Elantra HD (2006-10) :: 2009 - Steering Hard / Squealing Or Scratching Metal Noises
I heard some noise when the steering is hard. The noise sounds like squealing or scratching metals. What will be the problem? Is it the EPS system or just the serpentine belt slipping on the alternator?
BTW, the mileage is about 137700.
Prius (2004-09) :: Metal Clunk At Initial Acceleration And Hard Braking
I just had my front axels replaced. The Cv's were clicking. That problem was fixed.
Metal clunk at initial acceleration and hard braking (none during steering)...
Touareg :: Noise (metal-on-metal Rubbing) When Turning Steering Wheel
I have a base v6. When I turn the steering wheel (for example, to make a left turn), it sounds like there is metal-on-metal rubbing. The wheel is not extended (turned all the way til it stops)...
View 2 RepliesTouareg :: Metal Squealing Noise From Brakes
I've had the Treg for about 3.5 months now and at about 1500 miles I started to have intermittent squealing from the brakes. Now at 2300 its constant. I brought it to the dealer and of course all I get is the usual BS they feed everyone... brake pads today don't use asbestos and so the metal squeaks...blah, blah... total crap. No OEM brakes should squeal (let alone on a $40k vehicle) and its never been a problem with other cars with original pads. Is there a solution?
View 8 RepliesGolf VI R :: Loud Squealing / Stone On Metal Sound Coming From Front Passenger Wheel
4000 miles on my CW Golf R - zero problems until this morning. WILD, Loud sqealing, screeching metal on metal or maybe stone on metal sound coming from front passenger wheel. at first i was positive it was a pebble caught b/t the inside rotor and heat shield - i took the tire off and nothing there.. Also only really does it when I turn RIGHT.
View 13 RepliesFord F-150 (2004-2008) :: Intermittent Metal On Metal Grinding Noise
I have intermittent metal on metal grinding noise. Seems to happen when I am at highway speed. Seems to go away when I put it on 4 wheel drive or slow way down. On one occasion though, the grinding noise did not stop even after putting on 4 wheel drive - had to stop completely before it went away (did not come back after I drove off again). Diagnostics so far....
Unhooked the vacuum lines on passenger side actuator and hooked up vacuum gauge. Vacuum held at 20 psi and drops and raises slightly as the truck is being revved. Takes about 10 seconds for vacuum to drop to zero once truck is stopped. Putting it on 4 wheel drive drops it to zero immediately. Exact same scenario on the passenger side.
This leads me to believe my IWE solenoid is ok. So also my check valves. Next opportunity I get, I will raise one wheel, remove the vacuum line on that wheel and apply vacuum with my pump. Want to see if it will turn my half shaft.
2004 F150 FX4 ....
Prius (2010-12) :: Metal On Metal Grinding Noise At High Speed Above 75mph?
I commute 180 miles a day, 6 days a week. I noticed metal on metal grinding noise(more noticeable) at high speed above 75mph especially on asphalt road. I'm sure noise is there at low speed but not enough to notice. My car has 50,000 miles. Tires? Electric motor?
View 7 RepliesPrius (Gen 2) :: 2006 Metal To Metal Noise While ICE Charge The Hybrid Battery
I recently worked on a 2006 with 140K miles that presented with the following symptoms:
The hybrid battery was at 1 bar; the ICE would not start; the car was in Ready, but there were no codes. As I let it roll off the flatbed wrecker in Neutral, it felt lumpy. If you have ever pushed a car (or run out of gas in one) with a manual transmission that was in a high gear, engine off, it felt just like that.
I popped the hood and could see that the engine crank was turning while the car was being pushed in Neutral. What else turns with the wheels? MG2, or more specifically, the MG2 ring gear. What is the only way that the wheels could turn the ICE crank? The planetary carrier pinions were locked to the ring gear.
Surprisingly, while I was looking at things, it did manage to start the ICE pushing it around must have freed the carrier pinions, so I let it charge the hybrid battery. It was basically the worst metal-to-metal noise that I have ever heard! I pulled the drain plug and saw about a teaspoonful of large metal chips on the magnet. The fluid condition itself was very good, not the black factory fill that I am used to seeing come out.
Prius (2010-12) :: Light Metal On Metal Grinding Noise
I have a 2011 Prius with about 32K miles on it. I've been hearing light metal on metal grinding noise for a few days now. So I decided to take it to a stealership and they told me my ceramic pads and brake rotors both need to be replaced for all 4 wheels. I thought Prius brakes don't need to be replaced for 100K miles.
View 7 RepliesPrius C :: Front Steering Wheel Thunk Like Metal On Metal
I have a question about my C Four with 16" wheels. When the steering wheel goes all the way to a stop there is a thunk that feels like metal on metal. It is like there is no rubber bump stops. If this is normal. I am used to cars that have a nice cushioned bump at the steering limits.
View 1 RepliesPrius (2010-12) :: Metal-on-Metal Whining Sound While Running
I own a 2010 Toyota Prius that recently developed a metal-on-metal whining scraping sound when moving. It does not make sound when the vehicle is stationary, and it's intermittent - which makes me discount the rock-in-disc-rotor idea (not eliminate it, mind you). It's quite loud when it occurs, able to hear it over the stereo. Luckily I was near work at the time, so I went there - but the shop can't even look at it until Monday evening - so I am a bit panicked.
View 8 RepliesPrius (2004-09) :: 2007 - Metal Part In The Key Fob Is Broken
The metal key that comes out of the Key Fob is broken, is it replaceable from anywhere other than Toyota? The key fob is perfectly fine no issues with it.
View 1 RepliesPrius (2004-09) :: Dragging Metal Sound With No Visible Cause
My 2007 Toyota Prius occasionally sounds like there is metal dragging somewhere in the front of the car. It usually only happens at low speeds after I have been driving on a highway. If I get out of the car to check. I can't see anything dragging under the car. The sound usually goes away if I continue to drive or (if I've reached my destination) if I let drive the car again later. What this noise might be? The car has 172,000 miles on it, and it has had the wheel bearings changed multiple times in the past few years...I don't know if that has anything to do with the noise.
View 19 RepliesPrius (2004-09) :: Yellow Metal Ramps Don't Work
I tried to use my yellow metal ramps to raise my prius, but the bottom of the front bumper would hit. What can I do to modify it so the bottom of the car will not hit?
View 11 RepliesPrius (2004-09) :: Squealing Upon Making Tight Right Turn?
When I make very tight turn -- turning the steering wheel hard right to enter a parking spot, I am hearing a squeal seeming to come from the engine compartment area, possible near the right front tire, but not entirely sure about the location.
View 15 RepliesPrius (2001-03) :: Severe Vibration When Turning Hard Right Followed By PS Error Code
This summer my power steering went out. I replaced the steering rack with a remanufactured rack, which failed. I got the replacement rack replaced by the remanufacturer and installed by a different shop. Same problem: SEVERE vibration when turning hard right followed by the PS error code, or just little twitchy motions when driving. I'm having the second shop take a look at it again this monday as I suspect that this is a data processing issue.
View 13 RepliesPrius (2004-09) :: Metal Rattling Noise From Brakes Right Front When Going Over Bumps
I'm pretty sure I know what the problem is since when I hit the brakes it stops. When I took the left side tire off and right side I compared and there is a thin metal sheet that has room to move on the right, but is tight on the left. When the brakes were done before maybe it didn't seat correctly or something. Just wondering what that plate is called so I can order one and change it. Driven that way 2 years, but it bugs me when the window is down and people probably think my car is falling apart. Maybe I'll search for a brake diagram.
Edit: I think they might be called "anti squeal shims". I saw a picture of them, so maybe they didn't put enough high temp grease, but the left side is tight and the rights side you can move a couple milometers side to side so I'm sure that's the jingling noise.
Lexus GX 2004-09 :: Hard Start - Vehicle Sometimes Takes 3 Or 4 Tries Of Turning Key Before Engine Fires Up
Over the last week my GX has developed a strange issue. It sometimes takes 3 or 4 tries of turning the key before the engine fires up. It turns over strongly and quickly but it isn't "catching". The weird thing is, it doesn't happen every time. Here is what I have noticed:
1) Leave the vehicle parked overnight - no issues starting. It starts right up.
2) Crank the vehicle after having only been off a few minutes (like after you run in to pick something up at the grocery store) it cranks right up.
3) Let the vehicle sit for between 1 and 4 or 5 hours and the problem appears. It turns over and over and over but won't actually start. Anywhere between the 3rd and 5th turn of the key it will finally catch and actually crank.
In all cases, once it cranks it runs smoothly and normally with no issues.
I have replaced the battery thinking that was the issue but that did not fix the problem. Also strange is the fact that this problem occurred after I replaced both front door speakers, an operation that required me to have one or more doors open for an hour or so at a time (hence why I thought it might be a weak battery).
Honda - Cr-v :: 2004 - Making Clicking Noise When Turning Hard Left / Right At Low Speeds
I have a 2004 Honda CR-V, 100k, just did its 90k maintenance (a little late) and also had the ball joints replaced. Brought back from the mechanic and heard clicking sound when turning wheel hard left or hard right, only at low speeds, usually when parallel parking or simply sitting in park, turning wheel back and forth. Right back to the mechanic: they checked it out, re-lubricated everything, drove it, said it was OK. I got it home, still clicking. Safe to drive this weekend? It's back to the shop on Monday.
View 1 Replies