Passat (B5) :: Turn Signal Stay On And Won't Blink When Switched Either To The Right Or Left
The turn signals in the car (00 1.8t) are starting to act up. One day it'll stay on the on position and wont blink when switched either to the right or left. And on another day they will just decide to start working properly again. The hazards also follow suit. Ive checked all the bulbs all are good, took them out and put back in again. Still having problems.
View 2 RepliesCamry :: How To Make Turn Signals To Blink Faster
As i kid i hated seeing people make there turn signals blink faster but know as i got older I like it, so on my 2011 camry and i want to make the turn signals blink faster. Not too fast but a little faster. I know I need a flasher but i can't find one for the Camry. I know I have to remove the instrument cluster.
View 14 RepliesPrius (2004-09) :: Turn Signals And Hazards Don't Blink
2004 Prius here. The turn signals and hazard lights stopped working a few days ago. I found a disconnection in the grounding and repaired it. Also replaced the fuse and the flasher switch. Now the lights work, and I can hear the flasher switch clicking, but they don't blink!
View 13 RepliesToyota - Corolla :: 2000 - Turn And Hazard Signals Don't Blink
Car is 2000 Corolla with 58k miles. Today, I had my hazard signals on while parked when suddenly....they stopped blinking. The signal lights in the dash just stay on...they do not blink. I also verified that both front and rear lights also turns on...it just doesn't blink.
The corolla has a fuse box under the hood in the drivers side. Here is the schematic for the fusebox: [URL] .....
From what little I know about mechanics/electricity, can I just pull the wiper fuse and put it into the turn signal fuse while I wait for a new fuse? Do I need to disconnect the battery?
How to confirm this is the part I'm suppose to install: [URL] ....
Camry 2012+ :: SE V6 - How To Make Turn Signals To Do 3 Blink For Changing Lanes
How to make the 2012 Camry SEV6 turn signals do the little 3 blink for changing lanes, llike the newer ones, or the corollas do... Is it impossible???
View 14 RepliesFord Excursion :: No Turn Signals / Hazards Work But When Press Brake Tail Lights Just Blink
I have checked all fuses, checked wires on top of steering column all checked out ok. Hazards work but when I press brake tail lights just blink with no brake light but the 3rd brake light works??? Signal switch maybe??
View 14 RepliesPassat (B5) :: 1998 - At Start Up Oil Come On Right Away Beep 3 Times Blink Then Car Shut Off?
My 98' 1.8t AEB was having a bad valve tick so i took the valve cover off and noticed the top camshaft had a lobe eaten away pretty bad and it looks like the bearing next to it was spinning I KNOW that its from a lack of lubrication so that means its my oil pump? there was absolutely no sludge or swarf that i could see.
what made me take the valve cover off was a small oil leak and i thought it was the gasket, but my PCV valve slipped out of its sleeve so thats where the oil came from.
also, every time i started my car the oil would come on right away, beep three times, and blink until i shut the car off.
So, i guess i am wondering, do i have deeper problems here or could i replace the cams, bearings and oil pump?
Buick - Lesabre :: 1997 - When Using Turn Signals, Arrows On The Dash Stay Illuminated
I have a 97 Buick Lesabre, when I use the turn signals (Doesn't matter right or left) the arrows on the dash stay illuminated. The turn signals aren't turning on, on the outside of the vehicle either. The hazards work just fine though (Blinking on the dash and outside of the car). I replaced all four flasher bulbs (2 in the back 2 in the front), nothing. I replaced the dual filament tail lights, still nothing. I replaced the flasher unit under the dash, still nothing. Where's the next place to look?
Other interesting information : This happened a day after I took the car through a drive through car wash.-Since I've had the car, the turn signals have never self canceled (As in after executing a turn the blinkers stay on)....
Ford F-150 - 1997-2003 :: Turn Signals / Blinkers Started Off Blinking A Few Times Then Stopped Working
My blinkers started off blinking a few times then stopped working, now they don't work at all. The fuse says it goes to the brake lamps, hazards and turn signals. The hazards work as well as the brake lamps. I found the relay/flasher box and it appears the relay and flasher is the same for both the turn signals and the hazards. I checked for the wire/connector problem in the column and all looks good there. When I activate the turn signal lever I feel one click in the relay/flasher which leads me to believe the turn signal switch is working. I went ahead and replaced the relay with no results. Is the flasher internals the same for both the hazards and the turn signals or is there two independent sections inside for each?
View 4 RepliesChevrolet - Venture :: 2001 - Turning Signals Blink Fast
Rhe problem is that both sides blink fast the left one used to blink normally sometimes and fast again. All the light bulbs work and are not led. I found the problem on the right side : in the front the side light blinks but the drl doesn't blink with it. Now both sides blink fast. What part of the car i should check ?
View 3 RepliesPassat (B5) :: 2002 - Turn Signals Flickering On And Off
i have a 2002 passat b5.5 and i have been having this problem every time i use one of my turning signals it sometimes turns on..........but quickly shuts off...and then sometimes it doesn't turn on at all..
View 2 RepliesPassat (B5) :: Turn Signals Stopped Working
So I get to explore my first repair with this new to me car. Yesterday morning, turn signals works fine. That afternoon, the stalk apparently stopped working, which I have heard of. Interestingly though:
-the brights and cruise work
-the hazards work (my improvised indication that I'm turning )
-the stalk had been replaced once before by the PO.
Did this thing eat another stalk, or are there some other things I should check first?
Touareg :: Code For Changing The Blinker To Blink Form 4 To 3 Times?
What is the VAG-COM code for changing the blinker so that it would blink 4 times instead of 3 when you just tap it. I tried searching for it and can't find it in the archives. What the code is, or where the message it?
View 7 RepliesPassat (B5) :: Turn Signals Nonfunctional - Click Sound Gone
Today I noticed that the "click" sound on my turn signals was gone. I had someone watch the front and rear signals and none of them lit up if the clicking/dash light didn't either. Sometimes it would come on for 2-3 clicks, then stop. I could sorta force the issue by flipping the level back and forth, but it only worked for about half of the times I flipped the lever.
I tried the hazard switch. In this situation, the lights stay on (blinking), but they have an irregular cadence, like a heart murmur (just in signal form!). Click-a, click-a, cli-cli-cli-cka...etc.
Passat (B6) :: Turn Signals Removal And Install In Mirror?
How do u remove and install the turn signals in the mirror?
View 6 RepliesPassat (B5) :: 1998 V6 Turn Signals And Hazard Not Working?
I just bought a 98 passat sedan v6 four days ago. When I purchased it the turn signals and hazards were working. I was driving yesterday and they went out all of the sudden. Thought it was the fuse at first, changed it, still not working. I bought a turn signal flasher relay, but the repair manual doesn't tell me which one it is so I can change it.
View 2 RepliesPassat (B6) :: Removing / Replacing Front Turn Signals?
I am gonna switch out my front turn signals from my 2006 Passat but I dont know how. Are there any screws or clips that I need to remove? Looking for Pics ....
View 3 RepliesPassat (B7) :: Parking Lights As Brakes And Turn Signals?
Is there a way to make the parking lights (on the boot) to work with turn signals and brakes? I want the turn signal action to look like this : [URL] .....
BTW, I tried searching on this topic but I found nothing. I'm planning to buy this kit - [URL] .....
Passat (B6) :: How To Replace Side Mirror Turn Signals
My blinker housing is cracked and I can't figure out how to remove and replace it. It looks like you might have to pull the mirror glass to get to the screws. Is this the case? If not, how do you do it, and if so, how do you pull the mirror glass off without it breaking?
View 5 Replies