Chevrolet - Prizm :: 1998 - CEL Emissions Evap System Code Comes Up
Check engine light emissions evap system code comes up when the system is scanned what could be problem? 1998 chevrolet prizm...
View 4 RepliesFord F-150 (2004-2008) :: Running Rough With Code P0171 - Engine Light Stays On?
I just started to have this problem yesterday. Engine light comes on and stays on. Engine shakes and truck won't go over 50 MPH. Autozone code checker came up with P0171.
Truck has about 95K miles and I had the spark plugs replaced at 75K miles.
Transmission was rebuilt at around that time also.
I only drove it to Autozone and back today to post the code and see what everyone's opinion is as to what's wrong.
Here's what the printout says : P0171 "Fuel Trim Bank One Condition"
Ford F-150 (2004-2008) :: Running Rough Loud And Dies - P0022 Cam Sensor Code
My wife's 06 expedition 5.43v runs rough loud and dies. Not all the time just when it's to hot. I got a code it's p0022 cam sensor. I changed both started the rig up and heard loud rattling like metal maybe chain. It lasted for a the length of my video 1.4mins give or take then went fine, i turned the car off and back on everything seems fine. I know I got her oil done after driving. She had metal/plastic in her oil. I had all plugs done and actually i re did the 8th cylinder plug because it was miss firing and i pulled it by hand with only the socket no ratchet. I'm thinking the chain is going bad if not already bad. Only 113k miles my 04 f150 5.43v lasted 250k before motor swap...
View 7 RepliesFord F-150 (2004-2008) :: Emissions Light Came On - P0054 Code
A couple of days ago my emissions light came on in my truck and the P0054 is the code I get when I scan it. Did a little research online and it looks like it could possibly be a 02 sensor issue. Truck seems to be running fine.. I have a 06 F150 with a 5.4L.....
View 1 RepliesSC/SL/SW :: Dies Intermittently While Driving - Car Never Threw A Code
I checked the fuel pressure it was good. Replaced the crank sensor behind the starter but that did not solve the problem. Replaced the Ignition control module (its located under the coil packs) and all is well now. The car never threw a code.
View 2 RepliesPassat (B5) :: Code P1128 Along With Emissions Workshop Warning Appeared
Car is a 2000 Passat Wagon 1.8T ATW FWD
I get the P1128 code and Emissions Workshop warning most of the year, then it cycles off in the summer. It went off yesterday, back on today, and I imagine it will go off again for weeks/months as the weather heats up.
Things I've tried so far:
Replaced MAF sensor
Replaced MAF wiring harness
Replaced front 02 sensor
Replaced air filter
Replaced cracked vacuum tubes, at least those accessible from the top. Some of the hidden lengths theoretically could be at issue but a mechanic said they were ok.
What I've not replaced is the secondary air pump. (Mechanic told me it's dry and checks okay.)
Passat (B6) :: 2008 Wagon Hatch Won't Open
Always used the button to close it, and nothing particularly different happened last time my wife shut it... now it just makes a groan for a second or two, the TOP of the hatch pops out about a quarter inch (bottom doesn't move at all), and nothing else happens.
View 11 RepliesPhaeton :: 2005 V8 Vs 2008 Passat Wagon VR6 4mo?
I've been looking at the wagon for about a month now, but I am not too sure it has enough space in the rear to accomodate 2 convertible kid seats and a baby seat in the middle.
The Phaeton probably has a ton more space in the rear for that setup, but haven't really test driven one yet, but I am sure its a dream. The good thing is that the Phaeton is certified too and about a couple grand cheaper, even though it is used.
Ford Excursion :: V10 Threw Fault Code - Dash Dim When Headlights Turned On
I got a check eng light and read the codes. Cam sensor, misfire 5 & 8. Replaced cam sensor. Got light twice more. Cam sensor. Cleared codes, now no light but, I lost bottom & mid range HP at a steady decline. Run like a scalded dog on top end. Replaced fuel filter on frame rail & air filter. No cure. Noticed dash dim when headlights turned on. Pulled pos battery cable engine died. Replaced alt old one tested good. Drove to parking spot no power damn near couldn't pull it self. Turned off wouldn't start. Before I turned off it would rev up perfect just no power to move. Had a camed up sound at an idle like a slight miss. No fault codes present. Ford claims crank sensor. Haven't replaced that yet. Have fuel in fuel rails. 10 coils could not have lost spark at once. Any part other than crank sensor?
View 14 RepliesPassat (B5) :: 2000 1.8T Vacuum Leak On Cold Start - Emissions Workshop 1 Code Flashing
I have a 2000 Passat 1.8T. When I start it up in the morning I hear a loud obnoxious noise like a vacuum leak from the engine compartment. It lasts for about 1.5 minutes then runs normally. After about a minute it starts up again and only last for about 7 seconds...ish. When I drive it afterwards, less that a half block or so, the CEL light goes on after 1 beep. Also, at that time I get a messages from the instrument panel that says "Emissions Workshop 1". I've read that it could be a simple damaged vacuum hose to the secondary air pump. Definitely a huge price difference to repair.
This morning is was colder outside than usual and the dash kept beeping and flashing the "Emissions Workshop 1" code intermittently.
Passat (B6) :: 2008 Wagon - Intermittent Hatch Button Hesitation
Every once in awhile - very intermittently - when I press the close hatch button on the tailgate of my 08 Passat Wagon V6 4mo, it starts down and stops. I have to make myself watch it because more than once I have gotten in and started off. I only notice when I look in the rearview mirror and notice the unobstructed view. It seems to happen most often the first time I use it in a day but that is not consistent.
View 4 RepliesFord Fuel System :: Running Rough - Skipping / Surging And Die
I built the 400 in my 79 a couple years ago and it runs very well...until yesterday. I'm about 80 miles into this tank, and on my way home from work, I thought I felt a vibration (not in the steering wheel, but in the front oc the truck). Then the engine became evident it was running rough and was skipping and surging. I stopped.
It idled pretty rough, then died. Fired right back up, ran rough, and died. Sometimes it would idle smooth for several seconds (20-30) then start surging and skipping and die. I could hold a little throttle and it would run about the same, except some backfiring in the exhaust (more like a big hiccup).
The carb is a 670 Street Avenger with nothing really done to it. The bores are really black (not sooty, more damp or so). I have always used the air filter, so that's odd. I took the carb off and removed the bowls. Nothing inside has a dirty or clogged appearance at all. Not sure if I should completely rebuild it.
Ford Exhaust System :: 1987 Ranger - Engine Is Running Very Rough And Seems To Miss At Low RPMs
How many O2 sensors does a 2.3 fi 4 cyl. have. I think just one on the manifold, but I'm not completely sure. Engine is running very rough and seems to miss at low RPMs, has no power and drinks gas like crazy!!! Emissions light is on on the dash. I'm thinking O2 sensor......tried replacing, but couldn't get enough torque on the sensor socket wrench to loosen, may be rusted.
View 6 RepliesGolf IV R32 :: Running Rough And Stumbling A Bit - Code P0103
124k, original owner, no mods. Car was running rough and stumbling a bit. A bunch of codes came up. I replaced coils because I had them, spark plugs look good. One code came back p0103. I cleaned the throttle butterfly and replaced the maf sensor. Still same problem.
When I first start it cold it idles high but stays running , once it warms a little the idle drops and then it won't stay running. Then the traction control light comes on and then the cel. I checked for a vacuum leak but came up with nothing.
Ford - Taurus :: 2003 - Running Rough / OBD Code P0172
I have a 2003 Ford Taurus. It has been running rough for awhile. It doesn't happen all the time, alas. I took it to my local repair guy. They first said, oh this happens when the AC is on. But I knew it happened otherwise.
The check engine light came on yesterday, blinking, but didn't stay on. And it was running rough. Check engine light came on, on a Sunday so I had to wait until Monday to bring the car in. They just called and said they can't find anything wrong, ran it on the computer, says it's running fine. I said, did you check the spark plugs, wires, etc? (I am good at googling, to be armed with some kind of info)
I am thinking they just put it on the computer. I suppose it has to be running bad to show anything (?) and even then, it's no guarantee. Anyway. It seems like I am "sentenced" to driving this car until it strands me, catches on fire (I read about that possibility and I have on occasion smelled something burning), or if luck has it, when it is running rough, and I bring it in while it's running rough, the computer finds the problem.
Golf/GTI VI :: 2010 - Running Rough / Timing - P0016 Code Comes On
So about six months ago I bought a used 2010 mkvi gti from a small dealer. Now here's my problem. The other day i started my car and it was a rough start. And the car ran rough. I stalled twice trying to back up. Then the car threw a light. I didnt drive it at all. Shut it off and left it. Read the code that night. P0016
Now I know the timing tensioner thing has been beaten to death. So that's my first thought. However, there was never a rattle or a noise. Nothing like that. Is it possible? All four cylinders have compression. About 210psi. I don't know if that is good or bad. Plugs are worn but look good enough. Not too much junk on them. Coil packs look "newer" and they are the "upgraded" versions. Other than the tensioner what else could cause a p0016 failt?
Jimmy :: 95 Running Rough / Stuttering - Camshaft Position Sensor Code
I have replaced the camshaft pos sensor multiple times from Autozone (warranty ) and replaced with one from Advance Auto still get cam sensor code changed crankshaft sensor today still running like crap, stuttering. I have also done a complete tune up and the Distributor has not been pulled.
View 1 RepliesJeep - Cherokee :: 2009 - Engine Is Running Rough / CEL Code Is P0152
I have a 2009 Jeep Grand Cherokee. Engine is running rough. Check engine light comes on. Code is P0152. The code is defined as high voltage on the front o2 sensor (bank 2). I hooked up the scanner again and checked the voltages. Both O2 sensors on bank 2 are never making it above 0.1V. That seems to contradict what the DTC is telling me. Is that somehow related to the fact that it is not going into closed loop? I'm a little confused.
View 8 RepliesFord Ranger / B-Series :: 1998 - Running Rough And Now Getting P1151 Code
1998 Ranger 4x4 4.0 Ltr - Runs rough ever now and then and CEL giving P1151 code. Upper and lower intake gaskets have been replaced.
View 14 Replies