Prius (Gen 3) :: Engine Hesitation After A Cold Start
Experiencing engine hesitation after a cold start? I've have noticed this and after the engine is warm there is no hesitation.
View 2 RepliesPrius (2010-12) :: Low Rev Cold Start With Delaying Engine Shutdown
My Prius is having a problem during cold start. When I bought it, the cold start was very energetic with a high rev tone then gradually regulate to a normal pace and petrol engine shuts down. But about 4 months I noticed the tone of the cold start has changed, it starts with a weak and low engine rev and delays to turn off the engine. Today it took about 10 mins to power off the engine. Got 2 months I changed my 12V battery (Bosch now), thought that these symptoms was to notify that battery is failing. But the problem is persistent despite I put new battery..
View 7 RepliesPrius (2004-09) :: Engine Speed Higher Than Before Mainly On Cold Start Or Go Uphill
I found recently that my 04' Prius' engine easily goes higher rev than before (based on engine sound pitch). It happens mainly when cold start, go up hill. After warmed up and on flat road, it goes back to normal. Overall, still in great condition at 211K. MPG stays at 46 on meter when temp is around 45F with 50% highway drive at 100 miles/day. I suspect the serpentine belt slippery or something. What do you think? I think the belt is original. I bought it used at 104K.
View 4 RepliesPrius (Gen 1) :: Rattling Sound Coming From Passenger-engine Side At Cold Start?
Upon starting, my 2002 (160,000) has a rattling sound coming from the passenger-engine side. I just started noticing it and it seems to happen in the morning on its first start up. It doesn't seem to be effecting driving, but not sure if it was something to be concerned about.
View 2 RepliesPrius (2010-12) :: Rough Cold Start - Engine Sounded Like Working On 3 Cylinders
So I had 1st rough cold start today on 2010 Prius with 72K. Wasn't too cold low 40s. The fix was to shut it down and then turn on again.
Engine sounded like it was working on 3 cylinders. It is probably ignition or perhaps valve train issue.. with ignition being prime suspect. If it happens again I'll pull and check plugs.
Prius (2010-12) :: Vibrate From Engine Bay At Cold Start - Sound Like Wheel Of Fortune Being Spun
I've had my 2010 Prius for about 3.5 years now and this is the 3rd maybe 4th time happening. This morning I started the car and the car started to vibrate/rattle from the engine bay. It almost sounded like the wheel of fortune being spun but louder.
View 5 RepliesC/K :: 98 K1500 - When 5.7 Engine Starts It Lags / Misses And Backfires
I have a 98 1500 4x4 with 5.7 the engine started acting like it was out of time.I replaced the gears and chain with no luck, replaced crank sensor still the same.when trying to start it , it starts to roll and then seams like the starter disengages the flywheel. When it does start it lags , misses and backfires. It is definitely flooding.I put it on my scan tool and a P1345 code is produced.(came sensor to crank sensor correlation ) What should I try next? I ordered a new distributor assembly but didn't install it yet.
View 3 RepliesMontana :: Engine Misses Sporadically And Sometimes Dies After Stopping
1999 Montana with V6, engine misses sporadically and sometimes dies after stopping.
The missing first became noticeable as it was shifting into 2nd. We took it to our usual mechanic and the computer indicated the camshaft sensor was questionable so replaced it. Cleared things up for a few days and then it started happening again.
Things progressively got worse so we took it to the dealer. They were able to experience the vehicle behaving this way but they said the computer registered no error codes at all.
We've had the injectors cleaned, replaced the spark plugs and wires, and fuel filter. It starts right up in the morning and runs fine but at temperature begins misbehaving again. Warm days are even worse.
It has continued to get worse, increasing in frequency of miss, duration of miss (sometimes it feels like two or three misses in succession), and even to now it dies when we come to a stop. It starts right up but will often die when we put it in gear again.
Mazda - 2300 :: Engine Misses At Steady Speed
[URL] .... Mazda 2.3 Liter 4 cyl. accelerates fine in all gears, but once you reach a steady speed in any gear, it jerks and bumps. Does not run smooth unless you are accelerating?
View 2 RepliesSierra GMC :: 1998 - Engine Misses At Idle And During Driving Speed Range
I recently had intake manifold gaskets replaced in my 98 gmc sierra 4x4 pickup 5.7 . The day I drove it home from the shop it ran fine, even day after but the next day I noticed it seem to idle a little rough and even at normal driving, sometimes seems worse than others. No service engine light has yet to come on. Could there be vacuum leak, trash in intake or bad wires and plugs. Plugs, wires, rotor button and distributor cap are only year and half old.
View 1 RepliesElantra XD (2001-06) :: 2002 HYD - Engine Misses Sporadically Often Every Time After Fill Up
My daughters 2002 HYD Elantra engines misses sporadically often every time after a fill up. What it might be. Once some of the gas is used then it stops.
View 3 RepliesFord - Escape :: 2004 V6 Misses / Bucks And Jumps - Multiple Check Engine Codes
This is a Ford Escape XLT with the 3.0L V6. I get the following codes - P0316 P0300 P0136 P0305 P0306. Sometimes it runs just fine and sometimes it misses and bucks and jumps. It has been taken to a local shop and they said they found a loose ground at the computer. They said they corrected this and it should run fine. It still shows the same codes and runs like it did before they worked on it.
View 10 RepliesFord 6.0L Power Stroke Diesel :: 2006 - Code P0263 - Engine Misses - White Smoke From Exhaust?
I have a 2006 F350. It started running rough and white smoke from the exhaust. I did an injector buzz test and found no codes. Cylinder contribution check showed cylinder one was not functioning. I replaced number one injector, cleaned injector cup installed new injector and copper washer. Engine runs the same. If it was a wiring harness issue should that have shown up in the buzz test?
View 8 RepliesFord - Mustang :: 1971 - Cold Engine Start Fine But Will Not Start When Warmed Up / Sluggish Crank
A cold engine crank will turnover and start normally. But stop to run and errand or grab lunch...and the warm 302 2 barrel engine will turn over very sluggishly, lke the battery is dying. If you wait until the engine is cool, an easy start is assured but that takes hours! A local repair shop has rebuilt the carb, the battery & cables are new, and the starter works fine when engine is cold. My local repair shop is out of suggestions. It seems to work a little to hold the gas pedal down on the floor for a warm engine start....but engine still turns over sluggishly when trying to start when warm. Now If I drive it.....I just drive it around town a bit then back home ...unless I stay several hours somewhere while the engine cools....but that's not fun. It is a convertible, fun to drive...and this problem needs to be solved.
View 14 RepliesPassat (B6) :: FSI Engine Chirp Noise When Start The Car And Engine Is Cold
I have a 2008 FSI engine and I have a chirping noise when I start the car and the engine is cold. The noise goes away when the engine is warmed up. This noise has been like this for a very long time (more than two years) and I was not seriously concerned about this until I found the below video which has exactly the same noise.
The owner in the below video says that the timing belt and the belt tensioner had to be replaced and that his engine was only at 26K miles. I am at 46K miles right now but I definitely had this noise when I was around 20K miles as well.
[URL] .....
Ignition - Saturn - Sl :: 1999 - Engine Misses / Low Power - Ignition Control Module?
My 1999 Saturn SL1 was running well. One evening, I started it up to go home, and it wasn't running well, and barely had power to make it the half mile home. It still starts up, but seems to miss in park and in gear. We tried spark plugs, wires, coils, catalytic converter, cylinder pressure, crankshaft position sensor, and fuel filter with no change in engine behavior. I think the EGR valve was looked at and passed. I hope it is not the fuel injectors as I put a cleaner in the fuel every so often. Could it be the Ignition Control Module, and is there a way to test the existing module? What else could it be, and how could I test it?
View 6 RepliesCamry :: 04 XLE Engine Rattle At First Cold Start Of The Day
Just bought a used 04 XLE Camry for daughter--60K miles. 4 cylinder engine. Engine sounded great when test drove. She has had it for 2 weeks, the engine now rattles badly upon first cold start of the day. Clears up almost immediately (maybe 3-4 seconds). Shut down and restart-no problem--only when cold (or has been sitting for more than a couple of hrs.) I'm thinking it is the valve lifters out of oil, but don't know. And what was the repair?(engine oil was just changed(Synth blend--5W-30Wt.))
View 2 RepliesTown Car :: 99 - Engine Cranks / No Start When Cold
I have a 99 Town car and have problems starting when it is cold (under 20 degrees). The engine cranks. If I jump it it will start after about 30 cranks then it runs fine. Looks like a lot of carbon being blown out the tail pipe. When it is warmed up it starts fine and runs fine, just won't start early in the morning when it is 10 degrees outside.
View 4 RepliesHonda - Fit :: High Rev Engine On Cold Start
I bought a new Honda fit Auto couple days ago, while getting ready to go from first job site to 2nd one, I wasn't paying attention (was adjusting the seat), I had my foot on the acceleator instead of brake. Of course, when I start the car, it cranks and follow by a high rev sound from the engine (I think I hold it half way for about 2 seconds) before realize my mistake and lift off the pad. The car was sitting in the parking lot for 4 hours about 5 degree outside (I drove the car for 40 minutes 4 hours ago). I heard cold starting your car while reving it is not a good idea. especially on a new car that needs break it. I am just wondering if this step cause any perm damange to the engine? After couple of days of driving, it sounded fine with no issue (though on the same day, when I arrived at my 2nd work place after that first debacle, the car took 2 cranks to get it start).
View 18 Replies