Accent MC (2006-11) :: No High Beam Indicator On The Dash
I installed a set of bi-Xenon HIDS identical to these.
in my wife's 2008 Accent. I unplugged the DRL module as shown in a thread I found here, but now there's no high beam indicator on the dash. Is there a wire on the plug that I can put a jumper on or something to make this work again?
And before all the nay-sayers growl at me, instead of assisting with this problem, I aimed the lights really low so there's minimal glare to oncoming traffic. We drove about 125 km last night with them and never got high-beamed once.
Passat (B6) :: 2007 1.8T - Low Beam On Passenger Side Not Working But High Beam Does
This morning a dash light informed me a headlight bulb was out. It was my DTR light on the passenger side.
I purchased Sylvania H7 high intensity, installed it and it failed to work properly. Daytime light on only drivers side works.
High Beam on , both lights works.
I checked my manual and it said to check fuse in the 5 slot on the driver side dash/door panel and there actually is no fuse in there. I checked the driver side and there was no fuse there either.
I replaced my driver side bulb last year and it took 5 mins....i am already 4 hours into this!
Passat (B7) :: Low Headlight Beam Indicator Shows Up On Dash
I bought a replacement bulb, swapped it out. No dice. I swapped over the passenger side low beam and still no dice. At this point I know its not the bulbs. I swapped in the original Driver's side light to the passenger side and it works. So now I have an extra bulb.
But the light is not working when I know the bulbs are good. Is this a fuse problem? It just happened one day while driving home from work the light shows up.
How should I go about fixing this and is it most likely a fuse that has gone out or something far worse?
Golf IV / Jetta IV :: High Beam Indicator Is Stuck On
I installed a headlight kit from VW tuning a while back d2s with 6k bulbs I believe.
The headlights work but my high beam indicator is stuck on. I know this is a common problem but for the life of me I can't figure out how to fix it. If I switch back and forth with the stick on the column it does nothing. Just stays on high beams. I've just kind of dealt with it for a while.
Celica :: 2000 GT - High Beam Indicator Not Showing In Dashboard
I have a 2000 Celica GT. Today I discovered that the blue high beam indicator is not showing in the dashboard. The high beam, low beam, and daytime running lights all are working.
View 1 RepliesAccent MC (2006-11) :: 2009 - No High Beam Indicator Light
I bought a 2009 Accent last week after my 1987 Camry wagon bit the dust. It has 47000 km and seems to have been very well maintained. The only problem I have noticed is that the high beam indicator light does not come on, although the hi beams do work. I downloaded an owner's manual but am not sure which fuse the indicator light is on; in any case, everything else seems to be working so I expect the bulb is burned out. My problem : I don't know its location on the instrument panel since it has never worked, and I don't know if it is possible to replace it without special tools.
View 2 RepliesFord - Explorer :: 1997 - High Beam Indicator Inoperative
The high beam indicator on the instrument panel stopped working. It does illuminate but is extremely dim. I changed the bulb, its one of those tiny little bulbs but that didn't work. I cleaned the connection areas where the bulb holder clicks into the back of the panel with scotchbrite, no luck.
I checked for voltage, this is where it gets interesting. I measured 6 volts. The other side is presumably ground, but my meter went a little crazy when I checked for ground, like it sensed voltage, but there is no voltage. This could be a bad ground, but where is the ground located? Buried somewhere under all those plastic panels, I suppose. And why only 6 volts? Is there some electronic control somewhere? The Chilton manual wire diagram just shows a hyper simple circuit from the high beam lights, through the indicator lamp, then to ground.
I DID replace the check engine light bulb and that works now (sarcastic hurray!). I have never seen it come on, the previous owner must have let it burn out, but the truck is in pretty decent shape for its year.
Ford Super Duty (1999-2016) :: 2004 F250 - High Beam Indicator Light Very Dimly Lit
I was cruising my truck down the road and noticed that my high beam indicator light was very dimly lit. I wondered why this would all of the sudden come on at all if the high beams were not on so I pulled over and took a walk to the front of my truck to check my headlights. Sure enough the passenger light was very dim. (I must assume the high beam indicator light being dimly lit is also an indicator for headlight malfunction/burn out)
I figured out the plug has a keeper piece that is supposed to hold it in the bulb base but it was broken off and missing.
I went to the auto parts store to find some kind of fix. To my surprise they have a replacement plug for my truck. The down side is it costs $95 and it still had to be shipped! I decided I could figure something else out.
After I pulled the four 5.5 millimeter screws out of the headlight housing. I noticed there is enough room on either side of the light contacts to drill a hole thru the plug and the bulb to allow a pin to be placed thru both of them which would keep the plug and bulb socket from coming apart.
These are the pins or keepers I used.
A 1/16" drill bit did the job. I put the new bulb/socket and the plug together and drilled a hole on each side of the plug right thru the socket at the same time far enough back and at a width to avoid the contacts of the bulb socket and plug. (there is a rubber gasket in the plug that should be avoided but if you still knick it as I did you can fill the plug or the socket with dielectric grease that most car parts stores have and it will keep any moisture out but not effect the electrical current, do not use silicone, one day you will have to take it back apart for a bulb replacement or something.)
This is the bulb socket with the holes already drilled and the plug removed. This is what it looks like with the bulb/socket and the plug together and the keepers in place. And the back of the composite headlight housing with the assembly installed.
Make sure you install the bulb/socket and plug with keepers on the housing before you bolt the housing to the truck because there is not enough room to get your hands behind the housing to install the keepers with the housing bolted to the truck.
Since I replaced the stock bulb with a Sylvania Silver star I had to replace the driver side too so I didn't end up with a headlight being brighter or "whiter" than the other. Even though I was incredibly careful I still broke the plug on the driver side too! So now both of my headlights now have this mod on them.
Ford Super Duty (1999-2016) :: 2001 F250 - No High Beams And Dash Lights Not Working
I have an 2001 F250 SD with 7.3 Diesel. Headlight switch failed and I replaced it. But now I have no high beams and my dash lights that light the dash up don't work. Gauges, fog light, low beams all work fine. Fuses checked. Multi function switch checked. What to do next?
View 1 RepliesPassat (B6) :: Main Right Beam Not Working Warning On Dash
The main right beam not working message came on in my dash. I have hids in and did the vag com already. I have had them for like three months now and the warning came on today. My lights still turn on and work fine.
View 3 RepliesGolf IV / Jetta IV :: Blinker And One High Beam Not Working
I have 2000 golf with a gli front end. Recently just did the swap and now I'm having issues with one blinker and one high beam not working. The running lights work on both sides. The headlights work on both sides. I checked the bulbs and they were good. I check for power it was all good. I checked the fuses and they were fine.
View 7 RepliesCamry :: 2011 - Left High Beam Is Not Working
I have a 2011 Camry XLE. My left high beam is not working not even for DRLs... I have replaced the bulbs and this is not the case.
View 3 RepliesCamry :: 2007 - DRL And High Beam Aren't Working
Where's the fuse for the DRL ...both my DRL and high beam isn't working ...I checked the bulb and is seem fine. I did check the fuse box on both locations ( under the hood and steering wheel) none of them says DRL fuse in there ...
View 14 RepliesPassat (B7) :: High Beam Not Working - Switched Fuses To New Ones
My high beam doesnt work. I have a Euro Passat with H7. I bought new H7 yesterday but still no luck.
I have switched fuses to new ones.
Is there anything else I can check?
Is there relays on this model for the high beams?
Low beams works fine and everything else in lights.
Passat (B5) :: 2002 - High Beam Switch No Longer Working
So, last night I go to turn on the high beams on my 2002 Passat (pushing the bar on the left of the steering column forward) ... and nothing happens. The bar clicks into place as it should, but no high beams. The little indicator light on the dashboard does not come on, either.
I try to flash my high beams, and that DOES work. The brights come on, and the little indicator lights up when the beams engage.
So ... I know it's not a fuse, since the lights are actually functioning. What part/switch/relay/whatever needs to be replaced to get this fixed? I feel like this would involve me needing to pull apart the mechanism in the steering column, but I hope not ...
Lexus GS 2006-11 :: High Beam Not Working Anymore After Led Change
Wanted to change my stock yellow high beam (DRL) bulb to an LED bulb i bought from jdmtoys I also changed the parking light to LED and it works perfectly, so after changing the high beam bulbs it worked for few seconds then stopped working... I put back the stock high beam bulbs and it still is not working did i blow a fuse or something? Now when I turn the high beam on my headlight turns on instead of the high beam....
This is the bulb i purchased : [URL] .....
Jeep - Compass :: 2007 - High Beam Went Off And Not Working Anymore
My hight beam went off and doesn't work anymore ..my fuse box is the problem and i dont want to replace it cuz its too expensive maybe a chip inside not work right and in my car when i switch the gear to d the hight beam turns on On 6 volts day and night . Now its doesn't work ether the 6 or 12 volts .. How to fix it?
View 2 RepliesFord F-150 - 1997-2003 :: High Beam Headlights Won't Working?
I added plow lights to my truck and something quit when I had the high beams all on at once. All 4 shut off. Low beams still working. What I fried or where to check? Its a 99 F250 superduty.
View 14 RepliesCamry :: 2006 - Key Fob, High Beam, Interior Lights Stopped Working
I have an '06 Camry, which has lost all power functionality. The follow items just stopped working
1. Key fob -- keyless entry and alarm stopped working
2. high beam doesn't come on when headlight is on. However, when headlight is off, it comes on--go figure
3. Power door lock also does not work, even from driver side door. Have to lock all doors manually
4. Interior lights don't come on when door is open.