 Front Brakes Dragging
2003 Santa Fe 3.6 V6 with ABS
The car sat virtually driven for a year before it was given to me. After 2 weeks of normal driving this past December, the power brakes completely went out. Had to drive the pedal to the floor to stop at even slow speeds. Took the mechanic and they replaced the Master Cylinder and both brake lines.
Shortly thereafter had an unrelated issue with a coilpack gone bad. Replaced coilpack and at that time replaced both sets of brake pads on the rear.
In January, started noticing grinding metal on metal from both front brakes. Took the mechanic and they replaced both calipers, rotors, and pads.
2 weeks or so later, after 10 minutes of driving the front brakes started dragging. The pedal would become extremely hard, and I could notice thew smell of the pads burning. Would have to pull over, put the car in park and pump the brakes to get the calipers to release. This would occur intermittently every few days. Pumping the brakes would always solve the problem.
Over time, the issue became worse, ocurring far more frequently. Around this time I noticed leaving the engine on in park while pumping the brakes would no longer solve the issue. I would have to completely turn the car off and pump the brakes to get them to release.
Started noticing around this same time that the left rear started grinding. The brake pads completely wore down in 3 months time. Too to the mechanic. Replaced caliper, rotor and pads.
Still having the same issue with the brakes dragging. One mechanic thought it could be ABS related and advised me to pull the fuse and the two breakers to diagnose. Still had the same issue, so put the fuse and breakers back in.
No mechanic seems to know what is going on with it, and I'd hate to have to replace all the brakes again as the problem goes untreated. Is it possible that the master cylinder or brake booster could be the issue? It's a brand new master but that doesn't necessarily mean anything, I'm told. Again, I can only get the brakes to release the pressure by pumping the pedal with the engine off.
Santa FE SM (2001-06) :: Front And Back Brakes Locking On Intermittently
Front and back brakes heating up and locking on intermittently brake pedal feels normal this has happened 3 times over the last 500 km of driving pedal not sticking down break fluid ok no swelled lines today noticed front left and rear right rotors were hotter than front right and rear left once vehicle sits they release and all is good no abs lights or any other warning lights on.
View 1 RepliesPassat (B7) :: 2012 - Brakes Grip Won't Catching Rotors While Stopping?
So, got the 20 K miles service done last month on my 2012 Passat.
Recently I noticed that when I press the brake pedal to slow down, it seems to work fine. The brakes "catch" the rotors, there is a clear "grip" to the rotors and the car responds pretty fast to start slowing down. However, when I did a brake check to stop the car, I notice that when I press the brakes hard, they don't "grip" the rotors as hard as I would expect past that initial grip instance. Seems like their grip is not "catching" the rotors. As a comparison, my other car (6-cy, disc brakes front and rear) does maintain that grip. Am I missing something in this? Is the behaviour of the Passat's brakes expected?
How often does VW do break flushed based on their service schedule?
Golf/GTI VI :: 2011 - Selective Brakes Intermittently Engaging When Grip Is Adequate
2011 GTI (65k miles). Selective brakes intermittently engaging when grip is adequate. Only happens at speed (>50 mph) when turning, most often with change in pitch (uphill/downhill). Traction light flashes. Happens when ESP on or off, wet or dry. Plenty of tread on (snow) tires. Mild bearing noise has persisted for >20k miles. Two dealers and one third-party shop couldn't find anything wrong, including with bearings. No stored faults.
My suspicion: slow (non-critical) bearing failure causing bad ABS sensor signal/fault, causing ABS/ESP engagement, especially with change in pitch. Related but simpler: ABS sensor failure or bad connection. Pulling fuses?
Elantra MD (2010-15) :: 2013 - Brakes Slip And Re-grip While Coming To A Stop Intermittently
I've relocated back to Texas, and I've noticed since the roads here are much older than the streets in Vegas, if I'm braking while going over a bump in the road my brakes seem to slip and re-grip while coming to a stop. It doesn't happen every day but it happens enough to make my heart skip a beat and think I'm about to die
I do plan on taking this to the dealership because it is pretty big problem, I have a 2013 Limited Elantra
Santa FE SM (2001-06) :: 2004 - Front Driver Side Coil Spring Broken
The driver's side coil spring broke, but here's the story.
When I found out there was a recall on my 2004, I called the dealership. They told me that they were not replacing the coils springs, they were only going to attach a brace or bracket in case the coil springs would fail.
Well, last night the coil broke and it was in the parking lot and not at 50mph on the road.
What about bracket fix? It was told to me that it would only prevent the coil from cutting into the tire, not fix it.
I am going to call Hyundai HQ this morning, but what should I expect? Is it unreasonable to expect to get a set of springs and have someone local do the work?
Santa FE SM (2001-06) :: 2004 - Passenger Front Window Will Not Roll Down From Driver Side Switch
I have a 2004 Hyundia Santa Fe. The passenger front window will not roll down from driver side switch but will from passenger switch but then will not go up on passenger side switch. I found a broken wire on driver side and repaired it. I put a test light on the wires on the passenger side and used the driver switch and the test light lights when using the up button and down button! I have already put a new master switch in and tested all switches they all work!
View 1 RepliesSanta FE SM (2001-06) :: Rear Brakes Keep Wearing Out
My rear brakes keep wearing out extremely prematurely (2,000-7,000 mile intervals) and have been for 60,000+ miles. (No joke my mechanic has warrantied the rotors and pads over and over literally like 10 times) its the insides pads of the back that wear down while the outsides and front are fine...is the proportioning valve causing this problem or is it something else? We've changed the calipers and brake hosed
View 17 RepliesSanta FE SM (2001-06) :: 2003 V6 Shudder When Press The Brakes
I have a 2003 Hyundai Sante Fe 2.7 v6. About 2 months ago I started the car and it was kind of a rough start. It usually starts right up. I was driving in the rain and when I would press the brakes the car would shudder like it wanted to turn off but the head lights and dash lights did not flicker. I had it towed to my mechanic. He found a broken vacum hose and replaced it. The car seemed fine.
Today it started up kinda rough and then would shudder and not accelerate no matter how hard I pressed on the gas pedal. It was also idling roughly.
I bought the car from a friend who was the first and only owner. She has ALL of the service records and took good care of it. It has about 120k miles on it. The spark plugs and battery are only about a year old. It has a half tank of gas. I checked all fluids, pulled a few plugs and they look fine too. Air filter is clean too.
I asked the previous owner if she had ever changed the fuel filter and she said she didn't think so. I reviewed the service records (assuming I have them all) and it doesn't look like it was ever done. I have run seafoam through it 3 times since I bought it last August. I change the oil regularly and rarely let the gas get below 1/4 tank.
Santa FE SM (2001-06) :: Brakes Pedal So Soft That It Goes To The Floor
I have a Hyundai Santa Fe 2005 2.7L 4WD ABS.
The problem is that the Brakes pedal is so soft, that it goes to the floor, and doesn't brake at all in first pedaling. I am able to apply brakes after pumping the pedal thrice in continuation and then when it builds up some pressure, then it brakes and I'm able to stop the car. Once, I take the foot out of the pedal, it goes bad again. Once, again if I have to apply brakes, I have to do 3-4 times pedaling.
The brakes are stopping the car fine when they get applied in 3rd or 4th pedaling and when pressure is built up. Its the pressure not getting built up or maintained in the first go.
What has been done by the mechanics to solve this:
1. Master Cylinder has been replaced with a new one. (This has been done twice)
2. Brake Pads have been changed.
3. Brake fluid has been replaced and is upto the brim in cylinder reservoir.
Santa FE SM (2001-06) :: Brakes Don't Apply Enough Pressure To Actually Stop
When i press the brake pedal the brakes seem to start working ,but they dont apply enough pressure to actually stop the car from speed , it's just happened car was fine yesterday , also i've noticed when i start the car , and press pedal with my hand there is a air leak noise behind the pedal , and a faint low pitched tone noise as well , its as if the servo isnt working fully.
View 2 RepliesSanta FE SM (2001-06) :: 2007 - When Tap The Brakes Lights Go Dim Then Come Back On
I have a 2007 Santa Fe, I have been having issues with the power. I tap the brakes and the lights go dim and come back on. Then when the truck is turned off then back on I have nothing like the truck is dead. I replaced the battery and still same issue. I then replaced the alternator and I thought it was good. Just today I decided the use the keyless remote to lock the truck and it locked but not horn sound. I tried to unlock the truck with the remote and nothing. I opened the door and no lights. Turn the key and nothing. The battery still has power to hit. What it could be?
View 6 RepliesSanta FE SM (2001-06) :: 2002 - Shimmy When Applying Brakes
2002 Santa Fe has Shimmy when applying brakes. Had tire balanced and rotated-no change. New brakes with life time pads one year ago. Rotors were turned. Should I replace the rotors and pads or just rotors? Am I on the right track for repairs?
View 2 RepliesSanta FE SM (2001-06) :: 2003 - Rough Idle When Using Brakes
2003 Sante Fe is suddenly having a problem at stop lights or anytime the car is stopped with brakes. It feels as if the car is going to stall - or back fire. Very evident since it pulls on the brake pedal - just had back brakes replaced.
View 1 RepliesSanta Fe (CM - 2007-12) :: Brakes Started Squealing - Front Pads Replacement?
A week ago my brakes started squealing badly. This past weekend I pulled off the offending tire to take a look and sure enough the squeeler is riding on the rotor so it looks like I need to replace the brakes at 53,000km.
The rotors look good so I plan to only replace the front pads. While I am working on it, I am going to disassemble and preform the TSB on the rears as they have been neglected lately.
What pad material should I go for, metallic or ceramic? Ideally I would like something that has good performance, yet had a good life span. I occasionally pull a 2500lbs (dry weight) braked tent trailer, but that is not very often.
Santa Fe (DM - 2013+) :: Click / Clunk In Front Brakes On Passenger Side
I have a click/clunk in my front brakes, passenger side. Happens mostly braking and turning right into my driveway. It was recently attributed to a strut bearing, but this was not the case, and their replacement didn't fix the problem.
Dealer has said it's a common noise and occurs after service. The only way to stop the noise is to stop lubing the calipers so they drag.
I say they are full of crap. This has now been going on at least 30k km. I have documented it on every oil change that I can remember (always at the dealer). Any way I should be handling it?
Santa FE SM (2001-06) :: High Pitch Squeal In Rear Brakes
Just replaced pads, rotors, caliper hardware, e-brake shoes and hardware and rear wheel bearing assembly on 2006 Santa Fe. Still get a high pitch sound after the car warms up in 5-10 miles. Sound is intermittent and gets somewhat louder as you drive.
View 2 RepliesSanta FE SM (2001-06) :: Creaking Noise In Pedal And The Brakes Don't Seem As Good
So for the last month when I hit the brake pedal I've been getting a creaking noise in the pedal and the brakes don't seem as good. Within the last 6 months I've replaced the rotors, calipers and pads on the front and back. Starting last week when driving between 0-40 mph the ABS has started to engage on its own without even touching the brake pedal. So I've pulled the 2 ABS fuses and I no longer have the creaking noise when hitting the pedal and of course without the ABS its no longer engaging on its own. I've checked both the tone rings in the front and both of them are fine. I also now have a cel with code 0501 and I'm guessing that is because the ABS is currently disconnected. Is it safe to assume that the ABS Pump also known as the hydraulic electronic control unit has gone bad and needs to be replaced?
View 2 RepliesSanta FE SM (2001-06) :: Faint High-pitched Noise When Apply Brakes
So I've started hearing a faint high-pitched noise when I apply my brakes. It's not EVERY time I apply the brakes, and it's not nearly as loud and annoying as the noise I hear other vehicles make when they need their brakes checked, but it's noticeable.
Also: There's a (possibly related) scratching/rattling noise that just started. I can only hear it with the windows down and it's not very loud. But it happens intermittently when the vehicle is moving or when it's braking, and it makes an almost sputtering sound when I slow to a stop. It will abruptly go silent before I'm fully stopped. Sometimes it cuts in and out, similar to when you've got a short in a speaker wire and the sound cuts in and out.
I'll be getting this checked out. Is this a "drop everything and go to the mechanic" issue, do you think, or more of a "get it looked at when you can"? I should note I haven't had any problems with the car actually braking (yet). It seems to function fine other than the new noises.