Phaeton :: How To Replace Rear Bumper Cover Chrome Trim
I was searching for instruction how to replace the chrome trim that appears to be a seperate piece of trim on the rear of the Phaeton. Mine has some issues on the passenger side and would like to remove it to have it either repaired or replaced.
View 11 RepliesPrius (2010-12) :: Rear Bumper Cover Loose And Gap?
2013 Prius IV.... I just noticed that my right side rear bumper cover has a 1/4 inch gap between the bumper and the quarter panel. I think it's from me sitting on the bumper while tying up my shoes or something. When I apply downward pressure on the rear bumper, the gap widens. The left side is tighter, but does gap out when downward pressure is applied. In any case, the gap is annoying.
View 19 RepliesCamry :: Remove / Replace Rear Bumper Cover On 2003 Vehicle?
How to remove and possibly replace the rear bumper cover on a 2003 camry?
View 4 RepliesPrius (2004-09) :: Rear Bumper Cover Became Detached To Left
I was recently in a fender bender where I was rear ended. My rear bumper cover became detached on the left side and the spoiler underneath it (left side and center parts) became detached. I lost several pieces of hardware in the crash. I was able to clip the bumper cover back in on the left side, and aside from that, I don't believe any bolts, screws, etc. are missing for the bumper cover. However, the spoiler seems to be missing about half of its hardware.
View 3 RepliesPrius (2010-12) :: DRLs Are Dead After Reinstalling Bumper Cover
Ok here is my situation:
After removing my bumper cover and reinstalling it, my DRLs are dead. The harness is reconnected and the turn signals distress signals work.
I unplugged the left DRL, turn signal to see if the right would work and vice versa and I still cannot get either to come on.
I checked the fuse and that isn't popped.
I turned the car to the DRL marker mode and auto mode and everything works except the DRLs.
I even took the bumper cover off again and inspected the harness.
Camry :: Rear Bumper Cover Removal?
how to remove it.My wife backed into my truck and put a dent in the corner of it so I am hoping i can pop it out.
View 4 RepliesCamry 2012+ :: How To Remove Rear Bumper Cover
I have a 2012 Camry and was wondering how to remove the rear bumper cover? Someone backed into me so I have a shallow dent I want to pop out of the plastic.
View 6 RepliesSonata I45 (LF 2015+) :: How To Remove Rear Bumper Cover
So I'm trying to remove the rear bumper cover on a '15, but it has been a royal pain. I went in thinking that the procedure would be similar to what it is on the '14, but it is way more involved. The biggest issue I'm having is removing the large plastic triangular side bracket. It has these weird T-nuts fastened to the body, which you cant remove, and the whole thing looks like it would need to slide upwards to get it off, but you wouldn't have enough room because the shape of the body just gets in the way.
View 1 RepliesPassat (B6) :: Rear Bumper Chrome Cover Molding
Looking for a DIY for this part? It is part number 5 in the illustration.
View 5 RepliesAccent RB (2012+) :: 2013 GLS - Rear Bumper Cover Replacement?
I have a 2013 Accent GLS and I have to replace the rear bumper cover. Any detailed instructions on how to do this?
View 2 RepliesLexus LS 2007+ :: 2010 - Bumper Cover Not Fitting Properly?
I had a low impact accident with my 2010 LS460 where the body shop replaced the bumper cover, collision cushion behind the bumper and a new grill. Below are the picture from their finished work, however I know my car should look better than this. What could be wrong/missing to cause the grill and bumper to not align correctly with my car?
View 7 RepliesFord F-150 (2009-2014) :: Replace Rear Bumper And Trailer Hitch
My wife backed the truck into a pole and bent the driver's side bumper and one of the ears on the trailer hitch (the part that bolts to the frame). I bought all the parts that need to be replaced (the left bumper end, the hitch itself, and the plastic bumper cover), gut am hesitant to try to change it all myself. How hard is it to change out all these parts? Is there a write-up any where out there for this?
View 2 RepliesPrius (2010-12) :: Passenger Side Rear Bumper Gap Is Normal?
This thing drives me nuts.
View 9 RepliesPrius (Gen 2) :: Matrix Front Bumper Cover?
Have an '04 Prius and banged up the front bumper cover. Wanted to know if a Toyota Matrix front bumper cover from the same year would fit on it (without extensive mods, I know anything could fit, but would it bolt right up?).
View 4 RepliesElantra MD (2010-15) :: 2012 - How To Remove Rear Bumper Reflectors
I have a '12 Elantra Limited and I'm planning to smoke the rear bumper reflectors. How to remove them?
View 20 RepliesGolf/GTI VI :: Front Bumper Cover Removal?
I need to remove the front bumper cover of my Mk6 GTI. I think I know how to do it.
View 1 RepliesPassat (B5) :: Removal Of Front Bumper Cover
How do you take off a front bumper cover on a b5.5 wagon? cant find anything on the internet, I am trying to replace headlight lamps. pictures would be great too.
View 5 RepliesPrius (Gen 3) :: Rear Bumper Scratched Up
I've had my 2010 Gen III for about five months. I play in a folk band and we do a lot of gigs in DC and Northern Virginia. We have to haul a lot of stuff, and my Prius holds it all.
But in just a few months my rear bumper has gotten all scratched up moving stuff in and out of the car. I looked around for something I could cover it with to protect it from scratches. The dealership said they could put a non-skid decal on the flat part, but I wanted something that covered a little more.
Camry 2012+ :: SE V6 - Front Bumper Cover Loose
I have a 2012 SE v6 with 1600 miles on it. About a week ago, I noticed my bumper cover pulled away from the corner of the headlight and there was a noticeable gap. I pushed on it, and heard a click. The bumper stayed in place. After a couple days driving, it came loose again. I didnt touch it so the Service Writer would see it first hand. Of course, his first instinct was to puch on it, but I got loud quickly, so he kept his hands to himself, and heard me out. I knew if he clicked it back into place I would be SOL. He admitted something needed to be done, not just click it back.
When I picked it up, he said it was a known issue, and there is a TSB on it. He claimed they replaced a bracket. The invoice reads, "ADDED FELT TO TIGHTEN FIT". Yeah, Im sure that will hold just long enough for them to wash their hands of it.