Subaru - Outback :: Found Engine Oil Jelled Up - Code 0028 With Less Than 1000 Miles After Oil Change
2011 Subaru outback with 49000 miles. Regular oil changes every 5000 miles with Subaru filters. After the last oil change at 45000 miles the engine started shuddering when reversing from garage at @48300 miles. Once warmed up drives okay. Within a week it threw up code 0028 and found engine oil jelled up. Drained, flushed and replaced oil. I replaced the oil pressure switch and solenoid just in case. Code came back with less than 1000 miles after oil change. Can't understand the reason for jelling. Have been using Castrol GTX 5-30 all the time with Subaru OEM filters.
View 5 RepliesCamry :: Serpentine Belt Change On 2.5 Engine?
I have a 2010 camry SE & have found nothing about how to change the serpentine belt on the 2.5 engine.
View 1 RepliesAccent LC (2000-05) :: Engine A Little Louder After Timing Belt Change
My mechanic just did the timing bet, water pump and other belts. Also changed the tensioner.
Car runs fine and everything seems great until I get to a red light. The engine sounds louder then before. Not very loud but its louder and maybe a very slight vibration, not sure yet. No noises while driving, seems like its running the same or better then before. Runs fine though
Honda - Accord :: Vibration And Engine Louder After Timing Belt Change
I have a 98 Honda Accord 4 cylinder with 110k miles on it. It used to be very quite and drives smoothly. I recently had my timing belt and water pump replaced. Right after i got my car back from my mechanic, the driving felt differently. Two main problems, first, every time I stop at red lights or traffic, the car vibrates and you can feel it from the steering wheel. Second, when I start to accelerate and when engine is over 2100 rpm, the engine becomes much louder than before, I feel like I am driving a race car. Other than these two problems, the can seems to drive fine. I took it back and they told me this is normal and takes time to settle down. Is this normal after the time belt change or what might have gone wrong?
View 14 RepliesPrius (2004-09) :: Check Engine Light On - No Codes Found
I have a 2005 Prius with 131k miles. The check engine light came on. I had my mechanic check for codes, he had 3different scanners. There were no codes posted. Next day light went off. It has been off for a week. Now it has returned.
View 5 RepliesPrius (2004-09) :: 2005 - ABS / Check Engine And Red Triangle Codes Found
My 2005 Prius was working quite fine until few days ago when the dash lit up with ABS, Check Engine, red triangle, ((!)), and the red car symbol on MFD. Additionally, the hybrid battery fan now comes on once in a while. Mileage on car is 164K; changed the 12v and hybrid batteries at about 153K. Running it through codes scanners, the following codes were read off it:
* B1421 (Solar Circuit malfunction, passenger side. Also, AC malfunction [although on the car, the AC still seems to work fine])
* P3000 (Hybrid control fault, and cruise control error)
*C2318 (Low voltage error-power supply malfunction)
I have checked 12V status using the diagnostic mode this morning and found it to be 12.0V (although 2 days ago when I checked it was 11.8V.)
I have not used the car since as I wouldn't want it park up by the roadside. I'm scarred to think its the hybrid battery again... For now, the car still moves well. What should I check to confirm real cause(s) of all these?
Lexus GX 2004-09 :: How To Change Serpentine Belt
I have changed belts on other cars just never a Lexs. how hard is it to do on or trucks?
View 7 RepliesLexus RX 2004-09 :: Timing Belt Change After How Much Time
I was wondering if the timing belt on my 05 RX 330 needed to be changed due to age and not miles. The car only has 72k miles on it but it is 10 years old.
View 5 RepliesPhaeton :: Timing Belt / Water Pump Change
So after saying "We don't work on that model" when I asked for a timing belt / water pump change (yup, they actually said that), I went in today to try and get a second key made since the guy I bought the Phaeton from only had 1. I do not have the little code. I was told that there was nothing they could do without the code. My only hope would be to contact EVE directly.
View 2 RepliesAccent LC (2000-05) :: AC Not Working After Timing Belt Change
I just changed the timing belt and everything runs great. I pushed the AC button and no light came on. I checked all the fuses and they are good I took the H and L caps of and tapped the pin and there was air blasting out. Don't know what it could be? All I did was loosen the compressor and remove the belt and put it back on.
View 2 RepliesFord Aerostar :: 1995 - Easiest Way To Change Belt?
Whats the easiest procedure
View 3 RepliesLexus RX 2004-09 :: Code P0016 After Timing Belt Change
After timing belt change code P0016 with Check engine light trac off and VSC light on.
Put on the entire kit...timing belt,tensioner, idler, and water pump. When I took it apart to put the new cam crank sensor I inspected everything and all looked good.
Changed the sensor and reset code, a few hours later back on. Car seems to run fine. I didn't think the sensor was bad. Car was running great...just due for timing belt.
Passat (B5) :: Serpentine Belt Slippage On Takeoff Or Throttle Change
I know the serp belts were done on my 1.8T passat 25k miles ago. The tensioners were not done, of course.
While the engine is still cool I sometimes hear belt slippage on take off or throttle change. I was thinking to just replace the serp belts but then it occurred to me that it could be one of the tensioners causing the problem.
Are the tensioners prone to failure? Or I should just change belts? Car has 92k miles on it total.
Honda - Cr-v :: 1999 - Vibration And Loss Of MPG After Timing Belt Change
My dad changed the timing belt on my 99 CR-V in August and he had some trouble getting it in time (he had to tear down and put it back together 3 times!). Sometime after the timing belt/water pump/spark plug change, I noticed a vibration in the steering wheel while at a stop and a loss of MPG (went from getting 24 mpg to 22.7).
It did not happen immediately after the timing belt change (or at least i dont think it did) so i thought the mpg loss might be due to the changing weather and the vibration coming from a motor mount that i knew was broken, but I got the motor mount fixed and it did not do anything. I think that the vibration has gotten worse, but it seems to be at its worst when the car is really cold. (this morning the temp. was 9 degrees and it vibrated harder than it ever has).
The vibration only happens when the car is in park or at a stop, and it goes away when i accelerate, even if I only accelerate a little bit. I have not noticed a loss in power, or any sluggishness in acceleration. I have tried to research this, and I read something about the drive belt being out of time, but I'm not savvy with cars so I just don't know.
What could be the cause, do I HAVE to get it fixed, and what do you think a reasonable cost to repair is?
Mitsubishi - Galant :: 2002 - Overheating After Timing Belt Change
2002 galant 4cly overheating! So my Galant has 120k miles and I just had the timing belt replaced and I thought I'd be good and have the water pump replaced as well. When I got it back I made a few short trips with it and it was running fine then I took a longer trip about 30 miles and I noticed it was overheating, so I took it back to the shop they thought it was air in the cooling system so they preformed a few flushes, replaced the thermostat even though it was new and then replaced the pump again and the radiator cap, the radiator it's self was replaced maybe 1-2k miles ago. I don't believe the head is leaking since I'm not losing coolant and the oil isn't milky.....I'm at a loss, could the thermostat be the problem? Do I need one from the dealer? Is there a history with replacement pumps bad?
View 12 RepliesCamry :: 2005 - Noticeable Knocking After Timing Belt Change
I have a 2005 Toyota Camry with 120K miles that was bought used with 110K. The previous owner did not have the vehicle long and did not know if or when the timing belt had been replaced. I have read several blogs that recommend replacing the timing belt at 60 or 90K. To err on the conservative side I decided just to do it at 120K. Now my problem. Before the timing belt change there was a slight knocking from one of the cylinders. After the belt change the knocking is more pronounced. Q. How concerned should I be that the knocking is more noticeable? Could this be a by-product of the new belt and as it loosens the knocking will subside somewhat? OR, am I looking at valve job or worse?
View 8 RepliesSubaru - Forester :: Whining Noise After Timing Belt Change
We just had our timing belt changed today as well as the waterpump and fanbelts. It has a loud whining noise now and I don't know if it is even safe to drive back to the mechanic...
View 3 RepliesAcura - Integra :: What Else To Change When Timing Belt / Water Pump Are Done
1987 Acura Integra AT with 158k... Water pump broke after 75k miles (in 18yr period)....
I am wondering what else should I have it done:
- thermostat
- oxygen sensor (is there one?)
- vacuum tubes (I hear that these fail due to age)
- anything else?
Are these near where they will be working on? Any other tips?
Sebring - Chrysler :: 2004 - At 90K Miles Should Change Timing Belt?
I have 2004 Chrysler Sebring base model 4 cylinder with 90,000 miles. Paid off long ago. The schedule says its time to change the timing belt but no symptoms. No other issues and have kept up the maintenance. The cost is around $1000. I need the car to last 2 more years until our new car is paid off. Should I do the repair or play the odds that it won't break down?
View 19 Replies