IS F (2008-2014) :: Tires Hitting Top Of Fender Liner When Going Over Moderate Bump
After installing BC Racing Coilover + Swift Spring which is lower than stock.. I've lowered the front another 1/2 inch.. Now going over moderate bump the tires are hitting the top of fender liner. I have tried to use heat gun and pushed the fender a little more up without success. If it involves removing the top fender liner..
View 10 RepliesPrius (Gen 2) :: Replacing Driver Side Inner Fender Liner?
I have 2005 Prius , and the inner fender liner on the driver's side needs to be replaced. The clips came loose and the loosened liner had been rubbing against the tire.
I'm wondering if replacing the inner fender liner would be a DIY job ?
Lexus GS 2006-11 :: 2008 GS460 - Front Fender Liner Was Cut On Outside
just checked my front fender liner(driver and passenger side) and noticed it was cut on the outside between the fender and liner from front of fender to back making a 2" gap above the tire. i bought the car used 2 years ago and never noticed it. i have 20k miles on it. is this a needed part to change? will water damage any items located under this fender lining? i figured they cut it out for an aggressive tire set up and drop???
View 2 RepliesGolf/GTI VI :: Driver Side Front Fender Liner Missing Access Panel
If the driver's side fender liner is supposed to have an access panel cover? I was swapping out my side markers today and noticed that my passenger's side has one but not the driver's side. Didn't think to check for something like that during delivery although from looking at the one from the passenger's side, it doesn't seem hard to believe that it could have fallen out due to spirited driving.
View 3 RepliesIS F (2008-2014) :: Rubbing Against Fender Liners
I'm lowered on coils with 20mm spacers in the front and I'm rubbing my liners not a whole lot but still bothers me. There's a lot of people here with dropped and flush "F's" so what have yall done? Or do yall just let it rub away
View 14 RepliesLexus GS 2013+ :: Rubbing Only On Front Fender Liners
I just recently dropped my car on BC racing coilovers 16k fronk and 14k rear. I am having slight rubbing issues in the Front only. For everyone that's dropped on coils, if you were rubbing what did you do? I currently have my dampening set on 16/32. The rubbing is actually only on my front fender liners. I love the comfort with 16/32 and don't want to turn it up stiffer and I don't want to raise it up too much. I was told to raise it, turn up stiffness or heat up fender liner and push it up or in a bit. Also for the rear since its 2 piece suspension, to raise or lower the rear 1/2 inch would you adjust the height on the BC struts or the BC springs (the one that's sitting in the bucket)? A shop installed mine and I've only owned 1pc rear suspension for my other cars.
View 5 RepliesCamry :: 2005 LE - Rubbing Noise After Driver Door And Fender Repaired
Last year an 8pt buck ran in to my driver door and bounced off the fender of my '05 Camry LE. I was able to get it into the shop Jan. 17th and got the car back Jan. 29th (driver door shell was replaced and fender repaired).
Since then my car has been making inconsistent "errr . . . errr" sounds on the highway going 65-70mph from the area where the driver door and fender meet near the base. Best described as metal rubbing metal. From what I can tell:
1) the sound produces the most on long highway curves to the right going 65-70mph
2) the sound produces the most on warmer days (40 degrees was the warmest we've had here in MN) and on days like today where the weather is 8 degrees I can hear it once in a while but very inconsistently.
3)The exterior looks fine from what I can tell.
4) suspensions and engine are all fine
I have taken it back to the shop and they seem very doubtful the noise is due to their repairs but I am positive that this noise did not exist until after it left their shop. One of the reps even sat in the car and heard the noise while we drove on the highway. They initially blamed the car noise on lug nuts that were placed on backwards which I knew was an excuse to get me out of their shop. Sure enough as soon as I took it out on the highway the noise was still there.
Ford Super Duty (1999-2016) :: Sounds Like Tire Is Rubbing Inner Fender When Make A Slight Turn To Left
Have a problem When i make a slight turn to the left sounds like the tire is rubbing the inner fender. Don't do it all the time. The tire is not rubbing.
View 4 RepliesIS F (2008-2014) :: Clunking / Rubbing On Right Turns And Hitting Pot Holes
2011 ISF with clunking and rubbing noises coming from the passenger front side, especially when making right turns or hitting a pot hole. It really does sound like something is loose and bouncing around when hitting a pot hole, and its the same noise when taking a right turn at any speed. It doesn't make any sense!!! Could be engine bay or could be in the tire well, unsure. We took the tire off today and found nothing wrong and no rubbing points around. We checked the control arm, strut, sway bar, backing plate, wheel bearing for looseness. Cant find anything wrong at all...
View 12 RepliesPassat (B5) :: 2001 - How To Remove The Trunk Lid Liner
I just got the trunk latch problem that is frequently mentioned. Reading other messages here, it seems likely to be due to the spring of the post.
I eagerly went out to remove the trunk lid liner to see if I could fix the problem, but I couldn't for the life of me find the fuzzy screws that other people indicate have to be removed
Looking for a picture of what these seemingly invisible screws look like, or a diagram indicating where they are?
I have a 2001 Passat GLX (not the 2001.5 has the clips holding the liner in)
Lexus IS 2014+ :: Tire With Zero Air Pressure After Hitting Pothole On Highway
It's my first time experiencing a flat tire after hitting a pothole. I was on the Long Island Expressway in Queens, NY on Saturday evening after watching The Amazing Spiderman 2. It was about 12:15 AM, and there were still a lot of cars on the road. (and they were fast!!!) I wasn't aware and hit a pothole, and I immediately heard a loud "BANG" noise from the left wheel. I switched on the tire pressure indicator on the dashboard right afterward, and the air pressure started decreasing. Luckily, I was able to find an exit early and pulled over on local road to check the car. I swapped out the flat tire with the spare and went home safely with my girlfriend.
* I was surprised that the Bridgestone Turanza was able to hold up with 0 air pressure, without letting the rim rolling and touching on the ground.
* Rim is fine - no bent, no scratch
* Took the wheel to a tire shop and discovered that there must be some sharp edges in the pothole, which teared the side of the tire for about 2 inches (right underneath the tip of the rim). Total replacement with installation - $290. Shop ordered a brand new tire (same model) and I will return on Monday to get the tire fixed.
1) How do I check whether the suspension is okay?
2) The tire pressure indicator on the gauge shows nothing now - all 4 wheels. I'm not sure what's going on. I still have the spare wheel on, so I'm not sure whether this is causing the issue.
3) Where is the tire pressure sensor located? When I return to the tire shop on Monday, will the tire guy know how to swap out the bad tire with the new one without messing up with the tire pressure sensor in there?
Touareg :: Sounds Like Sand Is Hitting The Windshield When Traveling At Highway Speed
I know this will sound strange, but starting the other day, I notice that it sounds like sand is hitting my Treg windshield when traveling at highway speed. At first I thought it was coming from the truck in front of me, so I passed him, and it didn't stop. It is just about all the time now, and I cannot imagine what is causing this noise.
It is not incredibly annoying, but how will I know when I am being pelted by real sand? Any clues out there? With 48,000 miles on it, there is not much time left to get it under warranty.
Lexus GS 2006-11 :: Squeaky Dash Or Suspension After Hitting Bumps In The Highway Big Or Small
I have a Gs 430 - 2006. After hitting bumps in the highway big or small it seems like my dash or suspension squeaks inside the car. Since I can hear it so clearly I'm leaning towards its the dash or something behind the dash, It seems to be coming from the drivers side.What could it be?
View 6 RepliesPrius (2010-12) :: Balloon Rubbing Sound At Highway Speeds?
The temperature has dropped down into the 30s here and in my 2011 Gen 3 Prius, when I am driving at highway speeds (55mph-75mph), and go over any sort of light bump or rough road (gently rough, nothing significant just normal "imperfect" highway bumps), there is a rattling sound coming from the front of the dashboard where it meets the windshield that can only be described as the same sound that your hand makes when it's rubbing a balloon! Not your normal plastic random rattle, but like "rubbing a balloon with your hand quickly" sound.
I don't mind that other plastic random rattles from time to time (I am not OCD about the imperfections of how much plastic is in the car), but this is obnoxious and I feel like I'm literally driving a clown car. Is there some sort of lubricant or adhesive that is between where the dashboard and windshield meet that has possibly dried out, that the dealership could quickly fix or apply? I'll still under full warranty at 22k miles.
Lexus IS 2014+ :: Vibration / Rattle Or Buzzing Noise On Overpasses And Rough Roads
So I've been hearing this vibration rattle or buzzing noise... on rough roads and overpasses in southern California. I've uploaded a video clip. At 4 seconds I enter the overpass... and you can hear the buzzing noise from 6 seconds to 9 seconds, you might need to raise the volume.
Is this a normal noise from overpasses? My old cars didn't do this. Also I can't tell where it's coming from, maybe the rear upper area or who knows, could be the license plate for all I know.
Car is a 2015 IS 350 F Sport
Golf/GTI VII :: Spring Binding Popping Noise After Neuspeed Race Spring Install
This noise I have is driving me crazy, installed neuspeed race springs and now I have this weird spring noise, sounds like the springs are binding and then releasing when you turn the wheel, like a clicking dinging noise, it's on both sides and happens when moving slow and turning the wheel and when stationary and turning wheel, it sounds like tug and release not really spring bind I checked install and everything is correct even disassembled bearing assembly and everything is fine, lubed spring seats with silicone paste nothing is working.
When looking at the spring and turning wheel it's almost like the spring is getting stuck on the middle part of the seat then releasing, I know this was a common problem on the mk6 but I haven't heard anything about the mk7 the spring is seated in the lower perch perfectly the upper is were the noise is coming from you can see as you turn the upper bearing by hand it actually somewhat twists the spring and then releases and that's what makes the noise, and it dose not move in a nice circular motion kind of like an egg shaped rotation and it makes the spring flex and pop I think there's a problem with the springs,
Ford Super Duty (1999-2016) :: 2003 - Clock Spring Has 8 Spring Wire?
Adding cruise control to F350 XL I just bought. I got a steering wheel with the buttons. But I am having problems with the clock spring. Mine has an 8 wire plug with only 6 pins on the big plug and all of the clock springs I have found have only a 6 wire plug for the big one. Without changing my clock spring I have no where to plug in the cruise wiring. All have been for right year model with cruise and even tried different years but none will plug in under the dash.
View 3 RepliesFord Super Duty (1999-2016) :: Conversion Of Leaf Spring To Coil Spring?
Conversion from the dana 50 to the newer dana 60 with coil spring? My Dana 50 has called it quits so while my front end is already off the vehicle already why not make improvements. Ford used the 50 for 1999 to 2002 then upgraded to the 60, I'm guessing it was for a reason!
I've read this article on a similar project but the dana 60 had leaf springs as well: Dana 60 Conversion for F250 years 1986-1996 .: Articles I'd prefer coil spring, nothing more then personal preference with a bit of better ride quality. The donor vehicle is a 06 SRW F250 This is not what I'll be getting but just as an example of the parts I would get.
Ford Fuel System :: Gas Line Spring Lock Coupling - How To Release Garter Spring
I hope i don't give the impression on my very first post that I'm a total retard......but ...I can't figure out for the life of me how to get those spring line coupling apart! I've removed the clips...but it just won't pull apart. Is there a tool to release the garter spring?
View 4 Replies