Passat (B5) :: Center Dash Vent Assembly Removal?
How to remove the center (upper, right above the radio) dash vent assembly on an '04 Passat (I assume many other years would be similar). I have a rattle/squeek in there that I'd like to address. Sliding a credit card in between the vent/dash provides some improvement, so I'm thinking if I could get the assembly out and shim and/or lube it I might be able to resolve the problem.
View 2 RepliesPassat (B5) :: Dash Vent Lighting Burnt
My red ventilation symbols in the center console and the passenger side ones do not light up anymore . Are these lights inside changeable because now the center console looks a bit weird at night with only half the red vent lights lit up.
View 4 RepliesPassat (B7) :: How To Remove Center Dash Vent
I could not figure it out. Looking for a good spot to hide an aftermarket gps antenna...
View 2 RepliesPassat (B6) :: Interior B-Pillar And Dash Removal Diagram?
Looking for diagrams for the removal of the dash trim and B-pillar trim. I'm looking to fix the rattles myself.
View 1 RepliesPassat (B5) :: Airbag Fault Warning On Dash After Seat Removal
I removed my front seats to steam clean the carpets. After replacement, I get a "Air Bag Fault" warning on the dash. Is that something I can reset?
2000 Passat Wagon V6, 5sp
Passat (B6) :: Creaking - Plastic Dash Trim Removal On Passenger Side?
How to remove the plastic dash trim on the Passenger side? Is there a way to do this without removing the glovebox? I know there is one screw that needs to be removed. Mine creaks pretty badly. Ive already removed the center console trim and added felt to all those pieces. No more ticks/ creaks.
I guess I could have the dealer remove it but I dont want them taking my glovebox out to do it = more rattles. Why does VW make it so difficult to remove something that should be so simple!!
Ford 6.7L Power Stroke Diesel :: Air Vent Chrome Bezel Removal?
We just got back from our first trip towing our 5'er. One of the things we encountered was the sun glare coming off the chromed air vent ring bezels. I am probably going to have them powder coated to stop the reflection. How to take the rings off the truck?
View 2 RepliesPhaeton :: Do Dash Vent Doors Close
Do the outboard vents close like the vents around the clock? My center one opens and closes with the "need' of the A/C system, but the outboard ones are only open.
View 6 RepliesCamry :: Removing Pen Dropped Down In Center Dash Vent
Grandson shoved an ink pen into the center dash vents of our 2007 Camry LE. I removed the vent grille and found out the pen rolled on back and dropped down into the plenum. Now we cannot set the air circulation to defrost. I'm assuming the pen is restricting flap movement.The dealer was not sure the best way to extract the pen - guessing would have to gut the dash with 6 to 8 hours of labor. I'm mechanically inclined and would try the extraction myself, but want to ensure I take the best route and not waste time and effort with an incorrect approach.
View 12 RepliesCamry :: Remove Center Dash Air Vent On 2008 TCH
How to remove the center dash air vent on a 2008 TCH?
View 2 RepliesGolf/GTI VI :: CIM Center Dash Vent Boost Gauge Goes From -30 To 30?
I ordered the gauge kit, installed it with the printed out DIY (CIMs)
Looks great, everything is tight, no leaks. All power going to the gauge (even the dimmer).
When power is connected via the plug in the back of the gauge, the needle goes from -30 to 30, full swing like some newer vehicles, not when the car is turned on.
Here's the problem, is doesnt read anything. Sits at -30 at idle, rev (limiter) and under load. The DIY says it should be somewhere around -20 at idle.
The only thing I can think of is the pressure sending unit is broken. I know faulty equipment is not uncommon and I'm not mad if that is the case as long as it gets resolved, I just want to get this thing working. This is NOT a bash against CIM either, I don't want anyone getting the wrong idea.
Also, I used a forge boost tap. Everything tight, and secure, no leaks going to the filter, or the 4" hose from filter to psi sending unit. Did I miss anything that's not in the write up? Early 11 model DSG MKVI
Ford A/C :: Selector Stuck On Dash Vent Position
I have a 2004 F250 6.0 truck. My vent selector is stuck in the 'dash vent' position. I can't switch it to defrost, floor, or anything else. This past winter I noticed that heat would blow well but only through the dash vents. Now that summer is well underway I noticed that the AC blows through the dash vents also, but it doesn't blow very cold. I checked the freon, topped it off (didn't overfill), and still have the same issue. I checked the fuses and all are good also.
Of course, moving the selector to Max AC doesn't work either. Does this all point to the blend door motor? I hope not as the reading I have done means that this is one tough project to tackle.
Deville :: 2003 - Clicking Noise When Switch Vent From Dash To Defrost
Went to switch vent from dash to defrost and hear a clicking noise and also air doesn't come out defrost unless the air is switched to floor. Switch air to floor and it doesn't seem to change. Where is the blend door located. sound seems to come from center of the dash.
View 3 RepliesGolf/GTI VI :: Drivers Side Lower Right Dash Trim And Panel Removal?
Trying to remove all the lower trim on the dashboard. Have everything but the lower right portion on the drivers side. The carbon trim on there seems to be tucked under the upper part of the dashboard itself and I can't remove it. I assume there is one final screw under there?
I can pop it loose a bit on the left corner but feel if I force that trim something is going to break.
Ford 7.3L Power Stroke (1999-2003) :: Removal Entire Dash?
I want to remove my whole dash to paint it but i cant figure out what is holding it in,i removed all the black screws from one side to the other the screws under the tabs by the windshield and it still feels like its being held in somewhere underneath?
View 14 RepliesFord Super Duty (1999-2016) :: 2013 - Removal Of Upfitter Dash?
Recently purchased a 2013 F350 w/upfitters. Figured Ford would have made access to the stubs easier by now (previous was an 05 6.0 ) and of course not. A bit more challenging. What parts of the dash do I attack and how. As the dealer is willing to charge only 40 bucks to connect any wires I run to the vicinity, I figure there's a slam dunk sequence for access.
View 7 RepliesPassat (B5) :: How To Take Bulb Out Of Air Vent
I've been at it for a few hours and giving up. I've removed the air vent from dash unplugged wires now trying to take the bulb and bulb housing out of the vent to replace bulb....make sense?
View 1 RepliesTouareg :: Humming From Left Side Of Dash Behind Left Air Vent
A while back I posted a message about a humming sound that sounded like it was coming from the left side of the dash behind the left air vent.
I talked to the master tech from my local VW dealer and he tells me that the humming from the left side of the dash is not the CAN BUS. He says that there's a water pump high in the left front wheel well that is supposed to run as part of the engine cool process. He says it's not supposed to run during normal operation, but he has heard a LOT of complaints about the noise.
He suspects there will be a fix from VW given the number of complaints, but he says that it's normal and nothing to worry about. Just a little annoying.
Ford Super Duty (1999-2016) :: 2009 F350 - Dash Panel Removal
I need to remove the panel to the left of the dash that has the headlight switch and AC outlet in it.
View 1 Replies