Toyota - Sienna :: 2006 - Struts Of Wrong Size Causing Damage To Lower Control Arms?
Had after market front struts installed by a non-dealer shop on 2006 Toyota Sienna. Dealer service dept diagnosed two months later that the struts were one inch too long and caused damage to the lower control arms. A director for training for the other shop (one of 80 + shops) completely discredits the dealer shop's theory about the relationship between the size of the struts and the damage to the control arms, while admitting the error with the struts. Both sounded credible as I have very limited mechanical background.
View 19 RepliesPontiac - Bonneville :: 1987 - Socket Size To Remove The Drive Axle Hub Bolts?
What size socket I need to remove the driveaxle hub bolts from this car? I can see the bolts are considerably larger than the socket I have for my Ford Tauruses, and I would like to eliminate the guess work before I go to carquest to get the proper socket. Unfortunately bringing the car to the store and trying sockets until I get one that fits is not an option, since the car is not running right now.
View 3 RepliesPontiac - Grandam :: 1996 - Won't Blow Any Air (hot Or Cold)
I just got a 96 Grand Am for second vehicle, but it won't blow any air (hot or cold), I checked fuses they all look good. I'm thinking possibly blower motor, but wanted to get some feedback before I start plugging away.
View 5 RepliesPontiac - Grandam :: 1996 - ABS Light Staying On?
My 96 Grand Am 3.1 it the SE model. ABS Light is staying on I check all the fuses all are good I check the wires going to the wheels with a ohm meter get a reading of 117 ohms driver side and 110 ohms right side . Need to know if the reading are in specs or not if I need to replace the ABS unit just the control unit (the black box ) or the whole unit that mount on the master cly ? the car has no tags right now so I can't take it to be scan.
View 12 RepliesPontiac - Grandam :: 1996 With Theft System / Sometimes Refuses To Start
Our Grand Am runs well when it decides to start! But occasionally when the key is turned all the way on, the starter may take a few minutes to engage, or not at all. Usually it just starts right up, but not every time, so it is not reliable. The key lock cylinder has been replaced.
View 5 RepliesPontiac - Grandam :: 1996 - RPM Rises At Highway Speed While Turns
My daughter recently had me go for a ride in her car. 96 grand am 4 cyl. The car at highway speeds while making left turn the engine rpm raises. like the transmission is slipping or something. It only does it in a left hand turn above 55 mph. If you let off the gas pedal and the reapply it is normal until you steer into the turn again. only way to get it to not do it is to slow down. What would this be. transmission, wheel bearings, cv joints?
View 1 RepliesCorolla / Matrix 2009-13 :: Bolts Size For Rear License Plate?
what size bolts are needed for the rear license plate?
View 7 RepliesGolf IV / Jetta IV :: 2005 TDI BEW - Auto Transmission Bolts Size / Tool
I need to take the tranny (automatic) off the old engine (BEW).
What are type/size are the bolts connecting the tranny to the block?
The 2 bottom ones I got out using (assuming) 10mm (?) triple square.
What size (socket/tool) and type (triple square, torx, allen) are the others?
Camry :: Replacing Control Arms On 04 Solara?
I am going to start on the control arms on my 04 V6 Solara this afternoon since the bushings are beyond gone.I have done control arms on my 98 corolla but i didnt have to deal with the stupid motor mounts being in the way.I have done a search and it seems(if i have this right)that i need to
1.Remove Dog Bone
2.Loosen right and left side motor mounts but dont remove the bolts.
3.Jack up the engine just enough to get a wrench on the hidden bolts on each side.
Am i missing anything?I already have the Mevotech control arms with new ball joints already attached.I plan on renting a ball joint removal tool from autozone.
Golf IV R32 :: Adjustable Control Arms Are Squeaky / Creaky
I have Bluewater adjustable control arms, they have been on the car for about 22 months, and for the last few weeks they have been squeaking and creaking like a bastard, over any imperfection in the road.
We had the car up on the lift, and twisted the control arms, and it's definitely coming from there. I'm not the best mechanic in the world, pretty far from it, so is there a way to remedy this without replacing them? It sounds like I'm fornicating in a 1986 Caprice every time I hit a bump.
Toyota - Camry :: Replacing Lower Control Arms?
I have been told by a couple of mechanics that the bushings on the lower control arms on my 95 Camry are worn. They recommend replacement of the lower control arms and ball joints.Is this a repair I can do myself? I have reasonable mechanical competency. I figure that I will have to rent a tool at the auto parts store for the ball joint, remove a few nuts and bolts, and bring the car in for an alignment once I get the parts installed.Now my wife is adamantly against me doing this myself. She thinks that I am going to mess this up, the parts will fail at high speeds, and I will die in a fiery crash. She apparently has more confidence in the repair shop grease monkey than her engineer husband. So is she right? Is this a repair which is best left to the shop?
View 7 RepliesFord F-150 - 1997-2003 :: Lower Control Arms Replacement?
Replacing lower control arms? I've read a couple places that you don't need a spring compressor. Anything else to look out for? 2000 F150 4.6L 2WD 288,000 miles....
View 3 RepliesPontiac - Grandam :: All Of Night Light Went Off
Last night when I was driving home, I noticed that all of my "night lights" were off. The lights on the speedometer, gas gauge, gear shift, etc. did not seem to be working, but all of my system warning lights (Traction, Brake, etc) seemed to be fine. I tried to turn the car on and off a few times and also tried fiddling with the lights manually. Nothing seemed to be working.
View 4 RepliesPontiac - Grandam :: 2000 - Won't Turn Over?
I have a 2000 grand am Gt with 3400 motor it started up just fine went to turn around in the drive way the dash lights came on where the ABS sensor is bad, but if u shut it off and started it back up they would go out so i shut it down and went to start it back up and all it does is click, so i thought it was the starter and replaced it, still only clicks. I called GM dealership they said more then likely it is the plastic piece the ignition switch goes in to so i just replaced it and does the same thing.
View 8 RepliesPontiac - Grandam :: 2004 - ABS Light On / Off?
This is on a 2004 Pontiac Grand AM.
The old GM ABS light problem. The lights were on a month ago and the left front hub was replaced, the light went out. They just came back on all of a sudden (coincided with the temperature dropping to 15F). The next day they were out. Then the next day they came back on. I couldn't get a code read with the basic scan tool.
Where should I start? I'm thinking of cleaning the speed sensor connectors and reseating with dialectic grease. Maybe they're dirty or a bit brittle due to age and the cold?
Lexus LS 2007+ :: 2008 LS460 - New Control Arms / Bearings Are Wearing Out
Dealer told me needed new control arms as the bearings are wearing out. Was quoted a little over $3k. Doesn't really bother me bc it only makes a clicking noise when I apply brakes hard but concerned about safety issue. Surprised a car like this would need new control arms with only 70k miles on it.
View 14 RepliesPassat (B5) :: 1999 - Lower Control Arms Breaking At Ball Joint?
My daughter has a 1999 Passat 4cyl.... In the last year I've had 2 lower control arms at the front ball joints just break away. Lucky it has been when she was either stopping or at very slow speed.
On inspection this looks like a very unsafe design flaw. The aluminum control arm is strong except for the light metal around the ball joint it's self. If one of these let go at speed it could be fatal!!
What causes the break other than normal wear and is there any signs before one lets go?
Pontiac - Grandam :: 2004 Keeps Dying With A New Battery
I have a 2004 Pontiac Grand Am with about 130k miles on it. For some reason my car has been dying lately. It did this a few times so the obvious thing was to buy a new battery- oct 2011. Everything was good for a couple months but I recently went on a trip for the weekend and when I came home the car was dead. I jumped it and everything was good until this week. I had a work conference and left wednesday at 8am. When I got home Friday at 5pm the car was dead again. I had an alternator test done before but could it be the alternator? I love my little car and would like to get a couple more years out of her!!!
View 7 RepliesPontiac - Grandam :: 2004 Tries To Turn Over But Won't Start
Have a 2004 Grand am that was having some problems starting:
1) The last 10 times it would start cold, but it would take about 5-10 seconds of turnover before actually starting.
2) After it started, it would start fine the rest of the day.
Now it will not start at all. Today is the coldest day of the year so far... 43 degrees. It tries to turn over. The security light came on once, but did not come on again (i know that's a common problem). (note: I have not seen it in person, but will later today). Either fuel or spark.
My thought: either fuel pump, fuel pump relay, sensor, wires/plugs, etc.